Edmund G. Seebauer
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Edmund G. Seebauer has a total of 58 co-authors. Here are the top co-authors by number of shared publications:
- Heonjae Jeong
Sogang University 35, Baekbom-ro, Mapo-gu
10 shared publications - Elif Ertekin
Department of Mechanical Science and Engineering, University of Illinois at Urbana-Champaign, Urbana, Illinois 61801, USA
5 shared publications - Kandis Leslie Gilliard-AbdulAziz
Department of Civil and Environmental Engineering
3 shared publications Ming Li
Department of Chemical and Biomolecular Engineering, University of Illinois at Urbana-Champaign, Urbana, USA
3 shared publicationsYevgeniy V. Kondratenko
Dept. of Chemical and Biomolecular Engineering, University of Illinois, Urbana, IL 61801
3 shared publicationsAmitabh Jain
2 shared publications
Latest Publications
- Open Access
- 21 May 2026
- Published by Springer Nature in MRS Bulletin
- Vol. 51 (5) , 572-589
Point-defect kinetics in semiconductors: Experimental insights, modeling approaches, and applications
- 21 May 2026
- Published by Springer Nature in MRS Bulletin
- Vol. 51 (5) , 572-589
Open AccessPoint-defect kinetics in semiconductors: Experimental insights, modeling approaches, and applications
- Open Access
- 9 March 2026
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 28 (14) , 8372-8386
Ultraviolet photoeffects on oxygen–hydrogen interstitial clusters in rutile TiO 2
Ultraviolet illumination alters the concentrations of interstitial clusters containing oxygen and hydrogen in TiO 2 exposed to liquid water.
- 9 March 2026
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 28 (14) , 8372-8386
Open AccessUltraviolet photoeffects on oxygen–hydrogen interstitial clusters in rutile TiO 2
Ultraviolet illumination alters the concentrations of interstitial clusters containing oxygen and hydrogen in TiO 2 exposed to liquid water.
- Open Access
- 3 November 2025
- Published by Leipzig University Library in Diffusion Fundamentals
- Vol. 39
Diffusive Isotopic Fractionation: Implications for Diffusion Modeling in Crystalline Solids
The recent discovery [1] of strong isotopic fractionation of oxygen in a metal oxide semiconductor via "uphill diffusion" turns out to have unexpectedly broad implications for continuum models of defectmediated diffusion in crystalline solids. Fig. 1 shows examples of such fractionation, which drives the concentration of 18 O in single-crystal rutile TiO2 submerged in liquid water to well below natural abundance levels.
- 3 November 2025
- Published by Leipzig University Library in Diffusion Fundamentals
- Vol. 39
Open AccessDiffusive Isotopic Fractionation: Implications for Diffusion Modeling in Crystalline Solids
The recent discovery [1] of strong isotopic fractionation of oxygen in a metal oxide semiconductor via "uphill diffusion" turns out to have unexpectedly broad implications for continuum models of defectmediated diffusion in crystalline solids. Fig. 1 shows examples of such fractionation, which drives the concentration of 18 O in single-crystal rutile TiO2 submerged in liquid water to well below natural abundance levels.
- Open Access
- 10 April 2025
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 27 (18) , 9522-9536
Reactions of fluid and lattice oxygen mediated by interstitial atoms at the TiO 2 (110)–water interface
Interstitial atoms rather than vacancies mediate the exchange of oxygen between TiO 2 and liquid water containing dissolved O 2 .
- 10 April 2025
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 27 (18) , 9522-9536
Open AccessReactions of fluid and lattice oxygen mediated by interstitial atoms at the TiO 2 (110)–water interface
Interstitial atoms rather than vacancies mediate the exchange of oxygen between TiO 2 and liquid water containing dissolved O 2 .
- 25 September 2024
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 161 (12)
Influence of interstitial cluster families on post-synthesis defect manipulation and purification of oxides using submerged surfaces
Injection of interstitial atoms by specially prepared surfaces submerged in liquid water near room temperature offers an attractive approach for post-synthesis defect manipulation and isotopic purification in device structures. However, this approach can be limited by trapping reactions that form small defect clusters. The compositions and dissociation barriers of such clusters remain mostly unknown. This communication seeks to address this gap by measuring the dissociation energies of oxygen interstitial traps in rutile TiO2 and wurtzite ZnO exposed to liquid water. Isotopic self-diffusion measurements using 18O, combined with progressive annealing protocols, suggest the traps are small interstitial clusters with dissociation energies ranging from 1.3 to 1.9 eV. These clusters may comprise a family incorporating various numbers, compositions, and configurations of O and H atoms; however, in TiO2, native interstitial clusters left over from initial synthesis may also play a role. Families of small clusters are probably common in semiconducting oxides and have several consequences for post-synthesis defect manipulation and purification of semiconductors using submerged surfaces.
- 25 September 2024
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 161 (12)
Influence of interstitial cluster families on post-synthesis defect manipulation and purification of oxides using submerged surfaces
Injection of interstitial atoms by specially prepared surfaces submerged in liquid water near room temperature offers an attractive approach for post-synthesis defect manipulation and isotopic purification in device structures. However, this approach can be limited by trapping reactions that form small defect clusters. The compositions and dissociation barriers of such clusters remain mostly unknown. This communication seeks to address this gap by measuring the dissociation energies of oxygen interstitial traps in rutile TiO2 and wurtzite ZnO exposed to liquid water. Isotopic self-diffusion measurements using 18O, combined with progressive annealing protocols, suggest the traps are small interstitial clusters with dissociation energies ranging from 1.3 to 1.9 eV. These clusters may comprise a family incorporating various numbers, compositions, and configurations of O and H atoms; however, in TiO2, native interstitial clusters left over from initial synthesis may also play a role. Families of small clusters are probably common in semiconducting oxides and have several consequences for post-synthesis defect manipulation and purification of semiconductors using submerged surfaces.
- 21 March 2023
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 41 (3)
Effects of adventitious impurity adsorption on oxygen interstitial injection rates from submerged TiO2(110) and ZnO(0001) surfaces
Low bond coordination of surface atoms facilitates the injection of oxygen interstitial atoms into the bulk near room temperature from the clean surfaces of semiconducting metal oxides when exposed to liquid water, opening new prospects for postsynthesis defect engineering and isotopic fractionation. The injection rate and penetration depth vary considerably under identical experimental conditions, however, with the adsorption of adventitious carbon suggested as the cause. For water-submerged rutile TiO2(110) and wurtzite ZnO(0001), this work bolsters and refines that hypothesis by combining the isotopic self-diffusion measurements of oxygen with characterization by x-ray photoelectron spectroscopy and atomic force microscopy. Adventitious carbon likely diminishes injection rates by poisoning small concentrations of exceptionally active surface sites that either inject O or dissociate adsorbed OH to injectable O. These effects propagate into the penetration depth via the progressive saturation of Oi traps near the surface, which occurs less extensively as the injected flux decreases.
- 21 March 2023
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 41 (3)
Effects of adventitious impurity adsorption on oxygen interstitial injection rates from submerged TiO2(110) and ZnO(0001) surfaces
Low bond coordination of surface atoms facilitates the injection of oxygen interstitial atoms into the bulk near room temperature from the clean surfaces of semiconducting metal oxides when exposed to liquid water, opening new prospects for postsynthesis defect engineering and isotopic fractionation. The injection rate and penetration depth vary considerably under identical experimental conditions, however, with the adsorption of adventitious carbon suggested as the cause. For water-submerged rutile TiO2(110) and wurtzite ZnO(0001), this work bolsters and refines that hypothesis by combining the isotopic self-diffusion measurements of oxygen with characterization by x-ray photoelectron spectroscopy and atomic force microscopy. Adventitious carbon likely diminishes injection rates by poisoning small concentrations of exceptionally active surface sites that either inject O or dissociate adsorbed OH to injectable O. These effects propagate into the penetration depth via the progressive saturation of Oi traps near the surface, which occurs less extensively as the injected flux decreases.
- 1 December 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 126 (49) , 20800-20806
Effects of Ultraviolet Illumination on Oxygen Interstitial Injection from TiO2 under Liquid Water
- 1 December 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 126 (49) , 20800-20806
Effects of Ultraviolet Illumination on Oxygen Interstitial Injection from TiO2 under Liquid Water
- 17 October 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry Letters
- Vol. 13 (42) , 9841-9847
Strong Isotopic Fractionation of Oxygen in TiO2 Obtained by Surface-Enhanced Solid-State Diffusion
Isotopically pure semiconductors have important applications for cooling electronic devices and quantum computing and sensing. Raw materials of sufficiently high isotopic purity are expensive and difficult to obtain; therefore, a post-synthesis method for removing isotopic impurities would be valuable. Through isotopic self-diffusion measurements of oxygen in rutile TiO2 single crystals immersed in water, we demonstrate fractionation of 18O by a factor of 3 below natural abundance in a near-surface region up to 10 nm wide. The submerged surface injects O interstitials that displace lattice 18O deeper into the solid as a result of the statistics of interstitialcy-mediated diffusion combined with steep chemical gradients of O interstitials. Slightly acidic and slightly basic liquid solutions both enhance the fractionation and affect the details of isotopic profile shapes through several chemical and physical mechanisms.
- 17 October 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry Letters
- Vol. 13 (42) , 9841-9847
Strong Isotopic Fractionation of Oxygen in TiO2 Obtained by Surface-Enhanced Solid-State Diffusion
Isotopically pure semiconductors have important applications for cooling electronic devices and quantum computing and sensing. Raw materials of sufficiently high isotopic purity are expensive and difficult to obtain; therefore, a post-synthesis method for removing isotopic impurities would be valuable. Through isotopic self-diffusion measurements of oxygen in rutile TiO2 single crystals immersed in water, we demonstrate fractionation of 18O by a factor of 3 below natural abundance in a near-surface region up to 10 nm wide. The submerged surface injects O interstitials that displace lattice 18O deeper into the solid as a result of the statistics of interstitialcy-mediated diffusion combined with steep chemical gradients of O interstitials. Slightly acidic and slightly basic liquid solutions both enhance the fractionation and affect the details of isotopic profile shapes through several chemical and physical mechanisms.
- 18 July 2022
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 14 (29) , 34059-34068
Surface-Based Post-synthesis Manipulation of Point Defects in Metal Oxides Using Liquid Water
Initial synthesis of semiconducting oxides leaves behind poorly controlled concentrations of unwanted atomic-scale defects that influence numerous electrical, optical, and reactivity properties. We have discovered through self-diffusion measurements and first-principles computations that poison-free oxide surfaces inject interstitial oxygen atoms into the crystalline solid when simply contacted with liquid water near room temperature. These interstitials diffuse quickly to depths of 20 nm-2 μm and are likely to eliminate prominent classes of unwanted defects or neutralize their action. The mild conditions of operation access a regime for oxide fabrication that relaxes important thermodynamic constraints that hamper defect regulation by conventional methods at higher temperatures. The surface-based approach appears well-suited for use with nanoparticles, porous oxides, and thin films for applications in advanced electronics, renewable energy storage, photocatalysis, and photoelectrochemistry.
- 18 July 2022
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 14 (29) , 34059-34068
Surface-Based Post-synthesis Manipulation of Point Defects in Metal Oxides Using Liquid Water
Initial synthesis of semiconducting oxides leaves behind poorly controlled concentrations of unwanted atomic-scale defects that influence numerous electrical, optical, and reactivity properties. We have discovered through self-diffusion measurements and first-principles computations that poison-free oxide surfaces inject interstitial oxygen atoms into the crystalline solid when simply contacted with liquid water near room temperature. These interstitials diffuse quickly to depths of 20 nm-2 μm and are likely to eliminate prominent classes of unwanted defects or neutralize their action. The mild conditions of operation access a regime for oxide fabrication that relaxes important thermodynamic constraints that hamper defect regulation by conventional methods at higher temperatures. The surface-based approach appears well-suited for use with nanoparticles, porous oxides, and thin films for applications in advanced electronics, renewable energy storage, photocatalysis, and photoelectrochemistry.
- 11 January 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 126 (3) , 1376-1388
Electric Field Manipulation for Improved Rates of Photocatalysis by Mesoporous TiO2
- 11 January 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 126 (3) , 1376-1388
Electric Field Manipulation for Improved Rates of Photocatalysis by Mesoporous TiO2