Alexei Alexandrovich Lazutin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Alexei Alexandrovich Lazutin has a total of 48 co-authors. Here are the top co-authors by number of shared publications:
- Valentina V. Vasilevskaya
A. N. Nesmeyanov Institute of Organoelement Compounds Russian Academy of Sciences (INEOS RAS) 1 , Vavilov Str. 28, Bld. 1, 119334 Moscow
21 shared publications A. R. Khokhlov
A. N. Nesmeyanov Institute of Organoelement Compounds RAS, Vavilova ul., 28, Moscow 119991, Russia.and Faculty of Physics, M. V. Lomonosov Moscow State University, Leninskie gory, Moscow 119991, Russia
4 shared publicationsAlexei R. Khokhlov
3 shared publications- Alexander Victorovich Chertovich
Semenov Federal Research Center for Chemical Physics, Kosygina 4, 119991 Moscow, Russia
2 shared publications - Alexandra Ushakova
Department of Physical Chemistry, Kazan Federal University, Kremlevskaya str. 18, 420008 Kazan, Russia
2 shared publications - Anatoly V. Berezkin
Max-Planck Institut für Eisenforschung GmbH, Max-Planck str. 1, 40237 Düsseldorf, Germany
2 shared publications
Latest Publications
- Open Access
- 14 October 2025
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 7 (20) , 13455-13470
From Computer Simulation to Synthesis of Highly Lithium-Ion Conductive Block Copolymers with Bicontinuous Morphology
- 14 October 2025
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 7 (20) , 13455-13470
Open AccessFrom Computer Simulation to Synthesis of Highly Lithium-Ion Conductive Block Copolymers with Bicontinuous Morphology
- 30 November 2024
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 57 (23) , 11276-11288
Atomistic Simulation of Amorphous Poly(Lactic Acid) Blends: Stereodependent Miscibility and Properties
- 30 November 2024
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 57 (23) , 11276-11288
Atomistic Simulation of Amorphous Poly(Lactic Acid) Blends: Stereodependent Miscibility and Properties
- 10 October 2024
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 20 (42) , 8385-8394
Self-assembly of amphiphilic homopolymers grafted onto spherical nanoparticles: complete embedded minimal surfaces and a machine learning algorithm for their recognition
By means of computer modelling, the self-assembly of amphiphilic A-graft-B macromolecules, grafted onto a spherical nanoparticle, is studied. In a solvent, that is poor for side pendants, the macromolecules self-assemble into thin membrane-like ABBA bilayers deviated from spherical nanoparticles. The bilayers form morphological structures that depend on the grafting density and macromolecular polymerization degree and can be referred to as the classical family of complete embedded minimal surfaces. The plane disk, catenoid, helicoid, Costa and Enneper surfaces as well as “double” helicoid and “complex minimal surface” were identified, and the fields of their stability were defined. The surfaces can be grouped according to the sequences of conformal transformations that transform them into each other. These surfaces arise in different experiments situationally. Results are summarized in a pie diagram constructed using a machine learning algorithm based on matching grafting points with a specially created planar graphic image.
- 10 October 2024
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 20 (42) , 8385-8394
Self-assembly of amphiphilic homopolymers grafted onto spherical nanoparticles: complete embedded minimal surfaces and a machine learning algorithm for their recognition
By means of computer modelling, the self-assembly of amphiphilic A-graft-B macromolecules, grafted onto a spherical nanoparticle, is studied. In a solvent, that is poor for side pendants, the macromolecules self-assemble into thin membrane-like ABBA bilayers deviated from spherical nanoparticles. The bilayers form morphological structures that depend on the grafting density and macromolecular polymerization degree and can be referred to as the classical family of complete embedded minimal surfaces. The plane disk, catenoid, helicoid, Costa and Enneper surfaces as well as “double” helicoid and “complex minimal surface” were identified, and the fields of their stability were defined. The surfaces can be grouped according to the sequences of conformal transformations that transform them into each other. These surfaces arise in different experiments situationally. Results are summarized in a pie diagram constructed using a machine learning algorithm based on matching grafting points with a specially created planar graphic image.
- 12 February 2023
- Published by Taylor & Francis in Polymer Reviews
- Vol. 64 (1) , 80-118
Revealing Structural and Physical Properties of Polylactide: What Simulation Can Do beyond the Experimental Methods
Bio-based semicrystalline polylactide (PLA) has a growing value as a substitute for fossil-based polyesters in technical applications and as a biocompatible material in medicine. The complexity of the behavior of PLA, determined by the presence of different stereoisomers, the role of electrostatic interactions, and its slow crystallization rate, makes computer simulations an important tool to discover new approaches to control the properties of PLA-based materials. The goal of this review is to summarize the efforts to simulate PLA materials with different levels of detail, including the quantum mechanical approach, all-atom modeling, and coarse-grained particle models. We focus on the validation of the models and the ways to cross-check the results with other simulation and experimental data. Special attention is devoted to the simulations of PLA in the presence of water, which provide insights into molecular mechanisms of hydrolytic degradation of PLA, especially at the initial stage, when the structural changes can not yet be detected by experimental methods. Ultimately, the selection of the appropriate simulation methods can facilitate material design, by combining the throughput and level of detail necessary for the job.
- 12 February 2023
- Published by Taylor & Francis in Polymer Reviews
- Vol. 64 (1) , 80-118
Revealing Structural and Physical Properties of Polylactide: What Simulation Can Do beyond the Experimental Methods
Bio-based semicrystalline polylactide (PLA) has a growing value as a substitute for fossil-based polyesters in technical applications and as a biocompatible material in medicine. The complexity of the behavior of PLA, determined by the presence of different stereoisomers, the role of electrostatic interactions, and its slow crystallization rate, makes computer simulations an important tool to discover new approaches to control the properties of PLA-based materials. The goal of this review is to summarize the efforts to simulate PLA materials with different levels of detail, including the quantum mechanical approach, all-atom modeling, and coarse-grained particle models. We focus on the validation of the models and the ways to cross-check the results with other simulation and experimental data. Special attention is devoted to the simulations of PLA in the presence of water, which provide insights into molecular mechanisms of hydrolytic degradation of PLA, especially at the initial stage, when the structural changes can not yet be detected by experimental methods. Ultimately, the selection of the appropriate simulation methods can facilitate material design, by combining the throughput and level of detail necessary for the job.
- Open Access
Hedgehog, Chamomile, and Multipetal Polymeric Structures on the Nanoparticle Surface: Computer Modelling
A single spherical nanoparticle coated with a densely grafted layer of an amphiphilic homopolymer with identical A-graft-B monomer units was studied by means of coarse-grained molecular dynamics. In solvent, selectively poor for mainchain and good for pendant groups; the grafted macromolecules self-assemble into different structures to form a complex pattern on the nanoparticle surface. We distinguish hedgehog, multipetalar, chamomile, and densely structured shells and outline the area of their stability using visual analysis and calculate aggregation numbers and specially introduced order parameters, including the branching coefficient and relative orientation of monomer units. For the first time, the branching effect of splitting aggregates along with the distance to the grafting surface and preferred orientation of the monomer units with rearrangements of the dense compacted shell was described. The results explain the experimental data, are consistent with the analytical theory, and are the basis for the design of stimulus-sensitive matrix-free composite materials.
Open AccessHedgehog, Chamomile, and Multipetal Polymeric Structures on the Nanoparticle Surface: Computer Modelling
A single spherical nanoparticle coated with a densely grafted layer of an amphiphilic homopolymer with identical A-graft-B monomer units was studied by means of coarse-grained molecular dynamics. In solvent, selectively poor for mainchain and good for pendant groups; the grafted macromolecules self-assemble into different structures to form a complex pattern on the nanoparticle surface. We distinguish hedgehog, multipetalar, chamomile, and densely structured shells and outline the area of their stability using visual analysis and calculate aggregation numbers and specially introduced order parameters, including the branching coefficient and relative orientation of monomer units. For the first time, the branching effect of splitting aggregates along with the distance to the grafting surface and preferred orientation of the monomer units with rearrangements of the dense compacted shell was described. The results explain the experimental data, are consistent with the analytical theory, and are the basis for the design of stimulus-sensitive matrix-free composite materials.
- 28 June 2021
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 54 (13) , 6285-6295
Flowerlike Multipetal Structures of Nanoparticles Decorated by Amphiphilic Homopolymers
- 28 June 2021
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 54 (13) , 6285-6295
Flowerlike Multipetal Structures of Nanoparticles Decorated by Amphiphilic Homopolymers
- Open Access
- 19 June 2020
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 152 (23) , 234903
Self-assembly in amphiphilic spherical brushes
The structure of amphiphilic spherical brushes, consisting of the nano-SiO2 core, the hyperbranched polyamidoamine subshell, and a grafted layer of long hydrophobically modified polyacrylamide (HMPAM) chains, in aqueous solution was analyzed and described in the framework of the original mean-field approach. The scaling estimations of the hydrodynamic radius of such polymer brushes as a function of the number of grafted macromolecules allow concluding that the HMPAM shells are in a globular state and that the region of the stretched chains adjacent to the grafting surface is a minor part of the grafted macromolecules and does not have a significant impact on the self-assembly of the HMPAM shell caused by the complex hydrophobic–hydrophilic composition of their monomer units. In mean-field theory, the amphiphilic nature of HMPAM was taken into account by attaching the hydrophobic side group H to some fraction of monomer units of the hydrophilic P backbone. The strong attraction of H groups causes the aggregation of macromolecules, whereas the affinity of hydrophilic P groups to solvent forces the aggregates to increase their surface. Due to such effective surface activity, in poor solvent, the grafted amphiphilic macromolecules could form a spherical compacted structure around the nanoparticle or self-assemble into a “hedgehog” structure with several “spines” having hydrophobic core and hydrophilic shell. State diagrams, obtained theoretically, reveal that the “hedgehog” structure is preferable for a wide range of energetic parameters.
- 19 June 2020
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 152 (23) , 234903
Open AccessSelf-assembly in amphiphilic spherical brushes
The structure of amphiphilic spherical brushes, consisting of the nano-SiO2 core, the hyperbranched polyamidoamine subshell, and a grafted layer of long hydrophobically modified polyacrylamide (HMPAM) chains, in aqueous solution was analyzed and described in the framework of the original mean-field approach. The scaling estimations of the hydrodynamic radius of such polymer brushes as a function of the number of grafted macromolecules allow concluding that the HMPAM shells are in a globular state and that the region of the stretched chains adjacent to the grafting surface is a minor part of the grafted macromolecules and does not have a significant impact on the self-assembly of the HMPAM shell caused by the complex hydrophobic–hydrophilic composition of their monomer units. In mean-field theory, the amphiphilic nature of HMPAM was taken into account by attaching the hydrophobic side group H to some fraction of monomer units of the hydrophilic P backbone. The strong attraction of H groups causes the aggregation of macromolecules, whereas the affinity of hydrophilic P groups to solvent forces the aggregates to increase their surface. Due to such effective surface activity, in poor solvent, the grafted amphiphilic macromolecules could form a spherical compacted structure around the nanoparticle or self-assemble into a “hedgehog” structure with several “spines” having hydrophobic core and hydrophilic shell. State diagrams, obtained theoretically, reveal that the “hedgehog” structure is preferable for a wide range of energetic parameters.