Bruno César da Silva
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Bruno César da Silva has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
Fernando Iikawa
Institute of Physics “Gleb Wataghin”, University of Campinas, 13083-859Campinas, São Paulo, Brazil
4 shared publications- Monica Alonso Cotta
Universidade Estadual de Campinas
4 shared publications - Martien Ilse Den Hertog
Univ. Grenoble-Alpes, CNRS, Grenoble INP, Institut Néel , 43 av. des Martyrs
3 shared publications - Odilon Divino Damasceno Couto
Universidade Estadual de Campinas, Instituto de Física Gleb Wataghin, 13083-859 Campinas, Brazil
3 shared publications Caio E. de Oliveira
São Carlos Institute of Physics, University of São Paulo, 369, São Carlos, SP, 13566-590, Brazil
2 shared publications- David Cooper
LETI, University Grenoble Alpes, CEA 1 , F-38000 Grenoble
2 shared publications
Latest Publications
- 18 July 2023
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 6 (14) , 12784-12791
High-Aspect-Ratio GaN p–i–n Nanowires for Linear UV Photodetectors
- 18 July 2023
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 6 (14) , 12784-12791
High-Aspect-Ratio GaN p–i–n Nanowires for Linear UV Photodetectors
- Open Access
- 28 November 2022
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 22 (23) , 9544-9550
Assessment of Active Dopants and p–n Junction Abruptness Using In Situ Biased 4D-STEM
A key issue in the development of high-performance semiconductor devices is the ability to properly measure active dopants at the nanometer scale. In a p-n junction, the abruptness of the dopant profile around the metallurgical junction directly influences the electric field. Here, a contacted nominally symmetric and highly doped (NA = ND = 9 × 1018 cm-3) silicon p-n specimen is studied through in situ biased four-dimensional scanning transmission electron microscopy (4D-STEM). Measurements of electric field, built-in voltage, depletion region width, and charge density are combined with analytical equations and finite-element simulations in order to evaluate the quality of the junction interface. It is shown that all the junction parameters measured are compatible with a linearly graded junction. This hypothesis is also consistent with the evolution of the electric field with bias as well as off-axis electron holography data. These results demonstrate that in situ biased 4D-STEM can allow a better understanding of the electrostatics of semiconductor p-n junctions with nm-scale resolution.
- 28 November 2022
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 22 (23) , 9544-9550
Open AccessAssessment of Active Dopants and p–n Junction Abruptness Using In Situ Biased 4D-STEM
A key issue in the development of high-performance semiconductor devices is the ability to properly measure active dopants at the nanometer scale. In a p-n junction, the abruptness of the dopant profile around the metallurgical junction directly influences the electric field. Here, a contacted nominally symmetric and highly doped (NA = ND = 9 × 1018 cm-3) silicon p-n specimen is studied through in situ biased four-dimensional scanning transmission electron microscopy (4D-STEM). Measurements of electric field, built-in voltage, depletion region width, and charge density are combined with analytical equations and finite-element simulations in order to evaluate the quality of the junction interface. It is shown that all the junction parameters measured are compatible with a linearly graded junction. This hypothesis is also consistent with the evolution of the electric field with bias as well as off-axis electron holography data. These results demonstrate that in situ biased 4D-STEM can allow a better understanding of the electrostatics of semiconductor p-n junctions with nm-scale resolution.
- Open Access
- 23 November 2022
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 7 (48) , 44199-44206
Wurtzite Gallium Phosphide via Chemical Beam Epitaxy: Impurity-Related Luminescence vs Growth Conditions
The metastable wurtzite crystal phase in gallium phosphide (WZ GaP) is a relatively new structure with little available information about its emission properties compared to the most stable zinc-blend phase. Here, the effect of growth conditions of WZ GaP nano- and microstructures obtained via chemical beam epitaxy on the optical properties was studied using power- and temperature-dependent photoluminescence (PL). We showed that the PL spectra are dominated by two strong broad emission bands at 1.68 and 1.88 eV and two relatively narrow peaks at 2.04 and 2.09 eV. The broad emissions are associated with the presence of carbon and a small number of extended crystal defects, respectively. For the sharp emissions, two main radiative recombination channels were observed with ionization energies estimated in the range of 50-80 meV and lower than 10 meV. No variation of the low-temperature PL spectra was observed for samples grown at different P precursor flows, while increasing Ga content enhanced the dominant broad emission at around 1.68 eV, suggesting that the group III organometallic precursor is the main source of impurities. Finally, Be-doped samples were grown, and their characteristic optical emission at 2.03 eV was identified. These results contribute to the understanding of impurity-related luminescence in hexagonal GaP, being useful for further crystal growth optimization required for the fabrication of optoelectronic devices.
- 23 November 2022
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 7 (48) , 44199-44206
Open AccessWurtzite Gallium Phosphide via Chemical Beam Epitaxy: Impurity-Related Luminescence vs Growth Conditions
The metastable wurtzite crystal phase in gallium phosphide (WZ GaP) is a relatively new structure with little available information about its emission properties compared to the most stable zinc-blend phase. Here, the effect of growth conditions of WZ GaP nano- and microstructures obtained via chemical beam epitaxy on the optical properties was studied using power- and temperature-dependent photoluminescence (PL). We showed that the PL spectra are dominated by two strong broad emission bands at 1.68 and 1.88 eV and two relatively narrow peaks at 2.04 and 2.09 eV. The broad emissions are associated with the presence of carbon and a small number of extended crystal defects, respectively. For the sharp emissions, two main radiative recombination channels were observed with ionization energies estimated in the range of 50-80 meV and lower than 10 meV. No variation of the low-temperature PL spectra was observed for samples grown at different P precursor flows, while increasing Ga content enhanced the dominant broad emission at around 1.68 eV, suggesting that the group III organometallic precursor is the main source of impurities. Finally, Be-doped samples were grown, and their characteristic optical emission at 2.03 eV was identified. These results contribute to the understanding of impurity-related luminescence in hexagonal GaP, being useful for further crystal growth optimization required for the fabrication of optoelectronic devices.
- 19 September 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 121 (12) , 123503
The influence of illumination conditions in the measurement of built-in electric field at p–n junctions by 4D-STEM
Momentum resolved 4D-STEM, also called center of mass (CoM) analysis, has been used to measure the long range built-in electric field of a silicon p–n junction. The effect of different STEM modes and the trade-off between spatial resolution and electric field sensitivity are studied. Two acquisition modes are compared: nanobeam and low magnification (LM) modes. A thermal noise free Medipix3 direct electron detector with high speed acquisition has been used to study the influence of low electron beam current and millisecond dwell times on the measured electric field and standard deviation. It is shown that LM conditions can underestimate the electric field values due to a bigger probe size used but provide an improvement of almost one order of magnitude on the signal-to-noise ratio, leading to a detection limit of It is observed that the CoM results do not vary with acquisition time or electron dose as low as 24 e−/A2, showing that the electron beam does not influence the built-in electric field and that this method can be robust for studying beam sensitive materials, where a low dose is needed.- 19 September 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 121 (12) , 123503
The influence of illumination conditions in the measurement of built-in electric field at p–n junctions by 4D-STEM
Momentum resolved 4D-STEM, also called center of mass (CoM) analysis, has been used to measure the long range built-in electric field of a silicon p–n junction. The effect of different STEM modes and the trade-off between spatial resolution and electric field sensitivity are studied. Two acquisition modes are compared: nanobeam and low magnification (LM) modes. A thermal noise free Medipix3 direct electron detector with high speed acquisition has been used to study the influence of low electron beam current and millisecond dwell times on the measured electric field and standard deviation. It is shown that LM conditions can underestimate the electric field values due to a bigger probe size used but provide an improvement of almost one order of magnitude on the signal-to-noise ratio, leading to a detection limit of It is observed that the CoM results do not vary with acquisition time or electron dose as low as 24 e−/A2, showing that the electron beam does not influence the built-in electric field and that this method can be robust for studying beam sensitive materials, where a low dose is needed.- Open Access
- 9 July 2020
- Published by Springer Nature in Scientific Reports
- Vol. 10 (1) , 1
Author Correction: Optical Absorption Exhibits Pseudo-Direct Band Gap of Wurtzite Gallium Phosphide
An amendment to this paper has been published and can be accessed via a link at the top of the paper.
- 9 July 2020
- Published by Springer Nature in Scientific Reports
- Vol. 10 (1) , 1
Open AccessAuthor Correction: Optical Absorption Exhibits Pseudo-Direct Band Gap of Wurtzite Gallium Phosphide
An amendment to this paper has been published and can be accessed via a link at the top of the paper.
- Open Access
- 13 May 2020
- Published by Springer Nature in Scientific Reports
- Vol. 10 (1) , 1-7
Optical Absorption Exhibits Pseudo-Direct Band Gap of Wurtzite Gallium Phosphide
Definitive evidence for the direct band gap predicted for Wurtzite Gallium Phosphide (WZ GaP) nanowires has remained elusive due to the lack of strong band-to-band luminescence in these materials. In order to circumvent this problem, we successfully obtained large volume WZ GaP structures grown by nanoparticle-crawling assisted Vapor-Liquid-Solid method. With these structures, we were able to observe bound exciton recombination at 2.14 eV with FHWM of approximately 1 meV. In addition, we have measured the optical absorption edges using photoluminescence excitation spectroscopy. Our results show a 10 K band gap at 2.19 eV and indicate a weak oscillator strength for the lowest energy band-to-band absorption edge, which is a characteristic feature of a pseudo-direct band gap semiconductor. Furthermore, the valence band splitting energies are estimated as 110 meV and 30 meV for the three highest bands. Electronic band structure calculations using the HSE06 hybrid density functional agree qualitatively with the valence band splitting energies.
- 13 May 2020
- Published by Springer Nature in Scientific Reports
- Vol. 10 (1) , 1-7
Open AccessOptical Absorption Exhibits Pseudo-Direct Band Gap of Wurtzite Gallium Phosphide
Definitive evidence for the direct band gap predicted for Wurtzite Gallium Phosphide (WZ GaP) nanowires has remained elusive due to the lack of strong band-to-band luminescence in these materials. In order to circumvent this problem, we successfully obtained large volume WZ GaP structures grown by nanoparticle-crawling assisted Vapor-Liquid-Solid method. With these structures, we were able to observe bound exciton recombination at 2.14 eV with FHWM of approximately 1 meV. In addition, we have measured the optical absorption edges using photoluminescence excitation spectroscopy. Our results show a 10 K band gap at 2.19 eV and indicate a weak oscillator strength for the lowest energy band-to-band absorption edge, which is a characteristic feature of a pseudo-direct band gap semiconductor. Furthermore, the valence band splitting energies are estimated as 110 meV and 30 meV for the three highest bands. Electronic band structure calculations using the HSE06 hybrid density functional agree qualitatively with the valence band splitting energies.
- 10 November 2017
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 17 (12) , 7274-7282
Exploring Au Droplet Motion in Nanowire Growth: A Simple Route toward Asymmetric GaP Morphologies
Here we show a new nanowire growth procedure, exploring the thermally activated motion of Au droplets on III–V surfaces. We show that by setting a single growth parameter we can activate the crawling motion of Au droplets in vacuum and locally modify surface composition in order to enhance vapor–solid (VS) growth along oxide-free areas on the trail of the metal particle. Asymmetric VS growth rates are comparable in magnitude to the vapor–liquid–solid growth, producing unconventional wurtzite GaP morphologies, which shows negligible defect density as well as optical signal in the green spectral region. Finally, we demonstrate that this effect can also be explored in different substrate compositions and orientations with the final shape finely tuned by group III flow and nanoparticle size. This distinct morphology for wurtzite GaP nanomaterials can be interesting for the design of nanophotonics devices.
- 10 November 2017
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 17 (12) , 7274-7282
Exploring Au Droplet Motion in Nanowire Growth: A Simple Route toward Asymmetric GaP Morphologies
Here we show a new nanowire growth procedure, exploring the thermally activated motion of Au droplets on III–V surfaces. We show that by setting a single growth parameter we can activate the crawling motion of Au droplets in vacuum and locally modify surface composition in order to enhance vapor–solid (VS) growth along oxide-free areas on the trail of the metal particle. Asymmetric VS growth rates are comparable in magnitude to the vapor–liquid–solid growth, producing unconventional wurtzite GaP morphologies, which shows negligible defect density as well as optical signal in the green spectral region. Finally, we demonstrate that this effect can also be explored in different substrate compositions and orientations with the final shape finely tuned by group III flow and nanoparticle size. This distinct morphology for wurtzite GaP nanomaterials can be interesting for the design of nanophotonics devices.