Yoshiki Yamamoto
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yoshiki Yamamoto has a total of 52 co-authors. Here are the top co-authors by number of shared publications:
Akira Toriumi
4 shared publicationsHideki Makiyama
Renesas Electronics Corporation, Hitachinaka-shi, Ibaraki 312-8504 Japan
3 shared publicationsKentaro Kyuno
3 shared publications- Koji Kita
The University of Tokyo
3 shared publications - Tomohiro Yamashita
Renesas Electronics Corporation, Hitachinaka-shi, Ibaraki 312-8504 Japan
3 shared publications H. Makiyama
Low-power Electronics Association & Project (LEAP), West7, 16-1 Onogawa, Tsukuba, Ibaraki, 305-8569, JAPAN
2 shared publications
Latest Publications
- Open Access
- 24 May 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of the Electron Devices Society
- Vol. 7 (1) , 825-828
The Study of Plasma Induced Damage on 65-nm Silicon on Thin BOX Transistor
This paper reports new findings about the plasma induced damage on silicon on thin BOX transistor. The plasma charge collected by source or drain causes Vth shift, which depends on BOX thickness. In addition, the observation was made that the plasma charge collected by an antenna which is connected to the gate electrode has the same degradation effect as an antenna with the same size but being connected to drain or source. The mechanism of this phenomenon is investigated with various test structures.
- 24 May 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of the Electron Devices Society
- Vol. 7 (1) , 825-828
Open AccessThe Study of Plasma Induced Damage on 65-nm Silicon on Thin BOX Transistor
This paper reports new findings about the plasma induced damage on silicon on thin BOX transistor. The plasma charge collected by source or drain causes Vth shift, which depends on BOX thickness. In addition, the observation was made that the plasma charge collected by an antenna which is connected to the gate electrode has the same degradation effect as an antenna with the same size but being connected to drain or source. The mechanism of this phenomenon is investigated with various test structures.
- 1 December 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-7
Three-Phase Unbalance Compensator Using Neutral Point Clamped Multilevel Interleaved Inverter
This paper proposes a three-phase unbalance compensation system using interleaved NPC inverter and a fast current regulation method. The proposed compensator can reduce in volume of passive filters and voltage and current stress on power devices by using NPC and interleaved circuit structure. The proposed current regulation method decouples interference between reactive and unbalance current compensation on d-q rotating frame. Experimental results of the unbalance compensation clarify the proposed system having a capability of a good compensation performance in steady states and a fast current response in transient states. The proposed system is applicable for wide load range and improving power quality of the grid.
- 1 December 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-7
Three-Phase Unbalance Compensator Using Neutral Point Clamped Multilevel Interleaved Inverter
This paper proposes a three-phase unbalance compensation system using interleaved NPC inverter and a fast current regulation method. The proposed compensator can reduce in volume of passive filters and voltage and current stress on power devices by using NPC and interleaved circuit structure. The proposed current regulation method decouples interference between reactive and unbalance current compensation on d-q rotating frame. Experimental results of the unbalance compensation clarify the proposed system having a capability of a good compensation performance in steady states and a fast current response in transient states. The proposed system is applicable for wide load range and improving power quality of the grid.
- 1 June 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 07431562,p. T170-T171
Novel single p+poly-Si/Hf/SiON gate stack technology on silicon-on-thin-buried-oxide (SOTB) for ultra-low leakage applications
We demonstrate a cost effective 65-nm SOTB CMOS technology for ultra-low leakage applications. Novel single p+poly-Si/Hf/SiON gate stack of mid-gap work function and precise GIDL control achieved ultra-low leakage of 0.2 pA/μm, which corresponds to approx. 100nA/chip (100k gate logic). Now the SOTB technology can provide three options from ultra-low voltage to ultra-low leakage that covers a wide variety of applications in the Internet of Things (IoT) era.
- 1 June 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 07431562,p. T170-T171
Novel single p+poly-Si/Hf/SiON gate stack technology on silicon-on-thin-buried-oxide (SOTB) for ultra-low leakage applications
We demonstrate a cost effective 65-nm SOTB CMOS technology for ultra-low leakage applications. Novel single p+poly-Si/Hf/SiON gate stack of mid-gap work function and precise GIDL control achieved ultra-low leakage of 0.2 pA/μm, which corresponds to approx. 100nA/chip (100k gate logic). Now the SOTB technology can provide three options from ultra-low voltage to ultra-low leakage that covers a wide variety of applications in the Internet of Things (IoT) era.
- 27 March 2015
- Published by The Electrochemical Society in ECS Transactions
- Vol. 66 (5) , 43-48
(Invited) Ultralow-Voltage Design and Technology of Silicon-on Thin-Buried-Oxide (SOTB) CMOS for High Energy Efficient Electronics in IoT Era
We demonstrated ultralow voltage (<0.4V) operation of Silicon-on-Thin-Buried-oxide (SOTB) CMOS. Thanks to the small variability of SOTB Vmin of SRAM was lowered down to <0.4 V. Both fast access time and small standby leakage were achieved by adaptive back biasing (ABB). 32-bit RISC CPU operated at ultralow energy consumption of 13.4 pJ.
- 27 March 2015
- Published by The Electrochemical Society in ECS Transactions
- Vol. 66 (5) , 43-48
(Invited) Ultralow-Voltage Design and Technology of Silicon-on Thin-Buried-Oxide (SOTB) CMOS for High Energy Efficient Electronics in IoT Era
We demonstrated ultralow voltage (<0.4V) operation of Silicon-on-Thin-Buried-oxide (SOTB) CMOS. Thanks to the small variability of SOTB Vmin of SRAM was lowered down to <0.4 V. Both fast access time and small standby leakage were achieved by adaptive back biasing (ABB). 32-bit RISC CPU operated at ultralow energy consumption of 13.4 pJ.
- 1 June 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Statistical analysis of minimum operation voltage (Vmin) in fully depleted silicon-on-thin-BOX (SOTB) SRAM cells
The minimum operation voltage (V min ) of fully depleted (FD) silicon-on-thin-BOX (SOTB) SRAM cells are measured and statistically analyzed. It is newly found that V min deviates from a normal distribution and follows a log-normal distribution. Furthermore, it is found that the behaviors of the worst V min are different from the median V min or static noise margin (SNM), indicating that cell stability of high density SRAM must be judged by the worst V min .
- 1 June 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Statistical analysis of minimum operation voltage (Vmin) in fully depleted silicon-on-thin-BOX (SOTB) SRAM cells
The minimum operation voltage (V min ) of fully depleted (FD) silicon-on-thin-BOX (SOTB) SRAM cells are measured and statistically analyzed. It is newly found that V min deviates from a normal distribution and follows a log-normal distribution. Furthermore, it is found that the behaviors of the worst V min are different from the median V min or static noise margin (SNM), indicating that cell stability of high density SRAM must be judged by the worst V min .
- 1 June 2012
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 07431562,p. 109-110
Poly/high-k/SiON gate stack and novel profile engineering dedicated for ultralow-voltage silicon-on-thin-BOX (SOTB) CMOS operation
We demonstrated Silicon on Thin Buried oxide (SOTB) CMOS especially designed for ultralow-voltage (ULV) operation down to 0.4 V for the first time. Utilizing i) dual-poly gate stack with high-k having quarter-gap work functions best for the ULV CMOS operation, and ii) a novel “local ground plane (LGP)” structure that significantly improves short-channel effect (V th roll off) without increasing local variability unlike halo for bulk, low-leakage SRAM operation was demonstrated with adaptive-body-bias (ABB) scheme.
- 1 June 2012
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 07431562,p. 109-110
Poly/high-k/SiON gate stack and novel profile engineering dedicated for ultralow-voltage silicon-on-thin-BOX (SOTB) CMOS operation
We demonstrated Silicon on Thin Buried oxide (SOTB) CMOS especially designed for ultralow-voltage (ULV) operation down to 0.4 V for the first time. Utilizing i) dual-poly gate stack with high-k having quarter-gap work functions best for the ULV CMOS operation, and ii) a novel “local ground plane (LGP)” structure that significantly improves short-channel effect (V th roll off) without increasing local variability unlike halo for bulk, low-leakage SRAM operation was demonstrated with adaptive-body-bias (ABB) scheme.
- 1 April 2010
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 49 (4S) , 04DB11
Low-Temperature Silicon Oxide Offset Spacer Using Plasma-Enhanced Atomic Layer Deposition for High-k/Metal Gate Transistor
We have investigated the characteristics of silicon oxide films deposited by plasma-enhanced atomic layer deposition (PEALD) and plasma-enhanced chemical vapor deposition (PECVD) as offset spacer films of high-k/metal gate stacks. From the results of bonding structure analysis, the silicon oxide film deposited by PEALD has been found to be composed of a Si–O bond network of the stoichiometric silicon oxide film. On the other hand, the silicon oxide film deposited by PECVD is considered to contain suboxide bond structures. From the results of physical and mechanical evaluations, the silicon oxide film deposited by PEALD exhibits a lower wet etch rate, a higher film density, a lower dielectric constant, a smaller amount of water in the film, and a higher elastic modulus than that deposited by PECVD. PEALD showed excellent thickness controllability. From these results, the silicon oxide film deposited by PEALD has higher quality and is more suitable for use as an offset spacer than that deposited by PECVD. X-ray photoelectron spectroscopy showed that the surface oxidation of a titanium nitride film, which is used as a metal gate electrode, during PEALD can be suppressed by using a lower PEALD temperature. Finally, we have demonstrated that the drain current of a high-k/metal gate transistor with a silicon oxide offset spacer deposited by PEALD is markedly increased, compared with that with a high-temperature-deposited silicon oxide offset spacer.
- 1 April 2010
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 49 (4S) , 04DB11
Low-Temperature Silicon Oxide Offset Spacer Using Plasma-Enhanced Atomic Layer Deposition for High-k/Metal Gate Transistor
We have investigated the characteristics of silicon oxide films deposited by plasma-enhanced atomic layer deposition (PEALD) and plasma-enhanced chemical vapor deposition (PECVD) as offset spacer films of high-k/metal gate stacks. From the results of bonding structure analysis, the silicon oxide film deposited by PEALD has been found to be composed of a Si–O bond network of the stoichiometric silicon oxide film. On the other hand, the silicon oxide film deposited by PECVD is considered to contain suboxide bond structures. From the results of physical and mechanical evaluations, the silicon oxide film deposited by PEALD exhibits a lower wet etch rate, a higher film density, a lower dielectric constant, a smaller amount of water in the film, and a higher elastic modulus than that deposited by PECVD. PEALD showed excellent thickness controllability. From these results, the silicon oxide film deposited by PEALD has higher quality and is more suitable for use as an offset spacer than that deposited by PECVD. X-ray photoelectron spectroscopy showed that the surface oxidation of a titanium nitride film, which is used as a metal gate electrode, during PEALD can be suppressed by using a lower PEALD temperature. Finally, we have demonstrated that the drain current of a high-k/metal gate transistor with a silicon oxide offset spacer deposited by PEALD is markedly increased, compared with that with a high-temperature-deposited silicon oxide offset spacer.
- Open Access
- 1 January 2008
- Published by Japan Society of Mechanical Engineers in The Proceedings of Ibaraki District Conference
- Vol. 2008, 137-138
603 Crack initiation in bending deformation in a Corson series copper alloy related to its microstructure
- 1 January 2008
- Published by Japan Society of Mechanical Engineers in The Proceedings of Ibaraki District Conference
- Vol. 2008, 137-138
Open Access603 Crack initiation in bending deformation in a Corson series copper alloy related to its microstructure
- 1 November 2007
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 46 (11R) , 7251
Study of La-Induced Flat Band Voltage Shift in Metal/HfLaOx/SiO2/Si Capacitors
- 1 November 2007
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 46 (11R) , 7251
Study of La-Induced Flat Band Voltage Shift in Metal/HfLaOx/SiO2/Si Capacitors
- 18 September 2007
- Published by Japan Society of Applied Physics
A New Hf-based Dielectric Member, HfLaOx, for Amorphous High-k Gate Insulators in Advanced CMOS
2005 International Conference on Solid State Devices and Materials,Search for presentations
- 18 September 2007
- Published by Japan Society of Applied Physics
A New Hf-based Dielectric Member, HfLaOx, for Amorphous High-k Gate Insulators in Advanced CMOS
2005 International Conference on Solid State Devices and Materials,Search for presentations