Amritanshu Shriwastav
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Amritanshu Shriwastav has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
Ansaf V. Karim
11 shared publicationsSukanya Krishnan
Environmental Science and Engineering Department, Indian Institute of Technology Bombay, Mumbai, India
8 shared publicationsS. Sethulekshmi
Environmental Science and Engineering Department, Indian Institute of Technology Bombay, Mumbai 400 076, India
6 shared publicationsSwatantra Pratap Singh
4 shared publicationsPurnendu Bose
Environmental Engineering and Management Program, Department of Civil Engineering, Indian Institute of Technology Kanpur, Kanpur 208 016, India
3 shared publicationsJeenu Thomas
Environmental Engineering and Management Program, Department of Civil Engineering, Indian Institute of Technology Kanpur, Kanpur 208 016, India
2 shared publications
Latest Publications
- 29 August 2026
- Published by American Chemical Society (ACS) in ACS ES&T Engineering
- Vol. 6 (10) , 2824-2835
Electrochemical Degradation of PFOA Using Graphite-Sheet Electrodes: Kinetics and Mechanisms
Per- and polyfluoroalkyl substances (PFAS) are persistent, bioaccumulative, and toxic contaminants characterized by highly stable fluorinated alkyl chains. Due to their chemical resilience, PFAS are frequently detected in both influents and effluents of conventional wastewater treatment plants, where they undergo minimal to no removal. Electrooxidation offers a promising, chemical-free approach for PFAS remediation, but it typically relies on expensive, high-performance electrodes such as boron-doped diamond (BDD) or titanium-based materials, limiting scalability and practical deployment. This study establishes the use of low-cost, unmodified, flexible graphite sheet electrodes as anodes for the electrochemical degradation of perfluorooctanoic acid (PFOA). The degradation efficiency was assessed under varying conditions, including initial PFOA concentrations (5–1,000 μg·L–1), current densities (2.5–12.5 mA.cm–2), pH (3–9), electrolyte concentrations (0–0.05 M NaCl), and the presence of reactive radical species. Under optimized conditions (0.05 M NaCl, 10 mA.cm–2, pH ≈ 6), ∼99% PFOA degradation was achieved within 90 min at an initial concentration of 10 μg·L–1, with a corresponding energy consumption of 16.09 kWh.m–3 per order. Hydroxyl radicals and chlorine-based reactive species were identified as key contributors to the degradation mechanism. However, degradation efficiency was inhibited in the presence of a complex wastewater matrix, consistent with the known limitations of radical-mediated processes. Liquid chromatography–mass spectrometry (LC-MS) analysis of the 90 min sample revealed the formation of intermediate degradation products, including shorter-chain perfluoroalkyl carboxylic acids such as perfluoroheptanoic acid (PFHpA), perfluorohexanoic acid (PFHxA), perfluoropentanoic acid (PFPeA), and perfluorobutanoic acid (PFBA). Overall, the electrochemical oxidation approach demonstrated in this study offers a promising, economically attractive alternative for the degradation of PFAS in contaminated groundwater and wastewater.
- 29 August 2026
- Published by American Chemical Society (ACS) in ACS ES&T Engineering
- Vol. 6 (10) , 2824-2835
Electrochemical Degradation of PFOA Using Graphite-Sheet Electrodes: Kinetics and Mechanisms
Per- and polyfluoroalkyl substances (PFAS) are persistent, bioaccumulative, and toxic contaminants characterized by highly stable fluorinated alkyl chains. Due to their chemical resilience, PFAS are frequently detected in both influents and effluents of conventional wastewater treatment plants, where they undergo minimal to no removal. Electrooxidation offers a promising, chemical-free approach for PFAS remediation, but it typically relies on expensive, high-performance electrodes such as boron-doped diamond (BDD) or titanium-based materials, limiting scalability and practical deployment. This study establishes the use of low-cost, unmodified, flexible graphite sheet electrodes as anodes for the electrochemical degradation of perfluorooctanoic acid (PFOA). The degradation efficiency was assessed under varying conditions, including initial PFOA concentrations (5–1,000 μg·L–1), current densities (2.5–12.5 mA.cm–2), pH (3–9), electrolyte concentrations (0–0.05 M NaCl), and the presence of reactive radical species. Under optimized conditions (0.05 M NaCl, 10 mA.cm–2, pH ≈ 6), ∼99% PFOA degradation was achieved within 90 min at an initial concentration of 10 μg·L–1, with a corresponding energy consumption of 16.09 kWh.m–3 per order. Hydroxyl radicals and chlorine-based reactive species were identified as key contributors to the degradation mechanism. However, degradation efficiency was inhibited in the presence of a complex wastewater matrix, consistent with the known limitations of radical-mediated processes. Liquid chromatography–mass spectrometry (LC-MS) analysis of the 90 min sample revealed the formation of intermediate degradation products, including shorter-chain perfluoroalkyl carboxylic acids such as perfluoroheptanoic acid (PFHpA), perfluorohexanoic acid (PFHxA), perfluoropentanoic acid (PFPeA), and perfluorobutanoic acid (PFBA). Overall, the electrochemical oxidation approach demonstrated in this study offers a promising, economically attractive alternative for the degradation of PFAS in contaminated groundwater and wastewater.
- Open Access
- 30 April 2026
- Published by IWA Publishing in Water Science & Technology
- Vol. 93 (9) , 1296-1309
Investigations into the flocculent settling of microplastics
Figure showing a summary of experimental setup for settling experiments, effect of sludge concentration on microplastic removal efficiency, and the isoremoval plots for microplastics with depth and settling time. Sewage treatment plants (STPs) act as both significant sinks and sources of microplastics (MPs) in the environment. However, there is a lack of investigations into the flocculent settling characteristics of MPs and their removal trends in secondary clarifiers. Therefore, this study attempted to explore the flocculent settling behaviour of small-sized (15–105 μm) MPs of polymer types: nylon, polystyrene, polypropylene, and low-density polyethylene through controlled lab-scale experiments. Results showed that the MPs’ removal with flocculent settling improved from 55 to over 80% as sludge mixed liquor suspended solids (MLSS) concentration increased from 50 to ∼1,000 mg/L, highlighting the importance of MLSS in MPs’ retention. Furthermore, a lab-scale prototype of a secondary clarifier was used to study flocculent settling trends of a mixture of rising and settling polymers, and iso-removal plots for MPs’ flocculent settling were plotted, which provide an estimation of secondary clarifier removal efficiencies. It was observed that approximately 94% of MPs were effectively removed in secondary clarifiers under optimized conditions. This study provides novel insights into the flocculent settling characteristics of MPs in secondary treatment, improving our understanding of their fate in STPs and strategies to enhance MP removal efficiency.
- 30 April 2026
- Published by IWA Publishing in Water Science & Technology
- Vol. 93 (9) , 1296-1309
Open AccessInvestigations into the flocculent settling of microplastics
Figure showing a summary of experimental setup for settling experiments, effect of sludge concentration on microplastic removal efficiency, and the isoremoval plots for microplastics with depth and settling time. Sewage treatment plants (STPs) act as both significant sinks and sources of microplastics (MPs) in the environment. However, there is a lack of investigations into the flocculent settling characteristics of MPs and their removal trends in secondary clarifiers. Therefore, this study attempted to explore the flocculent settling behaviour of small-sized (15–105 μm) MPs of polymer types: nylon, polystyrene, polypropylene, and low-density polyethylene through controlled lab-scale experiments. Results showed that the MPs’ removal with flocculent settling improved from 55 to over 80% as sludge mixed liquor suspended solids (MLSS) concentration increased from 50 to ∼1,000 mg/L, highlighting the importance of MLSS in MPs’ retention. Furthermore, a lab-scale prototype of a secondary clarifier was used to study flocculent settling trends of a mixture of rising and settling polymers, and iso-removal plots for MPs’ flocculent settling were plotted, which provide an estimation of secondary clarifier removal efficiencies. It was observed that approximately 94% of MPs were effectively removed in secondary clarifiers under optimized conditions. This study provides novel insights into the flocculent settling characteristics of MPs in secondary treatment, improving our understanding of their fate in STPs and strategies to enhance MP removal efficiency.
- Open Access
- 5 December 2025
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 22 (1) , 13-43
Tire crumb in the environment: a review on occurrence, fate and recent advances in detection and analysis
This review provides a comprehensive overview of the characteristics of TWPs, their environmental occurrence, fate, and detection methodologies. The dominant methodological bottlenecks, key challenges, and possible way forwards are also discussed.
- 5 December 2025
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 22 (1) , 13-43
Open AccessTire crumb in the environment: a review on occurrence, fate and recent advances in detection and analysis
This review provides a comprehensive overview of the characteristics of TWPs, their environmental occurrence, fate, and detection methodologies. The dominant methodological bottlenecks, key challenges, and possible way forwards are also discussed.
- 12 May 2024
- Published by Elsevier in Science of The Total Environment
- Vol. 934, 173173
In vitro digestion of microplastics in human digestive system: Insights into particle morphological changes and chemical leaching
- 12 May 2024
- Published by Elsevier in Science of The Total Environment
- Vol. 934, 173173
In vitro digestion of microplastics in human digestive system: Insights into particle morphological changes and chemical leaching
- 17 December 2023
- Published by Elsevier in Water Research
- Vol. 250, 121029
Long-term presence of microplastics in aerobic and anaerobic sequential batch reactors: Effect on treatment, microbial diversity, and microplastics morphology
- 17 December 2023
- Published by Elsevier in Water Research
- Vol. 250, 121029
Long-term presence of microplastics in aerobic and anaerobic sequential batch reactors: Effect on treatment, microbial diversity, and microplastics morphology
- 11 October 2023
- Published by Elsevier in Applied Geochemistry
- Vol. 158
Solubility product of chromate analogue of hydrogarnet (Ca3Al2[CrO4]0.12[O4H4]2.88(s)) at 25 °C
- 11 October 2023
- Published by Elsevier in Applied Geochemistry
- Vol. 158
Solubility product of chromate analogue of hydrogarnet (Ca3Al2[CrO4]0.12[O4H4]2.88(s)) at 25 °C