Yasuhito Matsubayashi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Yasuhito Matsubayashi has a total of 56 co-authors. Here are the top co-authors by number of shared publications:
- Zenji Hiroi
Institute for Solid State Physics, University of Tokyo, Kashiwa, Chiba 277-8581, Japan
5 shared publications Jun Akedo
4 shared publications- Kazuo Terashima
Department of Advanced Materials Science, Graduate School of Frontier Sciences, The University of Tokyo
4 shared publications Daigorou Hirai
Institute for Solid State Physics, University of Tokyo, Kashiwa, Chiba 277-8581, Japan
3 shared publicationsIwao Yamaguchi
Advanced Coating Technology Research Center, National Institute of Advanced Industrial Science and Technology, Tsukuba, Japan
3 shared publications- Shinnya Uji
National Institute for Materials Science
3 shared publications
Latest Publications
- 16 July 2026
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 42 (29) , 21502-21509
Polymer Brush-Assisted Reduction of Contact Thermal Resistance via Interfacial Diffusion of a Liquid Polymer
In this study, we propose a thermal contact strategy to significantly reduce contact thermal resistance by introducing polydimethylsiloxane (PDMS) polymer brushes at the interface between Si substrates. When PDMS oil is sandwiched between the PDMS-brush-modified Si substrates, the contact thermal resistance is reduced by approximately a factor of 5 compared with unmodified Si substrates, achieving values comparable to or lower than those of commercial thermal greases. The time evolution of thermal resistance as a function of molecular weight and temperature suggests that this reduction is consistent with interfacial structural changes associated with the diffusion of PDMS oil into the polymer brush layer. This approach provides a promising route for increasing interfacial thermal transport.
- 16 July 2026
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 42 (29) , 21502-21509
Polymer Brush-Assisted Reduction of Contact Thermal Resistance via Interfacial Diffusion of a Liquid Polymer
In this study, we propose a thermal contact strategy to significantly reduce contact thermal resistance by introducing polydimethylsiloxane (PDMS) polymer brushes at the interface between Si substrates. When PDMS oil is sandwiched between the PDMS-brush-modified Si substrates, the contact thermal resistance is reduced by approximately a factor of 5 compared with unmodified Si substrates, achieving values comparable to or lower than those of commercial thermal greases. The time evolution of thermal resistance as a function of molecular weight and temperature suggests that this reduction is consistent with interfacial structural changes associated with the diffusion of PDMS oil into the polymer brush layer. This approach provides a promising route for increasing interfacial thermal transport.
- 10 May 2025
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 64 (20) , 10179-10193
Rhenium Bronze Oxide Containing Tellurium Ions with Two Lone Pairs
Hexagonal bronze oxides are represented by the chemical formula AxMO3, where A is an electropositive element such as alkali metal or alkaline earth metal and M is a transition metal such as Mo, W, or Re. We report the first synthesis of a tellurium-containing rhenium bronze oxide, Te0.30ReO3. The compound has an orthorhombic crystal structure, with tellurium located within the ab plane along with rhenium and oxygen, and planarly coordinated to three oxygen atoms. Electron localization function (ELF) analysis revealed that tellurium has two ELF attractors above and below the TeO3 plane and that the ELF structure around tellurium is similar to that of ClF3. Based on valence shell electron pair repulsion theory, two equatorial positions in the coordination structure of the trigonal bipyramid are occupied by lone pairs and the remaining three positions are occupied by oxygen. Electron density calculations demonstrated that the unique coordination structure of the tellurium arises from the hybridization of the 5s and 5p orbitals of tellurium with the 2p orbitals of oxygen.
- 10 May 2025
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 64 (20) , 10179-10193
Rhenium Bronze Oxide Containing Tellurium Ions with Two Lone Pairs
Hexagonal bronze oxides are represented by the chemical formula AxMO3, where A is an electropositive element such as alkali metal or alkaline earth metal and M is a transition metal such as Mo, W, or Re. We report the first synthesis of a tellurium-containing rhenium bronze oxide, Te0.30ReO3. The compound has an orthorhombic crystal structure, with tellurium located within the ab plane along with rhenium and oxygen, and planarly coordinated to three oxygen atoms. Electron localization function (ELF) analysis revealed that tellurium has two ELF attractors above and below the TeO3 plane and that the ELF structure around tellurium is similar to that of ClF3. Based on valence shell electron pair repulsion theory, two equatorial positions in the coordination structure of the trigonal bipyramid are occupied by lone pairs and the remaining three positions are occupied by oxygen. Electron density calculations demonstrated that the unique coordination structure of the tellurium arises from the hybridization of the 5s and 5p orbitals of tellurium with the 2p orbitals of oxygen.
- 22 February 2024
- Published by Elsevier in Ceramics International
- Vol. 50 (10) , 17940-17949
Thermal conductivity of nanocrystalline alumina films fabricated by aerosol deposition
- 22 February 2024
- Published by Elsevier in Ceramics International
- Vol. 50 (10) , 17940-17949
Thermal conductivity of nanocrystalline alumina films fabricated by aerosol deposition
- 18 October 2023
- Published by Elsevier in Ceramics International
- Vol. 50 (1) , 892-896
Ceramic coating on rubber by aerosol deposition with cryogenic substrate cooling
- 18 October 2023
- Published by Elsevier in Ceramics International
- Vol. 50 (1) , 892-896
Ceramic coating on rubber by aerosol deposition with cryogenic substrate cooling
- Open Access
- 3 April 2023
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 59 (33) , 4927-4930
Surface modification enhances the bulk proton conductivity of Prussian blue
Surface-modified Prussian blue shows 102 times higher bulk proton conductivity (0.018 S cm−1) than that of unmodified Prussian blue.
- 3 April 2023
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 59 (33) , 4927-4930
Open AccessSurface modification enhances the bulk proton conductivity of Prussian blue
Surface-modified Prussian blue shows 102 times higher bulk proton conductivity (0.018 S cm−1) than that of unmodified Prussian blue.
- 31 March 2023
- Published by Elsevier in Ceramics International
- Vol. 49 (13) , 21570-21576
Aerosol deposition of alumina films on microstructured silicon substrates
- 31 March 2023
- Published by Elsevier in Ceramics International
- Vol. 49 (13) , 21570-21576
Aerosol deposition of alumina films on microstructured silicon substrates
- 5 February 2022
- Published by Elsevier in Ceramics International
- Vol. 48 (19) , 28815-28821
Relationship between dielectric strength and mechanical properties of alumina films fabricated by aerosol deposition
- 5 February 2022
- Published by Elsevier in Ceramics International
- Vol. 48 (19) , 28815-28821
Relationship between dielectric strength and mechanical properties of alumina films fabricated by aerosol deposition
- 10 January 2022
- Published by American Physical Society (APS) in Physical Review B
- Vol. 105 (3) , 035116
Electronic states of metallic electric toroidal quadrupole order in determined by combining quantum oscillations and electronic structure calculationsPyrochlore oxide exhibits successive structural transitions upon cooling that break its inversion symmetry. The low-temperature noncentrosymmetric metallic phases are believed to be some odd-parity multipole ordered states that are associated with a Fermi-liquid instability due to the strong spin-orbit interaction (SOI) and electronic correlation. However, their microscopic ordering pictures and the driving force of the phase transitions are still unclear. We determined the electronic structure of the lowest temperature phase of by combining quantum oscillation measurements with electronic structure calculations. The observed Fermi surfaces were well reproduced based on the optimized crystal structure, and we demonstrated the strong influence of the antisymmetric SOI. From the mass enhancement factor, we elucidated the strongly correlated nature of the electronic states. In addition, we visualized the microscopic picture of the -type metallic electric-toroidal-quadrupole (ETQ) order characterized by the Re-O bond order. These results corroborate that the metallic ETQ order is driven by a Fermi-liquid instability associated with the strong SOI and electronic correlation, as has been theoretically proposed. Our results provide the basis for exploring unconventional phenomena expected in the metallic ETQ order.- 10 January 2022
- Published by American Physical Society (APS) in Physical Review B
- Vol. 105 (3) , 035116
Electronic states of metallic electric toroidal quadrupole order in determined by combining quantum oscillations and electronic structure calculationsPyrochlore oxide exhibits successive structural transitions upon cooling that break its inversion symmetry. The low-temperature noncentrosymmetric metallic phases are believed to be some odd-parity multipole ordered states that are associated with a Fermi-liquid instability due to the strong spin-orbit interaction (SOI) and electronic correlation. However, their microscopic ordering pictures and the driving force of the phase transitions are still unclear. We determined the electronic structure of the lowest temperature phase of by combining quantum oscillation measurements with electronic structure calculations. The observed Fermi surfaces were well reproduced based on the optimized crystal structure, and we demonstrated the strong influence of the antisymmetric SOI. From the mass enhancement factor, we elucidated the strongly correlated nature of the electronic states. In addition, we visualized the microscopic picture of the -type metallic electric-toroidal-quadrupole (ETQ) order characterized by the Re-O bond order. These results corroborate that the metallic ETQ order is driven by a Fermi-liquid instability associated with the strong SOI and electronic correlation, as has been theoretically proposed. Our results provide the basis for exploring unconventional phenomena expected in the metallic ETQ order.- Open Access
- 22 November 2021
- Published by Taylor & Francis in Journal of Asian Ceramic Societies
- Vol. 10 (1) , 40-48
Optical emission generated by particle impact during aerosol deposition of alumina films
Aerosol deposition (AD) is a ceramic coating process that enables films to be fabricated by microparticle impact at room temperature. The optical emission during AD reported in previous studies is thought to be fracto-emission or triboemission; however, the mechanism has never been investigated in detail. In this study, the optical emission of the electric discharge generated during aerosol deposition of alumina films using He, Ar, and N2 was measured by optical emission spectroscopy. Each spectrum had peaks corresponding to the emission peaks of the carrier gas and no blackbody radiation characteristics were observed. The emission intensity was proportional to the flux of the kinetic energy of the aerosol particles, which suggested that the emission occurred via fracto-emission during particle impact. The gas temperature remained low at around 300 K, which quantitatively confirmed that AD is a room-temperature process. Graphical abstract
- 22 November 2021
- Published by Taylor & Francis in Journal of Asian Ceramic Societies
- Vol. 10 (1) , 40-48
Open AccessOptical emission generated by particle impact during aerosol deposition of alumina films
Aerosol deposition (AD) is a ceramic coating process that enables films to be fabricated by microparticle impact at room temperature. The optical emission during AD reported in previous studies is thought to be fracto-emission or triboemission; however, the mechanism has never been investigated in detail. In this study, the optical emission of the electric discharge generated during aerosol deposition of alumina films using He, Ar, and N2 was measured by optical emission spectroscopy. Each spectrum had peaks corresponding to the emission peaks of the carrier gas and no blackbody radiation characteristics were observed. The emission intensity was proportional to the flux of the kinetic energy of the aerosol particles, which suggested that the emission occurred via fracto-emission during particle impact. The gas temperature remained low at around 300 K, which quantitatively confirmed that AD is a room-temperature process. Graphical abstract
- Open Access
- 26 August 2020
- Published by IntechOpen
Dusty Plasmas in Supercritical Carbon Dioxide
Dusty plasmas, which are systems comprising plasmas and dust particles, have emerged in various fields such as astrophysics and semiconductor processes. The fine particles possibly form ordered structures, namely, plasma crystals, which have been extensively studied as a model to observe statistical phenomena. However, the structures of the plasma crystals in ground-based experiments are two-dimensional (2D) because of the anisotropy induced by gravity. Microgravity experiments successfully provided opportunities to observe the novel phenomena hidden by gravity. The dusty plasmas generated in supercritical fluids (SCFs) are proposed herein as a means for realizing a pseudo-microgravity environment for plasma crystals. SCF has a high and controllable density; therefore, the particles in SCF can experience pseudo-microgravity conditions with the aid of buoyancy. In this chapter, a study on the particle charging and the formation of the plasma crystals in supercritical CO2, the realization of a pseudo-microgravity environment, and the outlook for the dusty plasmas in SCF are introduced. Our studies on dusty plasmas in SCF not only provide the pseudo-microgravity conditions but also open a novel field of strongly coupled plasmas because of the properties of media.
- 26 August 2020
- Published by IntechOpen
Open AccessDusty Plasmas in Supercritical Carbon Dioxide
Dusty plasmas, which are systems comprising plasmas and dust particles, have emerged in various fields such as astrophysics and semiconductor processes. The fine particles possibly form ordered structures, namely, plasma crystals, which have been extensively studied as a model to observe statistical phenomena. However, the structures of the plasma crystals in ground-based experiments are two-dimensional (2D) because of the anisotropy induced by gravity. Microgravity experiments successfully provided opportunities to observe the novel phenomena hidden by gravity. The dusty plasmas generated in supercritical fluids (SCFs) are proposed herein as a means for realizing a pseudo-microgravity environment for plasma crystals. SCF has a high and controllable density; therefore, the particles in SCF can experience pseudo-microgravity conditions with the aid of buoyancy. In this chapter, a study on the particle charging and the formation of the plasma crystals in supercritical CO2, the realization of a pseudo-microgravity environment, and the outlook for the dusty plasmas in SCF are introduced. Our studies on dusty plasmas in SCF not only provide the pseudo-microgravity conditions but also open a novel field of strongly coupled plasmas because of the properties of media.