Leon P. M. Brendel
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Leon P. M. Brendel has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Eckhard A. Groll
Ray W. Herrick Laboratories, School of Mechanical Engineering, Purdue University 1 , 177 S. Russell Street, West Lafayette, Indiana 47907-2099
2 shared publications - James E. Braun
Purdue University, West Lafayette, Indiana 47907-2099
2 shared publications - Derek Hengeveld
LoadPath, Albuquerque, NM, 87106, USA
1 shared publication Eckhard A. Groll
School of Mechanical Engineering, Ray W. Herrick Laboratories, Purdue University, West Lafayette, USA
1 shared publicationJames E. Braun
School of Mechanical Engineering, Ray W. Herrick Laboratories, Purdue University, West Lafayette, USA
1 shared publicationJonathan P. Ore
School of Mechanical Engineering, Ray W. Herrick Laboratories, Purdue University, West Lafayette, USA
1 shared publication
Latest Publications
- 5 August 2022
- Published by Springer Nature in Microgravity Science and Technology
- Vol. 34 (4) , 1-13
Liquid Flooding From an Evaporator Upon Compressor Start-up in Microgravity
- 5 August 2022
- Published by Springer Nature in Microgravity Science and Technology
- Vol. 34 (4) , 1-13
Liquid Flooding From an Evaporator Upon Compressor Start-up in Microgravity
- 1 October 2021
- Published by American Institute of Aeronautics and Astronautics (AIAA) in Journal of Thermophysics and Heat Transfer
- Vol. 35 (4) , 830-842
Comparison of Gravity Independence Criteria for Two-Phase Flow
The effect of gravity on two-phase flow phenomena depends on the relative magnitude of the gravity force to inertia, viscous, and surface tension forces. Two-phase flow research has investigated he...
- 1 October 2021
- Published by American Institute of Aeronautics and Astronautics (AIAA) in Journal of Thermophysics and Heat Transfer
- Vol. 35 (4) , 830-842
Comparison of Gravity Independence Criteria for Two-Phase Flow
The effect of gravity on two-phase flow phenomena depends on the relative magnitude of the gravity force to inertia, viscous, and surface tension forces. Two-phase flow research has investigated he...
- Open Access
- 1 August 2019
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 604 (1) , 012036
Vapor Compression Cycles for High Component Heat Loads on Next-Generation Small Satellites
High-power small satellites (SmallSats) have the potential to provide new and advanced capabilities; however, significant challenges prevent wide-spread use. Of these challenges, thermal management of high heat loads is most significant. This paper evaluates vapor compression cycles (VCCs) as a thermal management solution to increase the maximum component heat load at a fixed radiator area. The VCC with radiative heat transfer as a heat sink is described with analytical equations that couple the required compressor work input for a desired additional component heat load for a given second law efficiency. A figure of merit is defined. In a case study, the results of the equations are compared to a numerically modelled vapor compression cycle. Challenges for a realization of vapor compression cooling on-board SmallSats are pointed out.
- 1 August 2019
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 604 (1) , 012036
Open AccessVapor Compression Cycles for High Component Heat Loads on Next-Generation Small Satellites
High-power small satellites (SmallSats) have the potential to provide new and advanced capabilities; however, significant challenges prevent wide-spread use. Of these challenges, thermal management of high heat loads is most significant. This paper evaluates vapor compression cycles (VCCs) as a thermal management solution to increase the maximum component heat load at a fixed radiator area. The VCC with radiative heat transfer as a heat sink is described with analytical equations that couple the required compressor work input for a desired additional component heat load for a given second law efficiency. A figure of merit is defined. In a case study, the results of the equations are compared to a numerically modelled vapor compression cycle. Challenges for a realization of vapor compression cooling on-board SmallSats are pointed out.