PVPierre Jacques Verlinden

Pierre Jacques Verlinden

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Pierre Jacques Verlinden has a total of 644 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Applying Texturization Methods for Luminescent Down‐Shifting Films to Enhance the Light Absorption in High‐Efficiency Photovoltaic Devices

    by Yu An, Sila Bektaş, Ning Yang, Gence Bektaş, Luobu Danzeng, Xinliang Lou, Yuxuan Li, Jiahui Xu, Huibo Wei, Xueqing Xu, et al.

    Photon management offers a promising strategy to mitigate optical losses and improve the efficiency of photovoltaic devices. In most down‐shifting studies, the isotropic emission of down‐shifting materials limits the photon utilization. Herein, we combine inverted‐pyramid texturization with luminescent down‐shifting films to minimize broadband reflection of photovoltaic devices and enhance the utilization of down‐shifted photons. The textured architecture increases the energy transfer efficiency of down‐shifted photons to 1.3 times that of a flat down‐shifting film. For silicon solar cells, the textured down‐shifting film yields a total integrated photocurrent enhancement of 2.3% over its flat counterpart. Of this improvement, 0.2% is attributed to the enhanced redirection of down‐shifted photons toward the solar cell in the UV region (300–400 nm), while 2.1% originates from broadband light‐trapping effect across the full spectrum (400–1180 nm), resulting in a relative efficiency gain of 2.0%. The same strategy is further extended to wide‐bandgap perovskite solar cells, delivering a relative efficiency improvement of 2.3% with respect to bare devices, demonstrating the applicability of this optical management approach beyond silicon‐based technologies. This work provides insights into the underlying physical phenomena of textured luminescent down‐shifting film and optimal design considerations for encapsulation materials in high‐performance photovoltaic devices.

  • Open Access

    Potential-Induced Degradation in Perovskite Photovoltaics Mitigated by Positive-Voltage Systems

    by Marco Marengo, Anil Reddy Pininti, Thomas G Allen, Pierre Verlinden, Stefaan De Wolf

    Long-term reliability remains a major barrier to the commercialization of perovskite photovoltaics, with potential-induced degradation (PID) emerging as a critical system-level failure mode. Specifically, PID has been observed in thin-film perovskite solar cells under strong negative voltage and was attributed to sodium ions migrating from the glass substrate to the cell. Here, we report a PID study of encapsulated inverted (p-i-n) perovskite solar cells subjected to positive and negative voltage (±1000 V) for 168 h following the IEC aluminum-foil testing protocol. We find that devices under positive voltage retained more than 95% of the initial power output, meeting the qualification criterion typically applied to commercial modules. These results highlight that PID can be resolved at the system level, thereby relaxing constraints at both the cell and module levels.

  • Linear calibration of series resistance for accurate I–V characterization of advanced metallization solar cells using fewer probe bars

    by Zongtao Liu, Daming Chen, Zongcun Liang, Pierre J. Verlinden, Yifeng Chen, Pietro P. Altermatt, Ruy Sebastian Bonilla, Ruijiang Hong

  • Photovoltaic device innovation for a solar future

    by Pierre Verlinden, David L. Young, Gang Xiong, Matthew O. Reese, Lorelle M. Mansfield, Michael Powalla, Stefan Paetel, Ryan M. France, Philip T. Chiu, Nancy M. Haegel


  • Simulation, Experimental Evaluation, and Characterization of a Novel Grid Line Design for TOPCon Solar Cells With Reduced Silver Consumption

    by Zongtao Liu, Daming Chen, Huili Han, Jianjun Xiang, Zhiyuan Liu, Guanchao Xu, Xueling Zhang, Pierre J. Verlinden, Hui Shen, Yifeng Chen, et al.

    Silver paste accounts for a substantial portion of the nonsilicon cost of tunnel oxide polysilicon contact solar cells. Silver consumption is as well a major concern for material sustainability of global PV manufacturing. It is necessary to propose innovative grid line designs to reduce the amount of silver paste. Partially interrupting the metal fingers (also known as “Finger Break”) between the bus bars in areas where the fingers carry a relatively small current is a good method for reducing silver consumption in industrial production. Under the assumption of uniform generated current density (ISO-current), this article discusses the impact of the width of finger interruption on the cell efficiency under two different scenarios. Through simulations, experiments, and outdoor testing, it was found that one of the considered novel grid designs can save silver paste to a great extent, but suffers a rapid decline in power conversion efficiency, and also poses potential stability risks, while the other grid design not only saves silver, it does not severely affect the efficiency, and can be used outdoors while maintaining stability. Based on the different light intensities, the finger interruption width can be as high as 5 mm, resulting in a saving of 9.32 mg (∼1.61 mg/W) of silver paste on the front surface of 158.75 cm×158.75 cm solar cell, for a reduction of 12.97% of the original front silver consumption.


  • Top Cited Papers
    Open Access

    The silver learning curve for photovoltaics and projected silver demand for net‐zero emissions by 2050

    by Brett Hallam, Moonyong Kim, Yuchao Zhang, Li Wang, Alison Lennon, Pierre Verlinden, Pietro P. Altermatt, Pablo R. Dias

    The clean energy transition could see the cumulative installed capacity of photovoltaics increase from 1 TW before the end of 2022 to 15–60 TW by 2050, creating a significant silver demand risk. Here, we present a silver learning curve for the photovoltaic industry with a learning rate of 20.3 ± 0.8%. Maintaining business as usual with a dominance of p‐type technology could require over 20% of the current annual silver supply by 2027 and a cumulative 450–520 kt of silver until 2050, approximately 85–98% of the current global silver reserves. A rapid transition to higher efficiency tunnel oxide passivated contact and silicon heterojunction cell technologies in their present silver‐intensive forms could increase and accelerate silver demand. As we approach annual production capacities of over 1 TW by 2030, addressing the silver issue requires increased efforts in research and development to increase the silver learning rate by 30%, with existing silver‐lean and silver‐free metallisation approaches including copper plating and screen‐printing of aluminium and copper.


  • Author Correction: Status and perspectives of crystalline silicon photovoltaics in research and industry

    by Christophe Ballif, Franz-Josef Haug, Mathieu Boccard, Pierre J. Verlinden, Giso Hahn


  • Technology evolution of the photovoltaic industry: Learning from history and recent progress

    by Yifeng Chen, Daming Chen, Pietro P. Altermatt, Shu Zhang, Le Wang, Xueling Zhang, Jianmei Xu, Zhiqiang Feng, Hui Shen, Pierre J. Verlinden

    This paper reports on the latest advances in crystalline Si cells and modules in the industry and explores the dynamics shaping the silicon PV industry. First, we report on the recent efficiency improvements of passivated emitter and rear cell (PERC) and tunnel oxide passivated contact (TOPCon) cells on 210 mm wafers. At Trina Solar, the best batch average cell efficiency (total area) reached 23.61% for PERC and 25.04% for industrial‐TOPCon (i‐TOPCon). As far as we know, these are the highest values achieved on 210 mm wafers. The best champion efficiency for PERC and i‐TOPCon is 24.5% and 25.42%, respectively, as independently confirmed by the National Institute of Metrology of China in Beijing and ISFH CalTech in Hamelin. We have developed modules with power outputs of up to 660 W by using 66 pieces of these 210 mm cells with 12‐busbar technology in mass production. Besides, the aperture efficiency of the best laboratory PERC module fabricated by Trina Solar is 23.03%, which was independently confirmed by TÜV Rheinland. As far as we know, this is the first commercially sized PERC module with an aperture efficiency of 23% and a power output of over 600 W. Second, we have examined the technological development in the PV industry and summarise some empirical results. A look at the historical data shows that an increase in wafer area of at least 50% is required for a wafer size to become a new industry standard that lasts for 10 years. We find that it typically took about 3 years for the average efficiency of a cell in mass production to reach the efficiency of the champion cell produced in the industrial laboratory. We apply the empirical Goetzberger equation to analyse the module efficiency of c‐Si and thin‐film technologies. Based on our previous work, we update the selling price and manufacturing cost of PV modules and their learning curves. If we restrict the module price learning curve to the years starting in 2015, we find a short‐term learning rate (LR) of about 40%, while the overall LR since 1970 is about 24%. A strong LR is driven by collaboration among industrial players and clustering of the industry, as well as standardisation of the technology, the supply chain, and final product design, which lead to fast equipment development and fast increase in capacity of supply chain. We propose an empirical law to describe the recent evolution of equipment LR, which shows that the throughput of tool increases 100% in every 3 years, so that the investment in cell production lines has decreased by 50% every 3 years since 2015. Finally, we quantify the material consumption and carbon footprint of PV plants today and for the expansion of PV to terawatt (TW) levels. Besides replacing silver fingers with copper and aluminium, saving copper cables in utilities and low‐carbon mining of materials are the most effective carbon reduction measures in the PV supply chain.


  • Top Cited Papers

    Status and perspectives of crystalline silicon photovoltaics in research and industry

    by Christophe Ballif, Franz-Josef Haug, Mathieu Boccard, Pierre J. Verlinden, Giso Hahn