Andrew Seredinski
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Andrew Seredinski has a total of 62 co-authors. Here are the top co-authors by number of shared publications:
- Kenji Watanabe
National Institute for Materials Science 1-1 Namiki
5 shared publications - Ethan G. Arnault
Massachusetts Institute of Technology
3 shared publications F. Amet
Appalachian State University
3 shared publications- Gleb Finkelstein
Department of Physics Duke University 27708 Durham NC USA
3 shared publications - Anne Watson Draelos
University of Michigan
2 shared publications - François Amet
Department of Physics and Astronomy, Appalachian State University, Boone, North Carolina 28607, USA
2 shared publications
Latest Publications
- Open Access
- 1 June 2026
- Published by AIP Publishing in AIP Advances
- Vol. 16 (6)
Comparison of oxygen and air plasma treatments in the exfoliation of graphene
Oxygen plasma pretreatment of SiO2 substrates is commonly employed in graphene exfoliation. The plasma’s thorough cleaning of adsorbates from the substrate improves the surface interaction between the graphitic flakes and the substrate. However, oxygen plasma systems are seldom portable and can be large and costly. We compare few-layer graphene exfoliation yields from two oxygen plasma pretreatment recipes to low-pressure air plasma pretreatment, portable corona system pretreatment, and a control. We test each condition with both Kish graphite and highly oriented pyrolytic graphite. We find some evidence that these alternatives generally perform worse than the traditional oxygen plasma, supporting their absence from current graphene exfoliation procedures. There are indications of significant differences between the impact of these pretreatments for the different types of bulk graphite.
- 1 June 2026
- Published by AIP Publishing in AIP Advances
- Vol. 16 (6)
Open AccessComparison of oxygen and air plasma treatments in the exfoliation of graphene
Oxygen plasma pretreatment of SiO2 substrates is commonly employed in graphene exfoliation. The plasma’s thorough cleaning of adsorbates from the substrate improves the surface interaction between the graphitic flakes and the substrate. However, oxygen plasma systems are seldom portable and can be large and costly. We compare few-layer graphene exfoliation yields from two oxygen plasma pretreatment recipes to low-pressure air plasma pretreatment, portable corona system pretreatment, and a control. We test each condition with both Kish graphite and highly oriented pyrolytic graphite. We find some evidence that these alternatives generally perform worse than the traditional oxygen plasma, supporting their absence from current graphene exfoliation procedures. There are indications of significant differences between the impact of these pretreatments for the different types of bulk graphite.
- Open Access
- 26 September 2025
- Published by Springer Nature in Discover Education
- Vol. 4 (1) , 1-17
Using a Wikipedia edit-a-thon as a cross-curricular STEM representation assignment
- 26 September 2025
- Published by Springer Nature in Discover Education
- Vol. 4 (1) , 1-17
Open AccessUsing a Wikipedia edit-a-thon as a cross-curricular STEM representation assignment
- 2 July 2025
- Published by American Physical Society (APS) in Physical Review B
- Vol. 112 (1)
Noise-induced stabilization of dynamical states with broken time-reversal symmetry
- 2 July 2025
- Published by American Physical Society (APS) in Physical Review B
- Vol. 112 (1)
Noise-induced stabilization of dynamical states with broken time-reversal symmetry
- Open Access
- 1 November 2023
- Published by AIP Publishing in AIP Advances
- Vol. 13 (11)
Low-frequency electric fields at smartphone surface
Mobile phones, tablets, and other devices with capacitive touchscreens are ubiquitous in modern society. Consequently, the battery health of such devices along with the potential public health impacts of their typical use is of high importance. Here, we investigate the AC electric field present near the touchscreen surface during device charging. Using a Trifield TF2 meter for magnitude and a Faraday pickup coil for frequency, we study the AC electric field at the surface of an Apple iPhone 8 mobile phone in the 0–200 kHz range, well below the uplink/downlink bands used for cellular signals. We find the addition of the frequency content throughout this range and with integrated magnitude of the order of 500 V/m rms under certain phone charging conditions. Our findings suggest that the field is being generated by the lithium-ion battery. We note also that these AC electric fields are not present when the device is charged from a portable power bank.
- 1 November 2023
- Published by AIP Publishing in AIP Advances
- Vol. 13 (11)
Open AccessLow-frequency electric fields at smartphone surface
Mobile phones, tablets, and other devices with capacitive touchscreens are ubiquitous in modern society. Consequently, the battery health of such devices along with the potential public health impacts of their typical use is of high importance. Here, we investigate the AC electric field present near the touchscreen surface during device charging. Using a Trifield TF2 meter for magnitude and a Faraday pickup coil for frequency, we study the AC electric field at the surface of an Apple iPhone 8 mobile phone in the 0–200 kHz range, well below the uplink/downlink bands used for cellular signals. We find the addition of the frequency content throughout this range and with integrated magnitude of the order of 500 V/m rms under certain phone charging conditions. Our findings suggest that the field is being generated by the lithium-ion battery. We note also that these AC electric fields are not present when the device is charged from a portable power bank.
- Open Access
- 1 January 2023
- Published by ASME International in ASME Open Journal of Engineering
- Vol. 2
Electrostatic Charge on Smartphone Surfaces
Mobile phones, tablets, and capacitive touchscreens, in general, are ubiquitous in modern society. In this study, the electrostatic charge present near the capacitive touchscreen surfaces was investigated. Results from a Faraday pail experiment indicate that smartphones present an electrostatic charge due to charging and that the magnitude of this charge can vary due to adding additional materials, such as those used as common screen protectors, or by triboelectric events, such as rubbing against another material, as is the case when removing a phone from a pants pocket, for example. Furthermore, this charge increases with lower ambient relative humidity. Understanding these electrostatic charge behaviors may prove useful in minimizing the possibility of either attracting or dispersing unwanted electrically charged particles, such as dust, viruses, or contaminated aerosols, especially in indoor environments with low relative humidity (RH < 40%).
- 1 January 2023
- Published by ASME International in ASME Open Journal of Engineering
- Vol. 2
Open AccessElectrostatic Charge on Smartphone Surfaces
Mobile phones, tablets, and capacitive touchscreens, in general, are ubiquitous in modern society. In this study, the electrostatic charge present near the capacitive touchscreen surfaces was investigated. Results from a Faraday pail experiment indicate that smartphones present an electrostatic charge due to charging and that the magnitude of this charge can vary due to adding additional materials, such as those used as common screen protectors, or by triboelectric events, such as rubbing against another material, as is the case when removing a phone from a pants pocket, for example. Furthermore, this charge increases with lower ambient relative humidity. Understanding these electrostatic charge behaviors may prove useful in minimizing the possibility of either attracting or dispersing unwanted electrically charged particles, such as dust, viruses, or contaminated aerosols, especially in indoor environments with low relative humidity (RH < 40%).
- Open Access
- 10 June 2022
- Published by American Physical Society (APS) in Physical Review Research
- Vol. 4 (2) , 023203
Overdamped phase diffusion in hBN encapsulated graphene Josephson junctions
We investigate the zero-bias behavior of Josephson junctions made of encapsulated graphene boron nitride heterostructures in the long ballistic junction regime. For temperatures down to K, the junctions appear nonhysteretic with respect to the switching and retrapping currents and . A small nonzero resistance is observed even around zero-bias current and scales with temperature as dictated by the phase diffusion mechanism. By varying the graphene carrier concentration we are able to confirm that the observed phase diffusion mechanism follows the trend for an overdamped Josephson junction. This is in contrast with the majority of graphene-based junctions which are underdamped and shorted by the environment at high frequencies.- 10 June 2022
- Published by American Physical Society (APS) in Physical Review Research
- Vol. 4 (2) , 023203
Open AccessOverdamped phase diffusion in hBN encapsulated graphene Josephson junctions
We investigate the zero-bias behavior of Josephson junctions made of encapsulated graphene boron nitride heterostructures in the long ballistic junction regime. For temperatures down to K, the junctions appear nonhysteretic with respect to the switching and retrapping currents and . A small nonzero resistance is observed even around zero-bias current and scales with temperature as dictated by the phase diffusion mechanism. By varying the graphene carrier concentration we are able to confirm that the observed phase diffusion mechanism follows the trend for an overdamped Josephson junction. This is in contrast with the majority of graphene-based junctions which are underdamped and shorted by the environment at high frequencies. - Open Access
- 1 April 2021
- Published by AIP Publishing in AIP Advances
- Vol. 11 (4) , 045312
One-dimensional edge contact to encapsulated MoS2 with a superconductor
Establishing ohmic contact to van der Waals semiconductors such as MoS2 is crucial to unlocking their full potential in next-generation electronic devices. Encapsulation of few layer MoS2 with hBN preserves the material’s electronic properties but makes electrical contacts more challenging. Progress toward high quality edge contact to encapsulated MoS2 has been recently reported. Here, we evaluate a contact methodology using sputtered MoRe, a type II superconductor with a relatively high critical field and temperature commonly used to induce superconductivity in graphene. We find that the contact transparency is poor and that the devices do not support a measurable supercurrent down to 3 K, which has ramifications for future fabrication recipes.
- 1 April 2021
- Published by AIP Publishing in AIP Advances
- Vol. 11 (4) , 045312
Open AccessOne-dimensional edge contact to encapsulated MoS2 with a superconductor
Establishing ohmic contact to van der Waals semiconductors such as MoS2 is crucial to unlocking their full potential in next-generation electronic devices. Encapsulation of few layer MoS2 with hBN preserves the material’s electronic properties but makes electrical contacts more challenging. Progress toward high quality edge contact to encapsulated MoS2 has been recently reported. Here, we evaluate a contact methodology using sputtered MoRe, a type II superconductor with a relatively high critical field and temperature commonly used to induce superconductivity in graphene. We find that the contact transparency is poor and that the devices do not support a measurable supercurrent down to 3 K, which has ramifications for future fabrication recipes.
- Open Access
- 10 September 2019
- Published by American Physical Society (APS) in Physical Review B
- Vol. 100 (12) , 121403
Chiral quasiparticle tunneling between quantum Hall edges in proximity with a superconductor
We study a two-terminal graphene Josephson junction with contacts shaped to form a narrow constriction, less than in length. The contacts are made from type-II superconducting contacts and able to withstand magnetic fields high enough to reach the quantum Hall regime in graphene. In this regime, the device conductance is determined by edge states, plus the contribution from the constricted region. In particular, the constriction area can support supercurrents up to fields of . Additionally, enhanced conductance is observed through a wide range of magnetic fields and gate voltages. This additional conductance and the appearance of supercurrent is attributed to the tunneling between counterpropagating quantum Hall edge states along opposite superconducting contacts.- 10 September 2019
- Published by American Physical Society (APS) in Physical Review B
- Vol. 100 (12) , 121403
Open AccessChiral quasiparticle tunneling between quantum Hall edges in proximity with a superconductor
We study a two-terminal graphene Josephson junction with contacts shaped to form a narrow constriction, less than in length. The contacts are made from type-II superconducting contacts and able to withstand magnetic fields high enough to reach the quantum Hall regime in graphene. In this regime, the device conductance is determined by edge states, plus the contribution from the constricted region. In particular, the constriction area can support supercurrents up to fields of . Additionally, enhanced conductance is observed through a wide range of magnetic fields and gate voltages. This additional conductance and the appearance of supercurrent is attributed to the tunneling between counterpropagating quantum Hall edge states along opposite superconducting contacts. - Open Access
- 6 September 2019
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 5 (9) , eaaw8693
Quantum Hall–based superconducting interference device
Pushing superconductivity to the edge: Physicists make a SQUID using quantum Hall edge states.
- 6 September 2019
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 5 (9) , eaaw8693
Open AccessQuantum Hall–based superconducting interference device
Pushing superconductivity to the edge: Physicists make a SQUID using quantum Hall edge states.
- Open Access
- 30 June 2014
- Published by American Physical Society (APS) in Physical Review E
- Vol. 89 (6) , 062411
Cooperative sequential-adsorption model in two dimensions with experimental applications for ionic self-assembly of nanoparticles
Self-assembly of nanoparticles is an important tool in nanotechnology, with numerous applications, including thin films, electronics, and drug delivery. We study the deposition of ionic nanoparticles on a glass substrate both experimentally and theoretically. Our theoretical model consists of a stochastic cooperative adsorption and evaporation process on a two-dimensional lattice. By exploring the relationship between the initial concentration of nanoparticles in the colloidal solution and the density of particles deposited on the substrate, we relate the deposition rate of our theoretical model to the concentration.
- 30 June 2014
- Published by American Physical Society (APS) in Physical Review E
- Vol. 89 (6) , 062411
Open AccessCooperative sequential-adsorption model in two dimensions with experimental applications for ionic self-assembly of nanoparticles
Self-assembly of nanoparticles is an important tool in nanotechnology, with numerous applications, including thin films, electronics, and drug delivery. We study the deposition of ionic nanoparticles on a glass substrate both experimentally and theoretically. Our theoretical model consists of a stochastic cooperative adsorption and evaporation process on a two-dimensional lattice. By exploring the relationship between the initial concentration of nanoparticles in the colloidal solution and the density of particles deposited on the substrate, we relate the deposition rate of our theoretical model to the concentration.