IFIsaac Pilatowsky Figueroa

Isaac Pilatowsky Figueroa

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Isaac Pilatowsky Figueroa has a total of 24 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Harnessing Heat Pipes for Solar-Powered Cooling: An Experimental Study of a BaCl2–NH3 Thermochemical Refrigerator

    by Francisco Christian Martínez-Tejeda, José Andrés Alanís-Navarro, Elizabeth Cadenas-Castrejón, Victor Hugo Gómez-Espinoza, Isaac Pilatowsky-Figueroa, Ignacio Ramiro Martín Domínguez, Erick César López-Vidaña

    This study presents the experimental and thermodynamic evaluation of a solar thermochemical refrigeration system (STRS) powered by evacuated tube solar collectors with heat pipes as thermal energy sources, using industrial-grade BaCl2–NH3. The system was designed to produce refrigeration and ice using industrial-grade BaCl2–NH3 without additional additives or electrical input. Experimental tests were conducted under real-world conditions, with generation temperatures between 55 and 66 °C and solar irradiance of 750 to 900 W/m2. The system achieved efficient ammonia desorption, yielding up to 4.2 L of refrigerant and demonstrating repeatable operation over several thermochemical cycles. During the nighttime absorption–evaporation process, the STRS reached evaporation temperatures of −7 to −3 °C and absorption temperatures between 24 and 31 °C, suitable for ice production. The internal coefficient of performance ranged from 0.244 to 0.307, with an overall efficiency of 0.146 to 0.206. The experimental data obtained were used to derive pressure–temperature equilibrium equations for the BaCl2–NH3 working pair, yielding correlation coefficients greater than 0.98, which confirms thermodynamic consistency. The results demonstrate that additive-free, industrial-grade BaCl2 can achieve high efficiency at low temperatures, making this system a cost-effective and sustainable alternative for refrigeration and cold storage in rural areas. This research contributes new experimental knowledge on low-temperature thermochemical refrigeration and supports future development toward quasi-continuous optimization cycles based on experimental data.


  • Indirect and mixed‐mode solar drying and its effect on physicochemical properties of raw and cooked chicken breast meat

    by Erick César López‐Vidaña, Alfredo Domínguez Niño, Octavio García‐Valladares, Isaac Pilatowsky Figueroa, Margarita Castillo Téllez, Beatriz Castillo‐Téllez


  • Drying Process Habanero Chili Using a Hybrid-Solar-Fluidized Bed Dryer in Yucatán, México: Feasibility Analysis

    by Elizabeth Cortés Rodríguez, Isaac Pilatowsky Figueroa, Claudia A. Ruiz Mercado

    Solar energy was used to boost the drying process of Habanero chilli. The drying of habanero chilli is a significant seasonal commodity for Mexican producers; however, this process is costly and wasteful of energy. To determine the market trend and the optimal drying conditions for redesigning the Habanero chilli drying process using a hybrid solar-electric energy system, a feasibility study was developed. There will be two stages to the new drying process: (a) an open solar dryer was used; (b) an existing pilot fluidized bed dryer was adapted with a low temperature solar collector for air heating. Habanero chili was dehydrated from 90% to 5% moisture in 10.3 h, with good quality product, available for commercialization. With an energy savings of 0.52 kg of natural gas per kg of fresh Habanero chilli, a 50% reduction in average drying time was achieved, as well as a % reduction in energy consumption in the fluidized bed dryer.In order to expand the market for Habanero chilli, an innovative sustainable efficient drying process was created, which will save % on energy when compared to conventional equipment.

  • Experimental analysis of saline diffusion during saltwater freezing for desalination purposes

    by Beatriz Castillo‐Téllez, Isaac Pilatowsky Figueroa, Karim Allaf, Rachid Marzoug, Margarita Castillo Téllez

    The Freezing Melting (F/M) is considered one of the most sustainable desalination techniques in terms of energy consumption compared with commercial desalination. However, it presents some problems, especially salt trapping in the ice. In this paper, an experimental analysis is carried out to achieve a better understanding of saline ions displacement observed during the freezing of saline water. Different sizes, freezing temperatures and, geometries are tested using the F/M progressive desalination. It is found that salt diffusion improves with increasing the container length. Moreover, for all container geometries, the saline ion diffusion direction is from the bottom to the top of the formed ice. Furthermore, at low freezing temperature (−8°C), it is possible to purify 78.8 % of the frozen water, obtaining an easy‐to‐separate brine.


  • Open Access

    Experimental study of the dehydration kinetics of chicken breast meat and its influence on the physicochemical properties

    by Alfredo Domínguez-Niño, Ana María Lucho-Gómez, Isaac Pilatowsky-Figueroa, Erick Cesar López-Vidaña, Beatriz Castillo-Téllez, Octavio García-Valladares

    Dehydration effect on chicken breast physicochemical properties at different temperatures (45, 55, and 65°C) was determined using an electric oven at natural convection and a forced convective dehydrator. Protein content increased from 21.01% and 32.42% (raw and cooked chicken, respectively) to up to 80%. A low-fat content (2.55%) resulted in cooked chicken samples at 65°C in a forced convective dehydrator. The color difference (∆E) of the cooked chicken breast was found to be higher (19.39 to 21.36) in the oven. The highest dehydration time for raw and cooked chicken breast in a forced convection dryer at 45°C, 55°C and 65°C were 7 h, 6 h and 5 h, and 6 h, 4 h, and 3 h, respectively. Page, modified page, and logarithmic models were that the best represented the experimental data with r2 values ranged from 0.9999 to 0.9928.


  • Solar thermal dehydrating plant for agricultural products installed in Zacatecas, México

    by O. García-Valladares, I. Pilatowsky-Figueroa, N. Ortiz-Rodríguez, C. Menchaca-Valdez

    This paper presents a hybrid thermo-solar plant for the dehydration of foods, built in Zacatecas, Mexico. The plant is integrated by a semi-continuous drying chamber with a capacity of up to 2 700 kg of fresh product. The thermal energy required for the drying process is provided by two solar powered thermal systems: an air heating system with 48 collectors (111.1 m2) and a water heating system with 40 solar water heaters (92.4 m2), a thermal insulated storage tank, and a fin and tube heat exchanger. The plant also has a fossil energy backup system (LPG) to heat air. The monitoring system measures and records 55 process variables (temperature, relative humidity, water pressure, solar irradiance, air velocity, volumetric and mass flow rates). Experimental results obtained with the solar air heaters and water collectors are reported. The average efficiency of the solar air heaters field was ˜45% with a maximum increase of the air temperature of 40.8 °C and for the water solar collectors field the average efficiency was ˜50% and the water in the storage tank reaches 89.6 °C in two days of operation. A batch test was carried out on September 26 with the thermos-solar systems for the dehydration of 282 kg of Nopal (Opuntia ficus-indica) with an initial moisture content of 85.28 % (wet basis), reaching a final moisture content of 9.13 % (wet basis) in 9.7 hours. Both thermo-solar systems are able to deliver the temperature required in the food drying process (temperatures above 50 °C). According to the results obtained, different kind of food products can be dried on the thermo-solar plant designed, resulting in substantial fuel savings and environmental benefits. The development and implementation of solar drying systems technology, initially at demonstration scale, in the Mexican industrial sector could allow a technical and economic maturation of the technology, and the benefits could be presented in the short term.


  • Non-isothermal drying of garlic slices (Allium sativum, L.): Wave period and initial temperature of the heating/cooling effect

    by A. López-Ortiz, J. Rodríguez-Ramírez, L.L. Méndez-Lagunas, A. Martynenko, I. Pilatowsky-Figueroa


  • Open Access

    Theoretical Analysis of Saline Diffusion during Sodium Chloride Aqueous Solutions Freezing for Desalination Purposes

    by Beatriz Castillo Téllez, Karim Allaf, Isaac Pilatowsky Figueroa, Rosenberg Javier Romero Domínguez, Roberto Best Y Brown, Wilfrido Rivera Gomez Franco

    Considering the important demand of fresh water and its scarce availability, water desalination is an interesting technology, producing about 44 Mm3/year worldwide, but, in general the most common desalination techniques are highly energy demanding. Freezing-Melting (F/M) desalination uses just up to 70% less thermal energy, but is the least used process mainly, due to the difficulty of the salt separation. This study proposes a model able to analyses the thermodynamic potential that allows the salt diffusion during the F/M process, using an aqueous solution of sodium chloride. This should allow to obtain a sensitive analysis of the process to promote the separation between the high concentration brine and the ice with liquid separation by physical process. The unidimensional model is based on the evolution of both processes: thermal and mass diffusions, depending on temperature and saline gradients, predicting whether the salt will remain inside the ice or not. Thus, the thermal potential is adjusted to frozen only when the salt has been "pushed" towards the brine. Mostly models have base their results on the assumption of a “certain value of saline concentration of the liquid fraction”, value in which there is great disagreement. In this paper the calculations are based on the concentration in the solid-liquid interface, which has been extensively studied and there is a coincidence in those results, being the main advantage of the proposed model.