Onur Isik
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Onur Isik has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
Hale Ozgun
Istanbul Technical University, Civil Engineering Faculty, Environmental Engineering Department, Ayazaga Campus, Maslak, 34469, Istanbul, Turkey; National Research Center on Membrane Technologies, Istanbul Technical University, 34469, Maslak, Istanbul, Turkey
8 shared publicationsIsmail Koyuncu
Istanbul Technical University, Civil Engineering Faculty, Environmental Engineering Department, Ayazaga Campus, Maslak, 34469, Istanbul, Turkey; National Research Center on Membrane Technologies, Istanbul Technical University, 34469, Maslak, Istanbul, Turkey
8 shared publicationsMustafa Evren Ersahin
Istanbul Technical University, Civil Engineering Faculty, Environmental Engineering Department, Ayazaga Campus, Maslak, 34469, Istanbul, Turkey; National Research Center on Membrane Technologies, Istanbul Technical University, 34469, Maslak, Istanbul, Turkey
7 shared publications- Amr Mustafa Abdelrahman
Chemical and Biochemical Engineering Department, University of Western Ontario, London, ON N6A 5B9, Canada
5 shared publications Ibrahim Demir
Environmental Engineering Department, Civil Engineering Faculty, Istanbul Technical University Ayazaga Campus Maslak Istanbul Turkey
5 shared publicationsHazal Gulhan
Istanbul Technical University, Civil Engineering Faculty, Environmental Engineering Department, Ayazaga Campus, Maslak, 34469, Istanbul, Turkey
3 shared publications
Latest Publications
- 10 June 2024
- Published by Turkish Academy of Sciences
- p. 401-426
KENTSEL ATIKSULARDAN MİKROKİRLETİCİ GİDERİMİNDE GÜNCEL YAKLAŞIMLAR
- 10 June 2024
- Published by Turkish Academy of Sciences
- p. 401-426
KENTSEL ATIKSULARDAN MİKROKİRLETİCİ GİDERİMİNDE GÜNCEL YAKLAŞIMLAR
- 29 October 2022
- Published by Elsevier in Journal of Environmental Management
- Vol. 325 (Pt A) , 116549
Coupling high-rate activated sludge process with aerobic granular sludge process for sustainable municipal wastewater treatment
- 29 October 2022
- Published by Elsevier in Journal of Environmental Management
- Vol. 325 (Pt A) , 116549
Coupling high-rate activated sludge process with aerobic granular sludge process for sustainable municipal wastewater treatment
- 14 September 2022
- Published by Wiley in CLEAN – Soil, Air, Water
- Vol. 50 (12)
Treatment of Municipal Wastewater by Hollow Fiber Dynamic Membrane Bioreactors
In this study, an aerobic membrane bioreactor (MBR) with a polyester fabric hollow fiber filter is used for municipal wastewater treatment. This polyester fabric filter is used as support material for dynamic membrane formation in the MBR. High treatment performance is obtained in the permeate achieving over 93% of chemical oxygen demand removal efficiency and low particulate material concentration (−1). The system is operated for 58 d without any clogging. The average transmembrane value is found as around 598 mbar after the system reaches stable conditions. Morphological analyses including confocal laser scanning microscopy, environmental scanning electron microscopy, energy‐dispersive X‐ray, and Fourier transform infrared spectroscopy are performed to obtain a detailed understanding of the cake layer formation. The use of hollow fiber dynamic membranes can provide compact membrane volume with high surface area, thus, the volume of the reactor can be further decreased.
- 14 September 2022
- Published by Wiley in CLEAN – Soil, Air, Water
- Vol. 50 (12)
Treatment of Municipal Wastewater by Hollow Fiber Dynamic Membrane Bioreactors
In this study, an aerobic membrane bioreactor (MBR) with a polyester fabric hollow fiber filter is used for municipal wastewater treatment. This polyester fabric filter is used as support material for dynamic membrane formation in the MBR. High treatment performance is obtained in the permeate achieving over 93% of chemical oxygen demand removal efficiency and low particulate material concentration (−1). The system is operated for 58 d without any clogging. The average transmembrane value is found as around 598 mbar after the system reaches stable conditions. Morphological analyses including confocal laser scanning microscopy, environmental scanning electron microscopy, energy‐dispersive X‐ray, and Fourier transform infrared spectroscopy are performed to obtain a detailed understanding of the cake layer formation. The use of hollow fiber dynamic membranes can provide compact membrane volume with high surface area, thus, the volume of the reactor can be further decreased.
- 27 May 2022
- Published by Elsevier in Journal of Cleaner Production
- Vol. 363
Impact of seed sludge characteristics on granulation and performance of aerobic granular sludge process
- 27 May 2022
- Published by Elsevier in Journal of Cleaner Production
- Vol. 363
Impact of seed sludge characteristics on granulation and performance of aerobic granular sludge process
- 5 May 2022
- Published by Elsevier in Journal of Environmental Management
- Vol. 315, 115191
Impact of primary sedimentation on granulation and treatment performance of municipal wastewater by aerobic granular sludge process
- 5 May 2022
- Published by Elsevier in Journal of Environmental Management
- Vol. 315, 115191
Impact of primary sedimentation on granulation and treatment performance of municipal wastewater by aerobic granular sludge process
- 1 February 2022
- Published by Elsevier in Journal of Environmental Management
- Vol. 303, 114233
Removal of micropollutants from municipal wastewater by membrane bioreactors: Conventional membrane versus dynamic membrane
- 1 February 2022
- Published by Elsevier in Journal of Environmental Management
- Vol. 303, 114233
Removal of micropollutants from municipal wastewater by membrane bioreactors: Conventional membrane versus dynamic membrane
- 22 June 2020
- Published by Taylor & Francis in Critical Reviews in Environmental Science and Technology
- Vol. 51 (18) , 2119-2157
Anaerobic membrane bioreactors for sludge digestion: Current status and future perspectives
Excess sewage sludge in wastewater treatment plants (WWTPs) is regarded the key energy source for achieving energy neutral WWTPs. The anaerobic digestion process transforms sludge-organic matter into methane, which subsequently can be used for heat and electricity production. Conventional anaerobic digesters (ADs) have been used for sludge treatment for many decades, requiring high energy and providing poor effluent quality. Anaerobic membrane bioreactor (AnMBR) technology exhibits a promising option for treatment of high solids concentration streams including sludge. AnMBRs result in an increase in digestion efficiency and enhancement in effluent quality at small footprints. AnMBRs have the potential to reduce capital and operational costs, and produce more energy in comparison to conventional ADs. Thus, energy neutral or positive operation can be achieved with AnMBRs. Besides, nutrient recovery or direct use of permeate will become more feasible in AnMBRs compared to use of sludge supernatant in ADs. However, membrane fouling can limit the feasibility of AnMBRs for sludge treatment, which requires further research. This review paper critically evaluates the current status of AnMBR technology for municipal sludge treatment discussing the effect of different factors on treatment and membrane filtration performances. Furthermore, future research opportunities to enhance applicability of this technology are addressed.
- 22 June 2020
- Published by Taylor & Francis in Critical Reviews in Environmental Science and Technology
- Vol. 51 (18) , 2119-2157
Anaerobic membrane bioreactors for sludge digestion: Current status and future perspectives
Excess sewage sludge in wastewater treatment plants (WWTPs) is regarded the key energy source for achieving energy neutral WWTPs. The anaerobic digestion process transforms sludge-organic matter into methane, which subsequently can be used for heat and electricity production. Conventional anaerobic digesters (ADs) have been used for sludge treatment for many decades, requiring high energy and providing poor effluent quality. Anaerobic membrane bioreactor (AnMBR) technology exhibits a promising option for treatment of high solids concentration streams including sludge. AnMBRs result in an increase in digestion efficiency and enhancement in effluent quality at small footprints. AnMBRs have the potential to reduce capital and operational costs, and produce more energy in comparison to conventional ADs. Thus, energy neutral or positive operation can be achieved with AnMBRs. Besides, nutrient recovery or direct use of permeate will become more feasible in AnMBRs compared to use of sludge supernatant in ADs. However, membrane fouling can limit the feasibility of AnMBRs for sludge treatment, which requires further research. This review paper critically evaluates the current status of AnMBR technology for municipal sludge treatment discussing the effect of different factors on treatment and membrane filtration performances. Furthermore, future research opportunities to enhance applicability of this technology are addressed.
- 1 April 2020
- Published by Wiley in Journal of Chemical Technology & Biotechnology
- Vol. 95 (9) , 2437-2446
Impact of support material type on performance of dynamic membrane bioreactors treating municipal wastewater
BACKGROUND: Membrane bioreactor (MBR) applications have been limited by high cost of membrane modules and fouling problems. Dynamic membrane (DM) technology can be a solution for these problems. Low‐cost filters can be used as support materials for dynamic (cake) layer formation. The characteristics of support material play an important role on dynamic layer formation behavior. Therefore, the aim of this study was to investigate the impact of support material type on dynamic membrane bioreactor (DMBR) performance for municipal wastewater treatment. Hollow fiber support materials, made of polyester fabrics and glass fiber materials, were used for DM formation.RESULTS: Similar treatment performances were obtained with each membrane achieving high removal efficiencies for chemical oxygen demand (>97%) and total suspended solids (>99%) parameters. Higher transmembrane pressure (TMP) was observed for glass fiber material in comparison to polyester material. Based on morphological analyses, dynamic layers formed on both support materials had similar composition, organic and inorganic materials. A homogeneous layer was formed on polyester support material, while fine particles were deposited between the filaments of glass fiber support material, which caused clogging.CONCLUSION: Based on TMP results and morphological analyses, polyester support material provided better formation of DM layer. Thus selection of proper support material type is very important to achieve stable DM layer in DMBRs. © 2020 Society of Chemical Industry
- 1 April 2020
- Published by Wiley in Journal of Chemical Technology & Biotechnology
- Vol. 95 (9) , 2437-2446
Impact of support material type on performance of dynamic membrane bioreactors treating municipal wastewater
BACKGROUND: Membrane bioreactor (MBR) applications have been limited by high cost of membrane modules and fouling problems. Dynamic membrane (DM) technology can be a solution for these problems. Low‐cost filters can be used as support materials for dynamic (cake) layer formation. The characteristics of support material play an important role on dynamic layer formation behavior. Therefore, the aim of this study was to investigate the impact of support material type on dynamic membrane bioreactor (DMBR) performance for municipal wastewater treatment. Hollow fiber support materials, made of polyester fabrics and glass fiber materials, were used for DM formation.RESULTS: Similar treatment performances were obtained with each membrane achieving high removal efficiencies for chemical oxygen demand (>97%) and total suspended solids (>99%) parameters. Higher transmembrane pressure (TMP) was observed for glass fiber material in comparison to polyester material. Based on morphological analyses, dynamic layers formed on both support materials had similar composition, organic and inorganic materials. A homogeneous layer was formed on polyester support material, while fine particles were deposited between the filaments of glass fiber support material, which caused clogging.CONCLUSION: Based on TMP results and morphological analyses, polyester support material provided better formation of DM layer. Thus selection of proper support material type is very important to achieve stable DM layer in DMBRs. © 2020 Society of Chemical Industry
- 7 March 2019
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 26 (32) , 32723-32733
Comparative evaluation of ultrafiltration and dynamic membranes in an aerobic membrane bioreactor for municipal wastewater treatment
This study investigated the applicability of self-forming hollow fiber dynamic membrane (DM) as a low-cost alternative to ultrafiltration (UF) membrane. A hollow fiber polyester fabric was used as a support material to form the DM layer. Submerged DM and UF hollow fiber membrane were placed in the same reactor in order to compare the treatment and filtration performance of each membrane. Morphological analyses were also carried out for DM surface. The system was operated continuously at a flux of 5 L/m2 h for 85 days. High COD removal efficiency and total suspended solids (TSS) rejection were achieved by the DM. Transmembrane pressure (TMP) of the DM was higher in comparison to the UF membrane, which was related with the formation of cake layer in DM. DM technology can be used as an alternative to UF membrane for municipal wastewater treatment.
- 7 March 2019
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 26 (32) , 32723-32733
Comparative evaluation of ultrafiltration and dynamic membranes in an aerobic membrane bioreactor for municipal wastewater treatment
This study investigated the applicability of self-forming hollow fiber dynamic membrane (DM) as a low-cost alternative to ultrafiltration (UF) membrane. A hollow fiber polyester fabric was used as a support material to form the DM layer. Submerged DM and UF hollow fiber membrane were placed in the same reactor in order to compare the treatment and filtration performance of each membrane. Morphological analyses were also carried out for DM surface. The system was operated continuously at a flux of 5 L/m2 h for 85 days. High COD removal efficiency and total suspended solids (TSS) rejection were achieved by the DM. Transmembrane pressure (TMP) of the DM was higher in comparison to the UF membrane, which was related with the formation of cake layer in DM. DM technology can be used as an alternative to UF membrane for municipal wastewater treatment.