Chang-Zhu Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Chang-Zhu Yang has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
Bei Long
School of Architectural and Surveying & Mapping Engineering, Jiangxi University of Science and Technology, Hongqi Ave.86, Ganzhou, 341000, Jiangxi, China
4 shared publicationsWen-Hong Pu
College of Environmental Science and Engineering, Huazhong University of Science and Technology, Luoyu Road 1037, Wuhan 430074, China
3 shared publicationsFu-Biao Liu
College of Environmental Science and Engineering, Huazhong University of Science and Technology, Luoyu Road 1037, Wuhan 430074, China
2 shared publicationsGuo-Sheng Jiang
College of Environmental Science and Engineering, Huazhong University of Science and Technology, Luoyu Road 1037, Wuhan 430074, China
2 shared publicationsJia-Kuan Yang
College of Environmental Science and Engineering, Huazhong University of Science and Technology, Luoyu Road 1037, Wuhan 430074, China
2 shared publicationsJing Zhang
College of Environmental Science and Engineering, Huazhong University of Science and Technology, Luoyu Road 1037, Wuhan 430074, China
2 shared publications
Latest Publications
- 1 June 2019
- Published by Elsevier in Chemosphere
- Vol. 225, 460-469
Stability of aerobic granular sludge in a pilot scale sequencing batch reactor enhanced by granular particle size control
- 1 June 2019
- Published by Elsevier in Chemosphere
- Vol. 225, 460-469
Stability of aerobic granular sludge in a pilot scale sequencing batch reactor enhanced by granular particle size control
- 1 April 2017
- Published by Elsevier in Bioresource Technology
- Vol. 229, 126-133
Aerobic granular sludge inoculated microbial fuel cells for enhanced epoxy reactive diluent wastewater treatment
- 1 April 2017
- Published by Elsevier in Bioresource Technology
- Vol. 229, 126-133
Aerobic granular sludge inoculated microbial fuel cells for enhanced epoxy reactive diluent wastewater treatment
- 6 October 2015
- Published by Wiley in Electroanalysis
- Vol. 28 (1) , 189-196
Electrochemical Determination of Bisphenol A Using a Molecularly Imprinted Chitosan‐acetylene Black Composite Film Modified Glassy Carbon Electrode
In this study, a simple electrochemical sensor based on glassy carbon electrode (GCE) modified with molecularly imprinted chitosan film doping with acetylene black (AB) has been developed for the determination of bisphenol A (BPA). Several important parameters controlling the performance of the sensor are investigated and optimised. Two good linear relationships between the oxidation peak current and BPA concentration are obtained in the ranges from 0.005 to 0.20 μM and 0.50 to 10.00 μM with a detection limit of 2 nM (S/N=3). Meanwhile, the fabricated sensor shows good selectivity and high sensitivity. The construction of this sensor is relatively simple and provided a rapid and economical electrochemical method for the determination of BPA. The sensor is successfully employed to detect BPA in drinking water samples.
- 6 October 2015
- Published by Wiley in Electroanalysis
- Vol. 28 (1) , 189-196
Electrochemical Determination of Bisphenol A Using a Molecularly Imprinted Chitosan‐acetylene Black Composite Film Modified Glassy Carbon Electrode
In this study, a simple electrochemical sensor based on glassy carbon electrode (GCE) modified with molecularly imprinted chitosan film doping with acetylene black (AB) has been developed for the determination of bisphenol A (BPA). Several important parameters controlling the performance of the sensor are investigated and optimised. Two good linear relationships between the oxidation peak current and BPA concentration are obtained in the ranges from 0.005 to 0.20 μM and 0.50 to 10.00 μM with a detection limit of 2 nM (S/N=3). Meanwhile, the fabricated sensor shows good selectivity and high sensitivity. The construction of this sensor is relatively simple and provided a rapid and economical electrochemical method for the determination of BPA. The sensor is successfully employed to detect BPA in drinking water samples.
- Open Access
- 10 April 2015
- Published by IWA Publishing in Journal of Water and Health
- Vol. 13 (3) , 746-757
The treatment of solvent recovery raffinate by aerobic granular sludge in a pilot-scale sequencing batch reactor
Mature aerobic granular sludge (AGS) was inoculated for the start-up of a pilot-scale sequencing batch reactor for the treatment of high concentration solvent recovery raffinate (SRR). The proportion of simulated wastewater (SW) (w/w) in the influent gradually decreased to zero during the operation, while volume of SRR gradually increased from zero to 10.84 L. AGS was successfully domesticated after 48 days, which maintained its structure during the operation. The domesticated AGS was orange, irregular, smooth and compact. Sludge volume index (SVI), SV30/SV5, mixed liquor volatile suspended solids/mixed liquor suspended solids (MLVSS/MLSS), extracellular polymeric substances, proteins/polysaccharides, average particle size, granulation rate, specific oxygen utilization rates (SOUR)H and (SOUR)N of AGS were about 38 mL/g, 0.97, 0.52, 39.73 mg/g MLVSS, 1.17, 1.51 mm, 96.66%, 47.40 mg O2/h g volatile suspended solids (VSS) and 8.96 mg O2/h g VSS, respectively. Good removal effect was achieved by the reactor. Finally, the removal rates of chemical oxygen demand (COD), total inorganic nitrogen (TIN), NH4+-N and total phosphorus (TP) were more than 98%, 96%, 97% and 97%, respectively. The result indicated gradually increasing the proportion of real wastewater in influent was a useful domestication method, and the feasibility of AGS for treatment of high C/N ratio industrial wastewater.
- 10 April 2015
- Published by IWA Publishing in Journal of Water and Health
- Vol. 13 (3) , 746-757
Open AccessThe treatment of solvent recovery raffinate by aerobic granular sludge in a pilot-scale sequencing batch reactor
Mature aerobic granular sludge (AGS) was inoculated for the start-up of a pilot-scale sequencing batch reactor for the treatment of high concentration solvent recovery raffinate (SRR). The proportion of simulated wastewater (SW) (w/w) in the influent gradually decreased to zero during the operation, while volume of SRR gradually increased from zero to 10.84 L. AGS was successfully domesticated after 48 days, which maintained its structure during the operation. The domesticated AGS was orange, irregular, smooth and compact. Sludge volume index (SVI), SV30/SV5, mixed liquor volatile suspended solids/mixed liquor suspended solids (MLVSS/MLSS), extracellular polymeric substances, proteins/polysaccharides, average particle size, granulation rate, specific oxygen utilization rates (SOUR)H and (SOUR)N of AGS were about 38 mL/g, 0.97, 0.52, 39.73 mg/g MLVSS, 1.17, 1.51 mm, 96.66%, 47.40 mg O2/h g volatile suspended solids (VSS) and 8.96 mg O2/h g VSS, respectively. Good removal effect was achieved by the reactor. Finally, the removal rates of chemical oxygen demand (COD), total inorganic nitrogen (TIN), NH4+-N and total phosphorus (TP) were more than 98%, 96%, 97% and 97%, respectively. The result indicated gradually increasing the proportion of real wastewater in influent was a useful domestication method, and the feasibility of AGS for treatment of high C/N ratio industrial wastewater.
- 1 April 2015
- Published by Elsevier in Bioresource Technology
- Vol. 182, 314-322
Tolerance to organic loading rate by aerobic granular sludge in a cyclic aerobic granular reactor
- 1 April 2015
- Published by Elsevier in Bioresource Technology
- Vol. 182, 314-322
Tolerance to organic loading rate by aerobic granular sludge in a cyclic aerobic granular reactor
- 1 October 2014
- Published by Elsevier in Bioresource Technology
- Vol. 169, 244-250
The stability of aerobic granular sludge treating municipal sludge deep dewatering filtrate in a bench scale sequencing batch reactor
- 1 October 2014
- Published by Elsevier in Bioresource Technology
- Vol. 169, 244-250
The stability of aerobic granular sludge treating municipal sludge deep dewatering filtrate in a bench scale sequencing batch reactor