Sugchai Tantiviwat

This paper analyzes a microwave resonator sensor based on a square split-ring resonator operating at 5.122 GHz for permittivity characterization of a material under test (MUT). A single-ring square resonator edge (S-SRR) is coupled with several double-split square ring resonators to form the structure (D-SRR). The function of the S-SRR is to generate a resonant at the center frequency, whereas D-SRRs function as sensors, with their resonant frequency being very sensitive to changes in the MUT’s permittivity. In a traditional S-SRR, a gap emerges between the ring and the feed line to improve the Q-factor, but the loss increases as a result of the mismatched coupling of the feed lines. To provide adequate matching, the microstrip feed line is directly connected to the single-ring resonator in this article. The S-SRR’s operation switches from passband to stopband by generating edge coupling with dual D-SRRs located vertically on both sides of the S-SRR. The proposed sensor was designed, fabricated, and tested to effectively identify the dielectric properties of three MUTs (Taconic-TLY5, Rogers 4003C, and FR4) by measuring the microwave sensor’s resonant frequency. When the MUT is applied to the structure, the measured findings indicate a change in resonance frequency. The primary constraint of the sensor is that it can only be modeled for materials with a permittivity ranging from 1.0 to 5.0. The proposed sensors’ acceptable performance was achieved through simulation and measurement in this paper. Although the simulated and measured resonance frequencies have shifted, mathematical models have been developed to minimize the difference and obtain greater accuracy with a sensitivity of 3.27. Hence, resonance sensors offer a mechanism for characterizing the dielectric characteristics of varied permittivity of solid materials.

A design of a microstrip quad-band BPF with flexibly controlled bandwidth is presented in this paper. Two dual-mode short-circuited SLRs with a common via-hole are proposed, which are utilized to obtain the first and second passband, while the third passband is generated by implementing the second-order half-wavelength coupled-line resonator. Another dual-mode open-circuited SLR can be operated at the fourth passband. The proposed quad-band BPF is centered at 1.80/2.45/3.50/4.90 GHz for DCS/WLAN/WiMAX and 5G applications. By appropriately choosing the lengths of the four sets of resonators, all passbands can be fully varied independently with minimal effect on other passbands. Moreover, the bandwidth of each passband can be flexibly controlled by tuning the coupling parameters. The dimension of the fabricated proposed filter is about 0.12 × 0.20 λg, indicating the compactness of the design, whereas the measurements are in good agreement with the simulated results. The measured S11 are at least 12 dB in the four passbands. The passbands S21 are approximately 0.65, 1.42, 0.78, and 1.20 dB, which exhibit low insertion loss at the passband frequency of the first, second, third, and fourth passband, respectively.