Changfeng Fang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Changfeng Fang has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
Xian Zhao
4 shared publications- Desheng Liu
The Ohio State University
3 shared publications - Bo Durbeej
Linkoping University (LiU)
2 shared publications - Cheng-Jie Zhu
Soochow University
2 shared publications Heming Li
School of Physics, State Key Laboratory of Crystal Materials, Shandong University, Jinan 250100, China
2 shared publicationsJiezhao Lv
2 shared publications
Latest Publications
- 11 October 2024
- Published by Elsevier in Optical Materials
- Vol. 157
Femtosecond laser-induced damage on the surface of KDP crystals by Zn2+ doping
- 11 October 2024
- Published by Elsevier in Optical Materials
- Vol. 157
Femtosecond laser-induced damage on the surface of KDP crystals by Zn2+ doping
- 13 December 2023
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 26 (3) , 2242-2248
Comparison of carrier doping in ZnSnO 3 and ZnTiO 3 from first principles
Ferroelectric materials have attracted increasing attention due to their rich properties. Unlike perovskite ferroelectric oxides, in the LiNbO3-type ferroelectric oxides of ABO3, ferroelectrically active cations are not necessary. While the effects of carrier doping on perovskite ferroelectric oxides have been extensively studied, the studies on LiNbO3-type ferroelectric oxides are rare. We consider two LiNbO3-type ferroelectric oxides ZnSnO3 and ZnTiO3, where the former has no ferroelectrically active cation and the latter has ferroelectrically active cation Ti4+, and study the effect of carrier doping by performing first-principles calculations. Comparison results indicate that the B-site cation has significant effects on the polar distortion in LN-type ferroelectrics. Our studies show that LN-type materials can maintain the coexistence of ferroelectricity and conductance over a very wide range of concentrations. The polar displacement is even enhanced under hole doping. More importantly, ZnSnO3 can be doped by electrons up to a high level to realize the conducting ferroelectrics of high mobility due to its isolated s conduction band.
- 13 December 2023
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 26 (3) , 2242-2248
Comparison of carrier doping in ZnSnO 3 and ZnTiO 3 from first principles
Ferroelectric materials have attracted increasing attention due to their rich properties. Unlike perovskite ferroelectric oxides, in the LiNbO3-type ferroelectric oxides of ABO3, ferroelectrically active cations are not necessary. While the effects of carrier doping on perovskite ferroelectric oxides have been extensively studied, the studies on LiNbO3-type ferroelectric oxides are rare. We consider two LiNbO3-type ferroelectric oxides ZnSnO3 and ZnTiO3, where the former has no ferroelectrically active cation and the latter has ferroelectrically active cation Ti4+, and study the effect of carrier doping by performing first-principles calculations. Comparison results indicate that the B-site cation has significant effects on the polar distortion in LN-type ferroelectrics. Our studies show that LN-type materials can maintain the coexistence of ferroelectricity and conductance over a very wide range of concentrations. The polar displacement is even enhanced under hole doping. More importantly, ZnSnO3 can be doped by electrons up to a high level to realize the conducting ferroelectrics of high mobility due to its isolated s conduction band.
- Open Access
- 1 September 2023
- Published by AIP Publishing in AIP Advances
- Vol. 13 (9)
Optimized hologram generation method for real-time spontaneous manipulation
Aided by computer generated holography, holographic optical tweezers enable manipulation of particles and objects with exceptional versatility. The responsiveness of the manipulation is often hindered by the speed of holograph generation, especially when the number of manipulated objects is high. Here, we propose an optimized hologram generation method with an improved iterative algorithm utilizing parallel computation with graphic processing units. The algorithm requires fewer iterations to produce high-quality holograms than established methods, such as weighted Gerchberg–Saxton algorithm, leading to a responsive and stable micromanipulation. This method expands the capabilities of holographic optical tweezers and provides more responsive traps in micro-manipulation.
- 1 September 2023
- Published by AIP Publishing in AIP Advances
- Vol. 13 (9)
Open AccessOptimized hologram generation method for real-time spontaneous manipulation
Aided by computer generated holography, holographic optical tweezers enable manipulation of particles and objects with exceptional versatility. The responsiveness of the manipulation is often hindered by the speed of holograph generation, especially when the number of manipulated objects is high. Here, we propose an optimized hologram generation method with an improved iterative algorithm utilizing parallel computation with graphic processing units. The algorithm requires fewer iterations to produce high-quality holograms than established methods, such as weighted Gerchberg–Saxton algorithm, leading to a responsive and stable micromanipulation. This method expands the capabilities of holographic optical tweezers and provides more responsive traps in micro-manipulation.
- 7 July 2023
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 25 (29) , 19970-19975
Stability of oxygen vacancies at metal/oxide interfaces
The influence of charge doping and work function on the formation of oxygen vacancies in metal and insulating perovskites SrTiO 3 (STO) or a BaTiO 3 (BTO) interface was investigated by first-principles calculations.
- 7 July 2023
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 25 (29) , 19970-19975
Stability of oxygen vacancies at metal/oxide interfaces
The influence of charge doping and work function on the formation of oxygen vacancies in metal and insulating perovskites SrTiO 3 (STO) or a BaTiO 3 (BTO) interface was investigated by first-principles calculations.
- 7 November 2022
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 22 (12) , 7031-7039
Numerical Investigation of the Stimulated Growth of Single-Crystal Fibers by Point-Effect-Induced Fluid Dynamics
- 7 November 2022
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 22 (12) , 7031-7039
Numerical Investigation of the Stimulated Growth of Single-Crystal Fibers by Point-Effect-Induced Fluid Dynamics
- 27 October 2020
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 22 (45) , 26255-26264
Rational design of [ e ]-fusion induced high-performance DHP/CPD based photoswitches
We report an effective strategy for improving the electronic transport and switching behaviors of dimethyldihydropyrene/cyclophanediene (DHP/CPD)-based molecular devices, an intriguing photoswitch that can be triggered by ultraviolet/visible (UV-vis) light irradiation. Aiming to obtain molecular devices with high on–off ratios, we assess a series of molecular designs formed by [e]-fusing different arenes on a conjugated macrocycle to modulate the photochemical and electronic properties. Here, the switching mechanism and transport properties of [e]-fused DHP/CPD-based nanojunctions are theoretically investigated by first-principles calculations. As a result, the large diversity in electrical conductance between the closed and open forms certifies the substantial switching behavior observed in these sandwich structures. The maximum on–off ratios in all designed photoswitches are greater than 102. Further analysis confirms the improvement of switching performance caused by [e]-fusion. Notably, in the benzo-fused molecular junctions, the maximum on–off ratio is up to 103, which is 55 times larger than that of the un-fused one. We also find that the position of the switch core can remarkably affect the performance of photoswichable nanodevices.
- 27 October 2020
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 22 (45) , 26255-26264
Rational design of [ e ]-fusion induced high-performance DHP/CPD based photoswitches
We report an effective strategy for improving the electronic transport and switching behaviors of dimethyldihydropyrene/cyclophanediene (DHP/CPD)-based molecular devices, an intriguing photoswitch that can be triggered by ultraviolet/visible (UV-vis) light irradiation. Aiming to obtain molecular devices with high on–off ratios, we assess a series of molecular designs formed by [e]-fusing different arenes on a conjugated macrocycle to modulate the photochemical and electronic properties. Here, the switching mechanism and transport properties of [e]-fused DHP/CPD-based nanojunctions are theoretically investigated by first-principles calculations. As a result, the large diversity in electrical conductance between the closed and open forms certifies the substantial switching behavior observed in these sandwich structures. The maximum on–off ratios in all designed photoswitches are greater than 102. Further analysis confirms the improvement of switching performance caused by [e]-fusion. Notably, in the benzo-fused molecular junctions, the maximum on–off ratio is up to 103, which is 55 times larger than that of the un-fused one. We also find that the position of the switch core can remarkably affect the performance of photoswichable nanodevices.
- 17 April 2020
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 20 (5) , 3531-3536
Strong Mesoscopic Prismatic Face Growth Suppression in High-Speed Unidirectional Growth of KDP Single Crystals
- 17 April 2020
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 20 (5) , 3531-3536
Strong Mesoscopic Prismatic Face Growth Suppression in High-Speed Unidirectional Growth of KDP Single Crystals
- 12 September 2019
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 123 (40) , 8485-8495
Calculation of Free-Energy Barriers with TD-DFT: A Case Study on Excited-State Proton Transfer in Indigo
The performance of time-dependent density functional theory (TD-DFT) for the calculation of excited states of molecular systems has been the subject of many benchmark studies. Often, these studies focus on excitation energies or, more recently, excited-state equilibrium geometries. In this work, we take a different angle by instead exploring how well TD-DFT reproduces experimental free-energy barriers of a well-known photochemical reaction: the excited-state proton transfer (ESPT) in indigo. Specifically, by exploiting the possibility of using TD-DFT to locate and compute free energies of first-order saddle points in excited states, we test the performance of several popular density functionals in reproducing recently determined experimental free-energy barriers for ESPT in indigo and in an N-hexyl substituted derivative thereof. Through the calculations, it is found that all of the tested functionals perform quite well, uniformly overestimating the experimental values by 1.4-3.5 (mean error) and 2.5-5.5 kcal mol–1 (maximum error) only. Given that these errors are not larger than those typically observed when barriers for ground-state proton transfer reactions are calculated in ground-state DFT, the results highlight the potential of TD-DFT to enable accurate modeling of ESPT reactions based on free energies and explicit localization of transition states.
- 12 September 2019
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 123 (40) , 8485-8495
Calculation of Free-Energy Barriers with TD-DFT: A Case Study on Excited-State Proton Transfer in Indigo
The performance of time-dependent density functional theory (TD-DFT) for the calculation of excited states of molecular systems has been the subject of many benchmark studies. Often, these studies focus on excitation energies or, more recently, excited-state equilibrium geometries. In this work, we take a different angle by instead exploring how well TD-DFT reproduces experimental free-energy barriers of a well-known photochemical reaction: the excited-state proton transfer (ESPT) in indigo. Specifically, by exploiting the possibility of using TD-DFT to locate and compute free energies of first-order saddle points in excited states, we test the performance of several popular density functionals in reproducing recently determined experimental free-energy barriers for ESPT in indigo and in an N-hexyl substituted derivative thereof. Through the calculations, it is found that all of the tested functionals perform quite well, uniformly overestimating the experimental values by 1.4-3.5 (mean error) and 2.5-5.5 kcal mol–1 (maximum error) only. Given that these errors are not larger than those typically observed when barriers for ground-state proton transfer reactions are calculated in ground-state DFT, the results highlight the potential of TD-DFT to enable accurate modeling of ESPT reactions based on free energies and explicit localization of transition states.
- 22 January 2019
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 123 (5) , 2736-2745
Rational Design of Reversible Molecular Photoswitches Based on Diarylethene Molecules
- 22 January 2019
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 123 (5) , 2736-2745
Rational Design of Reversible Molecular Photoswitches Based on Diarylethene Molecules