Jędrzej Matla
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jędrzej Matla has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Andrzej Kaźmierczak
Faculty of Mechanical Engineering, Wroclaw University of Science and Technology, Wroclaw, Poland
4 shared publications - Radosław Wróbel
Department of Automotive Engineering,Wrocław University of Science and Technology,Wroclaw,Poland, Poland
4 shared publications - Gustaw Sierzputowski
Department of Automotive Engineering, Wroclaw University of Science and Technology, 50-370 Wroclaw, Poland
3 shared publications - Radosław Włostowski
Department of Automotive Engineering, Wroclaw University of Science and Technology, Wyb. Wyspianskiego 27, 50-370 Wrocław, Poland
3 shared publications - Adriana Włóka
Department of Automotive Engineering, Wroclaw University of Science and Technology, Wyb. Wyspianskiego 27, 50-370 Wrocław, Poland
2 shared publications - Agnieszka Szulak
Department of Automotive Engineering, Wroclaw University of Science and Technology, Wyb. Wyspianskiego 27, 50-370 Wrocław, Poland
2 shared publications
Latest Publications
- Open Access
- 14 November 2025
- Published by Polish Scientific Society of Combustion Engines in Combustion Engines
The study of hydrogen consumption in 12-meter fuel cell electric urban buses
The fuel consumption aspect of fuel cell electric buses (FCEBs) in urban transportation is a significant research and economic issue. Following article presents the results of hydrogen consumption studies for a fleet of 12-meter FCEBs under real life operating conditions in a Polish public transport company on selected routes and evaluates their operational suitability. The analysis includes factors such as the impact of weather conditions, number of stops, elevation gain, and average slope of the route. The article also discusses the challenges associated with implementing hydrogen technology in public transport and the future development prospects for this sector. The results obtained were compared with other studies in this research area.
- 14 November 2025
- Published by Polish Scientific Society of Combustion Engines in Combustion Engines
Open AccessThe study of hydrogen consumption in 12-meter fuel cell electric urban buses
The fuel consumption aspect of fuel cell electric buses (FCEBs) in urban transportation is a significant research and economic issue. Following article presents the results of hydrogen consumption studies for a fleet of 12-meter FCEBs under real life operating conditions in a Polish public transport company on selected routes and evaluates their operational suitability. The analysis includes factors such as the impact of weather conditions, number of stops, elevation gain, and average slope of the route. The article also discusses the challenges associated with implementing hydrogen technology in public transport and the future development prospects for this sector. The results obtained were compared with other studies in this research area.
- 18 August 2025
- Published by Elsevier in Measurement
- Vol. 257
MONOKS: A universal measurement system for low to high NOx concentrations in underground mines
- 18 August 2025
- Published by Elsevier in Measurement
- Vol. 257
MONOKS: A universal measurement system for low to high NOx concentrations in underground mines
- Open Access
- 27 June 2024
- Published by MDPI AG in Microbiology Research
- Vol. 15 (3) , 1099-1109
Effect of Buffer Room Configuration on Isolation of Bacteriophage phi6 and Micrococcus Luteus Emissions
In light of the growing need to mitigate viral infections, such as SARS-CoV-2, which has caused over 770 million infections and 7 million deaths worldwide, the role of architectural design in reducing pathogen spread has become paramount. This study explores how different buffer room configurations impact microbial isolation using the bacterium Micrococcus luteus and bacteriophage phi6 as test organisms. Through a comprehensive approach integrating architecture, technology, and scientific methodologies, we developed strategies to optimise safe buffer environments. Comparative analyses of various isolation systems highlighted significant variations in their effectiveness at reducing bioaerosol concentrations, directly influenced by the design and layout of buffer rooms. These findings are crucial for the effective design of medical and public spaces, particularly during pandemics, where preventing virus transmission is critical for public health.
- 27 June 2024
- Published by MDPI AG in Microbiology Research
- Vol. 15 (3) , 1099-1109
Open AccessEffect of Buffer Room Configuration on Isolation of Bacteriophage phi6 and Micrococcus Luteus Emissions
In light of the growing need to mitigate viral infections, such as SARS-CoV-2, which has caused over 770 million infections and 7 million deaths worldwide, the role of architectural design in reducing pathogen spread has become paramount. This study explores how different buffer room configurations impact microbial isolation using the bacterium Micrococcus luteus and bacteriophage phi6 as test organisms. Through a comprehensive approach integrating architecture, technology, and scientific methodologies, we developed strategies to optimise safe buffer environments. Comparative analyses of various isolation systems highlighted significant variations in their effectiveness at reducing bioaerosol concentrations, directly influenced by the design and layout of buffer rooms. These findings are crucial for the effective design of medical and public spaces, particularly during pandemics, where preventing virus transmission is critical for public health.
- 29 May 2024
- Published by Elsevier in Measurement
- Vol. 235
Prediction of toxic compounds emissions in exhaust gases based on engine vibration and Bayesian optimized decision trees
- 29 May 2024
- Published by Elsevier in Measurement
- Vol. 235
Prediction of toxic compounds emissions in exhaust gases based on engine vibration and Bayesian optimized decision trees
- Open Access
- 6 February 2024
- Published by MDPI AG in Microbiology Research
- Vol. 15 (1) , 236-246
Assessment of the Possibility of Using Bacterial Strains and Bacteriophages for Epidemiological Studies in the Bioaerosol Environment
During the COVID-19 pandemic, microbiological controls neglected the spread of viruses through the air. Techniques to identify this threat required additional research to enable control measures to be introduced to protect against the spread of disease through this route. Due to the very high level of risk occurring during research on the COVID-19 and SARS-CoV-2 viruses, it seems necessary to use analogous microorganisms that will allow, through an experiment, to validate or challenge a method that stops the spread of infectious microorganisms, without unnecessary risk to research staff. The presented work was carried out to assess the possibility of using airborne microorganisms that are safe for humans for this type of research. The work presents the selection process of bacteria and viruses (bacteriophages) that have the greatest potential for use in experimental studies on airborne-droplet transmission indoors, especially in hospital facilities. In the study, it was assumed that determining the survival rates of groups of organisms would allow them to be used as a proxy for studying more dangerous bacteria and viruses. Survival studies of selected microorganisms were carried out, and the paper selected microorganisms with the highest survival rate in a given environment.
- 6 February 2024
- Published by MDPI AG in Microbiology Research
- Vol. 15 (1) , 236-246
Open AccessAssessment of the Possibility of Using Bacterial Strains and Bacteriophages for Epidemiological Studies in the Bioaerosol Environment
During the COVID-19 pandemic, microbiological controls neglected the spread of viruses through the air. Techniques to identify this threat required additional research to enable control measures to be introduced to protect against the spread of disease through this route. Due to the very high level of risk occurring during research on the COVID-19 and SARS-CoV-2 viruses, it seems necessary to use analogous microorganisms that will allow, through an experiment, to validate or challenge a method that stops the spread of infectious microorganisms, without unnecessary risk to research staff. The presented work was carried out to assess the possibility of using airborne microorganisms that are safe for humans for this type of research. The work presents the selection process of bacteria and viruses (bacteriophages) that have the greatest potential for use in experimental studies on airborne-droplet transmission indoors, especially in hospital facilities. In the study, it was assumed that determining the survival rates of groups of organisms would allow them to be used as a proxy for studying more dangerous bacteria and viruses. Survival studies of selected microorganisms were carried out, and the paper selected microorganisms with the highest survival rate in a given environment.
- Open Access
- 6 September 2023
- Published by Polish Scientific Society of Combustion Engines in Combustion Engines
- Vol. 196 (1) , 73-79
Hydrogen as a fuel for spark ignition combustion engines – state of knowledge and concept
Accelerating process of the transport and energy sectors increases the interest in fuels derived from renewable sources. The predicted three-fold increase in hydrogen production by 2050, driven by its falling production costs, justifies the direction of research aimed at its popularisation as a fuel for internal combustion engines (H2ICE). Presented article provides an overview of the state of knowledge on hydrogen combustion systems, which are currently the most attractive development path, mainly due to the well-developed production technology and relatively low recycling cost compared with fuel cells. The paper contains a comprehensive analysis of currently available solutions covering issues related to the production, storage, and transmission of hydrogen, with particular emphasis on the Polish market, which is one of the largest in Europe in terms of its production. The authors also propose their own concept of a hydrogen combustion system for application in an internal combustion engine. The presented solution is based on the idea of prechamber introduction in order to improve combustion process parameters and hence overall engine efficiency.
- 6 September 2023
- Published by Polish Scientific Society of Combustion Engines in Combustion Engines
- Vol. 196 (1) , 73-79
Open AccessHydrogen as a fuel for spark ignition combustion engines – state of knowledge and concept
Accelerating process of the transport and energy sectors increases the interest in fuels derived from renewable sources. The predicted three-fold increase in hydrogen production by 2050, driven by its falling production costs, justifies the direction of research aimed at its popularisation as a fuel for internal combustion engines (H2ICE). Presented article provides an overview of the state of knowledge on hydrogen combustion systems, which are currently the most attractive development path, mainly due to the well-developed production technology and relatively low recycling cost compared with fuel cells. The paper contains a comprehensive analysis of currently available solutions covering issues related to the production, storage, and transmission of hydrogen, with particular emphasis on the Polish market, which is one of the largest in Europe in terms of its production. The authors also propose their own concept of a hydrogen combustion system for application in an internal combustion engine. The presented solution is based on the idea of prechamber introduction in order to improve combustion process parameters and hence overall engine efficiency.
- Open Access
- 2 September 2023
- Published by Polish Scientific Society of Combustion Engines in Combustion Engines
Impact of water content in fuel for smoke opacity
- 2 September 2023
- Published by Polish Scientific Society of Combustion Engines in Combustion Engines
Open AccessImpact of water content in fuel for smoke opacity
- Open Access
- 24 April 2022
- Published by Polish Scientific Society of Combustion Engines in Combustion Engines
Possible applications of prechambers in hydrogen internal combustion engines
The use of hydrogen as a fuel for an internal combustion engines has caused many problems for years, the most significant of which seems to be the excessive emission of nitrogen oxides and the tendency to knock combustion. In order to ensure better control of the combustion process in a internal combustion engine powered by hydrogen, it has been proposed to use a split combustion chamber solution. Following paper contains a description of a hydrogen combustion system that includes an analysis of possible technical solutions. The considerations take into account the issues of the dual nature of hydrogen knocking and the problem of burning a stratified charge of a hydrogen-air mixture in a cylinder.
- 24 April 2022
- Published by Polish Scientific Society of Combustion Engines in Combustion Engines
Open AccessPossible applications of prechambers in hydrogen internal combustion engines
The use of hydrogen as a fuel for an internal combustion engines has caused many problems for years, the most significant of which seems to be the excessive emission of nitrogen oxides and the tendency to knock combustion. In order to ensure better control of the combustion process in a internal combustion engine powered by hydrogen, it has been proposed to use a split combustion chamber solution. Following paper contains a description of a hydrogen combustion system that includes an analysis of possible technical solutions. The considerations take into account the issues of the dual nature of hydrogen knocking and the problem of burning a stratified charge of a hydrogen-air mixture in a cylinder.
- Open Access
Influence of a Passenger Position Seating on Recline Seat on a Head Injury during a Frontal Crash
Presently, most passive safety tests are performed with a precisely specified seat position and carefully seated ATD (anthropomorphic test device) dummies. Facing the development of autonomous vehicles, as well as the need for safety verification during crashes with various seat positions such research is even more urgently needed. Apart from the numerical environment, the existing testing equipment is not validated to perform such an investigation. For example, ATDs are not validated for nonstandard seatback positions, and the most accurate method of such research is volunteer tests. The study presented here was performed on a sled test rig utilizing a 50cc Hybrid III dummy according to a full factorial experiment. In addition, input factors were selected in order to verify a safe test condition for surrogate testing. The measured value was head acceleration, which was used for calculation of a head injury criterion. What was found was an optimal seat angle −117°—at which the head injury criteria had the lowest represented value. Moreover, preliminary body dynamics showed a danger of whiplash occurrence for occupants in a fully-reclined seat.
Open AccessInfluence of a Passenger Position Seating on Recline Seat on a Head Injury during a Frontal Crash
Presently, most passive safety tests are performed with a precisely specified seat position and carefully seated ATD (anthropomorphic test device) dummies. Facing the development of autonomous vehicles, as well as the need for safety verification during crashes with various seat positions such research is even more urgently needed. Apart from the numerical environment, the existing testing equipment is not validated to perform such an investigation. For example, ATDs are not validated for nonstandard seatback positions, and the most accurate method of such research is volunteer tests. The study presented here was performed on a sled test rig utilizing a 50cc Hybrid III dummy according to a full factorial experiment. In addition, input factors were selected in order to verify a safe test condition for surrogate testing. The measured value was head acceleration, which was used for calculation of a head injury criterion. What was found was an optimal seat angle −117°—at which the head injury criteria had the lowest represented value. Moreover, preliminary body dynamics showed a danger of whiplash occurrence for occupants in a fully-reclined seat.
- Open Access
- 2 November 2021
- Published by Polish Scientific Society of Combustion Engines in Combustion Engines
- Vol. 189 (2) , 89-93
Method of verifying the emission level of the exhaust components of a special vehicle in relation to EURO III standard in road conditions
The following article presents the method of verification of EURO III standard in real life conditions for special vehicles. The test object qualified as a special vehicle of N3G category was tested in road conditions along a defined route, and then the obtained measurement results were compared to the exhaust emission standard (EURO III) applicable for this vehicle in transient testing mode. A method of comparing the emission factors in road conditions with the indicators obtained on the engine dynamometer was proposed. An AVL mobile exhaust gas analyzers (PEMS) dedicated for the Real Driving Emissions (RDE) road tests were used in the research.
- 2 November 2021
- Published by Polish Scientific Society of Combustion Engines in Combustion Engines
- Vol. 189 (2) , 89-93
Open AccessMethod of verifying the emission level of the exhaust components of a special vehicle in relation to EURO III standard in road conditions
The following article presents the method of verification of EURO III standard in real life conditions for special vehicles. The test object qualified as a special vehicle of N3G category was tested in road conditions along a defined route, and then the obtained measurement results were compared to the exhaust emission standard (EURO III) applicable for this vehicle in transient testing mode. A method of comparing the emission factors in road conditions with the indicators obtained on the engine dynamometer was proposed. An AVL mobile exhaust gas analyzers (PEMS) dedicated for the Real Driving Emissions (RDE) road tests were used in the research.