Satyanarayana Kokkula
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Satyanarayana Kokkula has a total of 52 co-authors. Here are the top co-authors by number of shared publications:
Gerrit Muller
University of South‐Eastern Norway Kongsberg Norway
9 shared publications- Gerrit Muller
Department of Science and Industry Systems, University of South-Eastern Norway, 3616 Kongsberg, Norway
8 shared publications - Elisabet Syverud
University of South‐Eastern Norway
3 shared publications - Giancarlo Guizzardi
University of Twente
3 shared publications - Joao Paulo Andrade Almeida
Federal University of Espírito Santo
3 shared publications - Rodrigo Fernandes Calhau
Federal Institute of Espírito Santo
3 shared publications
Latest Publications
- 9 October 2025
- Published by Wiley in INCOSE International Symposium
A Proposal for Making an Information Model for an Acquisition Organization
Norwegian Defence Materiel Agency (NDMA) acquires military systems for use in the Norwegian Armed Forces (NAF). Acquisitions are organized as projects, and at any given time, more than 200 projects of varying complexity are running. Projects last for several years, and a lot of information is created and shared between NDMA, NAF, and the suppliers during the project phases. In this research we propose an information model by collecting information elements from existing processes and presenting them in a coherent model. The information model is described in three different ways using systemigram, logical model, and physical model. We validated the proposed model in an internal training session for NDMA employees, where we found that the systemigram was a suitable tool for training new project members. The main benefit of the information model is to shorten the project time, as demonstrated by an estimated time saving up to 19% using the Constructive Systems Engineering Cost Model. Further validation of the proposed information model on a complete project is required.
- 9 October 2025
- Published by Wiley in INCOSE International Symposium
A Proposal for Making an Information Model for an Acquisition Organization
Norwegian Defence Materiel Agency (NDMA) acquires military systems for use in the Norwegian Armed Forces (NAF). Acquisitions are organized as projects, and at any given time, more than 200 projects of varying complexity are running. Projects last for several years, and a lot of information is created and shared between NDMA, NAF, and the suppliers during the project phases. In this research we propose an information model by collecting information elements from existing processes and presenting them in a coherent model. The information model is described in three different ways using systemigram, logical model, and physical model. We validated the proposed model in an internal training session for NDMA employees, where we found that the systemigram was a suitable tool for training new project members. The main benefit of the information model is to shorten the project time, as demonstrated by an estimated time saving up to 19% using the Constructive Systems Engineering Cost Model. Further validation of the proposed information model on a complete project is required.
- 9 October 2025
- Published by Wiley in INCOSE International Symposium
Integrating Concept of Operations in Prefabrication Processes for Effective Construction Projects: A Case Study on Plumbing Systems
This study examines how a Concept of Operations model integrated into a prefabrication process addresses the challenges of project cost and delivery time in plumbing operations from a technical contractor’s perspective. First, we analyzed the process flow to identify the pain points faced in the plumbing process and developed an As-Is Concept of operation model. We identified the factors affecting prefabrication of cost, labor, time, and logistics as provided by state-of-the-art. Second, we mapped out the workflow and proposed an improved model that addresses the challenges, with findings showing improvements in both time and cost savings for projects. Finally, we supported the findings with a cost model and evaluated the proposed Concept of the operations model with industry experts. These experts foresee the proposed model as a good recommendation for rethinking the process and setting up a streamlined prefabrication line. With the proposed model, we made an estimation for a selected building site, which revealed time saving of 1911 hours translating to 573 KNOK. To verify our results, we suggest additional testing before proceeding with full-scale implementation on a construction project.
- 9 October 2025
- Published by Wiley in INCOSE International Symposium
Integrating Concept of Operations in Prefabrication Processes for Effective Construction Projects: A Case Study on Plumbing Systems
This study examines how a Concept of Operations model integrated into a prefabrication process addresses the challenges of project cost and delivery time in plumbing operations from a technical contractor’s perspective. First, we analyzed the process flow to identify the pain points faced in the plumbing process and developed an As-Is Concept of operation model. We identified the factors affecting prefabrication of cost, labor, time, and logistics as provided by state-of-the-art. Second, we mapped out the workflow and proposed an improved model that addresses the challenges, with findings showing improvements in both time and cost savings for projects. Finally, we supported the findings with a cost model and evaluated the proposed Concept of the operations model with industry experts. These experts foresee the proposed model as a good recommendation for rethinking the process and setting up a streamlined prefabrication line. With the proposed model, we made an estimation for a selected building site, which revealed time saving of 1911 hours translating to 573 KNOK. To verify our results, we suggest additional testing before proceeding with full-scale implementation on a construction project.
- 6 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Systems Journal
- Vol. 19 (1) , 43-54
Detection of Detrimental Weak Emergent Behavior Considering Operational Factors: A Case Study in Search and Rescue
This article applies the design of experiments approach for detecting detrimental weak emergent behavior of an autonomous surface vessel operating in a dynamic environment on a search and rescue mission. The research utilizes orthogonal arrays in combination with regression analysis to systematically test the parameter space of an engineered system function. We explored the parameter space of interest and detected where the system model does not comply with a defined measure of effectiveness. The findings from this case study suggest that these methods enable a systematic exploration of the system's parameter space, allowing for the effective detection of detrimental weak emergent behavior. This approach potentially enhances test coverage, expands system operating knowledge and facilitates mitigation efforts more efficiently.
- 6 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Systems Journal
- Vol. 19 (1) , 43-54
Detection of Detrimental Weak Emergent Behavior Considering Operational Factors: A Case Study in Search and Rescue
This article applies the design of experiments approach for detecting detrimental weak emergent behavior of an autonomous surface vessel operating in a dynamic environment on a search and rescue mission. The research utilizes orthogonal arrays in combination with regression analysis to systematically test the parameter space of an engineered system function. We explored the parameter space of interest and detected where the system model does not comply with a defined measure of effectiveness. The findings from this case study suggest that these methods enable a systematic exploration of the system's parameter space, allowing for the effective detection of detrimental weak emergent behavior. This approach potentially enhances test coverage, expands system operating knowledge and facilitates mitigation efforts more efficiently.
- 7 September 2024
- Published by Wiley in INCOSE International Symposium
A Proposal for Model‐Based Systems Engineering Method for Creating Secure Cyber‐Physical Systems
Rising levels of risk as cyber-attackers look to exploit system vulnerabilities threatens the Air Traffic Control industry. Attacks on Air Navigation Service Providers' communications systems may lead to airspace closure and even cause safety issues. This paper presents a novel Model-Based Systems Engineering method that enables systems engineers, in collaboration with system security and software engineers, to perform threat-modeling analysis of cyber-physical systems early in the system development process and incorporate mitigation strategies into the system design. The proposed model-based method covers few security concepts, including misuse cases, system assets, threats, risks, vulnerabilities, and security control identification. The study found that the proposed method is suitable for conducting security analysis for complex cyber-physical systems early in the system development process.
- 7 September 2024
- Published by Wiley in INCOSE International Symposium
A Proposal for Model‐Based Systems Engineering Method for Creating Secure Cyber‐Physical Systems
Rising levels of risk as cyber-attackers look to exploit system vulnerabilities threatens the Air Traffic Control industry. Attacks on Air Navigation Service Providers' communications systems may lead to airspace closure and even cause safety issues. This paper presents a novel Model-Based Systems Engineering method that enables systems engineers, in collaboration with system security and software engineers, to perform threat-modeling analysis of cyber-physical systems early in the system development process and incorporate mitigation strategies into the system design. The proposed model-based method covers few security concepts, including misuse cases, system assets, threats, risks, vulnerabilities, and security control identification. The study found that the proposed method is suitable for conducting security analysis for complex cyber-physical systems early in the system development process.
- Open Access
- 10 May 2024
- Published by Springer Nature in Software and Systems Modeling
- Vol. 23 (3) , 599-601
Correction: Modeling competences in enterprise architecture: from knowledge, skills, and attitudes to organizational capabilities
- 10 May 2024
- Published by Springer Nature in Software and Systems Modeling
- Vol. 23 (3) , 599-601
Open AccessCorrection: Modeling competences in enterprise architecture: from knowledge, skills, and attitudes to organizational capabilities
- 26 March 2024
- Published by Springer Nature
- p. 691-705
Literature Review and Research Design for Systems Integration: Case Study in Defense Systems
- 26 March 2024
- Published by Springer Nature
- p. 691-705
Literature Review and Research Design for Systems Integration: Case Study in Defense Systems
- Open Access
- 5 March 2024
- Published by Springer Nature in Software and Systems Modeling
- Vol. 23 (3) , 559-598
Modeling competences in enterprise architecture: from knowledge, skills, and attitudes to organizational capabilities
Competence-based approaches have received increased attention, as the demand for qualified people with the right combination of competences establishes itself as a major factor of organizational performance. This paper examines how competences can be incorporated into Enterprise Architecture modeling: (i) we identify a key set of competence-related concepts such as knowledge, skills, and attitudes, (ii) analyze and relate them using a reference ontology (grounded on the Unified Foundational Ontology), and (iii) propose a representation strategy for modeling competences and their constituent elements leveraging the ArchiMate language, discussing how the proposed models can fit in enterprise competence-based practices. Our approach is intended to cover two tasks relevant to the combined application of Enterprise Architecture and Competence Modeling: ‘zooming in’ on competences, revealing the relations between competences, knowledge, skills, attitudes and other personal characteristics that matter in organizational performance, and ‘zooming out’ of competences, placing them in the wider context of other personal competences and overall organizational capabilities. An assessment of the representation is offered in the form of an empirical survey.
- 5 March 2024
- Published by Springer Nature in Software and Systems Modeling
- Vol. 23 (3) , 559-598
Open AccessModeling competences in enterprise architecture: from knowledge, skills, and attitudes to organizational capabilities
Competence-based approaches have received increased attention, as the demand for qualified people with the right combination of competences establishes itself as a major factor of organizational performance. This paper examines how competences can be incorporated into Enterprise Architecture modeling: (i) we identify a key set of competence-related concepts such as knowledge, skills, and attitudes, (ii) analyze and relate them using a reference ontology (grounded on the Unified Foundational Ontology), and (iii) propose a representation strategy for modeling competences and their constituent elements leveraging the ArchiMate language, discussing how the proposed models can fit in enterprise competence-based practices. Our approach is intended to cover two tasks relevant to the combined application of Enterprise Architecture and Competence Modeling: ‘zooming in’ on competences, revealing the relations between competences, knowledge, skills, attitudes and other personal characteristics that matter in organizational performance, and ‘zooming out’ of competences, placing them in the wider context of other personal competences and overall organizational capabilities. An assessment of the representation is offered in the form of an empirical survey.
- 20 October 2023
- Published by Springer Nature
- p. 3-20
A System Core Ontology for Capability Emergence Modeling
- 20 October 2023
- Published by Springer Nature
- p. 3-20
A System Core Ontology for Capability Emergence Modeling