Manuel Escudero
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Manuel Escudero has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Diego Pedro Morales
Department of Electronics and Computer Technology, University of Granada, 18071 Granada, Spain
5 shared publications - Noel Rodriguez
Department of Electronics and Computer Technology, University of Granada, 18071 Granada, Spain
5 shared publications - Matteo-Alessandro Kutschak
Infineon Technologies Austria AG, 9500 Villach, Austria
3 shared publications - David Meneses
Infineon Technol Austria AG, A-9500 Villach, Austria
2 shared publications - Alfredo Medina-Garcia
Infineon Technologies AG, Neubiberg, Germany
1 shared publication David Meneses
1 shared publication
Latest Publications
- Open Access
On the Practical Evaluation of the Switching Loss in the Secondary Side Rectifiers of LLC Converters
The switching loss of the secondary side rectifiers in LLC resonant converters can have a noticeable impact on the overall efficiency of the complete power supply and constrain the upper limit of the optimum switching frequencies of the converter. Two are the main contributions to the switching loss in the secondary side rectifiers: on the one hand, the reverse recovery loss (Qrr), most noticeably while operating above the series resonant frequency; and on the other hand, the output capacitance (Coss) hysteresis loss, not previously reported elsewhere, but present in all the operating modes of the converter (under and above the series resonant frequency). In this paper, a new technique is proposed for the measurement of the switching losses in the rectifiers of the LLC and other isolated converters. Moreover, two new circuits are introduced for the isolation and measurement of the Coss hysteresis loss, which can be applied to both high-voltage and low-voltage semiconductor devices. Finally, the analysis is experimentally demonstrated, characterizing the switching loss of the rectifiers in a 3 kW LLC converter (410 V input to 50 V output). Furthermore, the Coss hysteresis loss of several high-voltage and low-voltage devices is experimentally verified in the newly proposed measurement circuits.
Open AccessOn the Practical Evaluation of the Switching Loss in the Secondary Side Rectifiers of LLC Converters
The switching loss of the secondary side rectifiers in LLC resonant converters can have a noticeable impact on the overall efficiency of the complete power supply and constrain the upper limit of the optimum switching frequencies of the converter. Two are the main contributions to the switching loss in the secondary side rectifiers: on the one hand, the reverse recovery loss (Qrr), most noticeably while operating above the series resonant frequency; and on the other hand, the output capacitance (Coss) hysteresis loss, not previously reported elsewhere, but present in all the operating modes of the converter (under and above the series resonant frequency). In this paper, a new technique is proposed for the measurement of the switching losses in the rectifiers of the LLC and other isolated converters. Moreover, two new circuits are introduced for the isolation and measurement of the Coss hysteresis loss, which can be applied to both high-voltage and low-voltage semiconductor devices. Finally, the analysis is experimentally demonstrated, characterizing the switching loss of the rectifiers in a 3 kW LLC converter (410 V input to 50 V output). Furthermore, the Coss hysteresis loss of several high-voltage and low-voltage devices is experimentally verified in the newly proposed measurement circuits.
- Open Access
- 1 September 2020
- Published by MDPI AG in Electronics
- Vol. 9 (9) , 1407
Meminductor Emulator Based on a Modified Antoniou’s Gyrator Circuit
In this work, we presented the design and simulation of a new flux-controlled meminductor emulator based on a modified version of the well-known Antoniou’s inductor simulator circuit. The constitutive theoretical equations of meminductance are presented and subsequently correlated with the electrical behavior of Antoniou’s circuit, hence illustrating its practical meminductive behavior with a proper selection of feedback impedances. After that, the feasibility of a practical implementation using off-the-shelf devices is illustrated firstly for a two-state meminductor and secondly for a continuous-state meminductor by means of SPICE simulations. It was also demonstrated that this emulator can operate at different frequencies and input signals constituting one of the simplest and most versatile meminductor emulators to date.
- 1 September 2020
- Published by MDPI AG in Electronics
- Vol. 9 (9) , 1407
Open AccessMeminductor Emulator Based on a Modified Antoniou’s Gyrator Circuit
In this work, we presented the design and simulation of a new flux-controlled meminductor emulator based on a modified version of the well-known Antoniou’s inductor simulator circuit. The constitutive theoretical equations of meminductance are presented and subsequently correlated with the electrical behavior of Antoniou’s circuit, hence illustrating its practical meminductive behavior with a proper selection of feedback impedances. After that, the feasibility of a practical implementation using off-the-shelf devices is illustrated firstly for a two-state meminductor and secondly for a continuous-state meminductor by means of SPICE simulations. It was also demonstrated that this emulator can operate at different frequencies and input signals constituting one of the simplest and most versatile meminductor emulators to date.
- Open Access
- 30 June 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 116117-116131
Non-Linear Capacitance of Si SJ MOSFETs in Resonant Zero Voltage Switching Applications
The parasitic capacitances of modern Si SJ MOSFETs are characterized by their non-linearity. At high voltages the total stored energy E oss (V DC ) in the output capacitance C oss (v) differs substantially from the energy in an equivalent linear capacitor C oss(tr) storing the same amount of charge. That difference requires the definition of an additional equivalent linear capacitor C oss(er) storing the same amount of energy at a specific voltage. However, the parasitic capacitances of current SiC and GaN devices have a more linear distribution of charge along the voltage. Moreover, the equivalent C oss(tr) and C oss(er) of SiC and GaN devices are smaller than the ones of a Si device with a similar R ds,on . In this work, the impact of the non-linear distribution of charge in the performance and the design of resonant ZVS converters is analyzed. A Si SJ device is compared to a SiC device of equivalent C oss(tr) , and to a GaN device of equivalent C oss(er) , in single device topologies and half-bridge based topologies, in full ZVS and in partial or full hard-switching. A prototype of 3300 W resonant LLC DCDC converter, with nominal 400 V input to 52 V output, was designed and built to demonstrate the validity of the analysis.
- 30 June 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 116117-116131
Open AccessNon-Linear Capacitance of Si SJ MOSFETs in Resonant Zero Voltage Switching Applications
The parasitic capacitances of modern Si SJ MOSFETs are characterized by their non-linearity. At high voltages the total stored energy E oss (V DC ) in the output capacitance C oss (v) differs substantially from the energy in an equivalent linear capacitor C oss(tr) storing the same amount of charge. That difference requires the definition of an additional equivalent linear capacitor C oss(er) storing the same amount of energy at a specific voltage. However, the parasitic capacitances of current SiC and GaN devices have a more linear distribution of charge along the voltage. Moreover, the equivalent C oss(tr) and C oss(er) of SiC and GaN devices are smaller than the ones of a Si device with a similar R ds,on . In this work, the impact of the non-linear distribution of charge in the performance and the design of resonant ZVS converters is analyzed. A Si SJ device is compared to a SiC device of equivalent C oss(tr) , and to a GaN device of equivalent C oss(er) , in single device topologies and half-bridge based topologies, in full ZVS and in partial or full hard-switching. A prototype of 3300 W resonant LLC DCDC converter, with nominal 400 V input to 52 V output, was designed and built to demonstrate the validity of the analysis.
- 15 November 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 35 (7) , 7419-7433
Synchronous Rectifiers Drain Voltage Overshoot Reduction in PSFB Converters
- 15 November 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 35 (7) , 7419-7433
Synchronous Rectifiers Drain Voltage Overshoot Reduction in PSFB Converters
- Open Access
A Practical Approach to the Design of a Highly Efficient PSFB DC-DC Converter for Server Applications
The phase shift full bridge (PSFB) is a widely known isolated DC-DC converter topology commonly used in medium to high power applications, and one of the best candidates for the front-end DC-DC converter in server power supplies. Since the server power supplies consume an enormous amount of power, the most critical issue is to achieve high efficiency. Several organizations promoting electrical energy efficiency, like the 80 PLUS, keep introducing higher efficiency certifications with growing requirements extending also to light loads. The design of a high efficiency PSFB converter is a complex problem with many degrees of freedom which requires of a sufficiently accurate modeling of the losses and of efficient design criteria. In this work a losses model of the converter is proposed as well as design guidelines for the efficiency optimization of PSFB converter. The model and the criteria are tested with the redesign of an existing reference PSFB converter of 1400 W for server applications, with wide input voltage range, nominal 400 V input and 12 V output; achieving 95.85% of efficiency at 50% of the load. A new optimized prototype of PSFB was built with the same specifications, achieving a peak efficiency of 96.68% at 50% of the load.
Open AccessA Practical Approach to the Design of a Highly Efficient PSFB DC-DC Converter for Server Applications
The phase shift full bridge (PSFB) is a widely known isolated DC-DC converter topology commonly used in medium to high power applications, and one of the best candidates for the front-end DC-DC converter in server power supplies. Since the server power supplies consume an enormous amount of power, the most critical issue is to achieve high efficiency. Several organizations promoting electrical energy efficiency, like the 80 PLUS, keep introducing higher efficiency certifications with growing requirements extending also to light loads. The design of a high efficiency PSFB converter is a complex problem with many degrees of freedom which requires of a sufficiently accurate modeling of the losses and of efficient design criteria. In this work a losses model of the converter is proposed as well as design guidelines for the efficiency optimization of PSFB converter. The model and the criteria are tested with the redesign of an existing reference PSFB converter of 1400 W for server applications, with wide input voltage range, nominal 400 V input and 12 V output; achieving 95.85% of efficiency at 50% of the load. A new optimized prototype of PSFB was built with the same specifications, achieving a peak efficiency of 96.68% at 50% of the load.
- 19 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 35 (2) , 1377-1391
Modulation Scheme for the Bidirectional Operation of the Phase-Shift Full-Bridge Power Converter
- 19 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 35 (2) , 1377-1391
Modulation Scheme for the Bidirectional Operation of the Phase-Shift Full-Bridge Power Converter