Caio da Silva Mafra Neto
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Caio da Silva Mafra Neto has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Allana Katiussya Silva Pereira
Universidade de São Paulo (USP)
2 shared publications - Dalton Longue Júnior
Department of Plant Science and Animal Science, Southwest Bahia State University (UESB), Vitória da Conquista 45031-900, Brazil
2 shared publications - Ana Márcia Macedo Ladeira Carvalho
Department of Forestry Engineering, Federal University of Viçosa, Viçosa 36570-900, MG, Brazil
1 shared publication - Fernando José Borges Gomes
Forest Products Department, Forestry Institute, Universidade Federal Rural do Rio de Janeiro, BR-465 km 7, Seropédica 23897-000, RJ, Brazil
1 shared publication - Janderson de Jesus Lacerda
Universidade Estadual de Santa Cruz, Ilhéus, BA
1 shared publication - Jorge Luiz Colodette
Federal University of Viçosa
1 shared publication
Latest Publications
- Open Access
- 28 July 2021
- Published by Springer Nature in Scientific Reports
- Vol. 11 (1) , 1-10
Anatomical characterization and technological properties of Pterogyne nitens wood, a very interesting species of the Brazilian Caatinga biome
Pterogyne nitens is commonly known in northeastern Brazil as a lesser-known fast-growing species in the Caatinga biome, which is a difficult place for tree development due to the low natural fertility soils and low availability of water. Due to the importance of expanding information about the anatomical wood properties of Caatinga native species, the aim of this work was to characterize the anatomical elements, to macroscopically describe the wood and make inferences about its possible end-uses. Maceration was performed which enabled measuring fiber dimensions, pore frequency and the following technological indexes: cell wall fraction, slenderness ratio, Runkel index and flexibility coefficient. Histological sections enabled describing the arrangements of the cellular elements in different observation sections and to determine the pore diameter. P. nitens wood has anatomical arrangements characterized by confluent axial parenchyma, being diffuse-porous with the presence of tylosis and heterogeneous/stratified rays (biseriate). The fibers were classified as very short (length 0.81 mm), not flexible and Runkel index 0.82. The pores were few in number with a frequency of 32.9 pores/mm2, distributed in a diffuse format and many were obstructed by tylosis. Based on the anatomical results and considering other technological studies, P. nitens wood is most suitable for charcoal production.
- 28 July 2021
- Published by Springer Nature in Scientific Reports
- Vol. 11 (1) , 1-10
Open AccessAnatomical characterization and technological properties of Pterogyne nitens wood, a very interesting species of the Brazilian Caatinga biome
Pterogyne nitens is commonly known in northeastern Brazil as a lesser-known fast-growing species in the Caatinga biome, which is a difficult place for tree development due to the low natural fertility soils and low availability of water. Due to the importance of expanding information about the anatomical wood properties of Caatinga native species, the aim of this work was to characterize the anatomical elements, to macroscopically describe the wood and make inferences about its possible end-uses. Maceration was performed which enabled measuring fiber dimensions, pore frequency and the following technological indexes: cell wall fraction, slenderness ratio, Runkel index and flexibility coefficient. Histological sections enabled describing the arrangements of the cellular elements in different observation sections and to determine the pore diameter. P. nitens wood has anatomical arrangements characterized by confluent axial parenchyma, being diffuse-porous with the presence of tylosis and heterogeneous/stratified rays (biseriate). The fibers were classified as very short (length 0.81 mm), not flexible and Runkel index 0.82. The pores were few in number with a frequency of 32.9 pores/mm2, distributed in a diffuse format and many were obstructed by tylosis. Based on the anatomical results and considering other technological studies, P. nitens wood is most suitable for charcoal production.
- Open Access
- 10 December 2019
- Published by Universidade Federal de Santa Maria in Ciência Florestal
- Vol. 29 (4) , 1490-1500
Determinação da composição química e potencial de polpação da madeira Pterogyne nitens Tul.
A grande dependência por madeiras das espécies dos gêneros Eucalyptus e Pinus associada à busca por produtos de diferentes qualidades impulsionam estudos acerca de madeiras alternativas para fins industriais, principalmente de espécies do bioma Caatinga, pouco estudado para fins florestais. O objetivo deste estudo foi caracterizar quimicamente a madeira da espécie Pterogyne nitens assim como analisar seu potencial para produção de polpa celulósica. Foram colhidas três árvores representativas de 9 anos, em um plantio experimental localizado na Universidade Estadual do Sudoeste da Bahia – Campus Vitória da Conquista, e amostradas cinco seções do fuste entre as posições 0, 25, 50, 75 e 100% da altura comercial. Os toretes foram transformados em cavacos e homogeneizados formando uma amostra composta representativa para a análise de densidade básica e composição química completa, bem como para a realização da polpação Kraft (cinco cozimentos utilizando diferentes cargas de álcali efetivo objetivando um Número Kappa 18). A densidade básica da madeira Pterogyne nitens foi de 641 kg/m³, sua composição química apresentou 41,9% de celulose, 24,7% de hemiceluloses, 26,5% de lignina, 7,3% de extrativos e 0,5% de cinzas. O rendimento do cozimento para Número Kappa 18 foi 46,4% e viscosidade 1075 dm3/kg. A espécie não se apresentou como uma alternativa interessante para a produção de polpa celulósica (baixo teor de celulose e rendimento depurado), mas bastante promissora para aplicação na área de energia da madeira.
- 10 December 2019
- Published by Universidade Federal de Santa Maria in Ciência Florestal
- Vol. 29 (4) , 1490-1500
Open AccessDeterminação da composição química e potencial de polpação da madeira Pterogyne nitens Tul.
A grande dependência por madeiras das espécies dos gêneros Eucalyptus e Pinus associada à busca por produtos de diferentes qualidades impulsionam estudos acerca de madeiras alternativas para fins industriais, principalmente de espécies do bioma Caatinga, pouco estudado para fins florestais. O objetivo deste estudo foi caracterizar quimicamente a madeira da espécie Pterogyne nitens assim como analisar seu potencial para produção de polpa celulósica. Foram colhidas três árvores representativas de 9 anos, em um plantio experimental localizado na Universidade Estadual do Sudoeste da Bahia – Campus Vitória da Conquista, e amostradas cinco seções do fuste entre as posições 0, 25, 50, 75 e 100% da altura comercial. Os toretes foram transformados em cavacos e homogeneizados formando uma amostra composta representativa para a análise de densidade básica e composição química completa, bem como para a realização da polpação Kraft (cinco cozimentos utilizando diferentes cargas de álcali efetivo objetivando um Número Kappa 18). A densidade básica da madeira Pterogyne nitens foi de 641 kg/m³, sua composição química apresentou 41,9% de celulose, 24,7% de hemiceluloses, 26,5% de lignina, 7,3% de extrativos e 0,5% de cinzas. O rendimento do cozimento para Número Kappa 18 foi 46,4% e viscosidade 1075 dm3/kg. A espécie não se apresentou como uma alternativa interessante para a produção de polpa celulósica (baixo teor de celulose e rendimento depurado), mas bastante promissora para aplicação na área de energia da madeira.
- Open Access
- 30 September 2019
- Published by Universidade Federal de Santa Maria in Ciência Florestal
- Vol. 29 (3) , 1072-1081
Physiological responses of Eucalyptus urophylla young plants treated with biostimulant under water deficit
Biostimulants consist of a mixture of growth regulators that, when they are sprayed on plants, act on hormonal balance, enhancing its development. Stimulate® is a biostimulant composed by indole butyric acid (0.005%), kinetin (0.009%) and gibberellic acid (0.005%) which promotes root growth, improves water and nutrients uptake, and helps restore plant hormonal balance. This research was based on the hypothesis that Stimulate® spraying can be an alternate way to mitigate negative effects of soil water-limiting on plant growth. The experimental work was performed in greenhouse and aimed to evaluate physiological responses of young plants of Eucalyptus urophylla sprayed with different Stimulate® concentrations and submitted to the following irrigation regimes: full, partial and no irrigation. Leaf water potential, relative water content, net photosynthesis, plant height and main root length were measured. Under water-limited conditions, plants sprayed with Stimulate® showed higher net photosynthesis and relative water content had a less decrease, due to osmotic adjustment. Spraying with Stimulate® also provided greater plant height and longer main root length in plants under water deficit. We conclude that the use of Stimulate® can be a viable option to mitigate negative water stress physiological effects in young plants of Eucalyptus urophylla, helping to partially maintain the plant growth under water-limited conditions.
- 30 September 2019
- Published by Universidade Federal de Santa Maria in Ciência Florestal
- Vol. 29 (3) , 1072-1081
Open AccessPhysiological responses of Eucalyptus urophylla young plants treated with biostimulant under water deficit
Biostimulants consist of a mixture of growth regulators that, when they are sprayed on plants, act on hormonal balance, enhancing its development. Stimulate® is a biostimulant composed by indole butyric acid (0.005%), kinetin (0.009%) and gibberellic acid (0.005%) which promotes root growth, improves water and nutrients uptake, and helps restore plant hormonal balance. This research was based on the hypothesis that Stimulate® spraying can be an alternate way to mitigate negative effects of soil water-limiting on plant growth. The experimental work was performed in greenhouse and aimed to evaluate physiological responses of young plants of Eucalyptus urophylla sprayed with different Stimulate® concentrations and submitted to the following irrigation regimes: full, partial and no irrigation. Leaf water potential, relative water content, net photosynthesis, plant height and main root length were measured. Under water-limited conditions, plants sprayed with Stimulate® showed higher net photosynthesis and relative water content had a less decrease, due to osmotic adjustment. Spraying with Stimulate® also provided greater plant height and longer main root length in plants under water deficit. We conclude that the use of Stimulate® can be a viable option to mitigate negative water stress physiological effects in young plants of Eucalyptus urophylla, helping to partially maintain the plant growth under water-limited conditions.