John M. Martinis

We develop a high speed on-chip flux measurement using a capacitively shunted SQUID as an embedded cryogenic transducer and apply this technique to the qualification of a near-term scalable printed circuit board (PCB) package for frequency tunable superconducting qubits. The transducer is a flux-tunable LC resonator where applied flux changes the resonant frequency. We apply a microwave tone to probe this frequency and use a time-domain homodyne measurement to extract the reflected phase as a function of flux applied to the SQUID. The transducer response bandwidth is 2.6 GHz with a maximum gain of 1200°/Φ₀ allowing us to study the settling amplitude to better than 0.1%. We use this technique to characterize on-chip bias line routing and a variety of PCB-based packages and demonstrate that step response settling can vary by orders of magnitude in both settling time and amplitude depending on if normal or superconducting materials are used. By plating copper PCBs in aluminum we measure a step response consistent with the packaging used for existing high-fidelity qubits.

Scaling up to supremacy: Quantum information scientists are getting closer to building a quantum computer that can perform calculations that a classical computer cannot. It has been estimated that such a computer would need around 50 qubits, but scaling up existing architectures to this number is tricky. Neillet al.explore how increasing the number of qubits from five to nine affects the quality of the output of their superconducting qubit device. If, as the number of qubits grows further, the error continues to increase at the same rate, a quantum computer with about 60 qubits and reasonable fidelity might be achievable with current technologies.Science, this issue p.195

Putting photons to work: Interacting quantum particles can behave in peculiar ways. To understand that behavior, physicists have turned to quantum simulation, in which a tunable and clean system can be monitored as it evolves under the influence of interactions. Roushan et al. used a chain of nine superconducting qubits to create effective interactions between normally noninteracting photons and directly measured the energy levels of their system. The interplay of interactions and disorder gave rise to a transition to a localized state. With an increase in the number of qubits, the technique should be able to tackle problems that are inaccessible to classical computers. Science , this issue p. 1175

Fluxless flip-chip bonding using a lead-free solder bumping technique K. Hansen, S. Kousar, D.

Fundamental questions in chemistry and physics may never be answered due to the exponential complexity of the underlying quantum phenomena. A desire to overcome this challenge has sparked a new industry of quantum technologies with the promise that engineered quantum systems can address these hard problems. A key step towards demonstrating such a system will be performing a computation beyond the capabilities of any classical computer, achieving so-called quantum supremacy. Here, using 9 superconducting qubits, we demonstrate an immediate path towards quantum supremacy. By individually tuning the qubit parameters, we are able to generate thousands of unique Hamiltonian evolutions and probe the output probabilities. The measured probabilities obey a universal distribution, consistent with uniformly sampling the full Hilbert-space. As the number of qubits in the algorithm is varied, the system continues to explore the exponentially growing number of states. Combining these large datasets with techniques from machine learning allows us to construct a model which accurately predicts the measured probabilities. We demonstrate an application of these algorithms by systematically increasing the disorder and observing a transition from delocalized states to localized states. By extending these results to a system of 50 qubits, we hope to address scientific questions that are beyond the capabilities of any classical computer.

Josephson junctions form the essential non-linearity for almost all superconducting qubits. The junction is formed when two superconducting electrodes come within $\sim$1 nm of each other. Although the capacitance of these electrodes is a small fraction of the total qubit capacitance, the nearby electric fields are more concentrated in dielectric surfaces and can contribute substantially to the total dissipation. We have developed a technique to experimentally investigate the effect of these electrodes on the quality of superconducting devices. We use $\lambda$/4 coplanar waveguide resonators to emulate lumped qubit capacitors. We add a variable number of these electrodes to the capacitive end of these resonators and measure how the additional loss scales with number of electrodes. We then reduce this loss with fabrication techniques that limit the amount of lossy dielectrics. We then apply these techniques to the fabrication of Xmon qubits on a silicon substrate to improve their energy relaxation times by a factor of 5.

Statistical mechanics is founded on the assumption that all accessible configurations of a system are equally likely. This requires dynamics that explore all states over time, known as ergodic dynamics. In isolated quantum systems, however, the occurrence of ergodic behavior has remained an outstanding question. Here, we demonstrate ergodic dynamics in a small quantum system consisting of only three superconducting qubits. The qubits undergo a sequence of rotations and interactions and we measure the evolution of the density matrix. Maps of the entanglement entropy show that the full system can act like a reservoir for individual qubits, increasing their entropy through entanglement. Surprisingly, these maps bear a strong resemblance to the phase space dynamics in the classical limit; classically chaotic motion coincides with higher entanglement entropy. We further show that in regions of high entropy the full multi-qubit system undergoes ergodic dynamics. Our work illustrates how controllable quantum systems can investigate fundamental questions in non-equilibrium thermodynamics.

A quantum system can behave as a wave or as a particle, depending on the experimental arrangement. When, for example, measuring a photon using a Mach-Zehnder interferometer, the photon acts as a wave if the second beam splitter is inserted, but as a particle if this beam splitter is omitted. The decision of whether or not to insert this beam splitter can be made after the photon has entered the interferometer, as in Wheeler’s famous delayed-choice thought experiment. In recent quantum versions of this experiment, this decision is controlled by a quantum ancilla, while the beam splitter is itself still a classical object. Here, we propose and realize a variant of the quantum delayed-choice experiment. We configure a superconducting quantum circuit as a Ramsey interferometer, where the element that acts as the first beam splitter can be put in a quantum superposition of its active and inactive states, as verified by the negative values of its Wigner function. We show that this enables the wave and particle aspects of the system to be observed with a single setup, without involving an ancilla that is not itself a part of the interferometer. We also study the transition of this quantum beam splitter from a quantum to a classical object due to decoherence, as observed by monitoring the interferometer output.

Weak measurement has provided new insight into the nature of quantum measurement, by demonstrating the ability to extract average state information without fully projecting the system. For single qubit measurements, this partial projection has been demonstrated with violations of the Leggett-Garg inequality. Here we investigate the effects of weak measurement on a maximally entangled Bell state through application of the Hybrid Bell-Leggett-Garg inequality (BLGI) on a linear chain of four transmon qubits. By correlating the results of weak ancilla measurements with subsequent projective readout, we achieve a violation of the BLGI with 27 standard deviations of certainty.

A quantum system can behave as a wave or as a particle, depending on the experimental arrangement. When for example measuring a photon using a Mach-Zehnder interferometer, the photon acts as a wave if the second beam-splitter is inserted, but as a particle if this beam-splitter is omitted. The decision of whether or not to insert this beam-splitter can be made after the photon has entered the interferometer, as in Wheeler's famous delayed-choice thought experiment. In recent quantum versions of this experiment, this decision is controlled by a quantum ancilla, while the beam splitter is itself still a classical object. Here we propose and realize a variant of the quantum delayed-choice experiment. We configure a superconducting quantum circuit as a Ramsey interferometer, where the element that acts as the first beam-splitter can be put in a quantum superposition of its active and inactive states, as verified by the negative values of its Wigner function. We show that this enables the wave and particle aspects of the system to be observed with a single setup, without involving an ancilla that is not itself a part of the interferometer. We also study the transition of this quantum beam-splitter from a quantum to a classical object due to decoherence, as observed by monitoring the interferometer output.