T. M. Benseman
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
T. M. Benseman has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
- Wai Kwong Kwok
Argonne National Laboratory
4 shared publications - Daniel Rosenmann
Argonne National Laboratory
2 shared publications - Fabiano Colauto
Departamento de Física, Universidade Federal de São Carlos, 13565-905 São Carlos, SP, Brazil
2 shared publications K. Kadowaki
Algae Biomass and Energy System (ABES) Research & Development Center, University of Tsukuba, Ibaraki 305-8573, Japan
2 shared publications- Ulrich Welp
Argonne National Laboratory
2 shared publications - Vitalii K. Vlasko-Vlasov
University of Notre Dame
2 shared publications
Latest Publications
- Open Access
- 1 June 2025
- Published by IOP Publishing in Materials Research Express
- Vol. 12 (6) , 066001
Analytical determination of optimal sidewall angle for Bi2Sr2CaCu2O8+δ stacked IJJ terahertz sources
Mesa-shaped stacks of ‘intrinsic’ Josephson junctions in the high-T c superconductor Bi2Sr2CaCu2O8+δ are a promising source of coherent terahertz radiation. These devices consist of current-biased Josephson junctions connected in series, meaning that in order to maximize their THz power output, it is desirable to minimize the resulting spread of DC junction bias voltages, even in the presence of self-heating. In this work we analytically calculate the sidewall profile shape that results in zero junction voltage spread, by treating the heat diffusion equation as approximately linear in the limit in which self-heating of the device is small. The resulting optimal sidewall angle depends strongly upon a number of device parameters. Of these, the most important variables are the intended THz emission frequency, the doping-dependent c-axis electrical resistivity, and the vertical thickness of the stack. The optimal sidewall relative to the substrate always decreases as the intended emission frequency and/or the stack thickness is increased. For Bi2Sr2CaCu2O8+δ doped for maximum T c with p = 0.16 holes per Cu atom and a realistic device thickness of 1 micron, the optimal angle varies non-monotonically with cryogenic bath temperature, but always lies between 25° and 85° for realistic operating temperatures, which range from 10 K up to T c .
- 1 June 2025
- Published by IOP Publishing in Materials Research Express
- Vol. 12 (6) , 066001
Open AccessAnalytical determination of optimal sidewall angle for Bi2Sr2CaCu2O8+δ stacked IJJ terahertz sources
Mesa-shaped stacks of ‘intrinsic’ Josephson junctions in the high-T c superconductor Bi2Sr2CaCu2O8+δ are a promising source of coherent terahertz radiation. These devices consist of current-biased Josephson junctions connected in series, meaning that in order to maximize their THz power output, it is desirable to minimize the resulting spread of DC junction bias voltages, even in the presence of self-heating. In this work we analytically calculate the sidewall profile shape that results in zero junction voltage spread, by treating the heat diffusion equation as approximately linear in the limit in which self-heating of the device is small. The resulting optimal sidewall angle depends strongly upon a number of device parameters. Of these, the most important variables are the intended THz emission frequency, the doping-dependent c-axis electrical resistivity, and the vertical thickness of the stack. The optimal sidewall relative to the substrate always decreases as the intended emission frequency and/or the stack thickness is increased. For Bi2Sr2CaCu2O8+δ doped for maximum T c with p = 0.16 holes per Cu atom and a realistic device thickness of 1 micron, the optimal angle varies non-monotonically with cryogenic bath temperature, but always lies between 25° and 85° for realistic operating temperatures, which range from 10 K up to T c .
- 17 March 2023
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 19 (3) , 034055
Powerful Terahertz Emission from a 8+δ Mesa Operating Above 77 KMesa-shaped structures of the high critical temperature (high-) superconductor contain stacked intrinsic Josephson junctions. As such, they are a promising source of coherent radiation in the “terahertz gap” range, spanning from approximately 0.3 to 2.0 THz. Technological applications of these devices become far more practical if they can be operated at a cryogenic bath temperature of 77 K or higher. Previous works have reported emission from this type of device at high terahertz power levels at lower operating temperatures, 40–60 K, while at observed power levels have generally been low. Here we report generation of 130 μW of coherent power at 0.456 THz from a mesa of doped with 0.16 holes per atom, at a bath temperature of 77.4 K. We find that the device radiates terahertz power when clearly identifiable cavity modes are excited, and that the frequency and bias voltage corresponding to each of these modes is almost independent of . This is consistent with these modes having terahertz-frequency electric fields with very little dependence on vertical position within the mesa. We also find that the terahertz power radiated from any given mode decreases monotonically as the mesa temperature is increased. On the other hand, the low-frequency modes become inaccessible at low temperatures due to retrapping of the intrinsic Josephson junctions, and the maximum radiation power for the emitting mode is typically achieved at the temperature at which the retrapping voltage reaches the resonance voltage for this mode.- 17 March 2023
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 19 (3) , 034055
Powerful Terahertz Emission from a 8+δ Mesa Operating Above 77 KMesa-shaped structures of the high critical temperature (high-) superconductor contain stacked intrinsic Josephson junctions. As such, they are a promising source of coherent radiation in the “terahertz gap” range, spanning from approximately 0.3 to 2.0 THz. Technological applications of these devices become far more practical if they can be operated at a cryogenic bath temperature of 77 K or higher. Previous works have reported emission from this type of device at high terahertz power levels at lower operating temperatures, 40–60 K, while at observed power levels have generally been low. Here we report generation of 130 μW of coherent power at 0.456 THz from a mesa of doped with 0.16 holes per atom, at a bath temperature of 77.4 K. We find that the device radiates terahertz power when clearly identifiable cavity modes are excited, and that the frequency and bias voltage corresponding to each of these modes is almost independent of . This is consistent with these modes having terahertz-frequency electric fields with very little dependence on vertical position within the mesa. We also find that the terahertz power radiated from any given mode decreases monotonically as the mesa temperature is increased. On the other hand, the low-frequency modes become inaccessible at low temperatures due to retrapping of the intrinsic Josephson junctions, and the maximum radiation power for the emitting mode is typically achieved at the temperature at which the retrapping voltage reaches the resonance voltage for this mode.- 7 October 2019
- Published by American Physical Society (APS) in Physical Review B
- Vol. 100 (14) , 144503
Observation of a two-mode resonant state in a mesa device for terahertz emissionUsing low-temperature scanning laser microscopy (LTSLM), we have studied the cavity resonance behavior of a rectangular mesa THz device containing stacked intrinsic Josephson junctions. Our results show that this microscopy technique is an effective means of mapping electromagnetic resonances in this type of device, and we present a detailed analysis of the mechanisms underlying contrast formation in scanning laser microscopy. The LTSLM images reveal that the THz excitation of the stacked junctions contains more than one mode with components along both the long and short axes of the mesa. Thermoluminescent mapping of the same device shows that the mesa temperature is uniform demonstrating that the features seen in LTSLM are electromagnetic in origin, not thermal. Our results also imply that for the purposes of maximizing the THz emission power from mesas, it is important to design devices that are capable of being excited in a single, purely transverse mode.- 7 October 2019
- Published by American Physical Society (APS) in Physical Review B
- Vol. 100 (14) , 144503
Observation of a two-mode resonant state in a mesa device for terahertz emissionUsing low-temperature scanning laser microscopy (LTSLM), we have studied the cavity resonance behavior of a rectangular mesa THz device containing stacked intrinsic Josephson junctions. Our results show that this microscopy technique is an effective means of mapping electromagnetic resonances in this type of device, and we present a detailed analysis of the mechanisms underlying contrast formation in scanning laser microscopy. The LTSLM images reveal that the THz excitation of the stacked junctions contains more than one mode with components along both the long and short axes of the mesa. Thermoluminescent mapping of the same device shows that the mesa temperature is uniform demonstrating that the features seen in LTSLM are electromagnetic in origin, not thermal. Our results also imply that for the purposes of maximizing the THz emission power from mesas, it is important to design devices that are capable of being excited in a single, purely transverse mode.- Open Access
- 22 May 2017
- Published by American Physical Society (APS) in Physical Review B
- Vol. 95 (17) , 174514
Manipulating Abrikosov vortices with soft magnetic stripes
Tuning the polarization of a periodic array of magnetic stripes on top of a superconducting film allows control of Abrikosov vortex motion. Using direct magneto-optical imaging of the vortex patterns, we demonstrate that the proximity of the magnetic stripe ends to the edges of the superconducting film can strongly alter the vortex dynamics. We observe qualitatively different vortex behavior when the stripes overlap with the film edges. From the resulting unique magnetic flux patterns, we calculate the magnetic pinning strength of our stripe array and study effects of the modified edge barrier on vortex guidance and gating that result from different polarizations of the stripes.
- 22 May 2017
- Published by American Physical Society (APS) in Physical Review B
- Vol. 95 (17) , 174514
Open AccessManipulating Abrikosov vortices with soft magnetic stripes
Tuning the polarization of a periodic array of magnetic stripes on top of a superconducting film allows control of Abrikosov vortex motion. Using direct magneto-optical imaging of the vortex patterns, we demonstrate that the proximity of the magnetic stripe ends to the edges of the superconducting film can strongly alter the vortex dynamics. We observe qualitatively different vortex behavior when the stripes overlap with the film edges. From the resulting unique magnetic flux patterns, we calculate the magnetic pinning strength of our stripe array and study effects of the modified edge barrier on vortex guidance and gating that result from different polarizations of the stripes.
- Open Access
- 15 November 2016
- Published by Springer Nature in Scientific Reports
- Vol. 6 (1) , 36847
Triode for Magnetic Flux Quanta
In an electronic triode, the electron current emanating from the cathode is regulated by the electric potential on a grid between the cathode and the anode. Here we demonstrate a triode for single quantum magnetic field carriers, where the flow of individual magnetic vortices in a superconducting film is regulated by the magnetic potential of striae of soft magnetic strips deposited on the film surface. By rotating an applied in-plane field, the magnetic strip potential can be varied due to changes in the magnetic charges at the strip edges, allowing accelerated or retarded motion of magnetic vortices inside the superconductor. Scaling down our design and reducing the gap width between the magnetic stripes will enable controlled manipulation of individual vortices and creation of single flux quantum circuitry for novel high-speed low-power superconducting electronics.
- 15 November 2016
- Published by Springer Nature in Scientific Reports
- Vol. 6 (1) , 36847
Open AccessTriode for Magnetic Flux Quanta
In an electronic triode, the electron current emanating from the cathode is regulated by the electric potential on a grid between the cathode and the anode. Here we demonstrate a triode for single quantum magnetic field carriers, where the flow of individual magnetic vortices in a superconducting film is regulated by the magnetic potential of striae of soft magnetic strips deposited on the film surface. By rotating an applied in-plane field, the magnetic strip potential can be varied due to changes in the magnetic charges at the strip edges, allowing accelerated or retarded motion of magnetic vortices inside the superconductor. Scaling down our design and reducing the gap width between the magnetic stripes will enable controlled manipulation of individual vortices and creation of single flux quantum circuitry for novel high-speed low-power superconducting electronics.
- 1 January 2008
- Published by Elsevier in Physica C: Superconductivity and its Applications
- Vol. 468 (1) , 81-87
In-plane oxygen diffusion in single crystals of- 1 January 2008
- Published by Elsevier in Physica C: Superconductivity and its Applications
- Vol. 468 (1) , 81-87
In-plane oxygen diffusion in single crystals of