Guo-Hui Lei
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Guo-Hui Lei has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
Charles Wang Wai Ng
Hohai University
2 shared publicationsAbraham Chung Fai Chiu
Geotechnical Research Institute, Hohai University
1 shared publication- Cuiwei Fu
State Key Laboratory of Coastal and Offshore Engineering
1 shared publication - Dayong Li
Shandong University of Science and Technology
1 shared publication F.X. Liu
Key Laboratory of Geomechanics and Embankment Engineering of the Ministry of Education, Geotechnical Research Institute, Hohai University, 1 Xikang Road, Nanjing, Jiangsu 210024, P.R. China
1 shared publication- Fei Zhang
Ph.D. Student, Key Laboratory of Ministry of Education for Geomechanics and Embankment Engineering, Hohai Univ., No. 1, Nanjing 210098, China
1 shared publication
Latest Publications
- Open Access
- 14 January 2026
- Published by MDPI AG in Applied Sciences
- Vol. 16 (2) , 858
Evaluating the Effects of Pore Tortuosity on the Propagation of Compressional Waves in Saturated Soils
In the wave theory of saturated soils, pore tortuosity is an important physical property for quantifying the added mass force caused by the relative acceleration between solid and liquid phases. However, this inertial force is often ignored for simplicity in practical applications. To investigate the influence of pore tortuosity on the propagation of compressional waves in saturated soils, a system of generalized governing equations for one-dimensional infinitesimal strain elastic waves is solved using the Laplace transform method. Semi-analytical solutions are obtained for the spatiotemporal distributions of the excess pore water pressure, the pore water velocity, and the soil particle velocity caused by a step load perturbation under undrained conditions. These solutions are used to evaluate the effects of pore tortuosity on the velocities and amplitudes of fast and slow compressional waves. The results show that pore tortuosity has an insignificant effect on the propagation of fast compressional waves, but for slow compressional waves, the larger the pore tortuosity is, the lower the wave velocity and the larger the wave amplitude. Ignoring the influence of pore tortuosity can lead to an underestimation of the arrival time of slow compressional wave. The propagation of this wave is limited to a distance of approximately 1 m away from the loading boundary. This research finding is purely theoretical. For further experimental validation, it is suggested to detect the slow compressional wave by placing miniature acoustic receiving transducers as close as possible to the loading or transmitting surface. The proposed solutions are also useful for calibrating sophisticated numerical codes for dynamic consolidation of saturated soils and wave transmission in porous media.
- 14 January 2026
- Published by MDPI AG in Applied Sciences
- Vol. 16 (2) , 858
Open AccessEvaluating the Effects of Pore Tortuosity on the Propagation of Compressional Waves in Saturated Soils
In the wave theory of saturated soils, pore tortuosity is an important physical property for quantifying the added mass force caused by the relative acceleration between solid and liquid phases. However, this inertial force is often ignored for simplicity in practical applications. To investigate the influence of pore tortuosity on the propagation of compressional waves in saturated soils, a system of generalized governing equations for one-dimensional infinitesimal strain elastic waves is solved using the Laplace transform method. Semi-analytical solutions are obtained for the spatiotemporal distributions of the excess pore water pressure, the pore water velocity, and the soil particle velocity caused by a step load perturbation under undrained conditions. These solutions are used to evaluate the effects of pore tortuosity on the velocities and amplitudes of fast and slow compressional waves. The results show that pore tortuosity has an insignificant effect on the propagation of fast compressional waves, but for slow compressional waves, the larger the pore tortuosity is, the lower the wave velocity and the larger the wave amplitude. Ignoring the influence of pore tortuosity can lead to an underestimation of the arrival time of slow compressional wave. The propagation of this wave is limited to a distance of approximately 1 m away from the loading boundary. This research finding is purely theoretical. For further experimental validation, it is suggested to detect the slow compressional wave by placing miniature acoustic receiving transducers as close as possible to the loading or transmitting surface. The proposed solutions are also useful for calibrating sophisticated numerical codes for dynamic consolidation of saturated soils and wave transmission in porous media.
- 4 June 2025
- Published by Springer Nature in Acta Geotechnica
- Vol. 20 (9) , 4483-4502
Determination of finite-strain consolidation properties from one-dimensional CRD testing
- 4 June 2025
- Published by Springer Nature in Acta Geotechnica
- Vol. 20 (9) , 4483-4502
Determination of finite-strain consolidation properties from one-dimensional CRD testing
- 12 March 2024
- Published by Springer Nature in Acta Geotechnica
- Vol. 19 (5) , 2395-2418
Numerical modeling of free-falling spherical penetrometer–clay–water interactions
- 12 March 2024
- Published by Springer Nature in Acta Geotechnica
- Vol. 19 (5) , 2395-2418
Numerical modeling of free-falling spherical penetrometer–clay–water interactions
- Open Access
- 13 January 2024
- Published by MDPI AG in Applied Sciences
- Vol. 14 (2) , 694
Use of Linear Extrapolation to Estimate Critical State Void Ratio from Drained Triaxial Shear Tests on Dense Cohesionless Soil
Within the strain level attainable in drained triaxial tests, it is not uncommon for dense cohesionless soil to be sheared insufficiently to reach the critical state. Linear fitting of the correlative data from the maximum stress ratio or minimum dilatancy to the end of the test, and then extrapolating these fitted lines to the critical stress ratio or zero dilatancy has been frequently used to estimate the critical state void ratio. However, the linear extrapolation method is empirical and involves different choices of correlative test data, which leads to different estimates. Therefore, a series of simulations of drained tests on dense Toyoura sand are performed using a state-dependent model. Multiple data sets are generated, including void ratio e, volumetric strain εv, stress ratio η, and dilatancy D. The linear extrapolation accuracy of the e–η, e–D, and εv–D data sets is examined. It turns out that the e–η data set is best suited. The goodness of the e–η data set is examined against 18 sets of experimental data on dense sand. In addition, the selection of the start point for extrapolation is shown to influence the estimates. The latter 50% of the post-peak data is found to be reliable.
- 13 January 2024
- Published by MDPI AG in Applied Sciences
- Vol. 14 (2) , 694
Open AccessUse of Linear Extrapolation to Estimate Critical State Void Ratio from Drained Triaxial Shear Tests on Dense Cohesionless Soil
Within the strain level attainable in drained triaxial tests, it is not uncommon for dense cohesionless soil to be sheared insufficiently to reach the critical state. Linear fitting of the correlative data from the maximum stress ratio or minimum dilatancy to the end of the test, and then extrapolating these fitted lines to the critical stress ratio or zero dilatancy has been frequently used to estimate the critical state void ratio. However, the linear extrapolation method is empirical and involves different choices of correlative test data, which leads to different estimates. Therefore, a series of simulations of drained tests on dense Toyoura sand are performed using a state-dependent model. Multiple data sets are generated, including void ratio e, volumetric strain εv, stress ratio η, and dilatancy D. The linear extrapolation accuracy of the e–η, e–D, and εv–D data sets is examined. It turns out that the e–η data set is best suited. The goodness of the e–η data set is examined against 18 sets of experimental data on dense sand. In addition, the selection of the start point for extrapolation is shown to influence the estimates. The latter 50% of the post-peak data is found to be reliable.
- 1 March 2020
- Published by Canadian Science Publishing in Canadian Geotechnical Journal
- Vol. 57 (3) , 466
Discussion of “Analytical model for consolidation settlements under centrifuge environment”
- 1 March 2020
- Published by Canadian Science Publishing in Canadian Geotechnical Journal
- Vol. 57 (3) , 466
Discussion of “Analytical model for consolidation settlements under centrifuge environment”
- 1 December 2017
- Published by Springer Nature in Journal of Central South University
- Vol. 24 (12) , 2914-2923
Role of equal-strain assumption in unit-cell theory for consolidation with vertical drains
- 1 December 2017
- Published by Springer Nature in Journal of Central South University
- Vol. 24 (12) , 2914-2923
Role of equal-strain assumption in unit-cell theory for consolidation with vertical drains
- 1 July 2017
- Published by American Society of Civil Engineers (ASCE) in Journal of Materials in Civil Engineering
- Vol. 29 (7)
Effect of Super-Absorbent Polymer on the Undrained Shear Behavior of Cemented Dredged Clay with High Water Content
A series of isotropically consolidated undrained triaxial tests were performed on cemented clay with super-absorbent polymer (SAP) at high water content to investigate the effect of SAP content on the undrained shear behavior of cemented clay. The test results reveal that the compressibility and undrained shear strength of cemented clay with SAP in a preyield state are independent of the confining pressure. When the confining pressure is higher than the yield stress, the compressibility of the cemented clay with SAP increases dramatically. Meanwhile, the undrained shear strength of the cemented clay with SAP depends on the confining stress in the postyield state. The yield stress measured from the isotropic compression test is consistent with the transitional stress from the bilinear relation between the peak deviator stress and the confining pressure. For certain lime content, the role of SAP is to increase the cementation bond. Hence, the peak deviator stress increases with the increasing SAP content, lime content, and curing time. However, the cementation is shown to have no effect on pore pressure generation within the degree of cementation considered in this study. The linear failure envelope of the cemented clay with SAP is observed for the range of applied stress level in this study and is bounded by the tension cut-off and the critical state line of untreated clay. The difference between the failure line of cemented clay and the critical state line of untreated clay increase with the degree of the cementation bond (i.e., higher SAP content, higher lime content, and longer curing time).
- 1 July 2017
- Published by American Society of Civil Engineers (ASCE) in Journal of Materials in Civil Engineering
- Vol. 29 (7)
Effect of Super-Absorbent Polymer on the Undrained Shear Behavior of Cemented Dredged Clay with High Water Content
A series of isotropically consolidated undrained triaxial tests were performed on cemented clay with super-absorbent polymer (SAP) at high water content to investigate the effect of SAP content on the undrained shear behavior of cemented clay. The test results reveal that the compressibility and undrained shear strength of cemented clay with SAP in a preyield state are independent of the confining pressure. When the confining pressure is higher than the yield stress, the compressibility of the cemented clay with SAP increases dramatically. Meanwhile, the undrained shear strength of the cemented clay with SAP depends on the confining stress in the postyield state. The yield stress measured from the isotropic compression test is consistent with the transitional stress from the bilinear relation between the peak deviator stress and the confining pressure. For certain lime content, the role of SAP is to increase the cementation bond. Hence, the peak deviator stress increases with the increasing SAP content, lime content, and curing time. However, the cementation is shown to have no effect on pore pressure generation within the degree of cementation considered in this study. The linear failure envelope of the cemented clay with SAP is observed for the range of applied stress level in this study and is bounded by the tension cut-off and the critical state line of untreated clay. The difference between the failure line of cemented clay and the critical state line of untreated clay increase with the degree of the cementation bond (i.e., higher SAP content, higher lime content, and longer curing time).
- 19 April 2016
- Published by Springer Nature in Journal of Central South University
- Vol. 23 (4) , 934-943
A general solution for vertical-drain consolidation with impeded drainage boundaries
- 19 April 2016
- Published by Springer Nature in Journal of Central South University
- Vol. 23 (4) , 934-943
A general solution for vertical-drain consolidation with impeded drainage boundaries
- 12 June 2015
- Published by Springer Nature in Journal of Central South University
- Vol. 22 (6) , 2316-2321
Is Terzaghi’s effective stress a stress variable under seepage conditions?
- 12 June 2015
- Published by Springer Nature in Journal of Central South University
- Vol. 22 (6) , 2316-2321
Is Terzaghi’s effective stress a stress variable under seepage conditions?
- 1 September 2013
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 139 (9) , 1528-1538
Stability Charts for 3D Failures of Homogeneous Slopes
A three-dimensional (3D) kinematically admissible rotational failure mechanism is extended from toe failure to include face failure and base failure for homogeneous slopes in both purely cohesive and frictional/cohesive soils. In the strict framework of limit analysis, an analytical approach is derived to obtain the upper bounds on slope stability and the corresponding type of the critical failure mechanism. Compared with the available results from the finite-element limit-analysis method, the 3D rotational failure mechanisms give the best estimate on the upper bound. A set of stability charts is presented in a wide range of parameters for 3D homogeneous slopes under both static and pseudostatic seismic loading conditions. This set is useful in assessing the safety of the 3D homogeneous slopes in practical applications.
- 1 September 2013
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 139 (9) , 1528-1538
Stability Charts for 3D Failures of Homogeneous Slopes
A three-dimensional (3D) kinematically admissible rotational failure mechanism is extended from toe failure to include face failure and base failure for homogeneous slopes in both purely cohesive and frictional/cohesive soils. In the strict framework of limit analysis, an analytical approach is derived to obtain the upper bounds on slope stability and the corresponding type of the critical failure mechanism. Compared with the available results from the finite-element limit-analysis method, the 3D rotational failure mechanisms give the best estimate on the upper bound. A set of stability charts is presented in a wide range of parameters for 3D homogeneous slopes under both static and pseudostatic seismic loading conditions. This set is useful in assessing the safety of the 3D homogeneous slopes in practical applications.