Edward Cussler
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Edward Cussler has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
Mark S. Huberty
Dept. of Chemical Engineering and Materials Science University of Minnesota Minneapolis MN 55455
2 shared publicationsAlon McCormick
Dept. of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, MN, 55455
1 shared publicationAlon V. McCormick
Dept. of Chemical Engineering and Materials Science University of Minnesota Minneapolis MN 55455
1 shared publicationAndrew L. Wagner
Dept. of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, MN, 55455
1 shared publicationAndrew Wagner
Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, MN 55455
1 shared publicationBinay K. Dutta
Dept. of Chemical Engineering, Petroleum Institute, Abu Dhabi, U.A.E.
1 shared publication
Latest Publications
- 7 March 2017
- Published by Wiley in AIChE Journal
- Vol. 63 (5) , 1757-1764
Volume diffusion in purification by sublimation
The amount sublimated of large organic molecules varies with the square of the diameter of the tube in which sublimation occurs. This implies that the velocity profile in the tube is nearly flat, consistent with volume diffusion, but not with laminar flow, Knudsen diffusion, or slip flow. However, molecular simulation calculations show that under the conditions used, the velocity profile is near parabolic when there is no deposition on the tube wall, inconsistent with volume diffusion, but in agreement with laminar flow. These calculations also show that deposition on the wall does result in velocity which is almost constant with radial position. The result is a laminar flow profile which is nearly flat, and hence a total flux proportional to the square of the tube diameter, which is observed both in these simulations and in physical experiments. © 2017 American Institute of Chemical Engineers AIChE J, 63: 1757–1764, 2017
- 7 March 2017
- Published by Wiley in AIChE Journal
- Vol. 63 (5) , 1757-1764
Volume diffusion in purification by sublimation
The amount sublimated of large organic molecules varies with the square of the diameter of the tube in which sublimation occurs. This implies that the velocity profile in the tube is nearly flat, consistent with volume diffusion, but not with laminar flow, Knudsen diffusion, or slip flow. However, molecular simulation calculations show that under the conditions used, the velocity profile is near parabolic when there is no deposition on the tube wall, inconsistent with volume diffusion, but in agreement with laminar flow. These calculations also show that deposition on the wall does result in velocity which is almost constant with radial position. The result is a laminar flow profile which is nearly flat, and hence a total flux proportional to the square of the tube diameter, which is observed both in these simulations and in physical experiments. © 2017 American Institute of Chemical Engineers AIChE J, 63: 1757–1764, 2017
- 27 January 2015
- Published by Wiley in AIChE Journal
- Vol. 61 (4) , 1364-1371
Ammonia synthesis enhanced by magnesium chloride absorption
Conversion to ammonia with Haber–Bosch catalysts can be increased above 95% by selective absorption of ammonia by MgCl2. The maximum conversion depends on reaction and absorption equilibria. At very short times, the measured conversion rate is the same with and without absorption by the MgCl2 salt; the overall rate constants are comparable to those in the literature. At larger times, conversion to ammonia can be over seven times greater with MgCl2 than without. However, the overall rate constants can be over 10 times slower because they are controlled by ammonia diffusion in the solid salt. An approximate, pseudosteady state theory consistent with these results provides a strategy for improving the overall rate while keeping the conversion over 90%. For example, the absorption rates might be increased using smaller particles of absorbent on a porous inert absorbent support. The results provide part of the basis for designing small scale ammonia plants. © 2015 American Institute of Chemical Engineers AIChE J, 61: 1364–1371, 2015
- 27 January 2015
- Published by Wiley in AIChE Journal
- Vol. 61 (4) , 1364-1371
Ammonia synthesis enhanced by magnesium chloride absorption
Conversion to ammonia with Haber–Bosch catalysts can be increased above 95% by selective absorption of ammonia by MgCl2. The maximum conversion depends on reaction and absorption equilibria. At very short times, the measured conversion rate is the same with and without absorption by the MgCl2 salt; the overall rate constants are comparable to those in the literature. At larger times, conversion to ammonia can be over seven times greater with MgCl2 than without. However, the overall rate constants can be over 10 times slower because they are controlled by ammonia diffusion in the solid salt. An approximate, pseudosteady state theory consistent with these results provides a strategy for improving the overall rate while keeping the conversion over 90%. For example, the absorption rates might be increased using smaller particles of absorbent on a porous inert absorbent support. The results provide part of the basis for designing small scale ammonia plants. © 2015 American Institute of Chemical Engineers AIChE J, 61: 1364–1371, 2015
- 21 November 2012
- Published by Springer Nature
- p. 13-39
Chemicals in the Environment, Diffusive Transport
- 21 November 2012
- Published by Springer Nature
- p. 13-39
Chemicals in the Environment, Diffusive Transport
- 21 February 2012
- Published by Wiley in AIChE Journal
- Vol. 58 (12) , 3825-3831
On separation efficiency
Rising energy costs have renewed interest in energy efficient separations. Such efficiencies can be defined as the free energy of unmixing divided by the work done on and the heat added to the process. The greatest efficiencies occur when the energy cost far exceeds any capital cost. In this limit, rate processes are not important, and efficiency is governed by thermodynamics. Efficiencies for gas absorption and stripping are then typically around 50%. The efficiencies of liquid–liquid extractions are lower, especially when one solute is wanted at higher concentration. The efficiencies of membrane separations are higher, but these require high pressure, normally obtained mechanically. As a result, membrane efficiencies should be reduced by any Carnot efficiency of generating the mechanical energy. These results, which are consistent with earlier estimates for distillation, have implications for carbon dioxide capture as a route to mitigating global warming. © 2012 American Institute of Chemical Engineers AIChE J, 2012
- 21 February 2012
- Published by Wiley in AIChE Journal
- Vol. 58 (12) , 3825-3831
On separation efficiency
Rising energy costs have renewed interest in energy efficient separations. Such efficiencies can be defined as the free energy of unmixing divided by the work done on and the heat added to the process. The greatest efficiencies occur when the energy cost far exceeds any capital cost. In this limit, rate processes are not important, and efficiency is governed by thermodynamics. Efficiencies for gas absorption and stripping are then typically around 50%. The efficiencies of liquid–liquid extractions are lower, especially when one solute is wanted at higher concentration. The efficiencies of membrane separations are higher, but these require high pressure, normally obtained mechanically. As a result, membrane efficiencies should be reduced by any Carnot efficiency of generating the mechanical energy. These results, which are consistent with earlier estimates for distillation, have implications for carbon dioxide capture as a route to mitigating global warming. © 2012 American Institute of Chemical Engineers AIChE J, 2012
- 12 January 2012
- Published by Wiley in AIChE Journal
- Vol. 58 (11) , 3526-3532
Ammonia absorption at haber process conditions
The kinetics of ammonia absorption into magnesium chloride is measured as ammonia pressure change in the temperature range 170‐430°C. The actual pressure minus that at equilibrium drops quickly, with a half life of less than a minute. It varies with the square‐root of time, suggesting diffusion limited absorption. The diffusion coefficient of ammonia in solid magnesium chloride inferred from these data is on the order 10−11‐10−13 cm2/s, considerably faster than many solid‐phase diffusivities. While optical microscopy and BET surface area experiments indicate recrystallization and agglomeration of the absorbent at ammonia synthesis temperatures, the absorption rate remains high. The dependence of absorption rate on temperature, particle size and the presence of a silica support is also investigated. The results suggest both improved ammonia separation and ways to develop high‐conversion, small‐scale, multifunctional ammonia synthesis reactors. © 2012 American Institute of Chemical Engineers AIChE J, 2012
- 12 January 2012
- Published by Wiley in AIChE Journal
- Vol. 58 (11) , 3526-3532
Ammonia absorption at haber process conditions
The kinetics of ammonia absorption into magnesium chloride is measured as ammonia pressure change in the temperature range 170‐430°C. The actual pressure minus that at equilibrium drops quickly, with a half life of less than a minute. It varies with the square‐root of time, suggesting diffusion limited absorption. The diffusion coefficient of ammonia in solid magnesium chloride inferred from these data is on the order 10−11‐10−13 cm2/s, considerably faster than many solid‐phase diffusivities. While optical microscopy and BET surface area experiments indicate recrystallization and agglomeration of the absorbent at ammonia synthesis temperatures, the absorption rate remains high. The dependence of absorption rate on temperature, particle size and the presence of a silica support is also investigated. The results suggest both improved ammonia separation and ways to develop high‐conversion, small‐scale, multifunctional ammonia synthesis reactors. © 2012 American Institute of Chemical Engineers AIChE J, 2012
- 1 January 2012
- Published by Springer Nature
- p. 2016-2030
Chemicals in the Environment, Diffusive Transport
- 1 January 2012
- Published by Springer Nature
- p. 2016-2030
Chemicals in the Environment, Diffusive Transport
- 7 January 2010
- Published by Wiley in AIChE Journal
- Vol. 56 (2) , 283-288
Designing chemical products requires more knowledge of perception
- 7 January 2010
- Published by Wiley in AIChE Journal
- Vol. 56 (2) , 283-288
Designing chemical products requires more knowledge of perception
- 1 November 2006
- Published by Elsevier in Journal of Membrane Science
- Vol. 284 (1-2) , 431
Erratum to “Hollow fibers as structured packing for olefin/paraffin separations” [J. Membr. Sci. 279 (2006) 61–69]
- 1 November 2006
- Published by Elsevier in Journal of Membrane Science
- Vol. 284 (1-2) , 431
Erratum to “Hollow fibers as structured packing for olefin/paraffin separations” [J. Membr. Sci. 279 (2006) 61–69]
- 15 February 2006
- Published by Elsevier in Journal of Membrane Science
- Vol. 270 (1-2) , 13-21
Barrier films made with various lamellar block copolymers
- 15 February 2006
- Published by Elsevier in Journal of Membrane Science
- Vol. 270 (1-2) , 13-21
Barrier films made with various lamellar block copolymers
- 15 April 2003
- Published by Elsevier in Journal of Membrane Science
- Vol. 215 (1-2) , 185-193
Hollow fibers as structured distillation packing
- 15 April 2003
- Published by Elsevier in Journal of Membrane Science
- Vol. 215 (1-2) , 185-193
Hollow fibers as structured distillation packing