Binod Kumar Roul
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Binod Kumar Roul has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
P. P. Rout
Institute of Materials Science
4 shared publicationsS. K. Das
Institute of Physics
4 shared publications- Dipti Ranjan Sahu
Namibia University of Science and Technology
3 shared publications S. K. Pradhan
Norfolk State University
3 shared publicationsS.K. Das
Institute of Materials Science, Planetarium Building, Acharaya Vihar, Bhubaneswar-751013, Odisha, India
3 shared publications- Saroj Kumar Singh
CSIR-Institute of Minerals and Materials Technology, Bhubaneswar, India
3 shared publications
Latest Publications
- 1 January 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1953 (1) , 050015
Dielectric and electrical characteristics of Sr modified Ca1Cu3Ti4O12
This paper mainly reports on the effect of Sr substitution on dielectric and electrical properties of CaCu3Ti4O12 at different temperature and frequency. Preliminary analysis of X-ray diffraction data of sintered samples confirms the reported cubic structure. Study of surface morphology shows that the surface of the samples contains well-defined and uniformly distributed grains. Some electrical parameters (permittivity, tangent loss and impedance) of the materials were measured and analyzed over a wide range of temperature (25 to 315 °C) and frequency (50 to 2x106 Hz). The ultra high dielectric constant and low energy dissipation have been observed in the said experimental conditions of phase-pure prepared compounds. It is expected that the addition of nano-size compounds or oxide will help to enhance the above properties useful for fabrication of super-capacitor.
- 1 January 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1953 (1) , 050015
Dielectric and electrical characteristics of Sr modified Ca1Cu3Ti4O12
This paper mainly reports on the effect of Sr substitution on dielectric and electrical properties of CaCu3Ti4O12 at different temperature and frequency. Preliminary analysis of X-ray diffraction data of sintered samples confirms the reported cubic structure. Study of surface morphology shows that the surface of the samples contains well-defined and uniformly distributed grains. Some electrical parameters (permittivity, tangent loss and impedance) of the materials were measured and analyzed over a wide range of temperature (25 to 315 °C) and frequency (50 to 2x106 Hz). The ultra high dielectric constant and low energy dissipation have been observed in the said experimental conditions of phase-pure prepared compounds. It is expected that the addition of nano-size compounds or oxide will help to enhance the above properties useful for fabrication of super-capacitor.
- 20 July 2017
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 28 (20) , 15676-15684
Inter-grain mediated intrinsic and extrinsic barrier layer network mechanism involved in Ca1Cu3Ti4O12 bulk ceramic
- 20 July 2017
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 28 (20) , 15676-15684
Inter-grain mediated intrinsic and extrinsic barrier layer network mechanism involved in Ca1Cu3Ti4O12 bulk ceramic
- 13 February 2015
- Published by Springer Nature in Applied Physics A
- Vol. 119 (1) , 163-168
Structural, magnetic and ferroelectric properties of Ho1−x Ca x Mn1−y Co y O3 (x = 0.05, y = 0.05, 0.1)
- 13 February 2015
- Published by Springer Nature in Applied Physics A
- Vol. 119 (1) , 163-168
Structural, magnetic and ferroelectric properties of Ho1−x Ca x Mn1−y Co y O3 (x = 0.05, y = 0.05, 0.1)
- 1 April 2014
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 363, 77-81
Room temperature magnetism and ferroelectricity in BaTi0.95−xHf0.05CoxO3 ceramics
- 1 April 2014
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 363, 77-81
Room temperature magnetism and ferroelectricity in BaTi0.95−xHf0.05CoxO3 ceramics
- 12 March 2014
- Published by Springer Nature in Applied Physics A
- Vol. 116 (4) , 1897-1903
Diluted magnetic ferroelectric effect in BaTi0.9Hf0.05Co0.05O3 ceramic
- 12 March 2014
- Published by Springer Nature in Applied Physics A
- Vol. 116 (4) , 1897-1903
Diluted magnetic ferroelectric effect in BaTi0.9Hf0.05Co0.05O3 ceramic
- 24 June 2013
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 345, 106-110
Enhancement of magnetic and ferroelectric behaviour in (Ca, Co) co-doped HoMnO 3 multiferroics
- 24 June 2013
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 345, 106-110
Enhancement of magnetic and ferroelectric behaviour in (Ca, Co) co-doped HoMnO 3 multiferroics
- 5 May 2013
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 24 (9) , 3387-3393
Dielectric and magnetic properties of DyMnO3 ceramics
- 5 May 2013
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 24 (9) , 3387-3393
Dielectric and magnetic properties of DyMnO3 ceramics
- 16 February 2013
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 24 (7) , 2493-2499
Effect of Ca doping on enhancement of ferroelectricity and magnetism in HoMnO3 multiferroic system
- 16 February 2013
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 24 (7) , 2493-2499
Effect of Ca doping on enhancement of ferroelectricity and magnetism in HoMnO3 multiferroic system
- 7 February 2013
- Published by Springer Nature in Journal of Electroceramics
- Vol. 30 (4) , 266-271
Structural and magnetic properties of Ba0.98Zn0.02Ti1-xMnxO3 ceramics
- 7 February 2013
- Published by Springer Nature in Journal of Electroceramics
- Vol. 30 (4) , 266-271
Structural and magnetic properties of Ba0.98Zn0.02Ti1-xMnxO3 ceramics
- Open Access
- 1 September 2012
- Published by Tsinghua University Press in Journal of Advanced Ceramics
- Vol. 1 (3) , 241-248
Effect of equiproprotional substitution of Zn and Mn in BaTiO3 ceramic—An index to multiferroic applications
This paper reports that ferromagnetism (FM) can be induced in ferroelectric barium titanate (BaTiO3) ceramic with selection of appropriate substituents like Zn and Mn. High density polycrystalline samples of Zn and Mn substituted BaTiO3 (Ba1−xZn x Ti1−xMn x O3, x=0, 0.02, 0.04, 0.06, 0.08 and 0.1) were prepared using slow step solid state sintering technique to study the effect of equiproprotional substituents on structural, ferroelectric and magnetic properties of BaTiO3 (BTO). High precision electrical and magnetic measurements were carried out along with XRD, XPS, and SEM to understand and co-relate magnetic and ferroelectric hysteresis loop observed at room temperature with different values of ‘x’. It is seen that ferroelectric hysteresis loop (P∼E) is deteriorated (became lossy type) with the increase of Zn and Mn concentration. However, at x=0.1, the material showed the signature of room temperature ferromagnetism, which is an index for BTO to became a promising material for multiferroic applications. M∼H loops observed in Zn and Mn substituted BTO are expected to be due to the formation of oxygen vacancies and exchange interaction induced magnetism.
- 1 September 2012
- Published by Tsinghua University Press in Journal of Advanced Ceramics
- Vol. 1 (3) , 241-248
Open AccessEffect of equiproprotional substitution of Zn and Mn in BaTiO3 ceramic—An index to multiferroic applications
This paper reports that ferromagnetism (FM) can be induced in ferroelectric barium titanate (BaTiO3) ceramic with selection of appropriate substituents like Zn and Mn. High density polycrystalline samples of Zn and Mn substituted BaTiO3 (Ba1−xZn x Ti1−xMn x O3, x=0, 0.02, 0.04, 0.06, 0.08 and 0.1) were prepared using slow step solid state sintering technique to study the effect of equiproprotional substituents on structural, ferroelectric and magnetic properties of BaTiO3 (BTO). High precision electrical and magnetic measurements were carried out along with XRD, XPS, and SEM to understand and co-relate magnetic and ferroelectric hysteresis loop observed at room temperature with different values of ‘x’. It is seen that ferroelectric hysteresis loop (P∼E) is deteriorated (became lossy type) with the increase of Zn and Mn concentration. However, at x=0.1, the material showed the signature of room temperature ferromagnetism, which is an index for BTO to became a promising material for multiferroic applications. M∼H loops observed in Zn and Mn substituted BTO are expected to be due to the formation of oxygen vacancies and exchange interaction induced magnetism.