SPStephen K. Park

Stephen K. Park

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Stephen K. Park has a total of 12 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Electrical resistivity changes not observed with the 28 September 2004 M6.0 Parkfield earthquake on the San Andreas fault, California

    by Stephen K. Park, Jimmy C. Larsen, Tien‐Chang Lee

    An 18 a long experiment to capture changes in electrical resistivity prior to, during, and after a M6 earthquake on the San Andreas fault at Parkfield, California, culminated with an event of that magnitude on 28 September 2004. Resistivity was monitored with a telluric array, giving precisions in measured parameters of 0.2% or less. No coseismic resistivity changes greater than 5% could have occurred or they would have been detected by the array, and any precursory changes would have been much smaller because maximum possible precursory strains were 4000 times smaller than the coseismic strain. Given that the earthquake ruptured directly beneath the telluric array, this experiment places a bound on the amount resistivity might change at the hypocentral location; changes measured with instruments farther from earthquakes can only be smaller. It is still possible that a measurable change with a larger earthquake or other fault geometries are capable of generating larger signals, but our results show clearly that future experiments should be designed with precisions of much better than 0.1% if they are to be successful.


  • The 2004 Parkfield earthquake: Test of the electromagnetic precursor hypothesis

    by Stephen K. Park, William Dalrymple, Jimmy C. Larsen

    A controversy has existed for 30 years concerning the possibility of earthquake prediction using electromagnetic precursors. Long‐term electromagnetic monitoring prior to, during, and after the M6.0 earthquake at Parkfield, California, on 28 September 2004 now provides a definitive test of this hypothesis. During the earthquake our instruments recorded clearly documented electrical signals from an earthquake: impulsive changes of up to +2.5 mV at an electrode located 250 m from the rupture zone followed by a transient decay lasting at least 3 1/4 hours. Similar signals (−1.5 mV) were recorded with the only two M > 5 aftershocks, but their transient decays lasted for only ∼17 min. These signals are unambiguously a result of the earthquake and can be useful in studies of fluid flow in faults, a major current topic in earthquake physics. Patterns in the distribution of transient voltages differ from static stress changes, but are consistent with a small coseismic pressure drop on the fault and fluid flow inward. Signals at a distance of 1 km from the fault are less than 1 mV and are statistically no different from zero in our analysis. Transient voltages for the aftershocks have opposite polarity from those recorded with the main shock and are again maximal close to the fault, suggesting subsequent outward flow from the fault. Finally, there is no evidence of any precursory signal, strongly calling into question previously suggested signals preceding smaller or more distant earthquakes.


  • Mantle heterogeneity beneath eastern California from magnetotelluric measurements

    by Stephen K. Park

    A 300 km long magnetotelluric profile across the Great Valley, Sierra Nevada, and California Basin and Range reveals minimum resistivity differences of 1 order of magnitude at depths from Moho at 30–35 km to depths greater than 200 km. Horizontal wavelengths of 25 km are seen for these changes at depths shallower than 100 km, and the Isabella high seismic wave speed anomaly is present in the section between depths of 100 and 200 km as a minimum tenfold resistivity increase. A transformation from electrical resistivity to temperature and melt fraction using a petrological model and laboratory measurements reveals that partial melt is relatively uncommon and confined primarily to depths between 30 and 100 km. The remainder of the observed resistivity variation is attributed to lateral variations in temperature. Predicted melt fractions match those inferred from Miocene‐Quaternary xenoliths, but modeled temperatures are ∼200°C higher than inferred from thermobarometric analyses of the xenoliths. Possible causes for this discrepancy include an incorrect starting material for the petrological model, exotic conductive phases, higher conductivity due to oxidation state and/or iron content, and diffusion of ions through the solid matrix. I show that hydrogen diffusion or higher oxygen concentrations are plausible explanation for the higher model temperatures. Less than 200 ppm H/106 Si in olivine would increase the conductivity of the matrix sufficiently to allow temperatures inferred from the resistivity section to match those from the xenoliths. A possible source of the hydrogen would be fragments of sinking, metasomatized mantle lithosphere that melted during Cenozoic delamination.


  • Conductivity structure of the San Andreas fault, Parkfield, revisited

    by Stephen K. Park, Jeffery J. Roberts

    A previous interpretation of a high resolution magnetotelluric profile across the San Andreas fault at Parkfield attributed an anomalously conductive region just west of the fault and extending to depths of 3 km to fractured rock saturated with brines. Laboratory measured electrical resistivities of samples of sedimentary rocks known to border the fault to the east are comparable to resistivities of the anomalous zone. We suggest that the anomalous region results from conductive sedimentary rocks in a plunging syncline that is adjacent to the fault, rather than caused by fractured rock. If correct, the current surface trace of the San Andreas fault at Middle Mountain does not form the boundary between the Salinian block and the North American plate. Instead, that boundary is ∼1 km west and collocated with current seismicity.


  • Lithospheric heterogeneity in the Kyrgyz Tien Shan imaged by magnetotelluric studies

    by Robert A. Bielinski, Stephen K. Park, Anatoly Rybin, Vlad Batalev, Shen Jun, Clayton Sears

    A 450 km long north‐south magnetotelluric profile spanning the Tien Shan from Kazakhstan to western China reveals lateral variations in the resistivity of the mantle lithosphere to depths of 140 km. Minimum changes of one order of magnitude in this depth range result from variations in temperature or composition, or both. Higher resistivities beneath a central portion of the range where the Moho is half as deep as elsewhere in the Tien Shan indicate a strong lithospheric block. We propose that this block protects this region of thin crust from appreciable deformation and instead transmits stresses due to India‐Asia plate convergence from the southern to the northern parts of the range.


  • Electrical conductivity images of Quaternary faults and Tertiary detachments in the California Basin and Range

    by Stephen K. Park, Brian Wernicke

    Comparison of an electrical resistivity section derived from magnetotelluric (MT) data to a geologic section extending eastward from the Sierra Nevada near latitude 36°20′N shows that the crust is dominated by steeply dipping conductive features that correlate with active strike‐slip faults. While there is a subhorizontal conductor at a depth ∼20 km beneath some of the profile, it is broken by vertical structures associated with the active strike‐slip faults. The continuous subhorizontal anomalies in the lower crust typically observed in extensional regions are therefore absent in the resistivity section. The present‐day strike‐slip tectonic regime as indicated by geodetic data in this part of the Basin and Range is not producing features that could be inferred to indicate subhorizontal shear zones resulting from lateral crustal flow during extension. Because the Miocene tectonic regime resulted in the formation of metamorphic core complexes and thus was accompanied by such flow, the present regime appears to represent a fundamental transition in the mode of crustal deformation in the region. A serendipitous result of our study was the identification on resistivity sections of carbonate aquifers in the upper crust. Comparison of resistivities from the MT section to measured fluid resistivities from springs and boreholes suggests that the aquifers must be heterogeneous, with more saline brines occupying the deepest portions of the carbonates.


  • Can in situ measurements of mantle electrical conductivity be used to infer properties of partial melts?

    by Stephen K. Park, Mihai N. Ducea

    Constraints on bulk conductivity from magnetotelluric measurements and petrological analyses of late Quaternary peridotite xenoliths from the southern Sierra Nevada allow evaluation of models commonly used to relate electrical conductivity to the physical and chemical state of the upper mantle. In these models, two conductive melts (basalt and sulfide) are embedded in a resistive matrix. Bounds on the amount of sulfide (0.06–0.4%) and the bulk conductivity (0.03–0.1 S/m) place constraints on the degree of interconnection between the melts. Because the sulfide melt is very conductive, even a small fraction of well‐connected melt results in a bulk conductivity larger than 0.1 S/m. Similarly, completely disconnected melts result in bulk conductivities much less than 0.03 S/m. The only models which matched both the bulk conductivity and sulfide bounds consisted of a small fraction (<1%) interconnected basalt melt with a discontinuous sulfide phase. Such a texture is observed in laboratory experiments with much larger sulfide melt fractions, but has not been reported for small melt fractions. A variant of the Hashin‐Shtrikman model and a hybrid model consisting of cascaded Hashin‐Shtrikman calculations were successful in matching the magnetotelluric and petrologic constraints. With a model that appropriately simulates the melt interconnectivity, we suggest that electrical conductivity may be used to infer in situ melt properties in the mantle.


  • Preface

    by Seiya Uyeda, Stephen Park