Y. Huang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Y. Huang has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
C. Zheng
Institute of Oceanology, Chinese Academy of Sciences, Qingdao 266071 (P.R. China)
2 shared publicationsQ. Yu
Institute of Oceanology, Chinese Academy of Sciences, Qingdao 266071 (P.R. China)
2 shared publicationsC. Huo
1 shared publicationY. Zhu
Institute of Oceanology, Chinese Academy of Sciences, Qingdao 266071, PR China
1 shared publication
Latest Publications
- 9 October 2007
- Published by Wiley in Materials and Corrosion
- Vol. 58 (9) , 716-720
Hydrogen permeation behavior and corrosion monitoring of steel in cyclic wet–dry atmospheric environment
Hydrogen permeation of 16Mn steel under a cyclic wet–dry condition was investigated by Devanathan–Stachurski's electrolytic cell with a membrane covered on the exit side by a nickel layer and the weight loss was measured for each wet–dry cycle. The results show that hydrogen permeation current change with different atmospheric environment: distilled water, seawater, and seawater containing 100 ppm H2S. The results show that seawater can induce an increase in the hydrogen permeation current due to the hydrolyzation reaction. And after the increase, equilibrium is reached due to the equilibrium of hydrolyzation reaction effect and the block of the rust layer. On the other hand, H2S contamination also can induce an increase in the maximum hydrogen permeation current due to the hydrolyzation reaction. And H2S contamination delays the time that hydrogen permeation is detected because of the formation of the FeS(1−x) film. The FeS(1−x) film can block the absorption of hydrogen onto the specimen surface. The surface potential change and the pH change of the metal surface control the hydrogen permeation current. And a clear linear correlation exists between the quantities of hydrogen permeated through the 16Mn steel and the weight loss. Based on the linear correlation, we monitored the corrosion rate by monitoring the hydrogen permeation current by a sensor outside. Good coherences were shown between results in laboratory and outside.
- 9 October 2007
- Published by Wiley in Materials and Corrosion
- Vol. 58 (9) , 716-720
Hydrogen permeation behavior and corrosion monitoring of steel in cyclic wet–dry atmospheric environment
Hydrogen permeation of 16Mn steel under a cyclic wet–dry condition was investigated by Devanathan–Stachurski's electrolytic cell with a membrane covered on the exit side by a nickel layer and the weight loss was measured for each wet–dry cycle. The results show that hydrogen permeation current change with different atmospheric environment: distilled water, seawater, and seawater containing 100 ppm H2S. The results show that seawater can induce an increase in the hydrogen permeation current due to the hydrolyzation reaction. And after the increase, equilibrium is reached due to the equilibrium of hydrolyzation reaction effect and the block of the rust layer. On the other hand, H2S contamination also can induce an increase in the maximum hydrogen permeation current due to the hydrolyzation reaction. And H2S contamination delays the time that hydrogen permeation is detected because of the formation of the FeS(1−x) film. The FeS(1−x) film can block the absorption of hydrogen onto the specimen surface. The surface potential change and the pH change of the metal surface control the hydrogen permeation current. And a clear linear correlation exists between the quantities of hydrogen permeated through the 16Mn steel and the weight loss. Based on the linear correlation, we monitored the corrosion rate by monitoring the hydrogen permeation current by a sensor outside. Good coherences were shown between results in laboratory and outside.
- 1 June 2007
- Published by Wiley in Materials and Corrosion
- Vol. 58 (6) , 447-451
The hydrogen permeation investigation of API X56 steel in sea mud
It was found that the corrosion rate of steel in the sea mud with sulfate‐reducing bacteria (SRB) could be as high as 10 times of that in the sea mud without SRB. And the hydrogen permeation reaction would occur when metals were corroded. So it is necessary to investigate the effect of living SRB on hydrogen permeation in the sea mud. Cathodic potential was often added to metals in order to protect them. But hydrogen permeation could be affected by the cathodic potential. So it is also necessary to study the effect of cathodic potential on hydrogen permeation. In this paper, the hydrogen permeation actions of API X56 steel in the sea mud with and without SRB at corrosion and cathodic potential were studied with an improved Devanathan‐Stachurski's electrolytic cell. Experimental results showed that during the growth of SRB, the current density curve of hydrogen permeation was accordant with the growth curve of SRB. But the hydrogen permeation current density of API X56 steel hardly changed in the sterilized sea mud. Compared with the hydrogen permeation current density of API X56 steel in the sterilized sea mud, the hydrogen permeation of API X56 steel in the sea mud could be accelerated by living SRB. Experimental results also showed that the hydrogen permeation current density increased rapidly when the cathodic potential was added to the three‐electrode system of the cathodic cell, and then the hydrogen permeation current density could obtain a stable value slowly. So the cathodic potential added to the cathodic cell could accelerate hydrogen permeation.
- 1 June 2007
- Published by Wiley in Materials and Corrosion
- Vol. 58 (6) , 447-451
The hydrogen permeation investigation of API X56 steel in sea mud
It was found that the corrosion rate of steel in the sea mud with sulfate‐reducing bacteria (SRB) could be as high as 10 times of that in the sea mud without SRB. And the hydrogen permeation reaction would occur when metals were corroded. So it is necessary to investigate the effect of living SRB on hydrogen permeation in the sea mud. Cathodic potential was often added to metals in order to protect them. But hydrogen permeation could be affected by the cathodic potential. So it is also necessary to study the effect of cathodic potential on hydrogen permeation. In this paper, the hydrogen permeation actions of API X56 steel in the sea mud with and without SRB at corrosion and cathodic potential were studied with an improved Devanathan‐Stachurski's electrolytic cell. Experimental results showed that during the growth of SRB, the current density curve of hydrogen permeation was accordant with the growth curve of SRB. But the hydrogen permeation current density of API X56 steel hardly changed in the sterilized sea mud. Compared with the hydrogen permeation current density of API X56 steel in the sterilized sea mud, the hydrogen permeation of API X56 steel in the sea mud could be accelerated by living SRB. Experimental results also showed that the hydrogen permeation current density increased rapidly when the cathodic potential was added to the three‐electrode system of the cathodic cell, and then the hydrogen permeation current density could obtain a stable value slowly. So the cathodic potential added to the cathodic cell could accelerate hydrogen permeation.