Robert J. Pugh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Interests
Robert J. Pugh has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
E. Forssberg
Department of Chemical and Metallurgical Engineering, Division of Mineral Processing, Luleå University of Technology, S-97187 Luleå, Sweden
1 shared publicationHuiting Shen
Changsha Research Institute of Mining and Metallurgy, Changsha, 410012, China
1 shared publicationJohn Ralston
Ian Wark Research Institute, University of South Australia, Mawson Lakes, SA 5095, Australia
1 shared publicationKatarina Theander
Institute for Surface Chemistry, Stockholm, S 11486, Sweden
1 shared publication- Mark William Rutland
KTH Royal Institute of Technology
1 shared publication
Latest Publications
- 22 July 2009
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 338 (1) , 326-327
Joseph Alfred Kitchener (1916–2009)
- 22 July 2009
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 338 (1) , 326-327
Joseph Alfred Kitchener (1916–2009)
- 20 June 2007
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 23 (15) , 7972-7980
Foaming in Chemical Surfactant Free Aqueous Dispersions of Anatase (Titanium Dioxide) Particles
Steady-state dynamic aqueous foams were generated from surfactant-free dispersion of aggregated anatase nanoparticles (in the micrometer size range). In order to tune the particle surfaces, to ensure a critical degree of hydrophobicity (so that they disperse in water and generate foam), the particles were subjected to low-temperature plasma treatment in the presence of a vapor-phase silane coupling agents. From ESCA it was shown that hydrophobization only occurred at a small number of surface sites. Foamability (foam generation) experiments were carried out under well-defined conditions at a range of gas flow rates using the Bikermann Foaming Column.1 The volume of the steady-state foams was determined under constant gas flow conditions, but on removing the gas flow, transient foams with short decay times (<5 s) were observed. The foamability of the steady-state foams was found to be dependent on (a) the time of plasma treatment of the particles (surface hydrophobicity), (b) the particle concentration in the suspension, and (c) the state of dispersion of the particles. High foamability was promoted in the neutral pH regions where the charged particles were highly dispersed. In the low and high pH regions where the particles were coagulated, the foamability was considerably reduced. This behavior was explained by the fact that the large coagula were less easily captured by the bubbles and more easily detached from the interface (during the turbulent foaming conditions) than individual dispersed particles.
- 20 June 2007
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 23 (15) , 7972-7980
Foaming in Chemical Surfactant Free Aqueous Dispersions of Anatase (Titanium Dioxide) Particles
Steady-state dynamic aqueous foams were generated from surfactant-free dispersion of aggregated anatase nanoparticles (in the micrometer size range). In order to tune the particle surfaces, to ensure a critical degree of hydrophobicity (so that they disperse in water and generate foam), the particles were subjected to low-temperature plasma treatment in the presence of a vapor-phase silane coupling agents. From ESCA it was shown that hydrophobization only occurred at a small number of surface sites. Foamability (foam generation) experiments were carried out under well-defined conditions at a range of gas flow rates using the Bikermann Foaming Column.1 The volume of the steady-state foams was determined under constant gas flow conditions, but on removing the gas flow, transient foams with short decay times (<5 s) were observed. The foamability of the steady-state foams was found to be dependent on (a) the time of plasma treatment of the particles (surface hydrophobicity), (b) the particle concentration in the suspension, and (c) the state of dispersion of the particles. High foamability was promoted in the neutral pH regions where the charged particles were highly dispersed. In the low and high pH regions where the particles were coagulated, the foamability was considerably reduced. This behavior was explained by the fact that the large coagula were less easily captured by the bubbles and more easily detached from the interface (during the turbulent foaming conditions) than individual dispersed particles.
- 1 June 2005
- Published by Elsevier in Advances in Colloid and Interface Science
- Vol. 114-115, 239-251
Experimental techniques for studying the structure of foams and froths
- 1 June 2005
- Published by Elsevier in Advances in Colloid and Interface Science
- Vol. 114-115, 239-251
Experimental techniques for studying the structure of foams and froths
- 1 July 2001
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 239 (1) , 209-216
The Influence of pH and Temperature on the Equilibrium and Dynamic Surface Tension of Aqueous Solutions of Sodium Oleate
- 1 July 2001
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 239 (1) , 209-216
The Influence of pH and Temperature on the Equilibrium and Dynamic Surface Tension of Aqueous Solutions of Sodium Oleate
- 1 August 1999
- Published by Elsevier in Resources, Conservation and Recycling
- Vol. 27 (3) , 285-286
Erratum to “A review of plastics waste recycling and the flotation of plastics”
- 1 August 1999
- Published by Elsevier in Resources, Conservation and Recycling
- Vol. 27 (3) , 285-286
Erratum to “A review of plastics waste recycling and the flotation of plastics”
- 1 May 1997
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 125 (1) , 33-46
Calcium soaps in flotation deinking; fundamental studies using surface force and coagulation techniques
- 1 May 1997
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 125 (1) , 33-46
Calcium soaps in flotation deinking; fundamental studies using surface force and coagulation techniques