Junhai Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Junhai Liu has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Xiangjin Kong
Shandong Provincial Key Laboratory of Chemical Energy Storage and Novel Cell Technology, School of Chemistry and Chemical Engineering, Liaocheng University, Liaocheng 252059, China
4 shared publications Shuxiang Wu
M.A. Student, School of Chemistry and Chemical Engineering, Liaocheng Univ., No. 1, Hunan Rd., Dongchangfu District, Liaocheng City, Shandong 252059, China
2 shared publicationsXiaole Li
M.A. Student, School of Chemistry and Chemical Engineering, Liaocheng Univ., No. 1, Hunan Rd., Dongchangfu District, Liaocheng City, Shandong 252059, China
2 shared publicationsCui Shou-Xin
Liaocheng Univ, Sch Phys Sci & Informat Technol, Liaocheng 252059, Peoples R China
1 shared publicationFang Yu-Zhen
Liaocheng Univ, Sch Chem & Chem Engn, Liaocheng 252059, Peoples R China
1 shared publicationKong Xiang-Jin
Liaocheng Univ, Sch Chem & Chem Engn, Liaocheng 252059, Peoples R China
1 shared publication
Latest Publications
- 5 June 2018
- Published by Acta Physica Sinica, Chinese Physical Society and Institute of Physics, Chinese Academy of Sciences in Acta Physica Sinica
- Vol. 67 (11) , 117101
First principle study of electron and band structure of BixBa1-xTiO3
Some perovskite structured catalysts have narrower forbidden band widths than pure TiO2, and they have been widely used in a number of photo-catalytic reactions. The ions in the perovskite may be replaced by other ions while maintaining the structure unchanged for its tailorable character. Bi-Ti-O can form into the typical perovskite composite oxide BiTiO3 under specific preparation conditions. The regulation of the energy gap of the perovskite BaTiO3 can be realized by substituting Bi for Ba to form the BixBa1-xTiO3 perovskite structure to improve its photo-catalytic activity. But the improvement mechanism and the electron and band structures of BixBa1-xTiO3 are still not very clear. In this study, we exhibit a detailed theoretical investigation to predict the electronic structure, band gap and optical absorption properties of BixBa1-xTiO3 structures based on the first-principles plane-wave ultrasoft pseudopotential method. The exchange and correlation interactions are modeled using the generalized gradient approximation and the Perdew-Burke-Ernzerhof exchange-correlation functional. The cutoff kinetic energy of the electron wave function is 340 eV, and the k-point sampling sets 3 x 3 x 3 division of the reciprocal unit cell based on the Monkhorst-Pack scheme. In the geometrical optimization, all forces on atoms are converged into less than 1 x 10(-5) eV/atom, the maximum ionic displacement is within 0.001 angstrom and the total stress tensor decreases to the order of 0.05 GPa. The DFT calculation results reveal that the symmetry and binding energy decline in the BixBa1-xTiO3 structure, and the bond lengths of Ba-O and Ti-O decrease a little after Ba has been substituted by Bi atom, except for the structure of Bi0.5Ba0.5TiO3. The photo-catalysts of BixBa1-xTiO3 are direct band gap semiconductors, and the substitution Bi can regulate the band gaps of BixBa1-xTiO3. The band gaps become wider from x = 0.125 to x = 0.750 with the carrier concentration decreasing, and then decreases with the higher carrier concentration increasing when x = 0.875. It is predicted that the band width of Bi-based perovskite will be much lower than that of Ba-based perovskite. In the case of the density of states we reveal that the top of the valence band is hybrided by O-2p and Bi-6s and the bottom of the conduction band state is mainly constituted by the Ti-3d state. The electron transport properties and carrier types are mainly determined by Ti-3d, O-2p state and Ba-5p electronic states in BaTiO3 and Ti-3d, O-2p, Bi-6s and Bi-6p electronic states in BixBa1-xTiO3 respectively. The absorption spectra indicate that the ultraviolet absorption performance can be improved in BixBa1-xTiO3 system, which may effectively improve the photo-catalytic activity of BaTiO3.
- 5 June 2018
- Published by Acta Physica Sinica, Chinese Physical Society and Institute of Physics, Chinese Academy of Sciences in Acta Physica Sinica
- Vol. 67 (11) , 117101
First principle study of electron and band structure of BixBa1-xTiO3
Some perovskite structured catalysts have narrower forbidden band widths than pure TiO2, and they have been widely used in a number of photo-catalytic reactions. The ions in the perovskite may be replaced by other ions while maintaining the structure unchanged for its tailorable character. Bi-Ti-O can form into the typical perovskite composite oxide BiTiO3 under specific preparation conditions. The regulation of the energy gap of the perovskite BaTiO3 can be realized by substituting Bi for Ba to form the BixBa1-xTiO3 perovskite structure to improve its photo-catalytic activity. But the improvement mechanism and the electron and band structures of BixBa1-xTiO3 are still not very clear. In this study, we exhibit a detailed theoretical investigation to predict the electronic structure, band gap and optical absorption properties of BixBa1-xTiO3 structures based on the first-principles plane-wave ultrasoft pseudopotential method. The exchange and correlation interactions are modeled using the generalized gradient approximation and the Perdew-Burke-Ernzerhof exchange-correlation functional. The cutoff kinetic energy of the electron wave function is 340 eV, and the k-point sampling sets 3 x 3 x 3 division of the reciprocal unit cell based on the Monkhorst-Pack scheme. In the geometrical optimization, all forces on atoms are converged into less than 1 x 10(-5) eV/atom, the maximum ionic displacement is within 0.001 angstrom and the total stress tensor decreases to the order of 0.05 GPa. The DFT calculation results reveal that the symmetry and binding energy decline in the BixBa1-xTiO3 structure, and the bond lengths of Ba-O and Ti-O decrease a little after Ba has been substituted by Bi atom, except for the structure of Bi0.5Ba0.5TiO3. The photo-catalysts of BixBa1-xTiO3 are direct band gap semiconductors, and the substitution Bi can regulate the band gaps of BixBa1-xTiO3. The band gaps become wider from x = 0.125 to x = 0.750 with the carrier concentration decreasing, and then decreases with the higher carrier concentration increasing when x = 0.875. It is predicted that the band width of Bi-based perovskite will be much lower than that of Ba-based perovskite. In the case of the density of states we reveal that the top of the valence band is hybrided by O-2p and Bi-6s and the bottom of the conduction band state is mainly constituted by the Ti-3d state. The electron transport properties and carrier types are mainly determined by Ti-3d, O-2p state and Ba-5p electronic states in BaTiO3 and Ti-3d, O-2p, Bi-6s and Bi-6p electronic states in BixBa1-xTiO3 respectively. The absorption spectra indicate that the ultraviolet absorption performance can be improved in BixBa1-xTiO3 system, which may effectively improve the photo-catalytic activity of BaTiO3.
- 1 February 2018
- Published by American Society of Civil Engineers (ASCE) in Journal of Energy Engineering
- Vol. 144 (1)
Microwave-Assisted Liquefaction of Ulva prolifera over Fe2O3-Modified HY Catalyst
The microwave-assisted liquefaction of Ulva prolifera under atmospheric pressure conditions was investigated for an Fe species–modified HY catalyst. The characterization of Fe/HY confirmed that the Fe species existed in the form of and that the framework of HY remained intact. It was also found that the doped distinctly enhanced the total acid sites of the catalyst and thus increased the bio-oil yield from 40.6 to 52.6%. The GC-MS results demonstrated that the application of the solid catalysts facilitated the production of long-chain compounds (octadecanoic acid methyl ester and hexadecyl ester), thus leading to a distinct decrease in the oxygen content of the bio-fuel. Therefore, the obtained -modified HY exhibits the potential for bio-fuel production from Ulva prolifera.- 1 February 2018
- Published by American Society of Civil Engineers (ASCE) in Journal of Energy Engineering
- Vol. 144 (1)
Microwave-Assisted Liquefaction of Ulva prolifera over Fe2O3-Modified HY Catalyst
The microwave-assisted liquefaction of Ulva prolifera under atmospheric pressure conditions was investigated for an Fe species–modified HY catalyst. The characterization of Fe/HY confirmed that the Fe species existed in the form of and that the framework of HY remained intact. It was also found that the doped distinctly enhanced the total acid sites of the catalyst and thus increased the bio-oil yield from 40.6 to 52.6%. The GC-MS results demonstrated that the application of the solid catalysts facilitated the production of long-chain compounds (octadecanoic acid methyl ester and hexadecyl ester), thus leading to a distinct decrease in the oxygen content of the bio-fuel. Therefore, the obtained -modified HY exhibits the potential for bio-fuel production from Ulva prolifera.- 23 October 2017
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 31 (11) , 12232-12237
Continuous Hydrogenation of Ethyl Levulinate to γ-Valerolactone over Cu-Zn/ZrO2 Catalyst with Alumina Binder
- 23 October 2017
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 31 (11) , 12232-12237
Continuous Hydrogenation of Ethyl Levulinate to γ-Valerolactone over Cu-Zn/ZrO2 Catalyst with Alumina Binder
- 26 July 2016
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 30 (8) , 6500-6504
Efficient Conversion of Levulinic Acid to Ethyl Levulinate over a Silicotungstic-Acid-Modified Commercially Silica-Gel Sphere Catalyst
- 26 July 2016
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 30 (8) , 6500-6504
Efficient Conversion of Levulinic Acid to Ethyl Levulinate over a Silicotungstic-Acid-Modified Commercially Silica-Gel Sphere Catalyst
- Open Access
- 10 July 2014
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 9 (7) , e101744
Influence of Alumina Binder Content on Catalytic Performance of Ni/HZSM-5 for Hydrodeoxygenation of Cyclohexanone
The influence of the amount of alumina binders on the catalytic performance of Ni/HZSM-5 for hydrodeoxygenation of cyclohexanone was investigated in a fixed-bed reactor. N2 sorption, X-ray diffraction, H2-chemisorption and temperature-programmed desorption of ammonia were used to characterize the catalysts. It can be observed that the Ni/HZSM-5 catalyst bound with 30 wt.% alumina binder exhibited the best catalytic performance. The high catalytic performance may be due to relatively good Ni metal dispersion, moderate mesoporosity, and proper acidity of the catalyst.
- 10 July 2014
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 9 (7) , e101744
Open AccessInfluence of Alumina Binder Content on Catalytic Performance of Ni/HZSM-5 for Hydrodeoxygenation of Cyclohexanone
The influence of the amount of alumina binders on the catalytic performance of Ni/HZSM-5 for hydrodeoxygenation of cyclohexanone was investigated in a fixed-bed reactor. N2 sorption, X-ray diffraction, H2-chemisorption and temperature-programmed desorption of ammonia were used to characterize the catalysts. It can be observed that the Ni/HZSM-5 catalyst bound with 30 wt.% alumina binder exhibited the best catalytic performance. The high catalytic performance may be due to relatively good Ni metal dispersion, moderate mesoporosity, and proper acidity of the catalyst.