Dorothy W. Skaf
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Dorothy W. Skaf has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
Kevin C. Brodwater
Villanova University
2 shared publicationsAlexander J. Zoelle
Department of Chemical Engineering, Villanova University, 800 East Lancaster Avenue, Villanova, Pennsylvania 19805, United States
1 shared publicationAnthony R. DeBiase
Department of Chemical Engineering, Villanova University, 800 East Lancaster Avenue, Villanova, Pennsylvania 19805, United States
1 shared publicationChristopher R. Bongo
Villanova University
1 shared publicationMaulin N. Gandhi
Department of Chemical Engineering, Villanova University, 800 East Lancaster Avenue, Villanova, Pennsylvania 19805, United States
1 shared publicationMichael A. Smith
Department of Chemical Engineering, Villanova University, 800 East Lancaster Avenue, Villanova, Pennsylvania 19805, United States
1 shared publication
Latest Publications
- 27 February 2020
- Published by Wiley in Environmental Progress & Sustainable Energy
- Vol. 39 (5)
Removal of titanium dioxide nanoparticles from wastewater using traditional chemical coagulants and chitosan
Alum and ferric chloride were used individually as coagulants to remove P25 TiO2 nanoparticles (NPs) from a simulated wastewater. Previous studies have addressed the use of alum, polyaluminum chloride, chitosan, and polyaluminum chloride with chitosan for coagulation of NPs. A goal of this study was to reduce chemical usage associated with wastewater treatment by examining the coagulation effectiveness of chitosan in conjunction with alum. To further reduce chemical consumption during coagulation, the initial solution pH was limited to 6 or 8. A range of alum doses removed NPs from pH 8 wastewater to achieve residual turbidity <1 NTU. NP removal from pH 6 solutions produced water with residual turbidity <2 NTU only at lower initial NP concentrations. For pH 8 solutions, ferric chloride produced treated water with residual turbidity <1 NTU but at higher doses than required for alum. While chitosan alone did not significantly reduce turbidity, the use of alum and chitosan together reduced the optimal alum dose by 10% and also reduced alum treatment acidification. Therefore, the use of chitosan in coagulation can potentially reduce chemical usage during water treatment and the energy and water consumption associated with chemical production. Use of alum with low chitosan concentrations produces faster settling floc, which can potentially reduce settling tank volume and produce an effluent containing lower aluminum concentrations.
- 27 February 2020
- Published by Wiley in Environmental Progress & Sustainable Energy
- Vol. 39 (5)
Removal of titanium dioxide nanoparticles from wastewater using traditional chemical coagulants and chitosan
Alum and ferric chloride were used individually as coagulants to remove P25 TiO2 nanoparticles (NPs) from a simulated wastewater. Previous studies have addressed the use of alum, polyaluminum chloride, chitosan, and polyaluminum chloride with chitosan for coagulation of NPs. A goal of this study was to reduce chemical usage associated with wastewater treatment by examining the coagulation effectiveness of chitosan in conjunction with alum. To further reduce chemical consumption during coagulation, the initial solution pH was limited to 6 or 8. A range of alum doses removed NPs from pH 8 wastewater to achieve residual turbidity <1 NTU. NP removal from pH 6 solutions produced water with residual turbidity <2 NTU only at lower initial NP concentrations. For pH 8 solutions, ferric chloride produced treated water with residual turbidity <1 NTU but at higher doses than required for alum. While chitosan alone did not significantly reduce turbidity, the use of alum and chitosan together reduced the optimal alum dose by 10% and also reduced alum treatment acidification. Therefore, the use of chitosan in coagulation can potentially reduce chemical usage during water treatment and the energy and water consumption associated with chemical production. Use of alum with low chitosan concentrations produces faster settling floc, which can potentially reduce settling tank volume and produce an effluent containing lower aluminum concentrations.
- 1 December 2019
- Published by American Society of Civil Engineers (ASCE) in Journal of Environmental Engineering
- Vol. 145 (12)
Atmospheric Storage Tank Emission Estimates: Understanding the Calculation Basis and Effects of Uncertainty in Meteorological Inputs
Emissions from organic liquids stored in atmospheric tanks were estimated using semiempirical equations developed by the USEPA and implemented in Microsoft Excel® in order to study the effect of averaging time and meteorological data on estimated emissions. Annual emissions based on average annual weather data were typically lower than the sum of emission estimates based on average monthly weather data. However, some weather conditions displayed the opposite relationship, so the comparison of average time effects must be location specific. For both fixed and floating roof tanks, uncertainty in temperature data had the largest impact on calculated emissions. Solar insolation had little or no impact on emissions, and only external floating roof tank emissions showed a small dependence on wind speed. Trends were the same for the five locations used in the study. Finally, it was shown that the dimensionless pressure function used to calculate emissions from floating roof tanks is nearly proportional to the vapor mole fraction for liquids with vapor pressures appropriate for storage in atmospheric tanks, enabling emission estimates based on vapor mole fraction.
- 1 December 2019
- Published by American Society of Civil Engineers (ASCE) in Journal of Environmental Engineering
- Vol. 145 (12)
Atmospheric Storage Tank Emission Estimates: Understanding the Calculation Basis and Effects of Uncertainty in Meteorological Inputs
Emissions from organic liquids stored in atmospheric tanks were estimated using semiempirical equations developed by the USEPA and implemented in Microsoft Excel® in order to study the effect of averaging time and meteorological data on estimated emissions. Annual emissions based on average annual weather data were typically lower than the sum of emission estimates based on average monthly weather data. However, some weather conditions displayed the opposite relationship, so the comparison of average time effects must be location specific. For both fixed and floating roof tanks, uncertainty in temperature data had the largest impact on calculated emissions. Solar insolation had little or no impact on emissions, and only external floating roof tank emissions showed a small dependence on wind speed. Trends were the same for the five locations used in the study. Finally, it was shown that the dimensionless pressure function used to calculate emissions from floating roof tanks is nearly proportional to the vapor mole fraction for liquids with vapor pressures appropriate for storage in atmospheric tanks, enabling emission estimates based on vapor mole fraction.
- 10 July 2014
- Published by Wiley in Journal of the American Oil Chemists' Society
- Vol. 91 (9) , 1605-1610
Optimization of a Colorimetric Test Method for Quantifying Glycerol in Aqueous Solution
Many analytical methods for glycerol involve chemical techniques or instrumentation that may be unavailable to small biodiesel processors or have potential interactions with other components in the glycerol phase. This work presents an analytical method based on periodate oxidation of glycerol to formaldehyde, which is then quantified using a modification of the Nash test required to remove excess periodate. The method provides a linear calibration over the range of diluted glycerol concentrations from 0.02 to 0.25 mM and is limited at high concentrations by the formation of precipitate during the Nash test. There are no observed interferences from the formic acid coproduct of the glycerol oxidation or from potential contaminants in the crude glycerol, which includes methanol and sodium. Several disaccharides and starch, both as individual solutes or in glycerol solutions, gave no response under the conditions of the described method.
- 10 July 2014
- Published by Wiley in Journal of the American Oil Chemists' Society
- Vol. 91 (9) , 1605-1610
Optimization of a Colorimetric Test Method for Quantifying Glycerol in Aqueous Solution
Many analytical methods for glycerol involve chemical techniques or instrumentation that may be unavailable to small biodiesel processors or have potential interactions with other components in the glycerol phase. This work presents an analytical method based on periodate oxidation of glycerol to formaldehyde, which is then quantified using a modification of the Nash test required to remove excess periodate. The method provides a linear calibration over the range of diluted glycerol concentrations from 0.02 to 0.25 mM and is limited at high concentrations by the formation of precipitate during the Nash test. There are no observed interferences from the formic acid coproduct of the glycerol oxidation or from potential contaminants in the crude glycerol, which includes methanol and sodium. Several disaccharides and starch, both as individual solutes or in glycerol solutions, gave no response under the conditions of the described method.
- 17 August 2012
- Published by Springer Nature in Catalysis Letters
- Vol. 142 (10) , 1175-1179
Comparison of Photocatalytic Hydrogen Production from Glycerol and Crude Glycerol Obtained from Biodiesel Processing
- 17 August 2012
- Published by Springer Nature in Catalysis Letters
- Vol. 142 (10) , 1175-1179
Comparison of Photocatalytic Hydrogen Production from Glycerol and Crude Glycerol Obtained from Biodiesel Processing
- 8 June 2012
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 51 (24) , 8286-8292
Adsorption of Four Representative Biological Compounds onto Graphite Nanofibers
- 8 June 2012
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 51 (24) , 8286-8292
Adsorption of Four Representative Biological Compounds onto Graphite Nanofibers