JLJohanna Lehr

Johanna Lehr

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Johanna Lehr has a total of 16 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Challenges of Rotational Ground Motion Measurements in the Local Distance Range

    by Stefanie Donner, Johanna Lehr, Frank Krüger, Mathias Hoffmann, Manuel Hobiger, Sebastian Heimann

    Since almost two decades, there is a fast and steady progress in understanding the rotational part of the seismic wavefield and exploring possible applications. These achievements are based on studies using simulated data, array-derived measurements, and direct measurements of large (M > 5), teleseismic earthquakes by ringlasers. Since only a couple of years, direct measurements of smaller (M < 3) earthquakes in the local distance range are also feasible. This was made possible due to new instrumentation developments such as portable rotation sensors.From experience with translational measurements, seismology has developed a relatively simple description of the seismic wavefield, as long as the observation is recorded in the source far-field, and site-effects at the point of observation can be neglected by choosing an appropriate frequency range for the analysis.Within the NonDC-BoVo project two portable rotational sensors have been installed in the Vogtland/West-Bohemia earthquake swarm region with the goal to incorporate the rotational waveform data into the inversion for seismic moment tensors. Both sensors are located in an epicentral distance of ~10 km to the center of the swarm activity. So far, we have recorded 197 events with ML ≥ 1 and 6 events with ML ≥ 2.5.Although we are positively surprised how well we can record rotational ground motion of earthquakes with even very small magnitudes, we encountered challenges in the details of the waveform recordings. At the sensor location in Landwüst (D) we recorded events down to ML ~ 0.5 with good signal-to-noise ratio in a frequency range of 5 to 25 Hz. At the second location in Skalna (CZ) the signal-to-noise ratio is worse and we recorded earthquakes only with ML ≥ 1.5. Relocating the sensor to Wernitzgrün (D), about 25 km to the North of Skalna, did not improve the quality of the waveform recordings. Technical issues with the sensor can be ruled out for both locations.Here, we want to present details of the challenges with the rotational ground motion data from these small and local earthquake recordings. First analyses hint to a much stronger effect of local site conditions onto rotational than translational ground motion data. In addition, with the above-mentioned setting, we have to consider the complexities of the near-field part of the wavefield as well. With our contribution we aim to add another aspect to the understanding of the rotational wavefield.

  • Open Access

    A Python tool to monitor noise characteristics in large seismic data bases

    by Johanna Lehr, Klaus Stammler

    Continuous monitoring of data quality is a major issue in seismology because the achievement of robust scientific results depends on the reliability of the underlying data resources. We present a Python package which provides means to perform a systematic analysis of noise data in the time and frequency domain. The tool is designed to process large amounts of channels and years of data. In a first step, average amplitude levels and power spectral densities are computed for large parts - preferably the whole available time range - of the data of a station. Depending on the size of the data set, this processing takes minutes to hours. Therefore, the results are stored in rapidly accessible HDF5-files. Subsequently, they are visualized using color-coded matrix displays (spectrograms) and interactive 3D-figures. The resulting figures give insight to characteristic noise patterns at the station and possible noise sources, like various forms of anthropogenic noise or wind generated noise. Furthermore, changes in noise levels or noise patterns are easily detectable. Such changes either indicate changes in the environmental conditions at the recording site or changes in the recording hardware improperly reflected by the station metadata, often signaling a problem with the metadata. Furthermore, the processed data can easily be restricted to selected times, e.g. to investigate the influence of day/night cycles or to obtain wind-speed dependent spectrograms. In this manner, a comprehensive picture of relevant characteristics at a station site may be acquired.The package is build from established Python libraries like obspy, scipy and h5py. Matplotlib and plotly are used for data visualization. The core functionalities are accessible via command line interface while the underlying API allows for more customized workflows.

  • Open Access

    Rotational ground motion recordings in the West Bohemia / Vogtland region for waveform inversion for seismic moment tensors

    by Stefanie Donner, Johanna Lehr, Mathias Hoffmann, Frank Krüger, Sebastian Heimann, Rafel Abreu, Stephanie Durand

    In synthetic tests, rotational ground motion recordings proved to be beneficial for the wavefrom inversion for seismic moment tensors. In a next step, we want to verify these findings using real measurements. To do so, we installed two broadband rotational collocated to translational ground motion sensors in the West Bohemia / Vogtland area in summer 2022.The area is characterised by regular seismic swarm activity, the last one occurring in December 2021. The seismic swarms are known to be connected with crustal flow of mantle fluids. However, the detailed mechanism of this connection is not well understood yet. Full seismic moment tensors, especially their non-double-couple part, will contribute to investigate the connection between swarm activity and fluid flow. So far, a lacking number of moment tensors and difficulties in the reliability of the non-double-couple part hampered the analysis in the study area. Including rotational ground motion recordings to waveform inversion will help to overcome these difficulties.In seven months, we have recorded 120 events with magnitudes larger than M ≥ 0 in a distance of up to 35 km, thereof 35 around Nový Kostel, the center of the swarm activity. Considering that rotational sensors are about 2-4 times less sensitive than translational sensors (depending on the local phase velocity of the location) this is already a great success. Here, we show details of the sensor installations, first data analysis, and an estimate on the magnitude of completeness from rotational measurements.

  • Open Access

    Magnitude and Interevent Time Statistics of Strombolian Activity of Villarrica Volcano and Inference Regarding the Flow Regime

    by Johanna Lehr, Wolfgang Rabbel

    The different flow regimes of two‐phase gas‐in‐liquid flow—as it occurs in the shallow conduit of basaltic volcanoes—are characterized by distinct frequency‐size distributions of the liquid and gaseous slugs. Assuming that the ascent of gaseous bubbles is indicated by seismic events, we explore the possibility of inferring the flow regime from the frequency distributions of magnitudes and interevent times. Our data set consists of 20,000 volcanic seismic events recorded in early March 2012 at Villarrica Volcano (Chile), which are commonly attributed to Strombolian activity. One crucial factor is the completeness of the catalog in terms of detectable amplitudes, which we assess using a stochastic simulation of the network output based on statistical properties of the ambient seismicity. Magnitudes, at which we consider the catalog complete, show an exponential occurrence. Yet, the simulation approach indicates that low magnitude events occur indeed more sparsely than expected for an exponential distribution, and that the magnitude distribution does not obey the Gutenberg‐Richter law. Interevent times are log‐normally distributed, which implies a preferred recurrence interval. The distributions are consistent with a slug flow regime. They correlate weakly with the preceding magnitude, suggesting that slugs coalesce while ascending.


  • Open Access

    Inferring a shallow degassing model for Villarrica Volcano from seismic explosion signals and SO2 flux

    by Johanna Lehr, Stefan Bredemeyer, Wolfgang Rabbel

    Villarrica is a basaltic volcano with an active lava lake in South Central Chile. The lava lake displays a variety of degassing styles from gentle seething to more violent Strombolian explosions. This activity is accompanied by sequences of transient seismic waveforms suggesting the presence of discrete gas bubbles in the upper magma column. Gas bubbles flow through liquid-filled pipes according to distinct patterns depending on viscosity of the liquid and volumetric gas flow rate. Laboratory experiments indicate that these regimes are characterized by distinct frequency distributions of bubble sizes and spacings. By assuming that these parameters are reflected by the magnitude of the transients and the time between them, we compared their statistical distributions to infer a flow regime for the shallow conduit of Villarrica. The approximately log-normal distributions indicate a sustained slug flow regime in which the gas ascends in trains of conduit-wide gas slugs. The event catalog for our analysis contained about 20,000 events and was generated from 12 days of seismic data from March 2012 acquired by a dense local network. A well-known problem in earthquake statistics is the incompleteness of event catalogs towards low magnitudes due to decreasing detectability in the ambient noise. We estimated the actual distribution of magnitudes by using a Monte Carlo simulation of the event detection based on the statistical properties of the observed seismic noise. The unknown source depth and mechanism introduce further ambiguity regarding the distributions. Nevertheless, we hope to refine the degassing model by taking into account degassing rates, magma properties and more detailed analysis of the nature of the seismic events.

  • Open Access

    Comparative interevent time statistics of degassing and seismic activity at Villarrica Volcano (Chile)

    by Johanna Lehr, Stefan Bredemeyer, Wolfgang Rabbel, Martin Thorwart, Luis Franco

    It is generally assumed that seismic activity at volcanoes is closely connected to degassing processes. Intuitively, one would therefore expect a good correlation between degassing rates and seismic amplitude. However, both examples and counterexamples of such a correlation exist. In this study on Villarrica volcano (Chile), we pursued a different approach to relate gas flux and volcanic seismicity using 3 months of SO$_2$ flux rate measurements and 12 days of seismic recordings from early 2012. We analyzed the statistical distributions of interevent times between transient seismic waveforms commonly associated with explosions and between peaks in the degassing time series. Both event types showed a periodic recurrence with a mode of 20-25 s and around 1 h for transients and degassing, respectively. The normalized interevent times were fitted by almost identical log-normal distributions. Given the actually very different time scales, this similarity potentially indicates a scale-invariant phenomenon. We could reproduce these empirical findings by modelling the occurrence of transients as a renewal process from which the degassing events were derived recursively with increasing probability since the previous degassing event. In this model, the seismic transients could be either produced by degassing processes within the conduit or by gas release at the lava lake surface while the longer intervals of the degassing events may be explained by accumulation of gas either in the magma column or in the juvenile gas plume. Additionally, we analyzed volcano-tectonic events, which behaved very differently from the transients. They showed the clustered occurrence of tectonic earthquakes.

  • Open Access

    Characteristics of seismic activity of Villarrica Volcano

    by Johanna Lehr, Wolfgang Rabbel

    Villarrica is one of the most active and dangerous volcanoes in Chile. During the last decade it consisted of a single open vent hosting an active lava lake which produced mild stombolian explosions, persistent tremor and continuous degassing.We present an analysis of the seismic activity of Villarrica between 2010 and 2012. Periods of increased lava lake activity are characterized by numerous small transient events which exibit a variety of waveforms and spectral characteristics. Statistical analysis of interevent times revealed a periodic occurrence. At comparable volcanic systems (Stromboli, Erebus), such distributions of events indicated unusual periods of activity corresponding to magma injection. Methods of blind signal separation (ICA, PCA) were used to analyse the wavefield. While regional and local tectonic earthquakes can easily be separated, the tremor and transient events from the crater can not.

  • Open Access

    Low‐Frequency Seismicity at Villarrica Volcano: Source Location and Seismic Velocities

    by Johanna Lehr, Felix Eckel, Martin Thorwart, Wolfgang Rabbel

    Villarrica Volcano (Chile) is one of the most active volcanoes in South America. Its low‐frequency (≤5 Hz) seismicity consists of a continuous tremor, overlain by impulsive transient events of higher amplitude in 60‐s intervals. This signal was recorded in March 2012 by an extensive local network, comprising 75 stations and including 6 subarrays. It allowed us to apply and compare three techniques to locate the origin of the seismicity: intersection of propagation directions determined by array analysis, mapping amplitudes, and modeling of amplitude decay. All methods yield almost identical, temporally stable, epicenters inside the summit crater, which confirms earlier attributions of the seismicity to volcanic activity inside the conduit. The discrete transients and the interevent tremor share the same source location. From the dominance of surface waves and the obvious scattering, we infer a source near the surface. For two arrays at the northern and western flank, a dispersion relation was derived, which allowed for the determination ofSwave velocity‐depth functions. At both locations, the velocity structure can be modeled by three layers with interfaces at 100 and 400m depths. The velocities (300 to 3,000 m/s) correspond to pyroclastic material at different states of consolidation. The modeling of the amplitude decay reveals a quality factor around 50.