Ana Beatriz Soares Aguiar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ana Beatriz Soares Aguiar has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Renata Piacentini Rodriguez
Universidade Federal de Alfenas, Brazil
5 shared publications - Giselle Patrícia Sancinetti
Unifal-MG
2 shared publications André Motta Leguisamo
1 shared publicationBruna Moraes
1 shared publicationBruna de Souza Moraes
1 shared publication- Bruna de Souza Moraes
Center for Energy Planning (NIPE), University of Campinas (UNICAMP), Campinas, Brazil
1 shared publication
Latest Publications
- Open Access
- 27 February 2026
- Published by Elsevier in SSRN Electronic Journal
Biogas production from the anaerobic co-digestion of agro-industrial wastes: operation of a s-CSTR reactor under simulated sugarcane season and off-season conditions
Anaerobic digestion (AD) of organic waste is a sustainable alternative for renewable energy generation and efficient waste management. In this study, the potential for biogas production from the co-digestion of vinasse, cattle manure, and slaughterhouse wastewater (blood water) in a semi-continuous stirred tank reactor (s-CSTR) was evaluated. The waste, available throughout the year, was combined in different proportions to enhance methane production and ensure system stability. The reactor operated under mesophilic conditions (35 °C) with varying organic loading rates (OLR) and substrate compositions in the feed. The highest volumetric methane production (VMP) rates were observed in co-digestion systems combining vinasse and cattle manure. A mixing ratio of 5:1 (v/m) at an OLR of 1.7 kg VS m−3 d−1 resulted in 3,981 ± 1,207 NmL CH4 L−1 d−1, whereas a 1:1 (v/m) ratio at an OLR of 4.1 kg VS m−3 d−1 achieved a higher production of 5,269 ± 637 NmL CH4 L−1 d−1. Anaerobic co-digestion of vinasse with cattle manure demonstrated high efficiency, whereas the addition of glycerol as a supplementary organic substrate compromised system stability. During the sugarcane off-season, the operation occurred by mixing blood water and cattle manure (1:2 – v/m), without adding vinasse. The operation was successfully simulated, reaching a VMP of 3,008 ± 1,713 NmL CH4 d−1 L−1. Energy assessment from biogas production during season and off-season periods reached 59,169 MWh annually, confirming the continuous production feasibility.
- 27 February 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessBiogas production from the anaerobic co-digestion of agro-industrial wastes: operation of a s-CSTR reactor under simulated sugarcane season and off-season conditions
Anaerobic digestion (AD) of organic waste is a sustainable alternative for renewable energy generation and efficient waste management. In this study, the potential for biogas production from the co-digestion of vinasse, cattle manure, and slaughterhouse wastewater (blood water) in a semi-continuous stirred tank reactor (s-CSTR) was evaluated. The waste, available throughout the year, was combined in different proportions to enhance methane production and ensure system stability. The reactor operated under mesophilic conditions (35 °C) with varying organic loading rates (OLR) and substrate compositions in the feed. The highest volumetric methane production (VMP) rates were observed in co-digestion systems combining vinasse and cattle manure. A mixing ratio of 5:1 (v/m) at an OLR of 1.7 kg VS m−3 d−1 resulted in 3,981 ± 1,207 NmL CH4 L−1 d−1, whereas a 1:1 (v/m) ratio at an OLR of 4.1 kg VS m−3 d−1 achieved a higher production of 5,269 ± 637 NmL CH4 L−1 d−1. Anaerobic co-digestion of vinasse with cattle manure demonstrated high efficiency, whereas the addition of glycerol as a supplementary organic substrate compromised system stability. During the sugarcane off-season, the operation occurred by mixing blood water and cattle manure (1:2 – v/m), without adding vinasse. The operation was successfully simulated, reaching a VMP of 3,008 ± 1,713 NmL CH4 d−1 L−1. Energy assessment from biogas production during season and off-season periods reached 59,169 MWh annually, confirming the continuous production feasibility.
- 14 December 2025
- Published by Elsevier in Biomass and Bioenergy
- Vol. 208
Prospecting substrates and co-substrates for year-round biogas production in Brazilian sugarcane mills: Innovative arrangements scenarios
- 14 December 2025
- Published by Elsevier in Biomass and Bioenergy
- Vol. 208
Prospecting substrates and co-substrates for year-round biogas production in Brazilian sugarcane mills: Innovative arrangements scenarios
- 24 April 2025
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 15 (18) , 25433-25448
Assessment of methane production through co-digestion of biomass from the sugarcane and livestock sectors
- 24 April 2025
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 15 (18) , 25433-25448
Assessment of methane production through co-digestion of biomass from the sugarcane and livestock sectors
- Open Access
- 2 December 2022
- Published by MDPI AG in Sustainable Chemistry
- Vol. 3 (4) , 535-550
Removal of Metals by Biomass Derived Adsorbent in Its Granular and Powdered Forms: Adsorption Capacity and Kinetics Analysis
Among the various existing metals, zinc and copper are predominant metals in several effluents from industries such as electroplating, plastics production and mining. Technical methods have been applied in the treatment of effluents containing metals, including chemical removal, adsorption, ion exchange, membrane technologies and electrochemistry. However, it is necessary to develop technologies that minimize costs and increase treatment quality while reducing residual sludge generation. Adsorption using biological materials stands out for removing metals, a low-cost technique and high efficiency. Thus, this study evaluated metal adsorption using an adsorbent from granular and powdered anaerobic sludge, followed by a kinetic analysis, aiming at a new alternative for wastewater treatment. Evaluation of the copper and zinc adsorption process using granular and powdered biomass resulted in maximum removals of 72.9% and 62.7% for zinc, respectively, and 92.8% and 85.0% for copper, respectively. Analyzing the kinetic models, the pseudo-second-order model fitted the data better. Applying the kinetics of other studies in the literature for copper and zinc removal by other adsorbents, the pseudo-second-order model was the most representative model. In this context, kinetic modeling allowed the determination of the solute removal rate, estimating the adsorption mechanism.
- 2 December 2022
- Published by MDPI AG in Sustainable Chemistry
- Vol. 3 (4) , 535-550
Open AccessRemoval of Metals by Biomass Derived Adsorbent in Its Granular and Powdered Forms: Adsorption Capacity and Kinetics Analysis
Among the various existing metals, zinc and copper are predominant metals in several effluents from industries such as electroplating, plastics production and mining. Technical methods have been applied in the treatment of effluents containing metals, including chemical removal, adsorption, ion exchange, membrane technologies and electrochemistry. However, it is necessary to develop technologies that minimize costs and increase treatment quality while reducing residual sludge generation. Adsorption using biological materials stands out for removing metals, a low-cost technique and high efficiency. Thus, this study evaluated metal adsorption using an adsorbent from granular and powdered anaerobic sludge, followed by a kinetic analysis, aiming at a new alternative for wastewater treatment. Evaluation of the copper and zinc adsorption process using granular and powdered biomass resulted in maximum removals of 72.9% and 62.7% for zinc, respectively, and 92.8% and 85.0% for copper, respectively. Analyzing the kinetic models, the pseudo-second-order model fitted the data better. Applying the kinetics of other studies in the literature for copper and zinc removal by other adsorbents, the pseudo-second-order model was the most representative model. In this context, kinetic modeling allowed the determination of the solute removal rate, estimating the adsorption mechanism.
- Open Access
- 16 January 2022
- Published by Research, Society and Development in Research, Society and Development
- Vol. 11 (2)
Técnicas de remoção de metais de águas residuárias: uma revisão de literatura
Devido ao crescimento das indústrias, a geração de efluentes com metais cresce acentuadamente, gerando prejuízos sobre a fauna e flora. A preocupação com o destino dos metais gerados levou ao desenvolvimento de métodos de remoção de poluentes das águas residuárias. O presente estudo revisa os avanços das técnicas de remoção nos últimos anos. Neste trabalho, a remoção de metais foi avaliada sob a ótica dos processos de adsorção (componentes da fase fluida são transferidos para a superfície ou poros de uma fase sólida removendo assim as moléculas de adsorvato), biossorção (ligação de íons das moléculas em solução que se ligam a grupos funcionais presentes na superfície), eletrodiálise (transporte de íons através de membranas de troca iônica através de uma diferença de potencial elétrico como força motriz), osmose reversa (uma membrana é projetada para permitir a passagem da água, enquanto retém solutos), ultrafiltração (separação de íons metálicos por um processo de filtração em uma membrana), precipitação química (combinação de adição de agente coagulante seguida de ajuste do pH), precipitação por sulfeto (utilização do sulfeto como precipitador dos íons metálicos presentes), biomineração (microrganismos facilitam extração e recuperação de metais) e biolixiviação (solubilização de metais e reciclagem dada a ação de micro-organismos oxidantes).
- 16 January 2022
- Published by Research, Society and Development in Research, Society and Development
- Vol. 11 (2)
Open AccessTécnicas de remoção de metais de águas residuárias: uma revisão de literatura
Devido ao crescimento das indústrias, a geração de efluentes com metais cresce acentuadamente, gerando prejuízos sobre a fauna e flora. A preocupação com o destino dos metais gerados levou ao desenvolvimento de métodos de remoção de poluentes das águas residuárias. O presente estudo revisa os avanços das técnicas de remoção nos últimos anos. Neste trabalho, a remoção de metais foi avaliada sob a ótica dos processos de adsorção (componentes da fase fluida são transferidos para a superfície ou poros de uma fase sólida removendo assim as moléculas de adsorvato), biossorção (ligação de íons das moléculas em solução que se ligam a grupos funcionais presentes na superfície), eletrodiálise (transporte de íons através de membranas de troca iônica através de uma diferença de potencial elétrico como força motriz), osmose reversa (uma membrana é projetada para permitir a passagem da água, enquanto retém solutos), ultrafiltração (separação de íons metálicos por um processo de filtração em uma membrana), precipitação química (combinação de adição de agente coagulante seguida de ajuste do pH), precipitação por sulfeto (utilização do sulfeto como precipitador dos íons metálicos presentes), biomineração (microrganismos facilitam extração e recuperação de metais) e biolixiviação (solubilização de metais e reciclagem dada a ação de micro-organismos oxidantes).
- 5 April 2019
- Published by Elsevier in Journal of Water Process Engineering
- Vol. 31, 100817
Potential for anaerobic treatment of wastewater from pet bottle washing in a fluidized bed reactor
- 5 April 2019
- Published by Elsevier in Journal of Water Process Engineering
- Vol. 31, 100817
Potential for anaerobic treatment of wastewater from pet bottle washing in a fluidized bed reactor