Haoran Sun
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Haoran Sun has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
Wanzhong Yin
3 shared publicationsYulian Wang
School of Materials Science and Engineering, Shenyang Ligong University, Shenyang 110159, People’s Republic of China
3 shared publications- Jin Yao
School of Resources and Civil Engineering, Northeastern University, Shenyang, China
2 shared publications - Wanzhong Yin
School of Resources and Civil Engineering, Northeastern University, Shenyang 110819, China
2 shared publications - Yulian Wang
School of Materials Science and Engineering, Shenyang Ligong University, Shenyang, China
2 shared publications Baoquan Jiang
School of Materials Science and Engineering, Shenyang Ligong University, Shenyang 110159, People’s Republic of China
1 shared publication
Latest Publications
- 1 August 2025
- Published by IOP Publishing in Physica Scripta
- Vol. 100 (8) , 0859a8
Recovery of magnesium from iron ore tailings: acid leaching kinetics and CO2 mineralization
Aiming at the environmental problems caused by the accumulation of a large amount of iron ore tailings (IOT) and the status quo of low value added, this study proposes a new sulfuric acid leaching-mineralization process to recover magnesium from IOT. Combined with leaching experiments, kinetic equations, and reaction analysis, the leaching mechanism was explored, and the effects of reaction temperature, sulfuric acid concentration, and solid–liquid ratio on magnesium recovery were systematically investigated. And CO2 mineralization was carried out to synthesize anhydrous MgCO3. The results showed that the magnesium recovery was 55.75% under the optimal conditions (leaching temperature of 90 °C, sulfuric acid concentration of 300 g/L, and solid–liquid ratio of 1:4). A kinetic equation describing this leaching process was established: 1–3(1-L)2/3+2(1-L) = kt (R2 = 0.9923), indicating that the product layer diffusion is the rate-limiting step. The apparent activation energy was calculated to be 22.14 kJ/mol. The mineralization stage produces anhydrous MgCO3 with a good degree of crystallinity, and each ton of IOT sequesters 0.38 tons of CO2. This study establishes a synergistic technological pathway for high-value resource utilization and carbon capture, verifies its economic feasibility, and provides a new idea for sustainable tailings management.
- 1 August 2025
- Published by IOP Publishing in Physica Scripta
- Vol. 100 (8) , 0859a8
Recovery of magnesium from iron ore tailings: acid leaching kinetics and CO2 mineralization
Aiming at the environmental problems caused by the accumulation of a large amount of iron ore tailings (IOT) and the status quo of low value added, this study proposes a new sulfuric acid leaching-mineralization process to recover magnesium from IOT. Combined with leaching experiments, kinetic equations, and reaction analysis, the leaching mechanism was explored, and the effects of reaction temperature, sulfuric acid concentration, and solid–liquid ratio on magnesium recovery were systematically investigated. And CO2 mineralization was carried out to synthesize anhydrous MgCO3. The results showed that the magnesium recovery was 55.75% under the optimal conditions (leaching temperature of 90 °C, sulfuric acid concentration of 300 g/L, and solid–liquid ratio of 1:4). A kinetic equation describing this leaching process was established: 1–3(1-L)2/3+2(1-L) = kt (R2 = 0.9923), indicating that the product layer diffusion is the rate-limiting step. The apparent activation energy was calculated to be 22.14 kJ/mol. The mineralization stage produces anhydrous MgCO3 with a good degree of crystallinity, and each ton of IOT sequesters 0.38 tons of CO2. This study establishes a synergistic technological pathway for high-value resource utilization and carbon capture, verifies its economic feasibility, and provides a new idea for sustainable tailings management.
- Open Access
Investigation into the Adsorption Mechanism of a Novel Collector Cetyl Trimethyl Ammonium Chloride on the Surface of Hematite and Quartz
In this research, a novel collector cetyl trimethyl ammonium chloride (CTAC) was used to separate hematite from quartz via reverse flotation for the first time. Micro-flotation tests showed that CTAC had a strong ability to selectively collect quartz and that a separation of hematite from quartz could be accomplished with a concentration of 0.00263 mmol/L CTAC. Zeta-potential measurements indicated that the positive CTAC+ species could selectively increase the surface potential of quartz, but that it had rather a weak effect on the hematite. X-ray photoelectron spectroscopy (XPS) detection indicated that CTAC had a stronger binding affinity to oxygen sites on the surface of quartz than on hematite, resulting in a large amount of CTAC being predominantly adsorbed onto quartz. This was supported by the atomic concentration of C1s and N1s of quartz after CTAC treatments were 4.25 and 2.84 times higher than hematite, respectively.
Open AccessInvestigation into the Adsorption Mechanism of a Novel Collector Cetyl Trimethyl Ammonium Chloride on the Surface of Hematite and Quartz
In this research, a novel collector cetyl trimethyl ammonium chloride (CTAC) was used to separate hematite from quartz via reverse flotation for the first time. Micro-flotation tests showed that CTAC had a strong ability to selectively collect quartz and that a separation of hematite from quartz could be accomplished with a concentration of 0.00263 mmol/L CTAC. Zeta-potential measurements indicated that the positive CTAC+ species could selectively increase the surface potential of quartz, but that it had rather a weak effect on the hematite. X-ray photoelectron spectroscopy (XPS) detection indicated that CTAC had a stronger binding affinity to oxygen sites on the surface of quartz than on hematite, resulting in a large amount of CTAC being predominantly adsorbed onto quartz. This was supported by the atomic concentration of C1s and N1s of quartz after CTAC treatments were 4.25 and 2.84 times higher than hematite, respectively.
- Open Access
- 4 September 2023
- Published by MDPI AG in Preprints.org
Investigation on the Adsorption Mechanism of a Noval Collector Cetyl Trimethyl Ammonium Chloride on the Surface of Hematite and Quartz
In this research, a novel collector cetyl trimethyl ammonium chloride (CTAC) was used to separate hematite from quartz via reverse flotation for the first time. Micro-flotation tests showed that CTAC had a strong ability to selectively collect quartz and a separation of hematite from quartz could be accomplished with a concentration of 0.00263 mmol/L CTAC. Zeta-potential measurements indicated that the positive CTAC+ species could selectively increase the surface potential of quartz, but it had rather a weak effect on the hematite surface. X-ray photoelectron spectroscopy (XPS) detection indicated that CTAC had a stronger binding affinity to oxygen sites on the surface of quartz than that of hematite, resulting in a large amount of CTAC predominantly adsorbed on quartz rather than hematite.
- 4 September 2023
- Published by MDPI AG in Preprints.org
Open AccessInvestigation on the Adsorption Mechanism of a Noval Collector Cetyl Trimethyl Ammonium Chloride on the Surface of Hematite and Quartz
In this research, a novel collector cetyl trimethyl ammonium chloride (CTAC) was used to separate hematite from quartz via reverse flotation for the first time. Micro-flotation tests showed that CTAC had a strong ability to selectively collect quartz and a separation of hematite from quartz could be accomplished with a concentration of 0.00263 mmol/L CTAC. Zeta-potential measurements indicated that the positive CTAC+ species could selectively increase the surface potential of quartz, but it had rather a weak effect on the hematite surface. X-ray photoelectron spectroscopy (XPS) detection indicated that CTAC had a stronger binding affinity to oxygen sites on the surface of quartz than that of hematite, resulting in a large amount of CTAC predominantly adsorbed on quartz rather than hematite.
- Open Access
- 1 July 2023
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 2541 (1) , 012013
Study on the effect and mechanism of NaOH on the modification of fluorapatite: A new method of preparing fluor-hydroxyapatite
Fluorapatite (FA) and fluor-hydroxyapatite (FHA) have good biocompatibility to substitute for human hard tissue, whereas FA has more cytotoxic and genotoxic effects than FHA. In this study, a new method named nitric acid dissolution-recrystallization was proposed to achieve the modification of FA, and NaOH was used to introduce OH- into FA to prepare FHA in the recrystallization process. The effect and mechanism of NaOH/pH value on the modification of FA were investigated using XRD analysis, SEM detection, EDTA complexometric titration, and FT-IR measurements. XRD and SEM analyses indicated that the synthesized FHA at the pH value of 8.00 had the highest crystallinity and the largest crystal size, reaching 38.10 nm, and the crystal was in the form of short rods with a length of about 1 μm. It was found that the content of the F element in the synthesized FHA decreased as the pH value of the reaction system increased. When the pH value reached 8.00, the content of F was 0.60%, and the values of x and (2-x) in FHA [Ca10(PO4)6Fx(OH)2-x] were 0.16 and 1.84, respectively. FT-IR analysis further confirmed that the content of OH- in FHA obtained at the pH value of 8.00 was noticeably higher than that obtained at the pH value of 4.46. This work could provide a new prospect for utilizing FA to prepare FHA and be of great significance.
- 1 July 2023
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 2541 (1) , 012013
Open AccessStudy on the effect and mechanism of NaOH on the modification of fluorapatite: A new method of preparing fluor-hydroxyapatite
Fluorapatite (FA) and fluor-hydroxyapatite (FHA) have good biocompatibility to substitute for human hard tissue, whereas FA has more cytotoxic and genotoxic effects than FHA. In this study, a new method named nitric acid dissolution-recrystallization was proposed to achieve the modification of FA, and NaOH was used to introduce OH- into FA to prepare FHA in the recrystallization process. The effect and mechanism of NaOH/pH value on the modification of FA were investigated using XRD analysis, SEM detection, EDTA complexometric titration, and FT-IR measurements. XRD and SEM analyses indicated that the synthesized FHA at the pH value of 8.00 had the highest crystallinity and the largest crystal size, reaching 38.10 nm, and the crystal was in the form of short rods with a length of about 1 μm. It was found that the content of the F element in the synthesized FHA decreased as the pH value of the reaction system increased. When the pH value reached 8.00, the content of F was 0.60%, and the values of x and (2-x) in FHA [Ca10(PO4)6Fx(OH)2-x] were 0.16 and 1.84, respectively. FT-IR analysis further confirmed that the content of OH- in FHA obtained at the pH value of 8.00 was noticeably higher than that obtained at the pH value of 4.46. This work could provide a new prospect for utilizing FA to prepare FHA and be of great significance.
- 1 March 2021
- Published by Elsevier in Hydrometallurgy
- Vol. 200, 105564
Microstructure analysis of low-grade copper ore agglomerates prepared by geopolymerization
- 1 March 2021
- Published by Elsevier in Hydrometallurgy
- Vol. 200, 105564
Microstructure analysis of low-grade copper ore agglomerates prepared by geopolymerization
- Open Access
- 1 January 2001
- Published by Elsevier in Acta Physico-Chimica Sinica
- Vol. 17 (02) , 128-133
Spectra and Electrocatalytic Reduction of Dioxygen of Mesotetrakis (4Nbenzylpyridyl)porphyrinmetaloxo Cluster Supramolecular Complex
- 1 January 2001
- Published by Elsevier in Acta Physico-Chimica Sinica
- Vol. 17 (02) , 128-133
Open AccessSpectra and Electrocatalytic Reduction of Dioxygen of Mesotetrakis (4Nbenzylpyridyl)porphyrinmetaloxo Cluster Supramolecular Complex