Marleny Cáceres Najarro
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Marleny Cáceres Najarro has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Anders Feilberg
Department of Biosystems Engineering, Aarhus University, Blichers Allé 20, DK-8830 Tjele, Denmark
1 shared publication - André Deratani
Institut Europeen des Membranes, IEM UMR-5635, CNRS, ENSCM, University Montpellier, Place Eugène Bataillon, 34095 Montpellier, France
1 shared publication - Eddy Petit
Plateforme d’Analyses et de Caractérisations PAC Chimie Balard (UAR 2041), CNRS, ENSCM, University of Montpellier, 34095 Montpellier, France
1 shared publication Ib Johannsen
Department of Biological and Chemical Engineering, Aarhus University, Hangøvej 2, DK-8200 Aarhus, Denmark
1 shared publication- Ib Johannsen
Department of Engineering, Aarhus University, 8000 Aarhus, Denmark
1 shared publication Joseph Iruthayaraj
Department of Biological and Chemical Engineering, Aarhus University, Hangøvej 2, DK-8200 Aarhus, Denmark
1 shared publication
Latest Publications
- Open Access
Copper Adsorption on Lignin for the Removal of Hydrogen Sulfide
Lignin is currently an underutilized part of biomass; thus, further research into lignin could benefit both scientific and commercial endeavors. The present study investigated the potential of kraft lignin as a support material for the removal of hydrogen sulfide (H2S) from gaseous streams, such as biogas. The removal of H2S was enabled by copper ions that were previously adsorbed on kraft lignin. Copper adsorption was based on two different strategies: either directly on lignin particles or by precipitating lignin from a solution in the presence of copper. The H2S concentration after the adsorption column was studied using proton-transfer-reaction mass spectrometry, while the mechanisms involved in the H2S adsorption were studied with X-ray photoelectron spectroscopy. It was determined that elemental sulfur was obtained during the H2S adsorption in the presence of kraft lignin and the differences relative to the adsorption on porous silica as a control are discussed. For kraft lignin, only a relatively low removal capacity of 2 mg of H2S per gram was identified, but certain possibilities to increase the removal capacity are discussed.
Open AccessCopper Adsorption on Lignin for the Removal of Hydrogen Sulfide
Lignin is currently an underutilized part of biomass; thus, further research into lignin could benefit both scientific and commercial endeavors. The present study investigated the potential of kraft lignin as a support material for the removal of hydrogen sulfide (H2S) from gaseous streams, such as biogas. The removal of H2S was enabled by copper ions that were previously adsorbed on kraft lignin. Copper adsorption was based on two different strategies: either directly on lignin particles or by precipitating lignin from a solution in the presence of copper. The H2S concentration after the adsorption column was studied using proton-transfer-reaction mass spectrometry, while the mechanisms involved in the H2S adsorption were studied with X-ray photoelectron spectroscopy. It was determined that elemental sulfur was obtained during the H2S adsorption in the presence of kraft lignin and the differences relative to the adsorption on porous silica as a control are discussed. For kraft lignin, only a relatively low removal capacity of 2 mg of H2S per gram was identified, but certain possibilities to increase the removal capacity are discussed.
- 23 November 2020
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 2 (12) , 5767-5778
Tuning the Lignin-Caprolactone Copolymer for Coating Metal Surfaces
- 23 November 2020
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 2 (12) , 5767-5778
Tuning the Lignin-Caprolactone Copolymer for Coating Metal Surfaces
- 1 February 2020
- Published by Elsevier in Carbohydrate Polymers
- Vol. 229, 115461
Partial depolymerization of hydroxypropylmethyl cellulose for production of low molar mass polymer chains
- 1 February 2020
- Published by Elsevier in Carbohydrate Polymers
- Vol. 229, 115461
Partial depolymerization of hydroxypropylmethyl cellulose for production of low molar mass polymer chains