Qiang Zou

This paper presents a new method to generate iso-scallop tool paths for triangular mesh surfaces. With the popularity of 3D scanning techniques, scanning-derived mesh surfaces have seen a significant increase in their application to machining. Quite often, such mesh surfaces exhibit defects such as noises, which differentiate them from the good-quality mesh surfaces previous research work focuses on. To generate tool paths for such low-quality mesh surfaces, the primary challenge lies in robustness against the defects. In this work, a robust tool path generation method is proposed for low-quality mesh surfaces. In addition to robustness, the method is quite efficient, providing the benefit of faster iterations and improved integration between scanning and machining. The fundamental principle of the method is to convert the tool path generation problem to the heat diffusion problem that has robust and efficient algorithms available. The effectiveness of the method will be demonstrated by a series of case studies and comparisons.

This paper presents a new method to generate iso-scallop tool paths for triangular mesh surfaces. With the popularity of 3D scanning techniques, scanning-derived mesh surfaces have seen a significant increase in their application to machining. Quite often, such mesh surfaces exhibit defects such as noises, which differentiate them from the good-quality mesh surfaces previous research work focuses on. To generate tool paths for such poor-quality mesh surfaces, the primary challenge lies in robustness against the defects. In this work, a robust tool path generation method is proposed for poor-quality mesh surfaces. In addition to robustness, the method is quite efficient, providing the benefit of faster iterations and improved integration between scanning and machining. The fundamental principle of the method is to convert the tool path generation problem to the heat diffusion problem that has robust and efficient algorithms available. The effectiveness of the method will be demonstrated by a series of case studies and comparisons.

Boundary representation (B-rep) model editing plays an essential role in computer-aided design and motivates the very recent direct modeling paradigm, which features intuitive push-pull manipulation of the model geometry. In mechanical design, a substantial part of B-rep models being used are quadric models (composed of linear and quadric surfaces). However, push-pulling such models is not trivial due to the possible smooth face-face connections in the models. The major issue is that, during push-pull moves, it is often desirable to preserve these connections for functional, manufacturing, or aesthetic reasons, but this could cause complex inconsistencies between the geometry and topology in the model and lead to robustness issues in updating the model. The challenge lies in effectiveness towards detecting the instants when geometry-topology inconsistencies occur during push-pull moves. This paper proposes a novel reverse detection method to solve the challenge and then, based on it, presents a robust method for push-pull direct modeling while preserving smooth connections. Case studies and comparisons have been conducted to demonstrate the effectiveness of the method.

This paper presents discussions on the limitations of the witness configuration method. These limitations have rarely been reported in previous studies. The witness configuration method is a very recent approach for geometric constraint solving, which is of critical importance for modern computer-aided design systems. The witness configuration method may be the most promising method to solve satisfactorily the challenges of geometric constraint solving. This method, in the current form, is however found to be limited for the three essential tasks in the geometric constraint solving domain. Examples are given to validate this work's statements on these limitations.

Direct modeling is a very recent CAD paradigm that can provide unprecedented modeling flexibility. It, however, lacks the parametric capability, which is indispensable to modern CAD systems. For direct modeling to have this capability, an additional associativity information layer in the form of geometric constraint systems needs to be incorporated into direct modeling. This is no trivial matter due to the possible inconsistencies between the associativity information and geometry information in a model after direct edits. The major issue of resolving such inconsistencies is that there often exist many resolution options. The challenge lies in avoiding invalid resolution options and prioritizing valid ones. This paper presents an effective method to support the user in making decisions among the resolution options. In particular, the method can provide automatic information inconsistency reasoning, avoid invalid resolution options completely, and guide the choice among valid resolution options. Case studies and comparisons have been conducted to demonstrate the effectiveness of the method.