Nanda Kishore
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Nanda Kishore has a total of 63 co-authors. Here are the top co-authors by number of shared publications:
Anand Mohan Verma
Department of Chemical Engineering, Indian Institute of Technology Guwahati, India
12 shared publicationsSneha Acharya
10 shared publicationsGaffer Ahmed
Department of Chemical Engineering, Indian Institute of Technology Guwahati, Assam, India
8 shared publications- Kushagra Agrawal
Cardiff University
6 shared publications Rahul Ramdas Ramteke
Chemical Engineering Department Indian Institute of Technology Guwahati Guwahati Assam India
6 shared publications- Draksharapu Rammohan
Indian Institute of Technology Guwahati
5 shared publications
Latest Publications
- 2 June 2026
- Published by American Chemical Society (ACS) in ACS Sustainable Resource Management
- Vol. 3 (6) , 1858-1874
A Numerical Study on Sustainable Aviation Fuel Model Compound Production in Ebullated and Fluidized Bed Reactors
- 2 June 2026
- Published by American Chemical Society (ACS) in ACS Sustainable Resource Management
- Vol. 3 (6) , 1858-1874
A Numerical Study on Sustainable Aviation Fuel Model Compound Production in Ebullated and Fluidized Bed Reactors
- 13 February 2026
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 65 (7) , 4142-4154
Modified Pyrolysis of Erythrina indica Biomass to Produce Noncondensable Gases Rich in Hydrogen and Low in Carbon Dioxide
- 13 February 2026
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 65 (7) , 4142-4154
Modified Pyrolysis of Erythrina indica Biomass to Produce Noncondensable Gases Rich in Hydrogen and Low in Carbon Dioxide
- Open Access
- 18 September 2025
- Published by AIP Publishing in International Journal of Fluid Engineering
- Vol. 3 (1)
Hydrodynamics of gas–liquid–solid three phase systems in ebullated beds and fluidized beds using computational fluid dynamics
The hydrodynamics of the three-phase system in an ebullated bed reactor (EBR) is investigated using computational fluid dynamics and compared with that in a fluidized bed reactor (FBR). For consistency in the comparison, the two reactors have the same dimensions (2.20 m length and 0.172 m diameter), except that there is no recirculation column in the FBR, and the same superficial velocities of liquid phase (0.057 and 0.095 m/s) and gas phase (0.04, 0.08, 0.12 m/s), particle diameter (300 μm), initial solids volume fraction of the bed (0.5), and initial packing height (0.3 m). It is found that the expansion of the bed is greater in the EBR than in the FBR under identical conditions of low liquid superficial velocity. In the FBR, the larger size of the voids formed in the expanded region causes decreased interactions between the three phases, whereas in the EBR, smaller voids are formed at lower simulation times, whereas slugs are formed at longer times. In addition, early stability of bed expansion is attained at lower gas superficial velocities, irrespective of the value of the liquid superficial velocity. In the EBR, there is no symmetry of bed expansion on each side of the recirculation pipe even at low liquid superficial velocities. It is found that at 0.5 m bed height, the radial distributions of gas, liquid, and solids indicate a more uniform and better distribution of the three phases in the EBR. The local solids fraction distribution along the radial position indicates that in the EBR, for most of combinations of gas and liquid superficial velocities, the solids fraction is properly distributed and that it is even more uniform for the combination of a higher liquid and lower gas superficial velocity.
- 18 September 2025
- Published by AIP Publishing in International Journal of Fluid Engineering
- Vol. 3 (1)
Open AccessHydrodynamics of gas–liquid–solid three phase systems in ebullated beds and fluidized beds using computational fluid dynamics
The hydrodynamics of the three-phase system in an ebullated bed reactor (EBR) is investigated using computational fluid dynamics and compared with that in a fluidized bed reactor (FBR). For consistency in the comparison, the two reactors have the same dimensions (2.20 m length and 0.172 m diameter), except that there is no recirculation column in the FBR, and the same superficial velocities of liquid phase (0.057 and 0.095 m/s) and gas phase (0.04, 0.08, 0.12 m/s), particle diameter (300 μm), initial solids volume fraction of the bed (0.5), and initial packing height (0.3 m). It is found that the expansion of the bed is greater in the EBR than in the FBR under identical conditions of low liquid superficial velocity. In the FBR, the larger size of the voids formed in the expanded region causes decreased interactions between the three phases, whereas in the EBR, smaller voids are formed at lower simulation times, whereas slugs are formed at longer times. In addition, early stability of bed expansion is attained at lower gas superficial velocities, irrespective of the value of the liquid superficial velocity. In the EBR, there is no symmetry of bed expansion on each side of the recirculation pipe even at low liquid superficial velocities. It is found that at 0.5 m bed height, the radial distributions of gas, liquid, and solids indicate a more uniform and better distribution of the three phases in the EBR. The local solids fraction distribution along the radial position indicates that in the EBR, for most of combinations of gas and liquid superficial velocities, the solids fraction is properly distributed and that it is even more uniform for the combination of a higher liquid and lower gas superficial velocity.
- 9 April 2025
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 150 (8) , 6127-6143
Elucidation of kinetics and thermodynamic properties of Erythrina indica biomass pyrolysis
- 9 April 2025
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 150 (8) , 6127-6143
Elucidation of kinetics and thermodynamic properties of Erythrina indica biomass pyrolysis
- 1 March 2025
- Published by AIP Publishing in Journal of Renewable and Sustainable Energy
- Vol. 17 (2)
Kinetics, reaction models, and thermodynamic feasibility of non-isothermal catalytic pyrolysis of Erythrina indica
The pyrolysis process, which involves the transformation of biomass into valuable products like bio-oil, biochar, and non-condensable gases, is a crucial aspect of biomass waste utilization. Gaining an insight into the kinetics and thermodynamics involved in this process is paramount for enhancing its efficiency. This research employs iso-conversional methods to study the kinetics of non-catalytic and catalytic pyrolysis of Erythrina indica (EI) biomass at four different heating rates followed by thermodynamic feasibility. The catalytic pyrolysis of biomass was studied using 10 wt. % of catalysts such as biochar (obtained by non-catalytic pyrolysis of EI at 800 °C for 2 h), nickel, and titanium dioxide for each case to evaluate their effects on kinetics and thermodynamics. The iso-conversional methods include the differential Friedman method, Ozawa–Flynn–Wall, Kissinger–Akharia–Sunose, distributed activation energy model, and Starink. All kinetic models showed strong agreement (R2 > 0.96). The reaction models were also evaluated using the integral form of the master plots and were compared with those by Criado's master plots approach. Biochar catalyst exhibited the lowest activation energy requirements (155.924–162.846 kJ/mol), followed by titanium dioxide (160.231–167.924 kJ/mol) and nickel (172.125–176.482 kJ/mol), while non-catalytic pyrolysis required the highest energy (176.861–184.784 kJ/mol) for EI pyrolysis. Thermodynamic analysis revealed that biochar catalytic pyrolysis required the lowest enthalpy change (ΔH: 156–160 kJ/mol), followed by titanium dioxide (160–168 kJ/mol) and nickel (174–177 kJ/mol), all lower than non-catalytic pyrolysis (176–186 kJ/mol). The Gibbs free energy (ΔG) remained similar (170–175 kJ/mol) across all cases, indicating the conditional feasibility of pyrolysis regardless of the catalyst used. Finally, on the basis of master plots, suitable reaction models were proposed for catalytic pyrolysis of EI biomass.
- 1 March 2025
- Published by AIP Publishing in Journal of Renewable and Sustainable Energy
- Vol. 17 (2)
Kinetics, reaction models, and thermodynamic feasibility of non-isothermal catalytic pyrolysis of Erythrina indica
The pyrolysis process, which involves the transformation of biomass into valuable products like bio-oil, biochar, and non-condensable gases, is a crucial aspect of biomass waste utilization. Gaining an insight into the kinetics and thermodynamics involved in this process is paramount for enhancing its efficiency. This research employs iso-conversional methods to study the kinetics of non-catalytic and catalytic pyrolysis of Erythrina indica (EI) biomass at four different heating rates followed by thermodynamic feasibility. The catalytic pyrolysis of biomass was studied using 10 wt. % of catalysts such as biochar (obtained by non-catalytic pyrolysis of EI at 800 °C for 2 h), nickel, and titanium dioxide for each case to evaluate their effects on kinetics and thermodynamics. The iso-conversional methods include the differential Friedman method, Ozawa–Flynn–Wall, Kissinger–Akharia–Sunose, distributed activation energy model, and Starink. All kinetic models showed strong agreement (R2 > 0.96). The reaction models were also evaluated using the integral form of the master plots and were compared with those by Criado's master plots approach. Biochar catalyst exhibited the lowest activation energy requirements (155.924–162.846 kJ/mol), followed by titanium dioxide (160.231–167.924 kJ/mol) and nickel (172.125–176.482 kJ/mol), while non-catalytic pyrolysis required the highest energy (176.861–184.784 kJ/mol) for EI pyrolysis. Thermodynamic analysis revealed that biochar catalytic pyrolysis required the lowest enthalpy change (ΔH: 156–160 kJ/mol), followed by titanium dioxide (160–168 kJ/mol) and nickel (174–177 kJ/mol), all lower than non-catalytic pyrolysis (176–186 kJ/mol). The Gibbs free energy (ΔG) remained similar (170–175 kJ/mol) across all cases, indicating the conditional feasibility of pyrolysis regardless of the catalyst used. Finally, on the basis of master plots, suitable reaction models were proposed for catalytic pyrolysis of EI biomass.
- 25 February 2025
- Published by Elsevier in Renewable Energy
- Vol. 245
Non-catalytic hydrosolvolysis of Delonix regia biomass waste and analysis of products
- 25 February 2025
- Published by Elsevier in Renewable Energy
- Vol. 245
Non-catalytic hydrosolvolysis of Delonix regia biomass waste and analysis of products
- 17 February 2025
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 15 (7) , 2379-2394
Efficient CO2 reduction to methane on Ru2-based adjacent vacant graphene catalysts: insights into bimetallic synergies, thermodynamics, and kinetics
A comprehensive CO2 reduction mechanism is explored on Ru-based bimetallic graphene catalysts. Key mechanistic insights are revealed by a thorough examination of thermodynamics and kinetics, providing avenues for improved methane selectivity.
- 17 February 2025
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 15 (7) , 2379-2394
Efficient CO2 reduction to methane on Ru2-based adjacent vacant graphene catalysts: insights into bimetallic synergies, thermodynamics, and kinetics
A comprehensive CO2 reduction mechanism is explored on Ru-based bimetallic graphene catalysts. Key mechanistic insights are revealed by a thorough examination of thermodynamics and kinetics, providing avenues for improved methane selectivity.
- Open Access
- 12 February 2025
- Published by Elsevier in Industrial Crops and Products
- Vol. 226
Non-isothermal thermo-chemical pyrolytic conversion of Modar (Erythrina indica L.) and Mahaneem (Azadirachta indica A.): Kinetics & thermodynamics evaluation
- 12 February 2025
- Published by Elsevier in Industrial Crops and Products
- Vol. 226
Open AccessNon-isothermal thermo-chemical pyrolytic conversion of Modar (Erythrina indica L.) and Mahaneem (Azadirachta indica A.): Kinetics & thermodynamics evaluation