MPMyrto Papadopoulou

Myrto Papadopoulou

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Myrto Papadopoulou has a total of 61 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Seismic investigations of eight geological structures for potential storage of CO2 in Denmark: an introduction

    by Ulrik Gregersen, Michael B W Fyhn, Marie Keiding, Tanni Abramovitz, Morten Bjerager, Henrik Vosgerau, Florian W H Smit, Thomas Funck, Anders Mathiesen, Finn Mørk, et al.

    In June 2021, a novel Danish national carbon capture and storage strategy was ratified by the Danish Parliament, and this was followed by the initiation of the project ‘CCS2022–2024’, led by the Geological Survey of Denmark and Greenland. In collaboration with other institutions, we acquired and interpreted new 2D seismic data between 2022 to 2024 to investigate and mature eight sites for potential subsurface storage of CO2 in Danish onshore and offshore areas. This Bulletin contains a series of papers that present important results of the work. In this introduction paper, we provide an overview of seismic acquisitions and the interpretation of seismic data together with existing deep wells. The study sites selected are large subsurface structures located in onshore Jylland, Sjælland and Lolland and offshore Denmark in the eastern North Sea. The onshore targets are the Gassum, Havnsø, Rødby, Stenlille and Thorning structures, while the offshore sites comprise the Inez, Jammerbugt and Lisa structures. The project work comprises a series of reports regarding extensive seismic acquisition, processing and interpretation of the new and pre-existing seismic data as well as other publications emanating from the project. This Bulletin and the technical reports present an improved understanding of the formation, composition and geometry of the investigated structures. The studies include the mapping of the reservoir and seal formations, identification of principal faults, interpretation of the stratigraphic and structural development, reservoir and seal characterisation and estimates of the static storage capacity. Hence, this research provides a significant step forward concerning characterisation of the geology and maturation of the potential storage sites. In addition, it has inspired new ideas, including an updated regional stratigraphic interpretation of the Triassic succession of the Danish Basin and correlation with adjacent basins.


  • Open Access

    Shear‐wave tailored moveout corrections to improve multicomponent reflection seismic imaging

    by Samuel Zappalá, Myrto Papadopoulou, Alireza Malehmir

    Advancements in technologies and acquisition techniques in reflection seismology have increased the quantity of data that can be recorded in a single survey. The spreading of three‐component (3C) recorders has resulted in multicomponent data acquisitions to be more cost‐effective than single‐component (1C) acquisitions, making 3C datasets more common. Therefore, the need for processing workflows aiming to enhance S‐wave from P‐wave‐designed acquisitions is increasing. As part of a larger survey for geological carbon storage site investigations, a 1‐km‐long seismic profile was acquired near the city of Randers in Denmark and is considered in this study. The acquisition setup consisted of two vertical vibrating sources, operating every 10 m, recorded simultaneously from a 1C nodal array, 10 m spaced and a landstreamer system, equipped with 60 3C micro‐electro‐mechanical sensors in 2 m intervals. Analysis of the 3C data recorded from the landstreamer system shows PP‐, PS‐ and SS‐wavefield reflections from a shallow horizon nearly 50 m below the ground surface. Although the PP‐wavefield data processing was straightforward, the SS‐wavefield imaging was challenged by strong surface waves recorded in the data, thus requiring a tailored workflow for its processing. The workflow employs a reflection‐picked moveout correction specifically designed on the observed reflections with respect to the data acquisition geometry. Results demonstrate that this tailored method is effective, yielding improved continuity of the SS‐wavefield reflectivity with respect to the traditional normal moveout corrections. P‐ and S‐wave interval velocity models are estimated in depth, and their ratio is computed to complement the geological interpretations of the shallow subsurface. Similar imaging scenarios can benefit from the proposed method to sharpen SS‐wavefield reflections in stacked section.


  • Open Access

    Seismic Imaging of Halokinetic Sequences and Structures With High‐Resolution, Dual‐Element Acquisition, and Processing: Applications to the Gassum Structure in Eastern Jutland, Denmark

    by M. Westgate, K. Kucinskaite, E. Konstantinidis, A. Malehmir, M. Papadopoulou, U. Gregersen, M. Keiding, M. Bjerager

    Understanding the structural intricacies of subsurface halokinetic formations is crucial for various geological applications, including geological capture and storage (geological carbon storage (GCS)). This study focuses on the seismic imaging of the Gassum structure in eastern Jutland, Denmark, employing high‐resolution, dual‐element acquisition, and processing techniques. The investigation aims to unravel details in the evolution of the salt dome and its implications for GCS potential. High‐resolution seismic data processing and interpretation reveals a skewed dome structure with steeper flanks on the western and northern sides, characterized by faults and stratigraphic thinning. The asymmetric growth of the dome suggests uneven salt loading during its genesis, influencing local stress fields and structural development, with evidence of syn‐tectonic subsidence that produced salt welds. This is supported by the presence of stratigraphic wedges and an increased depth of imaged horizons within steeper flanks of the dome. A mild piercement of the salt into overlying sediments, onlapping features, and the presence of normal faults that originate from the dome apex and extend radially, all indicate a reactive piercement process in the salt pillow's development stage. This produced an extensional regime in overlying strata, inducing sequence thinning and graben structures. Analysis of reservoir and seal properties unveils adequate conditions for GCS, with a continuous reservoir and thick primary and secondary seals. However, the presence of faults intersecting these formations raises concerns regarding long‐term storage stability. Further investigations into reservoir porosity, migration paths, and volumetric analysis are warranted for conclusive GCS assessments.


  • Open Access

    Advancements in seismic imaging for geological carbon storage: Study of the Havnsø structure, Denmark

    by Myrto Papadopoulou, Samuel Zappalà, Alireza Malehmir, Kristina Kucinskaite, Michael Westgate, Ulrik Gregersen, Thomas Funck, Florian Smit, Henrik Vosgerau


  • Combined onshore and offshore wide-scale seismic data acquisition and imaging for carbon capture and storage exploration in Havnsø, Denmark

    by Samuel Zappalá, Alireza Malehmir, Myrto Papadopoulou, Ulrik Gregersen, Thomas Funck, Ole R. Clausen, Egon Nørmark

    Strong global actions for climate change include carbon capture and storage (CCS) as a feasible solution to reach carbon neutrality and raise opportunities for detailed subsurface investigations. An acquisition set-up designed for onshore-offshore zones was maximized for wide-scale high-resolution structural imaging and implemented to cover a domal structure of interest for CCS utilization close to the town of Havnsø (Denmark). The challenges of the combined acquisition and processing of land and marine multisensor data along a 42 km seismic profile are analyzed, the suggested solutions are applied, and the limitations are discussed. On the onshore side, a nodal array and a seismic landstreamer system were simultaneously used, whereas along the transition zone, a marine seismic streamer and ocean-bottom seismometers were added to record the seismic response generated by two seismic vibrator sources. The adopted sensing domains (velocity, acceleration, and pressure) were studied, and different processing steps were evaluated to enable their processing and subsequent data set merging. Results suggest, as the best approach, a separate prestack processing of the different data sets and the computation of new geometries and new surface-consistent residual static correction after their merging. The data acquired in the transition zone illuminate, for the first time, the subsurface geology of the region, delineating an expected domal closure. The final seismic section shows high continuity of the reflections with good resolution along the entire profile, identifying the main reservoir structure and the surrounding areas, which are important to ensure reservoir integrity and safe exploitation over longer time scales. Shallow and deep reflections are consistent with the stratigraphic column from a well log near the profile. The presented study shows a comprehensive workflow for processing such a multisensor data set in onshore and transition zone settings.


  • Open Access

    High‐resolution P‐ and S‐wavefield seismic investigations of a quick‐clay site in southwest of Sweden

    by Papadopoulou Myrto, Malehmir Alireza, Markovic Magdalena, Berglund Johan

    Seismic investigations were performed at a site in the southwest of Sweden where major quick‐clay landslides have occurred in the past. Given the potential high risk of the area and the presence of medium infrastructures, the site posed a need for detailed investigations in a wide depth range and in high resolution. A high‐fold seismic survey was designed and conducted along two profiles using a 1–2 m receiver and shot spacing in order to retrieve both P‐ and S‐wavefield seismic images from vertical component data. The data were analysed by combining first‐break traveltime tomography and surface‐wave analysis as well as P‐ and S‐wavefield reflection seismic imaging. Using the first breaks, P‐wave velocity (VP) models were estimated, indicating the bedrock topography along the profiles and the sediment characteristics. The S‐wave velocity (Vs) models were estimated from the surface waves and indicated areas of low shear strength. Combined with VP and Vs models, this permits the estimation of VP/VS, a parameter that can indicate areas with high water content, significant for the detection of quick clays and possible liquefaction issues. The results are integrated with the P‐ and S‐wave reflection seismic images and compared with other geophysical investigations, such as magnetic and gravity data that were collected along the profiles.


  • High-resolution static corrections derived from surface-wave tomography: Application to mineral exploration

    by Myrto Papadopoulou, Bojan Brodic, Emilia Koivisto, Albina Kaleshova, Mikko Savolainen, Paul Marsden, Laura Valentina Socco

    In hard-rock mineral exploration using reflection seismic imaging, standard methods to estimate the static corrections based on the analysis of seismic body waves might be ineffective due to near-surface complexities. A workflow to estimate the P-wave statics based on high-resolution surface-wave (SW) tomography is adopted. We combine the S-wave velocity model retrieved by SW tomography, a method known for its high resolution, with the Poisson’s ratio estimated by the wavelength-depth method, a technique based on the analysis of skin depth of SWs. We apply the workflow to a 2D data set recorded at a phosphate mining site in Finland and to a 2D data set acquired at an iron-oxide mining site in Sweden. The retrieved models and statics are evaluated using prior information, and the stacked sections are compared with the ones resulting after standard body-wave statics. Improvements in the continuity of deep reflectors and increase in the extent and the amplitude of the horizons associated with the orebodies are evident in the stacked sections whose statics are computed with our workflow that we call SW tomostatics.


  • Innovative land seismic investigations for CO2 geologic storage in Denmark

    by Myrto Papadopoulou, Samuel Zappalá, Alireza Malehmir, Ulrik Gregersen, Lars Hjelm, Lars Nielsen, Martin Patrong Haspang

    The increasing global interest in geologic carbon storage as a feasible way of reducing CO2 atmospheric levels requires extensive onshore high-resolution seismic investigations to characterize suitable storage sites, for example, close to major CO2 emitters. To partly address this challenge and to acquire quality data at shallower and greater depths in a cost- and time-effective approach, a tailored acquisition scheme is adopted and tested at a candidate site in Stenlille, Denmark. The survey aims to understand whether an anticline reservoir structure known to exist at a 1000 m depth can serve for long-term CO2 storage and presents the structural integrity for this purpose. The data are recorded using a combination of nodal arrays, spaced at 10 m in a fixed geometry, and a set of more closely (2 m) spaced digital recorders, mounted on a landstreamer, which was moved at each shot location. Two 12 t mini vibrators are used as seismic sources. The nodal and landstreamer data sets are compared and combined into a unique data set for reflection imaging purposes along five profiles with a total length of approximately 12 km. The seismic sections obtained using this tailored combination of different recorders provide images of the entire shallow and deeper structures with an unprecedented resolution at the different depth levels necessary to assess the full potential of the suggested CO2 storage reservoir. The results significantly increase the existing knowledge of the extent and structural closure of the reservoir as well as a possible fault, all of which are critical for future risk analysis and planning of the storage.


  • Advances in surface-wave tomography for near-surface applications

    by Myrto Papadopoulou, Farbod Khosro Anjom, Mohammad Karim Karimpour, Valentina Laura Socco

    Surface-wave (SW) tomography is a technique that has been widely used in the field of seismology. It can provide higher resolution relative to the classical multichannel SW processing and inversion schemes that are usually adopted for near-surface applications. Nevertheless, the method is rarely used in this context, mainly due to the long processing times needed to pick the dispersion curves as well as the inability of the two-station processing to discriminate between higher SW modes. To make it efficient and to retrieve pseudo-2D/3D S-wave velocity (VS) and P-wave velocity (VP) models in a fast and convenient way, we develop a fully data-driven two-station dispersion curve estimation, which achieves dense spatial coverage without the involvement of an operator. To handle higher SW modes, we apply a dedicated time-windowing algorithm to isolate and pick the different modes. A multimodal tomographic inversion is applied to estimate a VS model. The VS model is then converted to a VP model with the Poisson's ratio estimated through the wavelength-depth method. We apply the method to a 2D seismic exploration data set acquired at a mining site, where strong lateral heterogeneity is expected, and to a 3D pilot data set, recorded with state-of-the-art acquisition technology. We compare the results with the ones retrieved from classical multichannel analysis.


  • Application of surface‐wave tomography to mineral exploration: a case study from Siilinjärvi, Finland

    by Federico Da Col, Myrto Papadopoulou, Emilia Koivisto, Łukasz Sito, Mikko Savolainen, Laura Valentina Socco