Lu-Di Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Lu-Di Zhang has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
Chunfeng Liu
School of Science, Harbin University of Science and Technology , Harbin 150080, China
1 shared publicationFangshuo Liu
School of Science, Harbin University of Science and Technology , Harbin 150080, China
1 shared publicationFengmin Wu
School of Science, Harbin University of Science and Technology , Harbin 150080, China
1 shared publicationGuangyu Zhang
School of Science, Harbin University of Science and Technology , Harbin 150080, China
1 shared publication- Hong-Jian Feng
School of Physics, Northwest University, Xi'an 710127, China
1 shared publication Linjing Liu
School of Science, Harbin University of Science and Technology , Harbin 150080, China
1 shared publication
Latest Publications
- 15 September 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 140 (11)
Dose-varied tungsten ion implantation for performance modulation of GA2PbI4 x-ray detectors
This study investigates the performance modulation of GA2PbI4 perovskite single crystals for x-ray detection via W ion implantation at varied doses. All implanted samples exhibit improved carrier transport and enhanced charge dynamics. The sample implanted with a moderate dose of 5 × 1016 ions/cm2 shows a relatively low trap density of 5.35 × 108 cm−3, a high μτ product of 3.46 × 10−3 cm2 V−1, and an enhanced PL intensity with prolonged lifetimes, indicating partial defect passivation and suppressed non-radiative recombination. Its x-ray response time is also reduced by nearly 50% compared to the pristine sample. Density functional theory and time-dependent density functional theory calculations reveal that moderate W implantation introduces shallow donor states near the conduction band minimum, enhances dielectric polarization, and modulates charge redistribution in the Pb–I framework, in agreement with the experimental improvements. As a result, this sample achieves the most balanced and optimal performance, with ∼20% higher x-ray detection sensitivity than the pristine device.
- 15 September 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 140 (11)
Dose-varied tungsten ion implantation for performance modulation of GA2PbI4 x-ray detectors
This study investigates the performance modulation of GA2PbI4 perovskite single crystals for x-ray detection via W ion implantation at varied doses. All implanted samples exhibit improved carrier transport and enhanced charge dynamics. The sample implanted with a moderate dose of 5 × 1016 ions/cm2 shows a relatively low trap density of 5.35 × 108 cm−3, a high μτ product of 3.46 × 10−3 cm2 V−1, and an enhanced PL intensity with prolonged lifetimes, indicating partial defect passivation and suppressed non-radiative recombination. Its x-ray response time is also reduced by nearly 50% compared to the pristine sample. Density functional theory and time-dependent density functional theory calculations reveal that moderate W implantation introduces shallow donor states near the conduction band minimum, enhances dielectric polarization, and modulates charge redistribution in the Pb–I framework, in agreement with the experimental improvements. As a result, this sample achieves the most balanced and optimal performance, with ∼20% higher x-ray detection sensitivity than the pristine device.
- 28 October 2019
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 126 (16) , 164308
Photolithographic fabrication of graphene-based all-solid-state planar on-chip microsupercapacitors with ultrahigh power characteristics
The fabrication of all-solid-state planar on-chip microsupercapacitors with ultrahigh power characteristics was demonstrated by reduced graphene oxide and photolithography technology. In this paper, an ultrathin reduced graphene oxide film with a thickness of 8 nm was prepared by a modified spin coating method that makes the microsupercapacitors have higher power characteristics which appear in high conductivity and fast charge and discharge rates. The electrodes, with a width of 150 μm, are narrower than existing electrodes in the field and fabricated by photolithography. In terms of performance, these microsupercapacitors have an extremely short time constant which is 0.03 ms, a high power density which is 17.94 W cm−3, and an excellent cycle stability with a capacitance retention of 94.6% after 10 000 cycles.
- 28 October 2019
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 126 (16) , 164308
Photolithographic fabrication of graphene-based all-solid-state planar on-chip microsupercapacitors with ultrahigh power characteristics
The fabrication of all-solid-state planar on-chip microsupercapacitors with ultrahigh power characteristics was demonstrated by reduced graphene oxide and photolithography technology. In this paper, an ultrathin reduced graphene oxide film with a thickness of 8 nm was prepared by a modified spin coating method that makes the microsupercapacitors have higher power characteristics which appear in high conductivity and fast charge and discharge rates. The electrodes, with a width of 150 μm, are narrower than existing electrodes in the field and fabricated by photolithography. In terms of performance, these microsupercapacitors have an extremely short time constant which is 0.03 ms, a high power density which is 17.94 W cm−3, and an excellent cycle stability with a capacitance retention of 94.6% after 10 000 cycles.