Aaron Chunghin Chow
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Aaron Chunghin Chow has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Bader Shafaqa Al-Anzi
Department of Environmental Sciences, College of Life Sciences, Kuwait University, P.O. Box 5969, Safat 13060, Kuwait
3 shared publications - Edward Eric Adams
Department of Civil and Environmental Engineering, Massachusetts Institute of Technology, Cambridge, USA
3 shared publications - Ishita Shrivastava
Environmental Engineer, Gradient, Beacon St., Boston, MA 02108. ORCID:
2 shared publications - Fahed Al-Rabaie
Department of Environmental Technologies and Management, Kuwait University, POB 5969, Safat 13060, Kuwait
1 shared publication - Haitham M. S. Lababidi
Department of Chemical Engineering, College of Engineering & Petroleum, Kuwait University, Safat 13060, Kuwait
1 shared publication - Jiayun Sun
National Laboratory of the Rockies, Golden, CO (United States)
1 shared publication
Latest Publications
- Open Access
Combining Sea Level Rise Inundation Impacts, Tidal Flooding and Extreme Wind Events along the Abu Dhabi Coastline
This paper describes the development of a two-dimensional, basin-scale tidal model with waves and wave run-up to determine the inundation impacts on the Abu Dhabi coastline due to the combined effect of sea level rise, tidal flooding, storm surge and waves. The model combines a hydrodynamics model (DELFT3D), a spectral wave model (SWAN) and wave run-up. A high horizontal resolution (down to about 30 m) is employed in the vicinity of Abu Dhabi—a city built on a system of mangrove islands along the Arabian Gulf coast—to enable prediction of impact at the scale of the local infrastructure, such as individual highway links. The model confirms that, with a rise in sea level of 0.5 m, the islands along the outer coast of Abu Dhabi will experience inundation due to tidal flooding, wind, and high Shamal-induced waves. The incorporation of the wind and waves results in a prediction of more than double the area found underwater within the study area (from 82 to 188 km2). The inner water channel regions of Abu Dhabi, while mostly unaffected by wind-driven wave events, are still vulnerable to tidal flooding. Finally, the paper demonstrates the use of the model to predict whether protection of one segment of the city’s coastline will adversely affect the inundation potential of nearby unprotected segments.
Open AccessCombining Sea Level Rise Inundation Impacts, Tidal Flooding and Extreme Wind Events along the Abu Dhabi Coastline
This paper describes the development of a two-dimensional, basin-scale tidal model with waves and wave run-up to determine the inundation impacts on the Abu Dhabi coastline due to the combined effect of sea level rise, tidal flooding, storm surge and waves. The model combines a hydrodynamics model (DELFT3D), a spectral wave model (SWAN) and wave run-up. A high horizontal resolution (down to about 30 m) is employed in the vicinity of Abu Dhabi—a city built on a system of mangrove islands along the Arabian Gulf coast—to enable prediction of impact at the scale of the local infrastructure, such as individual highway links. The model confirms that, with a rise in sea level of 0.5 m, the islands along the outer coast of Abu Dhabi will experience inundation due to tidal flooding, wind, and high Shamal-induced waves. The incorporation of the wind and waves results in a prediction of more than double the area found underwater within the study area (from 82 to 188 km2). The inner water channel regions of Abu Dhabi, while mostly unaffected by wind-driven wave events, are still vulnerable to tidal flooding. Finally, the paper demonstrates the use of the model to predict whether protection of one segment of the city’s coastline will adversely affect the inundation potential of nearby unprotected segments.
- Open Access
Confined Plunging Liquid Jets for Dilution of Brine from Desalination Plants
Confined plunging jets are investigated as potential outfalls for the discharge of desalination brine. Compared to offshore submerged outfalls that rely on momentum to induce mixing, plunging jets released above the water surface utilize both momentum and negative buoyancy. Plunging jets also introduce air into the water column, which can reduce the possibility of hypoxic zones. In contrast to unconfined plunging jets, confined plunging jets include a confining tube, or downcomer, around the jet, which increases the penetration depth of the bubbles and can provide better aeration. However, the presence of this downcomer can hinder mixing with surrounding water. Therefore, laboratory measurements of dilution are reported here and compared to the dilution of unconfined plunging jets. In addition, qualitative observations of bubble penetration depth are also used to discuss aeration potential. For designs that increase the bubble penetration depth as compared to unconfined plunging jets, results show that dilution decreases as the depth of the downcomer is increased. However, it is shown that confined plunging jets can be designed with a short downcomer to provide higher dilution than unconfined jets. The effect of the diameter of downcomer on dilution is also investigated and a non-monotonic effect is observed.
Open AccessConfined Plunging Liquid Jets for Dilution of Brine from Desalination Plants
Confined plunging jets are investigated as potential outfalls for the discharge of desalination brine. Compared to offshore submerged outfalls that rely on momentum to induce mixing, plunging jets released above the water surface utilize both momentum and negative buoyancy. Plunging jets also introduce air into the water column, which can reduce the possibility of hypoxic zones. In contrast to unconfined plunging jets, confined plunging jets include a confining tube, or downcomer, around the jet, which increases the penetration depth of the bubbles and can provide better aeration. However, the presence of this downcomer can hinder mixing with surrounding water. Therefore, laboratory measurements of dilution are reported here and compared to the dilution of unconfined plunging jets. In addition, qualitative observations of bubble penetration depth are also used to discuss aeration potential. For designs that increase the bubble penetration depth as compared to unconfined plunging jets, results show that dilution decreases as the depth of the downcomer is increased. However, it is shown that confined plunging jets can be designed with a short downcomer to provide higher dilution than unconfined jets. The effect of the diameter of downcomer on dilution is also investigated and a non-monotonic effect is observed.
- Open Access
Unconfined Dense Plunging Jets Used for Brine Disposal from Desalination Plants
Laboratory experiments were conducted to measure entrained air bubble penetration depth and dilution of a dense vertical unconfined plunging jet to evaluate its performance as an outfall to dilute brine from desalination plants as well as a means to aerate water column. Experiments involved neutrally buoyant or dense plunging jets discharging in quiescent receiving water. The density difference between effluent and receiving water, the plunging jet length (height above water surface), and the receiving water salinity were varied in the experiments. Observed penetration depth for neutrally buoyant jets was somewhat greater than previously reported, and increased modestly with jet density. Increasing density also resulted in an increasing number of fine bubbles descending together with the dense plume. These observations can help guide the design of plunging jets to mitigate anoxic conditions in the water column when brine is introduced to a receiving water body, as with seawater desalination.
Open AccessUnconfined Dense Plunging Jets Used for Brine Disposal from Desalination Plants
Laboratory experiments were conducted to measure entrained air bubble penetration depth and dilution of a dense vertical unconfined plunging jet to evaluate its performance as an outfall to dilute brine from desalination plants as well as a means to aerate water column. Experiments involved neutrally buoyant or dense plunging jets discharging in quiescent receiving water. The density difference between effluent and receiving water, the plunging jet length (height above water surface), and the receiving water salinity were varied in the experiments. Observed penetration depth for neutrally buoyant jets was somewhat greater than previously reported, and increased modestly with jet density. Increasing density also resulted in an increasing number of fine bubbles descending together with the dense plume. These observations can help guide the design of plunging jets to mitigate anoxic conditions in the water column when brine is introduced to a receiving water body, as with seawater desalination.
- Open Access
Numerical Prediction of Background Buildup of Salinity Due to Desalination Brine Discharges into the Northern Arabian Gulf
Brine discharges from desalination plants into low-flushing water bodies are challenging from the point of view of dilution, because of the possibility of background buildup effects that decrease the overall achievable dilution. To illustrate the background buildup effect, this paper uses the Arabian (Persian) Gulf, a shallow, reverse tidal estuary with only one outlet available for exchange flow. While desalination does not significantly affect the long-term average Gulf-wide salinity, due to the mitigating effect of the Indian Ocean Surface Water inflow, its resulting elevated salinities, as well as elevated concentrations of possible contaminants (such as heavy metals and organophosphates), can affect marine environments on a local and regional scale. To analyze the potential effect of background salinity buildup on dilutions achievable from discharge locations in the northern Gulf, a 3-dimensional hydrodynamic model (Delft3D) was used to simulate brine discharges from a single hypothetical source location along the Kuwaiti shoreline, about 900 km from the Strait of Hormuz. Using nested grids with a horizontal resolution, comparable to a local tidal excursion (250 m), far field dilutions of about 28 were computed for this discharge location. With this far field dilution, to achieve a total dilution of 20, the near field dilution (achievable using a submerged diffuser) would need to be increased to approximately 70. Conversely, the background build-up means that a near field dilution of 20 yields a total dilution of only about 12.
Open AccessNumerical Prediction of Background Buildup of Salinity Due to Desalination Brine Discharges into the Northern Arabian Gulf
Brine discharges from desalination plants into low-flushing water bodies are challenging from the point of view of dilution, because of the possibility of background buildup effects that decrease the overall achievable dilution. To illustrate the background buildup effect, this paper uses the Arabian (Persian) Gulf, a shallow, reverse tidal estuary with only one outlet available for exchange flow. While desalination does not significantly affect the long-term average Gulf-wide salinity, due to the mitigating effect of the Indian Ocean Surface Water inflow, its resulting elevated salinities, as well as elevated concentrations of possible contaminants (such as heavy metals and organophosphates), can affect marine environments on a local and regional scale. To analyze the potential effect of background salinity buildup on dilutions achievable from discharge locations in the northern Gulf, a 3-dimensional hydrodynamic model (Delft3D) was used to simulate brine discharges from a single hypothetical source location along the Kuwaiti shoreline, about 900 km from the Strait of Hormuz. Using nested grids with a horizontal resolution, comparable to a local tidal excursion (250 m), far field dilutions of about 28 were computed for this discharge location. With this far field dilution, to achieve a total dilution of 20, the near field dilution (achievable using a submerged diffuser) would need to be increased to approximately 70. Conversely, the background build-up means that a near field dilution of 20 yields a total dilution of only about 12.