Deyong Wu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Deyong Wu has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
Li Han
3 shared publicationsZiru Shao
School of Chemical and Environmental Engineering, Hubei Minzu University, Enshi, China
3 shared publicationsChengyi Wu
School of Chemical and Environmental Engineering, Hubei Minzu University, Enshi, China
2 shared publicationsShuangfei Zhang
School of Chemical and Environmental Engineering, Hubei Minzu University, Enshi, Hubei Province 445000, China
2 shared publicationsWanting Liu
School of Chemical and Environmental Engineering, Hubei Minzu University, Enshi, China
2 shared publicationsXinru Ni
School of Chemical and Environmental Engineering, Hubei Minzu University, Enshi, China
2 shared publications
Latest Publications
- 12 October 2026
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 50 (39) , 17016-17032
Iron–nitrogen co-modified biochar as bifunctional peroxymonosulfate activator for adsorption and decomposition of tetracycline in water
Iron–nitrogen co-modified biochar is a cost-effective and eco-friendly material serving as both adsorbent and catalyst for aqueous pollutant removal.
- 12 October 2026
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 50 (39) , 17016-17032
Iron–nitrogen co-modified biochar as bifunctional peroxymonosulfate activator for adsorption and decomposition of tetracycline in water
Iron–nitrogen co-modified biochar is a cost-effective and eco-friendly material serving as both adsorbent and catalyst for aqueous pollutant removal.
- Open Access
- 7 July 2026
- Published by Elsevier in SSRN Electronic Journal
Cobalt-modified biochar as peroxymonosulfate activator for efficient tetracycline hydrochloride degradation
To achieve the resource utilization of agricultural and forestry waste and develop efficient catalysts for water treatment, this study employed waste pomelo peel as a raw material. After thorough mixing with cobalt salt, the precursor was subjected to high-temperature pyrolysis under oxygen-limited conditions to synthesize a cobalt-modified biochar composite (Co-NABC), which was used to activate peroxymonosulfate (PMS) for the degradation of tetracycline hydrochloride (TC). The successful loading of cobalt species onto the biochar surface was confirmed through characterization techniques including XRD, XPS and FT-IR. Co-NABC/PMS system showed excellent performance in TC degradation, and several influencing factors were investigated, such as initial pH, catalyst dosage, PMS concentration, reaction temperature and co-existing anions. And Co-NABC/PMS system exhibited high stability, the degradation efficiency remained as high as 90.2% after four consecutive reuse cycles. The reactive species generated during the reaction were dominated by superoxide radicals.
- 7 July 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessCobalt-modified biochar as peroxymonosulfate activator for efficient tetracycline hydrochloride degradation
To achieve the resource utilization of agricultural and forestry waste and develop efficient catalysts for water treatment, this study employed waste pomelo peel as a raw material. After thorough mixing with cobalt salt, the precursor was subjected to high-temperature pyrolysis under oxygen-limited conditions to synthesize a cobalt-modified biochar composite (Co-NABC), which was used to activate peroxymonosulfate (PMS) for the degradation of tetracycline hydrochloride (TC). The successful loading of cobalt species onto the biochar surface was confirmed through characterization techniques including XRD, XPS and FT-IR. Co-NABC/PMS system showed excellent performance in TC degradation, and several influencing factors were investigated, such as initial pH, catalyst dosage, PMS concentration, reaction temperature and co-existing anions. And Co-NABC/PMS system exhibited high stability, the degradation efficiency remained as high as 90.2% after four consecutive reuse cycles. The reactive species generated during the reaction were dominated by superoxide radicals.
- 29 August 2025
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 49 (39) , 16989-17004
Single atom Cu anchored on porous polymeric carbon nitride toward peroxymonosulfate activation for emerging pollutant degradation
Single atom Cu anchored on porous polymeric carbon nitride for peroxymonosulfate activation to efficiently decontaminate emerging pollutants.
- 29 August 2025
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 49 (39) , 16989-17004
Single atom Cu anchored on porous polymeric carbon nitride toward peroxymonosulfate activation for emerging pollutant degradation
Single atom Cu anchored on porous polymeric carbon nitride for peroxymonosulfate activation to efficiently decontaminate emerging pollutants.
- 3 October 2024
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 48 (42) , 18229-18240
Efficient peroxymonosulfate activation by microscale CuO coated melamine–cyanuric acid supramolecular assembly toward tetracycline degradation
For reducing the amount and fully utilizing the active sites of CuO, a microscale CuO coated melamine–cyanuric acid supramolecular assembly (CuO/MCSA) was developed in situ and employed as an efficient peroxymonosulfate (PMS) activator for water decontamination. The characteristics of CuO/MCSA were characterized by XRD, FT-IR, XPS, SEM, TEM and BET. CuO/MCSA showed strong catalytic ability to activate PMS for tetracycline (TC) degradation. Under the conditions of pH ≈ 7 and a PMS dosage of 0.5 mmol L−1, 1 g L−1 of CuO/MCSA including less than 3.0 wt% CuO can remove about 70% of 20 mg L−1 TC within 5 min. After five consecutive cycles, the degradation rate of CuO/MCSA was still around 52.6%. The PMS dosage, reaction temperature, initial pH value, and co-existing anions and small molecule acids all affected the performance of the CuO/MCSA/PMS system in TC degradation. According to quenching experiments and electron paramagnetic resonance (EPR) testing, 1O2 played the most important role in TC degradation in the CuO/MCSA/PMS system. In addition, the CuO/MCSA/PMS system exhibited wide applicability, and can effectively remove TC in different water bodies (deionized water, tap water and lake water) and various pollutants (TC, methylene orange and methyl blue). Overall, this work provided an effective strategy to enhance the efficient utilization of a catalyst for PMS activation.
- 3 October 2024
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 48 (42) , 18229-18240
Efficient peroxymonosulfate activation by microscale CuO coated melamine–cyanuric acid supramolecular assembly toward tetracycline degradation
For reducing the amount and fully utilizing the active sites of CuO, a microscale CuO coated melamine–cyanuric acid supramolecular assembly (CuO/MCSA) was developed in situ and employed as an efficient peroxymonosulfate (PMS) activator for water decontamination. The characteristics of CuO/MCSA were characterized by XRD, FT-IR, XPS, SEM, TEM and BET. CuO/MCSA showed strong catalytic ability to activate PMS for tetracycline (TC) degradation. Under the conditions of pH ≈ 7 and a PMS dosage of 0.5 mmol L−1, 1 g L−1 of CuO/MCSA including less than 3.0 wt% CuO can remove about 70% of 20 mg L−1 TC within 5 min. After five consecutive cycles, the degradation rate of CuO/MCSA was still around 52.6%. The PMS dosage, reaction temperature, initial pH value, and co-existing anions and small molecule acids all affected the performance of the CuO/MCSA/PMS system in TC degradation. According to quenching experiments and electron paramagnetic resonance (EPR) testing, 1O2 played the most important role in TC degradation in the CuO/MCSA/PMS system. In addition, the CuO/MCSA/PMS system exhibited wide applicability, and can effectively remove TC in different water bodies (deionized water, tap water and lake water) and various pollutants (TC, methylene orange and methyl blue). Overall, this work provided an effective strategy to enhance the efficient utilization of a catalyst for PMS activation.
- Open Access
- 1 November 2023
- Published by Scientific Scholar in Arabian Journal of Chemistry
- Vol. 16 (11)
Heterogeneous activation of peroxymonosulfate by recyclable magnetic CuO/Fe3O4 nanosheets for efficient degradation of organic pollutants
- 1 November 2023
- Published by Scientific Scholar in Arabian Journal of Chemistry
- Vol. 16 (11)
Open AccessHeterogeneous activation of peroxymonosulfate by recyclable magnetic CuO/Fe3O4 nanosheets for efficient degradation of organic pollutants
- 29 January 2020
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- Vol. 94 (2) , 251-256
MoS2 microspheres/MOF-derived In2S3 heterostructures with enhanced visible-light photocatalytic activity
- 29 January 2020
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- Vol. 94 (2) , 251-256
MoS2 microspheres/MOF-derived In2S3 heterostructures with enhanced visible-light photocatalytic activity
- 12 November 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (12) , 125501
Fabrication of novel Ag/AgBr/NH2-MIL-125(Ti) nanocomposites with enhanced visible-light photocatalytic activity
- 12 November 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (12) , 125501
Fabrication of novel Ag/AgBr/NH2-MIL-125(Ti) nanocomposites with enhanced visible-light photocatalytic activity
- 5 July 2019
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- Vol. 91 (3) , 441-445
Solvothermal synthesis and characterization of visible-light-active MoO3/MoS2 heterostructure
- 5 July 2019
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- Vol. 91 (3) , 441-445
Solvothermal synthesis and characterization of visible-light-active MoO3/MoS2 heterostructure
- 2 January 2019
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 30 (4) , 3773-3781
Construction and characterization of BiOI/NH2-MIL-125(Ti) heterostructures with excellent visible-light photocatalytic activity
- 2 January 2019
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 30 (4) , 3773-3781
Construction and characterization of BiOI/NH2-MIL-125(Ti) heterostructures with excellent visible-light photocatalytic activity