Su-Han Lee
Su-Han Lee has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Han-Jung Kim
IT Materials & Components Research Center, Gumi Electronics & Information Technology Research Institute (GERI), Cheomdangieop1-ro 17, Sandong-eup, Gumi 39171, Republic of Korea
2 shared publications - Yoonkap Kim
IT Materials & Components Research Center, Gumi Electronics & Information Technology Research Institute (GERI), Cheomdangieop1-ro 17, Sandong-eup, Gumi 39171, Republic of Korea
2 shared publications - Byong-Sam Han
SUNTECH Co., Ltd., Gumi-si 39166, Korea
1 shared publication - Dong-Ik Kim
Center for Integrated Smart Sensors (CISS), Korea Advanced Institute of Science and Technology (KAIST), Daejeon 34141, Korea
1 shared publication - Dong-Ik Kim
BRAIN GEAR Co., Ltd., Daejeon 34051, Korea
1 shared publication - Dong-In Choi
Convergence Materials Research Center, Gumi Electronics and Information Technology Research Institute (GERI), Gumi-si 39171, Korea
1 shared publication
Latest Publications
- Open Access
- 23 April 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (9) , 3831
Eco-Friendly Poly(Vinyl Alcohol) Nanofiber-Based Air Filter for Effectively Capturing Particulate Matter
Due to the increasing use of polypropylene-based nonwoven dust masks and air filters, environmental problems that occur due to the plastic pollution resulting from the disposal of these materials have also increased. Hence, an eco-friendly air filter based on PVA nanofibers (NFs) was fabricated by electrospinning on a nonwoven fabric, and its performance was evaluated as a filter capable of blocking or capturing particulate matter. The quality factor of the optimized PVA NF-based air filter was found to be 0.010606 Pa−1, which is lower than that of a HEPA filter (0.015394 Pa−1), but higher than that of a cabin air filter (0.010517 Pa−1) and a dust mask (0.009102 Pa−1). The contamination level of the PVA NF-based filter was analyzed by optical and structural analyses of the filter surface. Finally, the filter was soaked in water to selectively remove the contaminated PVA NF layer, and the remaining nonwoven fabric was able to be reused to make the filter.
- 23 April 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (9) , 3831
Open AccessEco-Friendly Poly(Vinyl Alcohol) Nanofiber-Based Air Filter for Effectively Capturing Particulate Matter
Due to the increasing use of polypropylene-based nonwoven dust masks and air filters, environmental problems that occur due to the plastic pollution resulting from the disposal of these materials have also increased. Hence, an eco-friendly air filter based on PVA nanofibers (NFs) was fabricated by electrospinning on a nonwoven fabric, and its performance was evaluated as a filter capable of blocking or capturing particulate matter. The quality factor of the optimized PVA NF-based air filter was found to be 0.010606 Pa−1, which is lower than that of a HEPA filter (0.015394 Pa−1), but higher than that of a cabin air filter (0.010517 Pa−1) and a dust mask (0.009102 Pa−1). The contamination level of the PVA NF-based filter was analyzed by optical and structural analyses of the filter surface. Finally, the filter was soaked in water to selectively remove the contaminated PVA NF layer, and the remaining nonwoven fabric was able to be reused to make the filter.
- Open Access
Evaporation-Rate Control of Water Droplets on Flexible Transparent Heater for Sensor Application
To develop high-performance de- or anti-frosting/icing devices based on transparent heaters, it is necessary to study the evaporation-rate control of droplets on heater surfaces. However, almost no research has been done on the evaporation-rate control of liquid droplets on transparent heaters. In this study, we investigate the evaporation characteristics of water droplets on transparent heater surfaces and determine that they depend upon the surface wettability, by modifying which, the complete evaporation time can be controlled. In addition, we study the defrosting and deicing performances through the surface wettability, by placing the flexible transparent heater on a webcam. The obtained results can be used as fundamental data for the transparent defrosting and deicing systems of closed-circuit television (CCTV) camera lenses, smart windows, vehicle backup cameras, aircraft windows, and sensor applications.
Open AccessEvaporation-Rate Control of Water Droplets on Flexible Transparent Heater for Sensor Application
To develop high-performance de- or anti-frosting/icing devices based on transparent heaters, it is necessary to study the evaporation-rate control of droplets on heater surfaces. However, almost no research has been done on the evaporation-rate control of liquid droplets on transparent heaters. In this study, we investigate the evaporation characteristics of water droplets on transparent heater surfaces and determine that they depend upon the surface wettability, by modifying which, the complete evaporation time can be controlled. In addition, we study the defrosting and deicing performances through the surface wettability, by placing the flexible transparent heater on a webcam. The obtained results can be used as fundamental data for the transparent defrosting and deicing systems of closed-circuit television (CCTV) camera lenses, smart windows, vehicle backup cameras, aircraft windows, and sensor applications.