RKRobert Kostecki

Robert Kostecki

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Robert Kostecki has a total of 279 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Persistent Inter-particle State-of-Charge Heterogeneity in Fast-Charged High-Loading NMC811 Electrodes Revealed by Ex Situ Raman Spectroscopy

    by Philipp Voß, Manuel Schnabel, Simon Lux, Robert Kostecki

    Designing high-energy lithium-ion battery (LIB) cells based on LiNi0.8Mn0.1Co0.1O2 (NMC811) cathodes that combine high areal capacity, fast-charge capability, and long-term cycling stability remains challenging. Particle de-/lithiation and degradation do not proceed uniformly across composite electrodes or within NMC secondary particles, resulting in inter- and intra-particle state-of-charge (SOC) heterogeneity that can accelerate electrode degradation and limit rate capability. This work introduces an ex situ Raman-based approach to estimate the local SOC in NMC811 particles in ion-milled electrode cross-sections with sub-micron lateral resolution. The method is based on an empirical correlation between SOC and the wavenumber of the minimum/inflection point near 500 cm–1 in the Raman spectra. We investigated high-loading NMC811 electrodes at charge rates from 0.5 to 3C (with 0.1C used for calibration) and after 100 aging cycles at 0.5C. Our key finding is the charge-rate-dependent occurrence of a particle subgroup with Raman-derived SOC values near 0% after open-circuit relaxation. At charge rates ≤1C, the measured particles exhibit a continuous, unimodal SOC distribution across particles, whereas at ≥1.5C, a distinct near-0% SOC particle subgroup is still detectable after >1 h under open-circuit conditions, with Raman signatures consistent with a highly lithiated state. The absence of this near-0% SOC particle subgroup in aged electrodes cycled at 0.5C argues against degradation as the primary origin and indicates that the phenomenon is primarily rate-driven. Overall, this work reveals persistent heterogeneous active-material utilization in high-loading NMC811 electrodes and suggests that fast charging can kinetically isolate a subset of particles or particle regions even after open-circuit relaxation, which may contribute to electrode degradation and capacity fade.

  • Open Access

    High purity and reduced defects hard carbon synthesis for sodium-ion batteries

    by Harshita Lohani, Xiaobing Zuo, Finn Babbe, Venkata Sai Avvaru, Andrew Dopilka, Robert Kostecki, Shilong Wang, Stephen E. Trask, Guiliang Xu, Hyunuk Kang, et al.

    The substrate and reaction atmosphere govern impurity incorporation and defect formation during hard-carbon synthesis, thereby strongly influencing its electrochemical Na-storage performance.

  • Improving the Calendar Life of Silicon Anodes with Inorganic Solid–Electrolyte Interphases

    by Youngmin Ko, Dong-Min Kim, Andrew Dopilka, Marco-Tulio Fonseca Rodrigues, Gabriel D. Parker, Steven Lam, Xiao-Ying Yu, Amanda L. Musgrove, Robert Kostecki, Brett A. Helms

    Silicon anodes unlock higher energy density in Li-ion batteries but suffer from poor calendar life due to inadequately passivating solid–electrolyte interphases (SEIs). Here, we contrast the calendar aging behaviors of single- and mixed-salt locally superconcentrated electrolytes (LSCEs) against carbonate electrolytes. Mixed-salt LSCE cells retained 96% and 44% of precalendar capacity after one month and then after five months, while carbonate electrolyte cells retained 77% and 1%, respectively. The mixed-salt LSCE advantage is tied to the formation of a predominantly inorganic SEI, evidenced by nanoscale Fourier transform infrared spectromicroscopy, X-ray photoelectron spectroscopy, and 3D time-of-flight secondary ion mass spectrometry. After 5 months, however, perturbations to SEIs were evident in all cells, accelerating voltage decay and capacity loss by lithium inventory loss associated with SEI growth. These findings suggest that future electrolytes may benefit from strategies that continuously reinforce the SEI through controlled anion and solvent redox in LSCEs.

  • In Operando Raman Reveals Voltage-Driven SEI Chemistry in Fluorinated Gel Electrolytes

    by Rhyz Pereira, Andrew Dopilka, Subhadra Jamkar, Jantakan Nedsaengtip, Taber Yim, Robert Kostecki, Vibha Kalra

    A particular advantage of gel polymer electrolytes (GPEs) has been their ability to incorporate chemical moieties that create stable electrode–electrolyte interfaces that guide uniform deposition and stripping of lithium. Understanding the chemical dynamics at these interfaces remains challenging. Previously, we reported that polyvinylidene fluoride-cohexafluoropropylene (PVDF-HFP) GPEs with an ether cosolvent showed greater stability in lithium metal symmetric cells. In this work, we used a Cu|PVDF-HFP|Li cell design along with in operando Raman spectroscopy to conduct a thorough characterization of the electrolyte–electrode interface to observe the chemical dynamics at work during electrode polarization, lithium plating, and stripping. We observe that PVDF-HFP, cosolvent, and supporting salt all contribute to the initial SEI formation prior to plating. The spectral and electrochemical data using this method allow us to understand the contribution of different chemical species in the evolution of interfaces in lithium metal batteries.

  • Open Access

    A practical introduction to electrochemical atomic force microscopy and scanning tunneling microscopy

    by Inhee Park, Austin D Ready, Rayan Alaufey, Robert Kostecki, Florian Hausen

    Directly monitoring the structure and evolution of an electrode surface during reaction provides uniquely powerful insight into interfacial processes. Electrochemical atomic force microscopy (EC-AFM) and Scanning Tunneling Microscopy (EC-STM) have therefore become essential tools for linking potential-controlled surface transformations to macroscopic current and product outcomes. In EC-AFM, surface features are measured from the deflection of a typically laser-tracked cantilever, enabling imaging of metals, semiconductors, and insulators in liquid electrolytes. By selecting appropriate probes and operating modes, EC-AFM maps topography together with complementary channels such as mechanical response, friction, and local electrical contrast, offering a multi-parametric view of the electrified interface during processes such as film formation, corrosion, gas evolution, and electrodeposition. By contrast, EC-STM measures the tunneling current between a conductive tip and a conductive substrate, providing access to atomic-scale surface order, reconstruction, and adsorbate structures under EC control. In liquid environments, STM performance is limited by parasitic faradaic currents and capacitive coupling, making careful EC configuration and robust tip insulation (coated everywhere except the apex) critical for stable imaging. This tutorial summarizes practical EC cell considerations, probe preparation, alignment and calibration steps, and data-handling best practices for acquiring reproducible in-operando SPM datasets. This tutorial seeks to make EC-AFM/EC-STM measurements more approachable for beginners by clearly explaining the fundamental principles as well as practical considerations, allowing practitioners to gain highly informative EC insights on their systems of interest. Throughout, we emphasize common EC artifacts and decision rules that help newcomers distinguish true potential-dependent surface dynamics from drift, bubble interference, leakage currents, and feedback-induced contrast, enabling reliable interpretation of AFM/STM observations in EC environments.


  • Enhancing Cycling Stability and Calendar Life of Silicon-Based Cells via Localized High-Concentration Electrolytes

    by Lydia Meyer, Marco-Tulio Rodrigues, Kevin L. Gering, Danielle Alexia Henckel, Andrew Dopilka, Nessa Majaya, Robert Kostecki, Kristin A. Persson, Gabriel M. Veith, Andrew M. Colclasure, et al.

    Silicon-based anodes can potentially increase the energy density of Li-ion batteries. However, silicon anodes have limited calendar lifetimes due to deleterious side reactions. For example, trace water in the electrolyte may hydrolyze to form HF, which can destroy the solid electrolyte interphase (SEI), even without cycling. While removing contaminants like water and HF from the electrolyte could be a solution, utilizing a different electrolyte system that provides a more passivating, stable, or contaminant tolerant SEI may be more effective for improving calendar life. Localized high concentration electrolytes (LHCEs) were chosen because of their stability in reactive systems, such as Li metal. In the present study, calendar life tests showed that cells with LHCEs containing 200 ppm of water retain up to 8% greater capacity (1200-1300 mAh/g Si) after 200 days of calendar aging compared to cells with LHCEs containing <20 ppm water. Calendar aging took place at 100% state of charge. In cycle life studies, cells with 200 and 20 ppm water retained similar capacities after 500 cycles (900-1000 mAh/g Si), and even adding up to 1000 ppm water did not rapidly deteriorate cell capacity. These findings indicate the considerable stability of LHCEs versus a reactive electrode despite the presence of deleterious contaminants. LHCEs represent a promising alternative to dilute carbonate-based electrolytes for improving the calendar life of Si-based anodes.

  • Open Access

    Electrode-omics reveals epochs in silicon anode evolution underpinning electrochemomechanical resilience

    by Youngmin Ko, Dong-Min Kim, Amanda L. Musgrove, Hyungyeon Cha, Liana Klivansky, Jaclyn Coyle, Andrew Dopilka, Stephen E. Trask, Marco-Tulio Fonseca Rodrigues, Young-Woon Byeon, et al.

    Here, we advance electrode-omics to identify evolutionary bursts by which ethereal locally superconcentrated electrolytes (LSCEs) mitigate silicon anode degradation through its epochs of electrochemical and chemical reactions. Anode composites form initially at high potential from ethereal solvent and anion [bis(fluorosulfonyl)imide (FSI − )] redox. A first evolutionary burst at lower potential enriches composites with lithium alkoxides (LiO–R) and lithium oxide (Li 2 O) and depletes sulfur oxides (SO x ) species. As the cells are cycled, a second evolutionary burst takes place, where previously extinct SO x species reemerge concurrently with a loss of LiO–R and Li 2 O. This identifies reactions rooted in “SuFEx” chemistry, where oxoanionic LiO–R and Li 2 O species, electrochemically generated in the solid-electrolyte interphase, chemically react with FSI − in the electrolyte to form emergent species. This sequence of evolutionary bursts produces a mechanically resilient composite that reduces silicon anode cracking over hundreds of cycles, leading to overpotential increase of only ~0.01 volts after 200 cycles.


  • Carbon–Mineral Slurry Electrodes for Energy-Efficient Lithium Leaching from Low-Grade Clay Feedstocks

    by Andrew Z. Haddad, Hyungyeon Cha, Sahand Adibnia, Xander B. Fleming, Liam McDonough, Floria Li, Siva Bandaru, Raynald Giovine, Chaochao Dun, Garrett Pohlman, et al.

    Lithium extraction from clay deposits is typically hampered by low lithium grades and the high capital and energy demands of conventional processing. We report an ambient temperature electrochemical leaching method that bypasses high-temperature roasting and concentrated-acid leaching, directly liberating 93% of lithium from low-grade hectorite in 24 h at 1 V, with 77% Faradaic efficiency, an energy intensity of 3.91 MWh/t lithium carbonate equivalent (LCE). Utilizing a carbon-mineral composite slurry electrode strategy we achieve electron-driven lattice deconstruction through iron oxidation coupled with proton uptake to drive lithium deintercalation, offering a new strategy for low-temperature critical-metal recovery. A preliminary cost analysis highlights pathways to achieving cost intensities below $3000/t LCE. Challenges remain in improving current density, extraction kinetics, and demonstrating process scalability, however, this work establishes a foundation for effective electrochemical lithium extraction from abundant but previously uneconomical clay deposits.


  • Top Cited Papers

    Nanoengineering of non-aqueous liquid electrolyte solutions for future lithium metal batteries

    by Dominik Weintz, Martin Werres, Birger Horstmann, Rachid Amine, Chi-Cheung Su, Xinlin Li, Yaobin Xu, Ridwan A. Ahmed, Wu Xu, Chongmin Wang, et al.

    Research and development of non-aqueous electrolyte solutions are essential for practical advancement towards the production of high-energy lithium metal batteries (LMBs). An ideal LMB electrolyte solution should enable highly efficient, uniform and prolonged lithium metal plating and stripping, preserve the electrodes’ electro(chemo)mechanical properties and ensure compatibility with all cell components. However, despite extensive research efforts, scientists have yet to achieve an electrolyte design that meets these requirements simultaneously. Here, by examining the nanoengineering aspects of various non-aqueous electrolyte solution designs, we elucidate the understanding of the nanoscale physicochemical and electrochemical processes taking place in LMBs, which are mainly governed by the thermodynamic and kinetic properties of the electrolyte system. We also explore emerging research directions and propose an accelerated, iterative framework that integrates nanoengineering principles with machine learning, high-throughput computation and experimentation to facilitate the development of next-generation non-aqueous electrolyte solutions for practical LMBs.