Xiaoying Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Xiaoying Liu has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Chong Peng
Engineering Software Steyr, Berggasse 35, 4400 Steyr, Austria
1 shared publication - Junfeng Jiang
Tianjin University
1 shared publication - Kun Liu
Tianjin University
1 shared publication - Lei Chen
School of Computing, Tokyo Institute of Technology, Ookayama 2-12-1, Meguro-ku, Tokyo 152-8550, Japan
1 shared publication Lei Xue
School of Precision Instrument and Optoelectronics Engineering, Tianjin University, Tianjin, China
1 shared publication- Lei Ye
School of Microelectronics and Communication Engineering, Chongqing University, Chongqing 400044, China
1 shared publication
Latest Publications
- Open Access
- 17 October 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 11 (6) , 1-10
A Compact Fiber Optic Fabry–Perot Sensor for Simultaneous Measurement of Acoustic and Temperature
A compact fiber optic Fabry-Perot (F-P) sensor for simultaneous acoustic and temperature measurement has been proposed in the research. The sensor consists of silicon-glass-silicon sandwich structure by anodic bonding. The air F-P cavity with a circular hole and slots utilizes the deformation of the silicon membrane to realize acoustic measurement, and the silicon F-P cavity utilizes the temperature sensitivity of the refractive index of silicon to realize temperature measurement. The acoustic signal and temperature information could be recovered by acoustic and temperature demodulation method, respectively. The experimental results demonstrate that the sensor has a signal-to-noise ratio (SNR) of 53 dB and the acoustic sensitivity of 4.65 mV/Pa at 21 kHz, and the temperature sensitivity of 123.10 nm/°C at 20 °C~120 °C. The proposed fiber optic F-P sensor has great potential for simultaneous acoustic and temperature measurement in aviation, due to its compact structure, mass production and immunity to electromagnetic interference.
- 17 October 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 11 (6) , 1-10
Open AccessA Compact Fiber Optic Fabry–Perot Sensor for Simultaneous Measurement of Acoustic and Temperature
A compact fiber optic Fabry-Perot (F-P) sensor for simultaneous acoustic and temperature measurement has been proposed in the research. The sensor consists of silicon-glass-silicon sandwich structure by anodic bonding. The air F-P cavity with a circular hole and slots utilizes the deformation of the silicon membrane to realize acoustic measurement, and the silicon F-P cavity utilizes the temperature sensitivity of the refractive index of silicon to realize temperature measurement. The acoustic signal and temperature information could be recovered by acoustic and temperature demodulation method, respectively. The experimental results demonstrate that the sensor has a signal-to-noise ratio (SNR) of 53 dB and the acoustic sensitivity of 4.65 mV/Pa at 21 kHz, and the temperature sensitivity of 123.10 nm/°C at 20 °C~120 °C. The proposed fiber optic F-P sensor has great potential for simultaneous acoustic and temperature measurement in aviation, due to its compact structure, mass production and immunity to electromagnetic interference.
- 26 December 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2095-2100
V2V channel allocation method based on SWM communication demand matrix
V2V transmission of Safety Warning Message (SWM) can provide warning before emergency occurs to avoid accident, and remind surrounding vehicles to avoid potential danger. There are two main problems that will affect the transmission performance of SWM, namely the high local flow and low efficiency caused by high probability of sub-health vehicles (SHV) and traditional single channel and flooding transmission mechanism. Therefore a novel channel allocation algorithm based on communication demand matrix has been proposed in this paper. A new parameter, communication demand relationship based on health evaluation results is defined and communication demand matrix (CDM) is constructed to measure the transmission demand between corresponding vehicles. Then intra-cluster channel allocation algorithm based on the CDM is studied to effectively allocate the channel resource and improve SWM dissemination performance. The simulation and experimental results show that the proposed mechanism has much higher ratio of fulfilled communication demand in the same time slots than flooding based on communication demand relationship (FD) methods in low, medium, and high vehicle density scenario. Beyond that, the proposed mechanism has better performance in receiving messages than FD and flooding.
- 26 December 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2095-2100
V2V channel allocation method based on SWM communication demand matrix
V2V transmission of Safety Warning Message (SWM) can provide warning before emergency occurs to avoid accident, and remind surrounding vehicles to avoid potential danger. There are two main problems that will affect the transmission performance of SWM, namely the high local flow and low efficiency caused by high probability of sub-health vehicles (SHV) and traditional single channel and flooding transmission mechanism. Therefore a novel channel allocation algorithm based on communication demand matrix has been proposed in this paper. A new parameter, communication demand relationship based on health evaluation results is defined and communication demand matrix (CDM) is constructed to measure the transmission demand between corresponding vehicles. Then intra-cluster channel allocation algorithm based on the CDM is studied to effectively allocate the channel resource and improve SWM dissemination performance. The simulation and experimental results show that the proposed mechanism has much higher ratio of fulfilled communication demand in the same time slots than flooding based on communication demand relationship (FD) methods in low, medium, and high vehicle density scenario. Beyond that, the proposed mechanism has better performance in receiving messages than FD and flooding.