Ying Wu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Ying Wu has a total of 69 co-authors. Here are the top co-authors by number of shared publications:
Sunan Ding
3 shared publications- Sunan Ding
Nanjing University
3 shared publications - Boyuan Feng
Vacuum Interconnected Nanotech Workstation (Nano-X), Suzhou Institute of Nano-Tech and Nano-Bionics, Chinese Academy of Sciences 3 , Suzhou 215123, China
2 shared publications - Gaohang He
IMEC 3001 Leuven Belgium
2 shared publications - Xiaohong Zeng
Nanjing University
2 shared publications - Yongfa Zhu
Department of Chemistry Tsinghua University Beijing People's Republic of China
2 shared publications
Latest Publications
- Open Access
- 25 July 2025
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 11 (30) , eadw5005
Two-dimensional buffer breaks substrate limit in III-nitrides epitaxy
Expanding the diversity of substrate materials for the growth of single-crystalline films enables the heterointegration of electronic and optoelectronic devices in modern semiconductor industry. However, the substrate materials are restricted to those having matched single-crystalline lattices with the epilayers, thereby making the use of non-single-crystalline substrates infeasible. Here, we report an epitaxy strategy for the wafer-scale growth of high-quality single-crystalline gallium nitride (GaN) on an amorphous silicon dioxide (SiO 2 ) substrate. We achieve this result through a chemical bond transition, converting multilayer molybdenum disulfide (MoS 2 ) to molybdenum nitride (MoN), which serves as a buffer layer to engineer a preferred orientation for the epitaxy of the overlying GaN film. Using this method, we also demonstrate the growth of an AlGaN/AlN/GaN heterostructure with high electron mobility exceeding 2000 square centimeters per volt per second. The resultant high-electron-mobility transistors exhibit subthreshold swing, on/off ratio, and threshold voltage comparable to those commercial devices.
- 25 July 2025
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 11 (30) , eadw5005
Open AccessTwo-dimensional buffer breaks substrate limit in III-nitrides epitaxy
Expanding the diversity of substrate materials for the growth of single-crystalline films enables the heterointegration of electronic and optoelectronic devices in modern semiconductor industry. However, the substrate materials are restricted to those having matched single-crystalline lattices with the epilayers, thereby making the use of non-single-crystalline substrates infeasible. Here, we report an epitaxy strategy for the wafer-scale growth of high-quality single-crystalline gallium nitride (GaN) on an amorphous silicon dioxide (SiO 2 ) substrate. We achieve this result through a chemical bond transition, converting multilayer molybdenum disulfide (MoS 2 ) to molybdenum nitride (MoN), which serves as a buffer layer to engineer a preferred orientation for the epitaxy of the overlying GaN film. Using this method, we also demonstrate the growth of an AlGaN/AlN/GaN heterostructure with high electron mobility exceeding 2000 square centimeters per volt per second. The resultant high-electron-mobility transistors exhibit subthreshold swing, on/off ratio, and threshold voltage comparable to those commercial devices.
- Open Access
Amorphous-like TiN Films as Barrier Layers for Copper
The titanium nitride (TiN) columnar structure results in a rapid diffusion of copper atoms into the substrate along a vertical path. In this paper, the TiN columnar growth process was modified, which resulted in the deposition of amorphous-like films. The amorphous-like TiN layer demonstrated a low resistivity of 75.3 μΩ·cm. For the test structure of Cu/TiN/SiO2, the Cu diffusion depth in the 3 nm TiN middle layer was only approximately 1 nm after annealing at 750 °C for 30 min. Excellent copper diffusion barrier due to high density and complex diffusion pathways. The results of this study suggest that conventional barrier materials can still be used in ultra-narrow copper interconnects.
Open AccessAmorphous-like TiN Films as Barrier Layers for Copper
The titanium nitride (TiN) columnar structure results in a rapid diffusion of copper atoms into the substrate along a vertical path. In this paper, the TiN columnar growth process was modified, which resulted in the deposition of amorphous-like films. The amorphous-like TiN layer demonstrated a low resistivity of 75.3 μΩ·cm. For the test structure of Cu/TiN/SiO2, the Cu diffusion depth in the 3 nm TiN middle layer was only approximately 1 nm after annealing at 750 °C for 30 min. Excellent copper diffusion barrier due to high density and complex diffusion pathways. The results of this study suggest that conventional barrier materials can still be used in ultra-narrow copper interconnects.
- Open Access
- 14 March 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 135 (10)
Study on the effects of Si-doping in molecular beam heteroepitaxial β-Ga2O3 films
β-Ga2O3, an emerging wide bandgap semiconductor material, holds significant potential for various applications. However, challenges persist in improving the crystal quality and achieving controllable doping of β-Ga2O3. In particular, the relationship between these factors and the mechanisms behind them are not fully understood. Molecular beam epitaxy (MBE) is viewed as one of the most sophisticated techniques for growing high-quality crystalline films. It also provides a platform for studying the effects of doping and defects in heteroepitaxial β-Ga2O3. In our study, we tackled the issue of Si source passivation during the MBE growth of Si-doped β-Ga2O3. We did this by using an electron beam vaporize module, a departure from the traditional Si effusion cell. Our research extensively explores the correlation between Si doping concentration and film properties. These properties include microstructure, morphology, defects, carrier conductivity, and mobility. The results from these investigations are mutually supportive and indicate that a high density of defects in heteroepitaxial β-Ga2O3 is the primary reason for the challenges in controllable doping and conductivity. These insights are valuable for the ongoing development and enhancement of β-Ga2O3-based device techniques.
- 14 March 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 135 (10)
Open AccessStudy on the effects of Si-doping in molecular beam heteroepitaxial β-Ga2O3 films
β-Ga2O3, an emerging wide bandgap semiconductor material, holds significant potential for various applications. However, challenges persist in improving the crystal quality and achieving controllable doping of β-Ga2O3. In particular, the relationship between these factors and the mechanisms behind them are not fully understood. Molecular beam epitaxy (MBE) is viewed as one of the most sophisticated techniques for growing high-quality crystalline films. It also provides a platform for studying the effects of doping and defects in heteroepitaxial β-Ga2O3. In our study, we tackled the issue of Si source passivation during the MBE growth of Si-doped β-Ga2O3. We did this by using an electron beam vaporize module, a departure from the traditional Si effusion cell. Our research extensively explores the correlation between Si doping concentration and film properties. These properties include microstructure, morphology, defects, carrier conductivity, and mobility. The results from these investigations are mutually supportive and indicate that a high density of defects in heteroepitaxial β-Ga2O3 is the primary reason for the challenges in controllable doping and conductivity. These insights are valuable for the ongoing development and enhancement of β-Ga2O3-based device techniques.
- 1 February 2022
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 627
First principle studies of oxygen absorption on GaN(0001) surface with steps
- 1 February 2022
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 627
First principle studies of oxygen absorption on GaN(0001) surface with steps
- 3 May 2021
- Published by AIP Publishing in Applied Physics Letters
- Vol. 118 (18) , 181602
Reduction of MOS interfacial states between β -Ga2O3 and Al2O3 insulator by self-reaction etching with Ga flux
In this Letter, self-reaction etching (SRE) with Ga flux demonstrates the capability of eliminating surface contaminations and damage, as well as improving the electrical characteristics of the interface between monoclinic gallium oxide (β-Ga2O3) and the insulator. Compared to post-tetramethyl ammonium hydroxide wet chemical treatment, SRE is a low damage repair method that effectively removes surface contaminants introduced during previous inductively coupled plasma etching of β-Ga2O3 without surface damage. As a consequence, the surface band bending on the β-Ga2O3 surface decreased as demonstrated by the core-level peak shifts of x-ray photoemission spectroscopy, which indicated fewer negative charges remained on the surface. Furthermore, the interface state density (Dit) between β-Ga2O3 and an Al2O3 insulator was determined by using high-temperature conductance and photoassisted C–V measurements. The Dit dropped significantly for samples treated by SRE as compared with other treatments. These results suggested that SRE is an attractive etching candidate for future Ga2O3 power device fabrication.
- 3 May 2021
- Published by AIP Publishing in Applied Physics Letters
- Vol. 118 (18) , 181602
Reduction of MOS interfacial states between β -Ga2O3 and Al2O3 insulator by self-reaction etching with Ga flux
In this Letter, self-reaction etching (SRE) with Ga flux demonstrates the capability of eliminating surface contaminations and damage, as well as improving the electrical characteristics of the interface between monoclinic gallium oxide (β-Ga2O3) and the insulator. Compared to post-tetramethyl ammonium hydroxide wet chemical treatment, SRE is a low damage repair method that effectively removes surface contaminants introduced during previous inductively coupled plasma etching of β-Ga2O3 without surface damage. As a consequence, the surface band bending on the β-Ga2O3 surface decreased as demonstrated by the core-level peak shifts of x-ray photoemission spectroscopy, which indicated fewer negative charges remained on the surface. Furthermore, the interface state density (Dit) between β-Ga2O3 and an Al2O3 insulator was determined by using high-temperature conductance and photoassisted C–V measurements. The Dit dropped significantly for samples treated by SRE as compared with other treatments. These results suggested that SRE is an attractive etching candidate for future Ga2O3 power device fabrication.
- Open Access
- 1 November 2019
- Published by AIP Publishing in AIP Advances
- Vol. 9 (11) , 115106
Accurate surface band bending determination on Ga-polar n-type GaN films by fitting x-ray valence band photoemission spectrum
The surface band bending in Ga-polar n-type GaN surfaces, as well as the effect of Si doping levels and in situ Ar+ ion processing on band bending, was systematically investigated. To precisely determine the valence band maximum (VBM) of GaN beyond instrumental and material surface environments by XPS, a valence band feature fitting procedure based on photoemission spectra and theoretical densities of states has been developed. Poisson calculation with quadratic depletion approximation on surface potential has been used to model the band bending and further correct the VBM energy. Then, the actual surface band bending was correctly evaluated. Upward band bending of 1.55 ± 0.03 eV with highly Si doped n-GaN, which is about 0.88 eV higher than that of the moderately doped sample, was found. After in situ Ar+ plasma treatment, the varying degree of band bending was observed distinctly depending on the Si doping density. The surface components associated with the Ga/N ratio and Ga–O bonding concentration on the n-GaN surface have been used to evaluate the contribution to surface band bending.
- 1 November 2019
- Published by AIP Publishing in AIP Advances
- Vol. 9 (11) , 115106
Open AccessAccurate surface band bending determination on Ga-polar n-type GaN films by fitting x-ray valence band photoemission spectrum
The surface band bending in Ga-polar n-type GaN surfaces, as well as the effect of Si doping levels and in situ Ar+ ion processing on band bending, was systematically investigated. To precisely determine the valence band maximum (VBM) of GaN beyond instrumental and material surface environments by XPS, a valence band feature fitting procedure based on photoemission spectra and theoretical densities of states has been developed. Poisson calculation with quadratic depletion approximation on surface potential has been used to model the band bending and further correct the VBM energy. Then, the actual surface band bending was correctly evaluated. Upward band bending of 1.55 ± 0.03 eV with highly Si doped n-GaN, which is about 0.88 eV higher than that of the moderately doped sample, was found. After in situ Ar+ plasma treatment, the varying degree of band bending was observed distinctly depending on the Si doping density. The surface components associated with the Ga/N ratio and Ga–O bonding concentration on the n-GaN surface have been used to evaluate the contribution to surface band bending.
- Open Access
- 1 June 2017
- Published by Elsevier in Computational Materials Science
- Vol. 134, 206-213
Self-consistent charge and dipole density functional tight binding method and application to carbon-based systems
- 1 June 2017
- Published by Elsevier in Computational Materials Science
- Vol. 134, 206-213
Open AccessSelf-consistent charge and dipole density functional tight binding method and application to carbon-based systems
- 27 November 2013
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 117 (49) , 26029-26039
Correlation Effects on Lattice Relaxation and Electronic Structure of ZnO within the GGA+U Formalism
- 27 November 2013
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 117 (49) , 26029-26039
Correlation Effects on Lattice Relaxation and Electronic Structure of ZnO within the GGA+U Formalism
- 21 July 2011
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 115 (34) , 16963-16969
Effect of Compensated Codoping on the Photoelectrochemical Properties of Anatase TiO2 Photocatalyst
- 21 July 2011
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 115 (34) , 16963-16969
Effect of Compensated Codoping on the Photoelectrochemical Properties of Anatase TiO2 Photocatalyst