BBBijish Babu
Bijish Babu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Bijish Babu has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Lars-Erik Lindgren
Luleå University of Technology
3 shared publications - Andreas Lundbäck
Department of Engineering Sciences and Mathematics, Division of Solid Mechanics, Luleå University of Technology, 971 87 Luleå, Sweden
2 shared publications A. Francois
CENAERO, Rue des Frères Wright 29, 6041 Gosselies, Belgium
1 shared publicationH. Tersing
Volvo Aero Corporation, 46181 Trollhättan, Sweden
1 shared publicationJ. Barboza
CENAERO, Rue des Frères Wright 29, 6041 Gosselies, Belgium
1 shared publicationJ. Lorentzon
Volvo Aero Corporation, 46181 Trollhättan, Sweden
1 shared publication
Latest Publications
- Open Access
Simulation of Ti-6Al-4V Additive Manufacturing Using Coupled Physically Based Flow Stress and Metallurgical Model
Simulating the additive manufacturing process of Ti-6Al-4V is very complex due to the microstructural changes and allotropic transformation occurring during its thermomechanical processing. The -phase with a hexagonal close pack structure is present in three different forms—Widmanstatten, grain boundary and Martensite. A metallurgical model that computes the formation and dissolution of each of these phases was used here. Furthermore, a physically based flow-stress model coupled with the metallurgical model was applied in the simulation of an additive manufacturing case using the directed energy-deposition method. The result from the metallurgical model explicitly affects the mechanical properties in the flow-stress model. Validation of the thermal and mechanical model was performed by comparing the simulation results with measurements available in the literature, which showed good agreement.Open AccessSimulation of Ti-6Al-4V Additive Manufacturing Using Coupled Physically Based Flow Stress and Metallurgical Model
Simulating the additive manufacturing process of Ti-6Al-4V is very complex due to the microstructural changes and allotropic transformation occurring during its thermomechanical processing. The -phase with a hexagonal close pack structure is present in three different forms—Widmanstatten, grain boundary and Martensite. A metallurgical model that computes the formation and dissolution of each of these phases was used here. Furthermore, a physically based flow-stress model coupled with the metallurgical model was applied in the simulation of an additive manufacturing case using the directed energy-deposition method. The result from the metallurgical model explicitly affects the mechanical properties in the flow-stress model. Validation of the thermal and mechanical model was performed by comparing the simulation results with measurements available in the literature, which showed good agreement. - Top Cited Papers
- 1 November 2013
- Published by Elsevier in International Journal of Plasticity
- Vol. 50, 94-108
Dislocation density based model for plastic deformation and globularization of Ti-6Al-4V
- 1 November 2013
- Published by Elsevier in International Journal of Plasticity
- Vol. 50, 94-108
Top Cited PapersDislocation density based model for plastic deformation and globularization of Ti-6Al-4V
- 1 April 2012
- Published by Elsevier in Finite Elements in Analysis and Design
- Vol. 51, 10-21
Simulation of manufacturing chain of a titanium aerospace component with experimental validation
- 1 April 2012
- Published by Elsevier in Finite Elements in Analysis and Design
- Vol. 51, 10-21
Simulation of manufacturing chain of a titanium aerospace component with experimental validation