Emad S. Elmolla
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Emad S. Elmolla has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
Malay Chaudhuri
Dept. of Civil Engineering, Universiti Teknologi PETRONAS, Bandar Seri Iskandar, 31750 Tronoh, Perak, Malaysia
5 shared publications- Mohamed Eid Mohamed Ali
National Research Centre
1 shared publication - Mohamed Ismail Badawy
Water Pollution Department, National Research Center, Dokki, Cairo, Egypt
1 shared publication Mohamed Meselhy Eltoukhy
Dept. of Electical and Elctronics Engineering, Universiti Teknologi PETRONAS (UTP), Bandar Seri Iskandar, 31750 Tronoh, Perak, Malaysia
1 shared publication- Tarek Abdel Shafy Gad Allah
Water Pollution Research Department, National Research Centre, 33 El Buhouth St., Dokki, 12622 Giza, Egypt
1 shared publication
Latest Publications
- Open Access
- 1 June 2014
- Published by Elsevier in Desalination and Water Treatment
- Vol. 52 (22-24) , 4538-4546
Heterogeneous Fenton process using iron-containing waste (ICW) for methyl orange degradation: process performance and modeling
The feasibility of using iron-containing waste (ICW) as new low-cost heterogeneous Fenton catalyst for methyl orange (MO) degradation has been studied. Process modeling and simulation has been conducted using artificial neural network (ANN). Complete degradation of MO was achieved at 0.2 g/L ICW concentration, 24 mM H2O2 dose, and pH 2 in 30 min. A three-layered back-propagation neural network with tangent sigmoid transfer function (tansig) at hidden layer and linear transfer function (purelin) at output layer was used for modeling the process performance. ANN-predicted results are very close to the experimental results with a correlation coefficient (R2) of 0.961 and a mean squared error of 0.039. The sensitivity analysis showed that all studied variables (reaction time, ICW concentration, H2O2 dose, pH, and MO concentration) have strong effect on MO degradation. Among all studied variables, pH appeared to be the most influential input variable followed by ICW concentration.
- 1 June 2014
- Published by Elsevier in Desalination and Water Treatment
- Vol. 52 (22-24) , 4538-4546
Open AccessHeterogeneous Fenton process using iron-containing waste (ICW) for methyl orange degradation: process performance and modeling
The feasibility of using iron-containing waste (ICW) as new low-cost heterogeneous Fenton catalyst for methyl orange (MO) degradation has been studied. Process modeling and simulation has been conducted using artificial neural network (ANN). Complete degradation of MO was achieved at 0.2 g/L ICW concentration, 24 mM H2O2 dose, and pH 2 in 30 min. A three-layered back-propagation neural network with tangent sigmoid transfer function (tansig) at hidden layer and linear transfer function (purelin) at output layer was used for modeling the process performance. ANN-predicted results are very close to the experimental results with a correlation coefficient (R2) of 0.961 and a mean squared error of 0.039. The sensitivity analysis showed that all studied variables (reaction time, ICW concentration, H2O2 dose, pH, and MO concentration) have strong effect on MO degradation. Among all studied variables, pH appeared to be the most influential input variable followed by ICW concentration.
- 1 September 2011
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 192 (3) , 1418-1426
Combined photo-Fenton–SBR process for antibiotic wastewater treatment
- 1 September 2011
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 192 (3) , 1418-1426
Combined photo-Fenton–SBR process for antibiotic wastewater treatment
- 1 July 2010
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 179 (1-3) , 127-134
The use of artificial neural network (ANN) for modeling of COD removal from antibiotic aqueous solution by the Fenton process
- 1 July 2010
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 179 (1-3) , 127-134
The use of artificial neural network (ANN) for modeling of COD removal from antibiotic aqueous solution by the Fenton process
- Top Cited Papers
- 15 January 2010
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 173 (1-3) , 445-449
Degradation of amoxicillin, ampicillin and cloxacillin antibiotics in aqueous solution by the UV/ZnO photocatalytic process
- 15 January 2010
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 173 (1-3) , 445-449
Top Cited PapersDegradation of amoxicillin, ampicillin and cloxacillin antibiotics in aqueous solution by the UV/ZnO photocatalytic process
- 1 December 2009
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 172 (2-3) , 1476-1481
Degradation of the antibiotics amoxicillin, ampicillin and cloxacillin in aqueous solution by the photo-Fenton process
- 1 December 2009
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 172 (2-3) , 1476-1481
Degradation of the antibiotics amoxicillin, ampicillin and cloxacillin in aqueous solution by the photo-Fenton process
- 30 October 2009
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 170 (2-3) , 666-672
Optimization of Fenton process for treatment of amoxicillin, ampicillin and cloxacillin antibiotics in aqueous solution
- 30 October 2009
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 170 (2-3) , 666-672
Optimization of Fenton process for treatment of amoxicillin, ampicillin and cloxacillin antibiotics in aqueous solution