GBGuillaume Brisson

Guillaume Brisson

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Guillaume Brisson has a total of 111 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Comparison of dietary fatty acid supplements on milk production, physicochemical properties, and butter characteristics

    by M. Landry, Y. Lebeuf, J. Chamberland, G. Brisson, P.Y. Chouinard, R. Gervais

  • Open Access

    Effects of dietary palmitic acid supplementation on milk technological properties and attempted mitigation of butter texture changes through cream ripening

    by Myriam Landry, Y. Lebeuf, Julien Chamberland, Guillaume Brisson, P. Yvan Chouinard, Rachel Gervais

    Dietary palmitic acid supplementation (PA) in dairy cows affects milk technological properties. In a controlled trial with 8 Holstein cows, we investigated the impact of PA on milk nitrogen fractions, milk fat integrity, and butter properties. We also investigated whether modifying cream ripening conditions could attenuate the impacts of PA on butter hardness. Milk caseins and whey proteins decreased, and non-protein nitrogen concentrations increased with PA. Supplementation with PA also increased milk susceptibility to lipolysis but decreased its sensitivity to oxidation. Butter manufacture from PA-supplemented cows required longer churning, and the resulting butter was harder at room temperature. The cold-warm-cold ripening protocol reduced churning time but had limited capacity to compensate for PA-induced texture modifications, only reducing butter hardness at 4°C.

  • Open Access

    Optimizing cream ripening conditions for high-fat butter with improved textural properties

    by R. Meddah, G. Remondetto, T. Ben Touati, D. Fortin, G. Brisson

    High-fat butter (up to ∼84% fat) is valued for its plasticity and handling performance during processing and utilization, which are strongly influenced by the fat crystal network and microstructure. This study aimed to optimize cream ripening conditions to enhance the techno-functional properties of butter. The effects of a 3-stage cold-warm-cold (CWC) cream ripening process, known as the Alnarp method, were investigated using various time-temperature regimens. Fatty acid (FA) composition was quantified by gas chromatography with flame ionization detection. Fat crystallization behavior, together with solid-to-liquid fat ratios, was characterized using differential scanning calorimetry. These analyses confirmed that differences in butter texture and crystallization were primarily attributable to ripening parameters, rather than variations in the FA composition of the cream or their influence on the solid-to-liquid fat ratio. Butter texture and structural properties were assessed using texture profile analysis and confocal laser scanning microscopy, whereas small-angle and wide-angle X-ray diffraction (WAXD) were used to determine triacylglycerol longitudinal packing and crystal polymorphism. Adjusting the temperature and duration of the 3-stage ripening process reduced butter hardness by up to 30%, improving spreadability, flexibility, and elasticity. Microstructural analysis showed that cream ripened at the lower second-stage temperature of 12°C produced butter with hardness similar to that obtained under isothermal ripening, while exhibiting a higher crystalline density than samples ripened at 20°C. Small-angle X-ray diffraction revealed no significant differences in triacylglycerol longitudinal packing among butter samples, whereas WAXD primarily detected β' crystals with minor β and α forms. Notably, butter produced from cream ripened using a 3-stage CWC process (6°C for 6 h → 12°C for 12 h → 6°C for 6 h) exhibited the lowest proportion of β crystals, correlating with reduced firmness, Young's modulus, and flexural modulus at 4°C. Overall, this study demonstrates that carefully controlled cream ripening conditions can fine-tune butter microstructure and crystallization, enhancing plasticity, workability, and functional performance in laminated dough pastry without altering FA composition.


  • Open Access

    Effect of dietary palmitic acid supplementation and milking frequency: 2. Butter manufacture and properties

    by M. Landry, M. Gareau-Vignola, M. Guyard, Y. Lebeuf, J. Chamberland, G. Brisson, P.Y. Chouinard, R. Gervais

    Dietary palmitic acid (PA) supplementation promotes fat yield, whereas increased milking frequency (MF) enhances milk yield. Such practices can be useful at the farm level, but their effects on milk processing remain to be determined. The objective of this study was to evaluate the effects of dietary PA supplementation and increased MF from 2 times to 3 times daily on butter manufacture and properties. In a duplicated 4 × 4 Latin square design, with a 2 × 2 factorial arrangement of treatments, 8 Holstein cows received a diet with or without PA (2% or 0%, on a DM basis) and were milked 2 times or 3 times daily. For each period, after 18 d of treatment adaptation, milk was collected from each cow for 2 d, and pooled by treatment before butter manufacture. Milk free fatty acids (FA) concentration and casein micelle size were similar between treatments, as well as cream fat globule diameter and butter yield. There was a significant interaction between PA and MF on churning time. With the nonsupplemented diets, 3 times daily milking increased churning time, and with 2 times daily milking, PA supplementation also increased churning time. Butter FA composition was mostly affected by PA, whereas MF had a limited effect. Total 16 C FA concentration in butter was increased with dietary PA at the expense of short-chain FA (6-14 C) and, to a lesser extent, long-chain FA (≥18 C). Dietary PA increased butter hardness at 20°C, whereas this effect was limited to a tendency when measured at 4°C. Resistance to spreadability increased with PA at both 4°C and 20°C. Overall, the effects of PA on butter texture were less pronounced at 4°C than at 20°C. Milking frequency had no effect on butter texture. Butter melting point was greater with PA and was positively correlated with the concentration in 16:0 and the spreadability index (cis-9 18:1/16:0). The solid fat content of butter was similar between PA and non-PA treatments at 5, 8, and 20°C. However, from 30°C, the solid fat content was higher with the PA diet. The spreadability index was correlated with butter hardness, and to a greater extent, with butter spreadability. This work underscores how dairy farm management influences the technological properties of milk, with potential implications for butter manufacturing and quality.


  • Open Access

    Can dietary palmitic supplementation and milking frequency modify the cheesemaking properties of milk?

    by Maude Blouin, Myriam Landry, Camille Vaubaillon, Jules Larouche, Éric Paquet, Yvan Chouinard, Guillaume Brisson, Rachel Gervais, Julien Chamberland

    Palmitic acid (PA) supplementation and greater milking frequency can increase milk production and fat yield in dairy cows. However, the technological impacts of those practices on cheesemaking still need to be determined. This work aimed to evaluate, with Holstein dairy cows, the effects of dietary PA, thrice-daily milking frequency, and their interaction on cheese yield and composition. Before cheesemaking, milks were standardized to a casein-to-fat ratio of 0.78 ± 0.02 and targets of 3.27 ± 0.03 and 4.20 ± 0.05% wt/wt, for casein and fat concentrations, respectively. Rennet coagulation properties of standardized milk, cheese composition, curd draining properties, free fatty acid (FFA) content, and proteolysis during ripening were analyzed. Dietary PA supplementation modified the milk fatty acid profile but did not affect coagulation and draining properties, cheese composition, and proteolysis. The moisture-adjusted yield and fat and protein recoveries were also similar between treatments. The greater milking frequency did not affect process performance. However, increasing milking frequency led to a significantly higher FFA content in cheese at the end of ripening of 1.4 ± 0.2 vs. 0.8 ± 0.2 mEq/kg of cheese fat for thrice- and twice-daily milkings, respectively. Consequently, dietary supplementation of PA to dairy cows only had a limited effect on the cheesemaking process under the standardized conditions tested. However, the effect of FFA on cheese sensory properties should be considered if the milking frequency is increased.


  • Open Access

    The affinity of milk fat globule membrane fragments and buttermilk proteins to hydroxyapatite

    by J. Lung, A. Doyen, G. Remondetto, Y. Pouliot, G. Brisson

    Buttermilk differs from skim milk by the presence of milk fat globule membrane (MFGM) fragments that are released during cream churning. Milk fat globule membrane is rich in health-promoting components, such as phospholipids and membrane proteins, but these compounds have a negative impact on buttermilk techno-functional properties in dairy applications. The isolation of MFGM from buttermilk improved its functionality while also recovering the MFGM bioactive components. Hydroxyapatite (HA) can be used to extract MFGM by adsorption via charged site interactions. However, the affinity of HA to MFGM or the main buttermilk proteins (casein micelles [CM], β-LG, and α-LA) is not known. The influence of important physicochemical parameters such as pH and temperature on these interactions is also unclear. For each buttermilk component, a quartz crystal microbalance diffusion analysis was performed to determine the maximum adsorption time and the attached mass density on HA-coated gold sensors. The influence of pH, ionic strength (IS), and temperature (T) on the affinity of each buttermilk component for HA particles was assessed using a 3-levels and 3-factors Box-Behnken design. The absorption rate was highest for the CM, followed by β-LG and α-LA, and then by the MFGM. Nevertheless, the final maximal attached mass densities to the HA were similar for the MFGM and CM, and 2.5 times higher than for β-LG and α-LA. This difference can be explained by the higher number of binding sites found in CM and their heavier mass. The model obtained by the Box-Behnken design plan showed that the adsorption of the CM changed with T, pH, and IS. These results suggest that the techno-functional properties of buttermilk may be restored by specifically extracting MFGM with HA. Experiments are ongoing to determine conditions for fractionating MFGM directly from buttermilk.