Sedat Gormus
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Sedat Gormus has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Hakan Aydin
Karadeniz Technical University
15 shared publications - Burak Aydin
Karadeniz Technical University
13 shared publications - Onder Civelek
Trabzon Vocational High School, Karadeniz Technical University, Trabzon, Turkey
3 shared publications - Halil Ibrahim Okumus
Department of Electrical and Electronics Engineering, Karadeniz Technical University, Trabzon, Turkey
2 shared publications - Hasan Yilmaz
Fırat Electricity Distribution Co., Elazıǧ, Turkey
2 shared publications - Ismail Hakki Dereli2 shared publications
Latest Publications
- 25 September 2026
- Published by Springer Nature in Sādhanā
- Vol. 51 (4) , 329
Implementation of a real-time rural smart grid monitoring and control system using radio frequency mesh topology
- 25 September 2026
- Published by Springer Nature in Sādhanā
- Vol. 51 (4) , 329
Implementation of a real-time rural smart grid monitoring and control system using radio frequency mesh topology
- 6 July 2026
- Published by Elsevier in Computer Communications
- Vol. 257
Extending IETF 6TiSCH to the 868 MHz Band P: A large-scale field study on smart meter communication
- 6 July 2026
- Published by Elsevier in Computer Communications
- Vol. 257
Extending IETF 6TiSCH to the 868 MHz Band P: A large-scale field study on smart meter communication
- 1 July 2026
- Published by Gumushane University Journal of Science and Technology Institute in Gümüşhane Üniversitesi Fen Bilimleri Enstitüsü Dergisi
- Vol. 16 (3) , 802-816
Experimental prototype study for 868 MHz 6TiSCH-based smart meter reading
Smart grid Advanced Metering Infrastructure (AMI) requires scalable, reliable, and regulation-compliant wireless communication for periodic remote meter readings. Although IEEE 802.15.4-based 6TiSCH networks have been widely studied, most existing implementations operate in the congested 2.4 GHz band, where interference and limited indoor penetration constrain reliability. In this study, we propose and experimentally validate an ETSI EN 300 220 compliant 6TiSCH framework operating in the 868 MHz sub-GHz band. The proposed framework explicitly incorporates per-sub-band duty-cycle and Effective Radiated Power (ERP) limits into the 6TiSCH operation, introduces a link-quality- and distance-aware sub-band assignment mechanism, and selectively enables or disables frequency hopping according to a per-sub-band link-budget evaluation. The system is implemented on Contiki-NG and deployed on real IEEE 802.15.4g hardware using the CC1312R1-based Umote platform. A comparative two-device prototype evaluation against a 2.4 GHz Mahmote testbed, carried out under indoor non-line-of-sight conditions, shows that the proposed 868 MHz configuration achieves a MAC-layer Packet Delivery Ratio of approximately 96.6%, compared with approximately 91.2% for the 2.4 GHz baseline, while reducing the MAC-layer drop ratio from approximately 0.073 to 0.035. These results indicate that the proposed sub-band-aware 6TiSCH framework provides improved link reliability, reduced retransmission overhead, and better acknowledgment efficiency, while remaining fully compliant with ETSI regulatory constraints. Within the scope of a single-hop prototype validation, the framework offers a practical pathway toward energy-aware, spectrum-compliant 868 MHz smart metering deployments in European AMI scenarios.
- 1 July 2026
- Published by Gumushane University Journal of Science and Technology Institute in Gümüşhane Üniversitesi Fen Bilimleri Enstitüsü Dergisi
- Vol. 16 (3) , 802-816
Experimental prototype study for 868 MHz 6TiSCH-based smart meter reading
Smart grid Advanced Metering Infrastructure (AMI) requires scalable, reliable, and regulation-compliant wireless communication for periodic remote meter readings. Although IEEE 802.15.4-based 6TiSCH networks have been widely studied, most existing implementations operate in the congested 2.4 GHz band, where interference and limited indoor penetration constrain reliability. In this study, we propose and experimentally validate an ETSI EN 300 220 compliant 6TiSCH framework operating in the 868 MHz sub-GHz band. The proposed framework explicitly incorporates per-sub-band duty-cycle and Effective Radiated Power (ERP) limits into the 6TiSCH operation, introduces a link-quality- and distance-aware sub-band assignment mechanism, and selectively enables or disables frequency hopping according to a per-sub-band link-budget evaluation. The system is implemented on Contiki-NG and deployed on real IEEE 802.15.4g hardware using the CC1312R1-based Umote platform. A comparative two-device prototype evaluation against a 2.4 GHz Mahmote testbed, carried out under indoor non-line-of-sight conditions, shows that the proposed 868 MHz configuration achieves a MAC-layer Packet Delivery Ratio of approximately 96.6%, compared with approximately 91.2% for the 2.4 GHz baseline, while reducing the MAC-layer drop ratio from approximately 0.073 to 0.035. These results indicate that the proposed sub-band-aware 6TiSCH framework provides improved link reliability, reduced retransmission overhead, and better acknowledgment efficiency, while remaining fully compliant with ETSI regulatory constraints. Within the scope of a single-hop prototype validation, the framework offers a practical pathway toward energy-aware, spectrum-compliant 868 MHz smart metering deployments in European AMI scenarios.
- Open Access
- 9 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 23598-23623
RL-OF: A Reinforcement Learning-Inspired Objective Function for IETF 6TiSCH Networks
Many wireless Internet of Things (IoT) Networks consist of low-power nodes and have a limited range of coverage. New protocol suites are being developed to ensure stability and reliability in such low-power and lossy networks. Towards this goal, RPL (IPv6 Routing Protocol for Low-Power and Lossy Networks) protocol was developed. Due to communication failures in the network, nodes in an RPL network may have to switch their preferred parents regularly to guarantee a certain level of quality of service. But these parent switches bring about extra signaling overhead due to the need to reconfigure RPL network. This behavior poses a greater challenge in networks running IETF 6TiSCH (An Architecture for IPv6 over the Time-Slotted Channel Hopping Mode of IEEE 802.15.4) since the nodes need to re-allocate the communication resources to their parents during each parent switch. In this study, a new RPL objective function called RL-OF is proposed for the IETF 6TiSCH protocol stack. RL-OF employs a lightweight reinforcement learning-inspired reward-penalty based mechanism to adaptively regulate parent switching decisions. The main motivation of the proposed objective function is to reduce the number of unnecessary parent switches to reduce the overheads in 6TiSCH networks related to reallocation of resources during the parent switching process. Our tests show that RL-OF significantly improves the key performance metrics, namely Packet Delivery Ratio and MAC layer packet drops of 6TiSCH networks, as compared to the networks utilizing state-of-the-art objective functions. Real-world testing on a 141-node 6TiSCH network further validates these findings.
- 9 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 23598-23623
Open AccessRL-OF: A Reinforcement Learning-Inspired Objective Function for IETF 6TiSCH Networks
Many wireless Internet of Things (IoT) Networks consist of low-power nodes and have a limited range of coverage. New protocol suites are being developed to ensure stability and reliability in such low-power and lossy networks. Towards this goal, RPL (IPv6 Routing Protocol for Low-Power and Lossy Networks) protocol was developed. Due to communication failures in the network, nodes in an RPL network may have to switch their preferred parents regularly to guarantee a certain level of quality of service. But these parent switches bring about extra signaling overhead due to the need to reconfigure RPL network. This behavior poses a greater challenge in networks running IETF 6TiSCH (An Architecture for IPv6 over the Time-Slotted Channel Hopping Mode of IEEE 802.15.4) since the nodes need to re-allocate the communication resources to their parents during each parent switch. In this study, a new RPL objective function called RL-OF is proposed for the IETF 6TiSCH protocol stack. RL-OF employs a lightweight reinforcement learning-inspired reward-penalty based mechanism to adaptively regulate parent switching decisions. The main motivation of the proposed objective function is to reduce the number of unnecessary parent switches to reduce the overheads in 6TiSCH networks related to reallocation of resources during the parent switching process. Our tests show that RL-OF significantly improves the key performance metrics, namely Packet Delivery Ratio and MAC layer packet drops of 6TiSCH networks, as compared to the networks utilizing state-of-the-art objective functions. Real-world testing on a 141-node 6TiSCH network further validates these findings.
- Open Access
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 147867-147900
6TiSCHSet-2026: A Multi-Layer Attack Dataset and Leakage-Aware Intrusion-Detection Benchmark for IETF 6TiSCH Networks
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 147867-147900
Open Access6TiSCHSet-2026: A Multi-Layer Attack Dataset and Leakage-Aware Intrusion-Detection Benchmark for IETF 6TiSCH Networks
- 17 July 2025
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 51 (6) , 7515-7536
Automated Localization of Illegally Connected Irrigation Loads in Smart Grids using RF Mesh Networks
- 17 July 2025
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 51 (6) , 7515-7536
Automated Localization of Illegally Connected Irrigation Loads in Smart Grids using RF Mesh Networks