Nilton Rodolfo N. M. Rodrigues
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Nilton Rodolfo N. M. Rodrigues has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Rodrigo M. S. de Oliveira
Graduate Program in Electrical Engineering (PPGEE), Institute of Technology (ITEC), Federal University of Pará (UFPA), Rua Augusto Corrêa, 01, Belém 66075-110, PA, Brazil
5 shared publications - Rodrigo Rodrigues Paiva
Graduate Program in Electrical Engineering (PPGEE), Institute of Technology (ITEC), Federal University of Pará (UFPA), Rua Augusto Corrêa, 01, Belém 66075-110, PA, Brazil
3 shared publications - Victor Dmitriev
Department of Electrical Engineering, Federal University of Para, Belem, Brazil
2 shared publications - Adonis Ferreira Raiol Leal
Department of Physics & Langmuir Lab New Mexico Tech Socorro NM USA
1 shared publication - Eduardo R. Ferreira
Lightning Research Laboratory Federal University of Para (UFPA) Belém Brazil
1 shared publication - Manoel R. Elias Filho
Universidade do Estado do Pará, Brasil
1 shared publication
Latest Publications
- Open Access
Multifunctional THz Graphene Antenna with 360∘ Continuous ϕ-Steering and θ-Control of Beam
A novel graphene antenna composed of a graphene dipole and four auxiliary graphene sheets oriented at to each other is proposed and analyzed. The sheets play the role of reflectors. A detailed group-theoretical analysis of symmetry properties of the discussed antennas has been completed. Through electric field control of the chemical potentials of the graphene elements, the antenna can provide a quasi-omnidirectional diagram, a one- or two-directional beam regime, dynamic control of the beam width and, due to the vertical orientation of the dipole with respect to the base substrate, a beam steering in the azimuth plane. An additional graphene layer on the base permits control of the radiation pattern in the -direction. Radiation patterns in different working states of the antenna are considered using symmetry arguments. We discuss the antenna parameters such as input reflection coefficient, total efficiency, front-to-back ratio, and gain. An equivalent circuit of the antenna is suggested. The proposed antenna operates at frequencies between 1.75 THz and 2.03 THz. Depending on the active regime defined by the chemical potentials set on the antenna graphene elements, the maximum gain varies from 0.86 to 1.63.Open AccessMultifunctional THz Graphene Antenna with 360∘ Continuous ϕ-Steering and θ-Control of Beam
A novel graphene antenna composed of a graphene dipole and four auxiliary graphene sheets oriented at to each other is proposed and analyzed. The sheets play the role of reflectors. A detailed group-theoretical analysis of symmetry properties of the discussed antennas has been completed. Through electric field control of the chemical potentials of the graphene elements, the antenna can provide a quasi-omnidirectional diagram, a one- or two-directional beam regime, dynamic control of the beam width and, due to the vertical orientation of the dipole with respect to the base substrate, a beam steering in the azimuth plane. An additional graphene layer on the base permits control of the radiation pattern in the -direction. Radiation patterns in different working states of the antenna are considered using symmetry arguments. We discuss the antenna parameters such as input reflection coefficient, total efficiency, front-to-back ratio, and gain. An equivalent circuit of the antenna is suggested. The proposed antenna operates at frequencies between 1.75 THz and 2.03 THz. Depending on the active regime defined by the chemical potentials set on the antenna graphene elements, the maximum gain varies from 0.86 to 1.63. - Open Access
- 1 March 2022
- Published by FapUNIFESP (SciELO) in Journal of Microwaves, Optoelectronics and Electromagnetic Applications
- Vol. 21 (1) , 11-34
Semi-analytical Equations for Designing Terahertz Graphene Dipole Antennas on Glass Substrate
- 1 March 2022
- Published by FapUNIFESP (SciELO) in Journal of Microwaves, Optoelectronics and Electromagnetic Applications
- Vol. 21 (1) , 11-34
Open AccessSemi-analytical Equations for Designing Terahertz Graphene Dipole Antennas on Glass Substrate
- Open Access
- 1 June 2021
- Published by FapUNIFESP (SciELO) in Journal of Microwaves, Optoelectronics and Electromagnetic Applications
- Vol. 20 (2) , 307-319
Lightning Protection Design for Small Riverboats Using the FDTD Method
- 1 June 2021
- Published by FapUNIFESP (SciELO) in Journal of Microwaves, Optoelectronics and Electromagnetic Applications
- Vol. 20 (2) , 307-319
Open AccessLightning Protection Design for Small Riverboats Using the FDTD Method
- 20 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 69 (6) , 3063-3073
Graphene Rectangular Loop Antenna for Terahertz Communications
Rectangular graphene loop antenna for terahertz (THz) band is proposed and analyzed. Symmetry properties of the antenna in terms of currents and the radiated fields are investigated. By means of numerical simulations, the antenna is analyzed in free space and on a semi-infinite substrate. It is shown that the maximum total efficiency and minimum input reflection coefficient occur around the second resonance frequency of the antenna. Depending on the relative permittivity of the semi-infinite substrate considered in this article (from 1 to 3.8), the maximum total efficiency of the proposed antenna ranges from 50.1% to 57.4% and its fractional bandwidth (BW) is between 85.2% and 96.6%. Fractional BW of loop antenna can be approximately twice that of graphene dipole antenna and maximum total efficiency can be about 14% higher. BW augmentation is explained using developed equivalent circuit models for dipole and loop antennas. It is also shown that under specific conditions, the radiation pattern of the proposed device can be approximated by an equivalent scheme of two coupled small electric dipole antennas. Finally, we demonstrate that the proposed antenna tolerates moderate variations of graphene parameters.
- 20 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 69 (6) , 3063-3073
Graphene Rectangular Loop Antenna for Terahertz Communications
Rectangular graphene loop antenna for terahertz (THz) band is proposed and analyzed. Symmetry properties of the antenna in terms of currents and the radiated fields are investigated. By means of numerical simulations, the antenna is analyzed in free space and on a semi-infinite substrate. It is shown that the maximum total efficiency and minimum input reflection coefficient occur around the second resonance frequency of the antenna. Depending on the relative permittivity of the semi-infinite substrate considered in this article (from 1 to 3.8), the maximum total efficiency of the proposed antenna ranges from 50.1% to 57.4% and its fractional bandwidth (BW) is between 85.2% and 96.6%. Fractional BW of loop antenna can be approximately twice that of graphene dipole antenna and maximum total efficiency can be about 14% higher. BW augmentation is explained using developed equivalent circuit models for dipole and loop antennas. It is also shown that under specific conditions, the radiation pattern of the proposed device can be approximated by an equivalent scheme of two coupled small electric dipole antennas. Finally, we demonstrate that the proposed antenna tolerates moderate variations of graphene parameters.
- Open Access
- 1 December 2019
- Published by FapUNIFESP (SciELO) in Journal of Microwaves, Optoelectronics and Electromagnetic Applications
- Vol. 18 (4) , 452-481
Smart Graphene-Based Frequency Selective Surface Designed to Act as Single or Dual Band Device with Reconfigurable Operation Bands
In this paper, a finite-difference time-domain (FDTD) formulation, based on the exponential matrix and on thin material sheet methods is developed for modeling subcellular thin graphene sheets. This formulation is validated by reproducing graphene frequency selective surfaces (FSS) known from literature. Then, we propose in this work a smart graphene FSS device. Smartness is obtained by means of a unity cell formed by a graphene ring with a graphene sheet placed in its aperture. By properly regulating the chemical potentials of the graphene elements, two frequency- tunable modus operandi are obtained: single- or dual-band rejection modes. When the device operates in its dual-band rejection mode, either of the rejection bands can be shifted individually in the frequency spectrum. Additionally, both rejection bands can also be reconfigured simultaneously.
- 1 December 2019
- Published by FapUNIFESP (SciELO) in Journal of Microwaves, Optoelectronics and Electromagnetic Applications
- Vol. 18 (4) , 452-481
Open AccessSmart Graphene-Based Frequency Selective Surface Designed to Act as Single or Dual Band Device with Reconfigurable Operation Bands
In this paper, a finite-difference time-domain (FDTD) formulation, based on the exponential matrix and on thin material sheet methods is developed for modeling subcellular thin graphene sheets. This formulation is validated by reproducing graphene frequency selective surfaces (FSS) known from literature. Then, we propose in this work a smart graphene FSS device. Smartness is obtained by means of a unity cell formed by a graphene ring with a graphene sheet placed in its aperture. By properly regulating the chemical potentials of the graphene elements, two frequency- tunable modus operandi are obtained: single- or dual-band rejection modes. When the device operates in its dual-band rejection mode, either of the rejection bands can be shifted individually in the frequency spectrum. Additionally, both rejection bands can also be reconfigured simultaneously.