RPRoman Prokop

Roman Prokop

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Roman Prokop has a total of 19 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Design of Constant Phase Elements for Adjustable Pseudocapacitance by a Single Driving Voltage Using Integrated Unipolar Transistor Fields

    by Roman Sotner, Anna Litovska, Ladislav Polak, Jan Jerabek, Vilem Kledrowetz, Roman Prokop, Winai Jaikla

    This paper presents the design of a passive fractional-order element with tunable pseudocapacitance, enabling adaptable circuit behavior without additional power consumption. This is an important feature for modelling and characterization in natural systems, as well as in the field of electrical and electronic engineering, particularly for the design of instrumentation and sensing systems. The proposed topologies are based on integrated unipolar transistor arrays. Two implementations are demonstrated, with fractional orders of 0.22 and 0.5, offering pseudocapacitance adjustment ranges from 65 to 1 670 mikroF/s^0.78 and from 6.7 to 51 mikroF/s^0.5, respectively. Tuning is achieved through a DC bias voltage ranging from 0.8 to 10 V. The devices operate across nearly two decades of frequency, from approximately 100 Hz to 200 kHz, and support signal amplitudes in the hundreds of millivolts. Two application examples highlight their potential: electronic tuning of the center frequency in a fractional-order band-pass filter, and adjustment of the oscillation frequency in a fractional-order oscillator with a fixed 22.5 degrees phase shift between output waves. All concepts and results are experimentally validated in the laboratory.

  • Open Access

    A Fully Differential Analog Front-End for Signal Processing from EMG Sensor in 28 nm FDSOI Technology

    by Vilem Kledrowetz, Roman Prokop, Lukas Fujcik, Jiri Haze

    This paper presents a novel analog front-end for EMG sensor signal processing powered by 1 V. Such a low supply voltage requires specific design steps enabled using the 28 nm fully depleted silicon on insulator (FDSOI) technology from STMicroelectronics. An active ground circuit is implemented to keep the input common-mode voltage close to the analog ground and to minimize external interference. The amplifier circuit comprises an input instrumentation amplifier (INA) and a programmable-gain amplifier (PGA). Both are implemented in a fully differential topology. The actual performance of the circuit is analyzed using the corner and Monte Carlo analyses that comprise fifth-hundred samples for the global and local process variations. The proposed circuit achieves a high common-mode rejection ratio (CMRR) of 105.5 dB and a high input impedance of 11 GΩ with a chip area of 0.09 mm2.


  • Open Access

    A Single Parameter Voltage Adjustable Immittance Topology for Integer- and Fractional-Order Design Using Modular Active CMOS Devices

    by Roman Sotner, Jan Jerabek, Ladislav Polak, Roman Prokop, Winai Jaikla

    A simple single parameter adjustable immittance concept designed with modular active devices, fabricated in I3T 25 0.35 μm 3.3 V CMOS process of ON Semiconductor, is introduced. The proposed devices employ an integer-order capacitor and specifically designed fractional-order capacitors (sometimes called constant phase elements). The proposed active topology consists of two simple active elements, namely a linearly voltage adjustable operational transconductance amplifier and a voltage differencing unity gain voltage follower/buffer, and only two passive elements, i.e. redundancy is minimized. The designed topology offers generation of an adjustable immittance having both the capacitive and inductive character. The importance of the order as well as the value of the pseudo-capacitance for design and analyzes are shown, including all important parasitic features for estimation of expected operational bandwidth which have to be considered in the design. The operational bandwidth is determined by high values of approximants of fractional-order capacities (225, 56 and 8.8 μF/sec^1- α, where α represents the order equal to 0.25, 0.5 and 0.75, respectively). These parameters result into ranges between tens of Hz and units-tens of kHz. The adjustability of the transconductance from 70 to 700 μS by the driving voltage between 0.05 and 0.5 V offers approximately one decade change of equivalent capacitance and inductance. Laboratory-based experiments done with a fabricated prototype confirmed the theoretical presumptions.


  • Open Access

    An Active Resistor With a Lower Sensitivity to Process Variations, and its Application in Current Reference

    by Vilem Kledrowetz, Jiri Haze, Roman Prokop, Lukas Fujcik

    A novel active resistor circuit offering less sensitivity to process and temperature variations without any extra trimming is proposed. The circuit consists of two accurately matched, high resistance polysilicon (hripoly) resistors and a voltage-controlled MOS resistor, and it is designed for the industrial temperature range (−20 °C to 85 °C) in the TSMC 180 nm general-purpose process. The actual performance of the circuit is analyzed by using the Corner and Monte Carlo analyses that comprise two thousand samples for the global and local process variations. The maximum error in the resistor value is ±6.2%, with the standard deviation of $\sigma = 1.2\,\,\%$ . The proposed active resistor reduces the maximum error from ±15% to ±6.2% when the both the process and the temperature variations are considered without trimming. As an application, a transconductor and a current reference based on the novel active resistor are introduced, and their accuracy-related performance is studied.


  • Open Access

    The CMOS Highly Linear Current Amplifier with Current Controlled Gain for Sensor Measurement Applications

    by Roman Prokop, Roman Sotner, Vilem Kledrowetz

    This paper introduces a new current-controlled current-amplifier suitable for precise measurement applications. This amplifier was developed with strong emphasis on linearity leading to low total harmonic distortion (THD) of the output signal, and on linearity of the gain control. The presented circuit is characterized by low input and high output impedances. Current consumption is significantly smaller than with conventional quadratic current multipliers and is comparable in order to the maximum processed input current, which is ±200 µA. This circuit is supposed to be used in many sensor applications, as well as a precise current multiplier for general analog current signal processing. The presented amplifier (current multiplier) was designed by an uncommon topology based on linear sub-blocks using MOS transistors working in their linear region. The described circuit was designed and fabricated in a C035 I3T25 0.35-µm ON Semiconductor process because of the demand of the intended application for higher supply voltage. Nevertheless, the topology is suitable also for modern smaller CMOS technologies and lower supply voltages. The performance of the circuit was verified by laboratory measurement with parameters comparable to the Cadence simulation results and presented here.


  • Open Access

    A 1 V 92 dB SNDR 10 kHz Bandwidth Second-Order Asynchronous Delta-Sigma Modulator for Biomedical Signal Processing

    by Vilém Kledrowetz, Lukáš Fujcik, Roman Prokop, Jiří Háze

    In this paper, a second-order asynchronous delta-sigma modulator (ADSM) is proposed based on the active-RCintegrators. The ADSM is implemented in the 0.18 μ m CMOS Logic or Mixed-Signal/RF, General Purpose process from the Taiwan Semiconductor Manufacturing Company with a center frequency of 848 kHz at a supply voltage of 1 V with a 92 dB peak signal-to-noise and distortion ratio ( S N D R ), which corresponds to 15 bit resolution. These parameters were achieved in all the endogenous bioelectric signals bandwidth of 10 kHz. The ADSM dissipated 295 μ W and had an area of 0.54 mm 2 . The proposed ADSM with a high resolution, wide bandwidth, and rail-to-rail input voltage range provides the universal solution for endogenous bioelectric signal processing.


  • Open Access

    Design of Signal Generators Using Active Elements Developed in I3T25 CMOS Technology Single IC Package for Illuminance to Frequency Conversion

    by Roman Sotner, Jan Jerabek, Ladislav Polak, Vilem Kledrowetz, Roman Prokop

    This paper presents a compact and simple design of adjustable triangular and square wave functional generators employing fundamental cells fabricated on a single integrated circuit (IC) package. Two solutions have electronically tunable repeating frequency. The linear adjustability of repeating frequency was verified in the range between 17 and 264 kHz. The main benefits of the proposed generator are the follows: A simple adjustment of the repeating frequency by DC bias current, Schmitt trigger (threshold voltages) setting by DC driving voltage, and output levels in hundreds of mV when the complementary metal-oxide semiconductor (CMOS) process with limited supply voltage levels is used. These generators are suitable to provide a simple conversion of illuminance to frequency of oscillation that can be employed for illuminance measurement and sensing in the agriculture applications. Experimental measurements proved that the proposed concept is usable for sensing of illuminance in the range from 1 up to 500 lx. The change of illuminance within this range causes driving of bias current between 21 and 52 μA that adjusts repeating frequency between 70 and 154 kHz with an error up to 10% between the expected and real cases.


  • Open Access

    Low-power ASIC suitable for miniaturized wireless EMG systems

    by Vilem Kledrowetz, Roman Prokop, Lukas Fujcik, Michal Pavlik, Jiří Háze

    Nowadays, the technology advancements of signal processing, low-voltage low-power circuits and miniaturized circuits have enabled the design of compact, battery-powered, high performance solutions for a wide range of, particularly, biomedical applications. Novel sensors for human biomedical signals are creating new opportunities for low weight wearable devices which allow continuous monitoring together with freedom of movement of the users. This paper presents the design and implementation of a novel miniaturized low-power sensor in integrated circuit (IC) form suitable for wireless electromyogram (EMG) systems. Signal inputs (electrodes) are connected to this application-specific integrated circuit (ASIC). The ASIC consists of several consecutive parts. Signals from electrodes are fed to an instrumentation amplifier (INA) with fixed gain of 50 and filtered by two filters (a low-pass and high-pass filter), which remove useless signals and noise with frequencies below 20 Hz and above 500 Hz. Then signal is amplified by a variable gain amplifier. The INA together with the reconfigurable amplifier provide overall gain of 50, 200, 500 or 1250. The amplified signal is then converted to pulse density modulated (PDM) signal using a 12-bit delta-sigma modulator. The ASIC is fabricated in TSMC0.18 mixed-signal CMOS technology.


  • Inductance simulator based on dual controlled CMOS voltage differencing current conveyor

    by J. Jerabek, R. Sotner, R. Prokop, V. Kledrowetz, A. Kartci, U. E. Ayten

    The voltage differencing current conveyor (VDCC) based lossless/lossy inductance simulator with the advantage of extended (i.e. dual-controlled) range of equivalent inductance value and possibility of reconfiguration of polarity is presented in this study. These unconventional features are available because of newly designed CMOS structure of VDCC element. VDCC was fabricated lately in I2T100 0.7 um technology. Relevant VDCC-based inductance simulators are compared briefly with attention to controllability of inductance value especially. Theoretical expectations are compared with experimental results of an inductance simulator prototype obtained in laboratory measurements of proposed circuit based mainly on VDCC chip and its unique features are provided.