Emad Samadaei
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Emad Samadaei has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Edris Pouresmaeil
Aalto University
2 shared publications - Mina Iranian
Department of Engineering, Atlas Danesh Co, Ghaemshahr 47658-37449, Iran
2 shared publications - Aidin Salehi
Department of engineering, Mazandaran University of Science and Technology, Babol 47166-85635, Iran
1 shared publication - Mohammad Kaviani
Department of engineering, Mazandaran University of Science and Technology, Babol 47166-85635, Iran
1 shared publication
Latest Publications
- Open Access
- 4 June 2020
- Published by MDPI AG in Electronics
- Vol. 9 (6) , 937
Single DC Source Multilevel Inverter with Changeable Gains and Levels for Low-Power Loads
Different types of multilevel converters have been used to convert DC voltage to AC voltage for different applications. It is, however, desirable for flexible AC output voltage to be created from a single DC source at lower cost. This paper presents a new type of single DC source multilevel inverter which has the ability to create a different number of levels with low rate components. This device is also able boost the magnitude of the output voltage by means of a variable gain with one DC source. The advantages of the multilevel inverter are rapid stepping among levels, and its ability to produce different ranges of levels (seven, nine and eleven) and gains (two, four and eight). The proposed multilevel inverter includes six semiconductor switches, eight diodes, two capacitors and two inductors, making it suitable for low-power applications. A simulation in MATLAB and experimental tests on a prototype setup showed good performance for different modulations, with THD% down to 2.29%, which are meets the IEEE standard (IEEE 519).
- 4 June 2020
- Published by MDPI AG in Electronics
- Vol. 9 (6) , 937
Open AccessSingle DC Source Multilevel Inverter with Changeable Gains and Levels for Low-Power Loads
Different types of multilevel converters have been used to convert DC voltage to AC voltage for different applications. It is, however, desirable for flexible AC output voltage to be created from a single DC source at lower cost. This paper presents a new type of single DC source multilevel inverter which has the ability to create a different number of levels with low rate components. This device is also able boost the magnitude of the output voltage by means of a variable gain with one DC source. The advantages of the multilevel inverter are rapid stepping among levels, and its ability to produce different ranges of levels (seven, nine and eleven) and gains (two, four and eight). The proposed multilevel inverter includes six semiconductor switches, eight diodes, two capacitors and two inductors, making it suitable for low-power applications. A simulation in MATLAB and experimental tests on a prototype setup showed good performance for different modulations, with THD% down to 2.29%, which are meets the IEEE standard (IEEE 519).
- Open Access
- 2 December 2019
- Published by MDPI AG in Electronics
- Vol. 8 (12) , 1460
The P-Type Module with Virtual DC Links to Increase Levels in Multilevel Inverters
There has been an active interest in the evolution of newer multilevel inverter topologies in which the highest operation of DC sources become an important subject. In the paper, a new structure module presented a seventeen levels asymmetrical multilevel inverter by using two unequal DC sources (with the ratio 3:1). The configuration was focused on creating virtual DC links by two chargeable capacitors. The module had a simple inherent charging for capacitors without any additional circuit. The proposed multilevel inverter could produce higher voltage levels by a lower number of components; therefore, it is suitable for a wide range of applications. Also, the cascade connection of the module led to a modular topology with more voltage levels at higher voltages. The capability of the inherent negative voltage was involved. The simulation results obtained in MATLAB/Simulink, as well as the experimental results, verified the proposed topology.
- 2 December 2019
- Published by MDPI AG in Electronics
- Vol. 8 (12) , 1460
Open AccessThe P-Type Module with Virtual DC Links to Increase Levels in Multilevel Inverters
There has been an active interest in the evolution of newer multilevel inverter topologies in which the highest operation of DC sources become an important subject. In the paper, a new structure module presented a seventeen levels asymmetrical multilevel inverter by using two unequal DC sources (with the ratio 3:1). The configuration was focused on creating virtual DC links by two chargeable capacitors. The module had a simple inherent charging for capacitors without any additional circuit. The proposed multilevel inverter could produce higher voltage levels by a lower number of components; therefore, it is suitable for a wide range of applications. Also, the cascade connection of the module led to a modular topology with more voltage levels at higher voltages. The capability of the inherent negative voltage was involved. The simulation results obtained in MATLAB/Simulink, as well as the experimental results, verified the proposed topology.