Chanwoo Kim
Research Subjects
Chanwoo Kim has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Hongjoon Kim
Department of Electrical Engineering, Kyungpook National University, Sangyeok-dong, Daegu 41566, Republic of Korea
2 shared publications - Hyung-Min Park
Department of Electronic Engineering, Sogang University, Seoul, Republic of Korea
2 shared publications - Richard M. Stern
Department of Electrical and Computer Engineering, Carnegie Mellon University, Pittsburgh, PA 15213, USA
2 shared publications - Soonwoo Park
School of Electronic and Electrical Engineering, Kyungpook National University, Daegu, South Korea
2 shared publications Evandro Gouvea
Department of Electrical and Computer Engineering and Language Technologies Institute, Carnegie Mellon University, Pittsburgh, PA 15213 USA
1 shared publicationHeeje Han
Kyungpook National University College of IT Engineering Electrical Engineering Daegu South Korea
1 shared publication
Latest Publications
- Open Access
- 6 December 2019
- Published by Wiley in International Journal of Antennas and Propagation
- Vol. 2019, 1-4
Compact Band-Selective Power Divider Using One-Dimensional Metamaterial Structure
A band-selective power divider is demonstrated for the first time. By replacing lumped element right-handed (RH) and left-handed (LH) transmission lines (TL) in a conventional Wilkinson power divider, it is possible to achieve both power division and filtering simultaneously. By utilizing the positive phase propagation property of an RHTL, which works as a low-pass filter, and the negative phase propagation property of an LHTL, which works as a high-pass filter, the band-selective quarter-wave sections required to construct a Wilkinson power divider are implemented. The fabricated circuit shows an insertion loss in the range 1.7 dB–2.5 dB in the passband, with the circuit dimensions of merely 12 mm by 10 mm.
- 6 December 2019
- Published by Wiley in International Journal of Antennas and Propagation
- Vol. 2019, 1-4
Open AccessCompact Band-Selective Power Divider Using One-Dimensional Metamaterial Structure
A band-selective power divider is demonstrated for the first time. By replacing lumped element right-handed (RH) and left-handed (LH) transmission lines (TL) in a conventional Wilkinson power divider, it is possible to achieve both power division and filtering simultaneously. By utilizing the positive phase propagation property of an RHTL, which works as a low-pass filter, and the negative phase propagation property of an LHTL, which works as a high-pass filter, the band-selective quarter-wave sections required to construct a Wilkinson power divider are implemented. The fabricated circuit shows an insertion loss in the range 1.7 dB–2.5 dB in the passband, with the circuit dimensions of merely 12 mm by 10 mm.
- 2 December 2019
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 62 (3) , 1204-1208
High frequency arbitrary waveform generator using a nonlinear transmission line
In this article, a high‐frequency arbitrary waveform generator (AWG) based on Fourier synthesis theory is presented. A key element consists of a nonlinear transmission line (NLTL) that acts as a harmonic generator for large signals and as a phase shifter for small signals. The harmonics generated by the NLTL are separated into four channels using power dividers and each harmonic is bandpass filtered in each channel. The phase and the amplitude are then modulated in each channel by an NLTL phase shifter and a voltage variable attenuator. Finally, vector modulated signals from each channel are combined in Wilkinson power combiners to form any waveform shape. We used 0.5 GHz as a master signal and synthesized waveforms using all four channels.
- 2 December 2019
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 62 (3) , 1204-1208
High frequency arbitrary waveform generator using a nonlinear transmission line
In this article, a high‐frequency arbitrary waveform generator (AWG) based on Fourier synthesis theory is presented. A key element consists of a nonlinear transmission line (NLTL) that acts as a harmonic generator for large signals and as a phase shifter for small signals. The harmonics generated by the NLTL are separated into four channels using power dividers and each harmonic is bandpass filtered in each channel. The phase and the amplitude are then modulated in each channel by an NLTL phase shifter and a voltage variable attenuator. Finally, vector modulated signals from each channel are combined in Wilkinson power combiners to form any waveform shape. We used 0.5 GHz as a master signal and synthesized waveforms using all four channels.
- Open Access
- 30 July 2015
- Published by Korea Institute for Structural Maintenance Inspection in Journal of the Korea institute for structural maintenance and inspection
- Vol. 19 (4) , 125-135
Dynamic Response of PSC I shape girder being used wide upper flange in Railway Bridge
- 30 July 2015
- Published by Korea Institute for Structural Maintenance Inspection in Journal of the Korea institute for structural maintenance and inspection
- Vol. 19 (4) , 125-135
Open AccessDynamic Response of PSC I shape girder being used wide upper flange in Railway Bridge
- 14 September 2014
- Published by International Speech Communication Association
- p. 2715-2718
Robust speech recognition in reverberant environments using subband-based steady-state monaural and binaural suppression
- 14 September 2014
- Published by International Speech Communication Association
- p. 2715-2718
Robust speech recognition in reverberant environments using subband-based steady-state monaural and binaural suppression
- Open Access
- 1 May 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 98-103
Binaural and Multiple-Microphone Signal Processing Motivated by Auditory Perception
It is well known that binaural processing is very useful for separating incoming sound sources as well as for improving the intelligibility of speech in reverberant environments. This paper describes and compares a number of ways in which the classic model of interaural cross-correlation proposed by Jeffress, quantified by Colburn, and further elaborated by Blauert, Lindemann, and others, can be applied to improving the accuracy of automatic speech recognition systems operating in cluttered, noisy, and reverberant environments. Typical implementations begin with an abstraction of cross-correlation of the incoming signals after nonlinear monaural bandpass processing, but there are many alternative implementation choices that can be considered. Typical implementations differ in the ways in which an enhanced version of the desired signal is developed using binaural principles, in the extent to which specific processing mechanisms are used to impose suppression motivated by the precedence effect, and in the precise mechanism used to extract interaural time differences.
- 1 May 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 98-103
Open AccessBinaural and Multiple-Microphone Signal Processing Motivated by Auditory Perception
It is well known that binaural processing is very useful for separating incoming sound sources as well as for improving the intelligibility of speech in reverberant environments. This paper describes and compares a number of ways in which the classic model of interaural cross-correlation proposed by Jeffress, quantified by Colburn, and further elaborated by Blauert, Lindemann, and others, can be applied to improving the accuracy of automatic speech recognition systems operating in cluttered, noisy, and reverberant environments. Typical implementations begin with an abstraction of cross-correlation of the incoming signals after nonlinear monaural bandpass processing, but there are many alternative implementation choices that can be considered. Typical implementations differ in the ways in which an enhanced version of the desired signal is developed using binaural principles, in the extent to which specific processing mechanisms are used to impose suppression motivated by the precedence effect, and in the precise mechanism used to extract interaural time differences.